• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.28 no.10
• /
• pp.101-106
• /
• 2014

Although anti-freezing heating cable has been widely installed in most residential boiler pipe, there were excessive energy consumption and fire risk due to inadequate temperature control. In this paper, a new energy saving fire risk-free controller was developed by using microprocessing operation which include detection of not only boiler room temperature but also pipe surface one. Its actual effect has been verified to save more than a half of the energy consumption comparing to conventional controller through temperature and humidity chamber experiment.

• Journal of the Korean Applied Science and Technology
• /
• v.28 no.4
• /
• pp.410-417
• /
• 2011

Effects of ethylene-propylene diene monomer (EPDM)/polypropylene (PP), zinc oxide, stearic acid, and clay on the combustive properties based on EDPM/PP were investigated. The EDPM/PP/clay nanocomposites was compounded to prepare specimen for combustive analysis by cone calorimeter (ISO 5660-1). It was found that the specific mass loss rate (SMLR) in the nanocomposites decreased due to the fire resistance compared with unfilled EDPM/PP, while the nanocomposites showed the higher total heat release (THR), higher CO production release, and higher specific extinction area (SEA) than those of virgin EPDM/PP. The stearic acid for softening ruber increased the THR and amount of smoke by itself, combustible.

• Journal of Integrative Natural Science
• /
• v.6 no.3
• /
• pp.151-157
• /
• 2013

The ion exchange resins were synthesized from 1-aza-18-crown-6 macrocyclic ligand attached to styrene (2th petroleum in 4th class hazardous material) divinylbenzene (DVB) copolymer with crosslinks of 1%, 6%, and 15% by substitution reaction. These synthetic resins were confirmed by chlorine content, elementary analysis, surface area, and IR-spectrum. The object of this study was to seperate the metal ion absorbed in reinforcement water fire extinguishing agent. As the results of the effects of pH, equilibrium arrival time, and crosslink of synthetic resin on metal ion adsorption for resin adsorbent, the metal ions were showed high adsorption at pH 3 or over and adsorption equilibrium of metal ions was about 2 hours. In addition, adsorption selectivity for the resin in water was the order of Al (III) > Ni (II) > Sm (III) ions, adsorbability of the metal ions was in the crosslinks order of 1%, 6%, and 15%.

• Journal of environmental and Sanitary engineering
• /
• v.23 no.1
• /
• pp.57-65
• /
• 2008

Resins were synthesized with 1-aza-15-crown-5 macrocyclic ligand attached to styrene(dangerous matter) divinylbenzene(DVB) copolymer with crosslink of 1, 2, 6 and 15% by substitution reaction. The synthesis of these resins was confirmed by content of chlorine, element analysis, and IR-spectrum. The effects of pH, time and crosslink on adsorption of metal ion　from water fire extinguishing agent by the synthetic resin adsorbent were investigated. The metal ion was showed fast adsorption on the resins above pH 3. The optimum equilibrium time for adsorption of metallic ions was about two hours. The adsorption selectivity determined in water was in increasing order of $Mg^{2+}>Al^{3+}>Pb^{2+}$. The adsorption was in the order of 1, 2, 6, and 15% crosslink resin.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2008.04a
• /
• pp.100-103
• /
• 2008

Autoignition suppression of hydrogen/air premixed mixtures by $CF_3CHFCF_3$(HFP) was investigated computationally. Numerical simulation was performed in isobaric and homogeneous system to evaluate the induction times. The detailed chemistry of 93 species and 817 reaction mechanism was introduced for hydrogen/air/HFP mixtures. The results shows the similar concentrations for the major reactants such as hydrogen and oxygen during autoignition while water vapor produced at the ignition temperature was decomposed later, which leaded to the shoulder on the concentration of H, OH and O radical with time. The fluorine included from HFP was converted mainly to stable HF and the carbon was formed to various species, CF2, CF2O, CO etc. More details of chemical effects of HFP addition will be investigate with sensitivity analysis in the near future.

