• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.1
• /
• pp.110-119
• /
• 2017

This paper describes a CMOS image sensor (CIS) with dual correlated double sampling (CDS) and column-parallel analog-to-digital converter (ADC) and its measurement method using a field-programmable gate array (FPGA) integrated module. The CIS is composed of a $320{\times}240$ pixel array with $3.2{\mu}m{\times}3.2{\mu}m$ pixels and column-parallel 10-bit single-slope ADCs. It is fabricated in a $0.11-{\mu}m$ CIS process, and consumes 49.2 mW from 1.5 V and 3.3 V power supplies while operating at 6.25 MHz. The measured dynamic range is 53.72 dB, and the total and column fixed pattern noise in a dark condition are 0.10% and 0.029%. The maximum integral nonlinearity and the differential nonlinearity of the ADC are +1.15 / -1.74 LSB and +0.63 / -0.56 LSB, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.148-149
• /
• 2008

As infrared light is radiated, the CMOS Readout IC (ROIC) for the microbolometer type infrared sensor detects voltage or current when the resistance value in the bolometer sensor varies. One of the serious problems in designing the ROIC is that resistances in the bolometer and reference resistor have process variation. This means that each pixel does not have the same resistance, causing serious fixed pattern noise problems in sensor operations. In this paper, Reference resistor compensation technique was proposed. This technique is to compensate the reference resistance considering the process variation, and it has the same reference resistance value as a bolometer cell resistance by using a comparator and a cross coupled latch.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.16-17
• /
• 2006

적외선 이미지 센서용으로 사용되는 마이크로 볼로미터 센서는 process variation으의 인하여 모든 볼로미터 센서의 셀이 정확한 저항값을 갖지 못하여 입력신호에 왜곡을 가져 온다. 본 논문에서는 적외선 이미지 센서용 CMOS 검출회로를 설계하는 데 있어, 이러한 볼로미터 셀 어레이의 고정패턴잡음(Fixed Pattern hoise)을 최소화하는 방법에 대해 연구하였다. 기존의 단일 입력 방식 검출회로는 볼로미터 셀어레이의 고정패턴잡음을 보정하기 위하여 추가적인 보정 회로를 필요로 하였다. 이러한 문제점을 해결하기 위해서 본 논문에서는 차동 입력 방식 검출회로를 제안하였으며, 이를 적용하여 출력을 살펴본 결과 추가적인 보정회로 없이 20%의 노이즈 감쇠효과를 얻을 수 있다. 연구 결과를 바탕으로 32${\times}$32 크기를 갖는 셀어레이의 볼로미터를 구성하여 전체 칩을 설계하였으며 컴퓨터 시물레이션을 통해 결과를 분석하였다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.11
• /
• pp.857-861
• /
• 2012

FPN (fixed-pattern-noise) mainly comes from the device or pattern mismatches in pixel and color filter, pixel photodiode leakage in CMOS image sensor. In this paper, optical stack module related pixel FPN was investigated and the classification of pixel FPN contribution with the individual optical module process was presented. The methodology and procedure would be helpful in reducing the greater pixel FPN and distinguishing the complex FPN sources with respect to various noise factors.

• Transactions of the Society of Information Storage Systems
• /
• v.5 no.2
• /
• pp.89-95
• /
• 2009

We setup the system to measure the noise characteristics of the 5M complementary metal-oxide semiconductor (CMOS) image sensor by generic measurement indicator of Standard mobile imaging architecture (SMIA) which is one of internal standard of mobile imaging architecture. To evaluate the effect of environment and setting parameters, such as temperature and integration time, we measure the variation of the dark signal, dynamic range and fixed pattern noise of image sensor. We also detect the number of defective pixels and cluster defects defined as adjacent single defect pixels at 5M CMOS image sensor. Then, we find the existence of some cluster defects in experiment, which are not expected in calculation.

• Smart Structures and Systems
• /
• v.7 no.2
• /
• pp.117-132
• /
• 2011

This paper is aimed at presenting two methods on the basis of pattern search and genetic algorithms to detect and estimate damage in plates using the modal data of a damaged plate. The proposed methods determine the damages of plate structures using optimization of an objective function by pattern search and genetic algorithms. These methods have been applied to two numerical examples, namely four-fixed supported and cantilever plates with and without noise in the modal data and containing one or several damages. The obtained results clearly reveal that the proposed methods can be viewed as a powerful and reliable method for structural damage detection in plates using the modal data.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.16 no.4
• /
• pp.276-280
• /
• 2016

A fixed rate speech coder based on the filter bank and the non-uniform sampling technique is proposed. The non-uniform sampling is achieved by the detection of inflection points (IPs). A speech block is band passed by the filter bank, and the subband signals are processed by the IP detector, and the detected IP patterns are compared with entries of the IP database. For each subband signal, the address of the closest member of the database and the energy of the IP pattern are transmitted through channel. In the receiver, the decoder recovers the subband signals using the received addresses and the energy information, and reconstructs the speech via the filter bank summation. As results, the coder shows fixed data rate contrary to the existing speech coders based on the non-uniform sampling. Through computer simulation, the usefulness of the proposed technique is confirmed. The signal-to-noise ratio (SNR) performance of the proposed method is comparable to that of the uniform sampled pulse code modulation (PCM) below 20 kbps data rate.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.46 no.4
• /
• pp.94-101
• /
• 2009

In this paper, we propose design of hardware based on a high speed digital signal processor (DSP) and a field programmable gate array (FPGA) for real-time suppression of fixed pattern noise (FPN) using hardware neural networks (HNN) in cooled infrared focal plane array (IRFPA) imaging system FPN appears a limited operation by temperature in observable images which applies to non-uniformity correction for infrared detector. These have very important problems because it happen serious problem for other applications as well as degradation for image quality in our system Signal processing architecture for our system operates reference gain and offset values using three tables for low, normal, and high temperatures. Proposed method creates virtual tables to separate for overlapping region in three offset tables. We also choose an optimum tenn of temperature which controls weighted values of HNN using mean values of pixels in three regions. This operates gain and offset tables for low, normal, and high temperatures from mean values of pixels and it recursively don't have to do an offset compensation in operation of our system Based on experimental results, proposed method showed improved quality of image which suppressed FPN by change of temperature distribution from an observational image in real-time system.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.49 no.2
• /
• pp.35-44
• /
• 2012

Most recent infrared (IR) sensors have a focal-plane array (FPA) structure. Spatial non-uniformity of a FPA structure, however, introduces unwanted fixed pattern noise (FPN) to images. This non-uniformity correction (NUC) of a FPA can be categorized into target-based and scene-based approaches. In a target-based approach, FPN can be separated by using a uniform target such as a black body. Since the detector response randomly drifts along the time axis, however, several scene-based algorithms on the basis of a video sequence have been proposed. Among those algorithms, the state-of-the-art one based on Kalman filter uses one-directional warping for motion compensation and only compensates for offset non-uniformity of IR camera detectors. The system model using one-directional warping cannot correct the boundary region where a new scene is being introduced in the next video frame. Furthermore, offset-only correction approaches may not completely remove the FPN in images if it is considerably affected by gain non-uniformity. Therefore, for FPN reduction in IR videos, we propose a joint correction algorithm of gain and offset based on bi-directional warping. Experiment results using simulated and real IR videos show that the proposed scheme can provide better performance compared with the state-of-the art in FPN reduction.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.3B
• /
• pp.557-564
• /
• 2000

This paper presents a watermarking algorithm for embedding visually recognizable pattern (Mark, Logo, Symbol, stamping or signature) into the image. first, the color image(RGB model)is transformed in YCbCr model and then the Y component is transformed into 3-level wavelet transform. Next, the values are assembled with pattern watermark. PN(pseudo noise) code at spread spectrum communication method and mutilevel watermark weights. This values are inserted into discrete wavelet domain. In our scheme, new calculating method is designed to calculate wavelet transform with integer value in considering the quantization error. and we used the color conversion with fixed-point arithmetic to be easy to make the hardware hereafter. Also, we made the new solution using mutilevel threshold to robust to common signal distortions and malicious attack, and to enhance quality of image in considering the human visual system. the experimental results showed that the proposed watermarking algorithm was superior to other similar water marking algorithm. We showed what it was robust to common signal processing and geometric transform such as brightness. contrast, filtering. scaling. JPEG lossy compression and geometric deformation.