• Journal of the Korean Wood Science and Technology
• /
• v.36 no.2
• /
• pp.73-78
• /
• 2008

Inorganic chemical treated wood was prepared by impregnation of calcium or magnesium chloride ($CaCl_2$ or $MgCl_2$) solution and immersion in saturated solution of ammonium fluoride ($NH_4F$) as a reactant in order to make an introduction of a refractory fluorides with fungicidal and insecticidal effects in wood. The weight percent gains (WPGs) were increased with increase in concentration of calcium chloride or magnesium chloride solution, and were higher in treatment with calcium chloride than with magnesium chloride. Inorganic substances were produced mainly in the lumina of tracheides. These substances were proved to be the calcium fluoride or magnesium fluoride by the energy dispersive X-ray analyzer in conjunction with a scanning electron microscope (SEM-EDX). The treated wood showed good decay resistance because the weight losses were hardly occurred by the test fungi such as Tyromyces palustris and Trametes versicolor. The fire resistance effect was superior to the treated wood compared with that of the untreated wood.

• Journal of the Korean Society of Safety
• /
• v.11 no.1
• /
• pp.90-98
• /
• 1996

In order to investigate the effects on intumescence to fire protective coatings, the characteristics of solubility, hygroscopic nature and X-ray diffration results on soluble silicate were determined. Solubility is depended on the mutual action of each silicate. In the result of hygroscopic characteristics by water absorption under several kinds of relative humidity, lithium silicate is more stable than sodium and potassium silicate over moistures. Eventhough free water is evaporated over $100^{\circ}C$ , physically adsorption water and ionic water are eliminated about $200^{\circ}C$, but evolution of structural water is expected to be emitted between 400~$600^{\circ}C$ range. Those are considered to be contributed intumescence on soluble silicate.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 1997.11a
• /
• pp.162-168
• /
• 1997

A theoretical model for the interaction of the moving heat source and a solid substrate when they are in contact is described. for purposes of the model the substrate is assumed to act as a continuum and the Fourier equation for transient. three-dimensional conduction is solved using Laplace and Fourier transformations. Unlike most previous models, this model shows the explicit relations between the properties of heat source and that of the substrate. Since the size, shape and speed of heat source impact the ignition of substrate, considerable attention is devoted to evaluating these parameters. Results are presented which show the effects of the size, shape and speed of heat source on the substrate.

• Proceedings of the KSR Conference
• /
• 2008.11b
• /
• pp.446-450
• /
• 2008

Urban transits of metropolises have been used by many citizens due to the merits of environment friendly traffic, mass transportation, safety and scheduled operation. It is very important to keep safety for the increased passengers. When the accidents as like fire occur, rapid evacuation from fire site is one of the most effective methods to decrease casualties. Furthermore, overseas buyers sometimes request the verification results of the passenger evacuation from rolling stock. In this study, algorithm for passenger flow analysis based on DEM(Discrete Element Method) is newly developed and made simulation program package. And, we applied it to the evacuation problem for urban transits. By using the developed program, we compared the simulation results of the effects of the location and size of door and elapsed time qualitatively and quantitatively.

• Research in Community and Public Health Nursing
• /
• v.32 no.3
• /
• pp.396-403
• /
• 2021

Purpose: The purpose of this study was to investigate the mediating effect of perceived appraisal support between neuroticism and occupational stress in firefighters. Methods: The subjects of this study were 156 firefighters who worked at three fire stations in G province in Korea. The collected data were analyzed by t-test, ANOVA, and multiple regression analysis using Baron and Kenny's method for mediation. Results: There were significant relationships between neuroticism and perceived appraisal support (r=.30, p<.001), neuroticism and occupational stress (r=.42, p<.001), and perceived appraisal support and occupational stress (r=.36, p<.001). Perceived appraisal support showed partial mediating effects in the relationship between neuroticism and occupational stress. Conclusion: The impact of neuroticism in firefighters was mediated by perceived appraisal support for occupational stress. This suggests that strategies for enhancing perceived appraisal support in fire fighters should be considered when developing neuroticism management interventions for decreasing their occupational stress.