• Restorative Dentistry and Endodontics
• /
• v.42 no.4
• /
• pp.324-331
• /
• 2017

Objectives: This study evaluated smear layer removal by different chemical solutions used with or without ultrasonic activation after post preparation. Materials and Methods: Forty-five extracted uniradicular human mandibular premolars with single canals were treated endodontically. The cervical and middle thirds of the fillings were then removed, and the specimens were divided into 9 groups: G1, saline solution (NaCl); G2, 2.5% sodium hypochlorite (NaOCl); G3, 2% chlorhexidine (CHX); G4, 11.5% polyacrylic acid (PAA); G5, 17% ethylenediaminetetraacetic acid (EDTA). For the groups 6, 7, 8, and 9, the same solutions used in the groups 2, 3, 4, and 5 were used, respectively, but activated with ultrasonic activation. Afterwards, the roots were analyzed by a score considering the images obtained from a scanning electron microscope. Results: EDTA achieved the best performance compared with the other solutions evaluated regardless of the irrigation method (p < 0.05). Conclusions: Ultrasonic activation did not significantly influence smear layer removal.

• Korean Journal of Optics and Photonics
• /
• v.8 no.4
• /
• pp.291-296
• /
• 1997

The slotted type of hollow copper cathode was constructed and tested for its geometric stability and usability for laser operation at 780nm. The peak output power of copper ion laser emission was measured for different operating conditions. The IR-laser power was dependent on the parameters of the geometry of the hollow cathodes, discharge current and gas fillings. The peak power decreased with increasing neon pressure over 60%. One reason for this decrease in output power may be conjectured as hier due to the decreasing population of the upper laser level. The copper ion laser transition at 780 nm populated at the 5p level. The hollow cathode copper ion laser is operated in He and Ne mixture by electric discharge excitation and could be operated for more than 100 hours with only a 35% drop in the output power(2.8mW cw for 9.6cm active length).

• Economic and Environmental Geology
• /
• v.13 no.2
• /
• pp.104-116
• /
• 1980

The Ulsan mine is one of the largest contact metasomatic magnetite and scheelite deposits in the southeastern part of Korea. Mineralization at the Ulsan mine is localized along the contact between upper Cretaceous volcanic rocks and age unknown limestone which were intruded by 58 m.y. -old biotite-horndlende granite. General zonal sequence of skarn toward crystalline limestone from limestone-volcanics contact is grandite, grandite-salite and salite zones. On the otherhand volcanics origin skarns exhibits zonal sequences toward hornfels from boundary with limestone is garnet, garnet-epidote, and epidote zone. Compositions of garnets and clinopyro xenes are determined by the X-ray diffraction and reflective indecies. Local brecciation of these early skarns were followed by formation of the later skarn as zoned patches, breccia fillings and cross-cutting veins. Paragenetic sequence of late skarn minerals which is exhibited in the zoned patches and veins is an overlapping progression with time from andradite through hedenbergite or actinolite, quartz to calcite deposition. Magnetite metallization followed early formed skarns and pyrite pyrrhoite, sphalerite, galena, tennantite, scheelite and arsenopyrite deposition were simultaneously with hedenbergite, quartz and calcite of late skarn. Filling temperatures of fluid inclusions in calcites range from $160^{\circ}$ to $280^{\circ}C$.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.1 s.178
• /
• pp.174-184
• /
• 2006

In order to fill the holes with complex shapes in the large polygon model, a new approach which is based on the implicit surface interpolation method combined with domain decomposition method is presented. In the present study, a surface is constructed by creating smooth implicit surface from the incomplete polygon model through which the surface should pass. In the method an implicit surface is defined by a radial basis function, a continuous scalar-valued function over the domain $R^3$ The generated surface is the set of all points at which this scalar function takes on the value zero and is created by placing zero-valued constraints at the vertices of the polygon model. In this paper the well-known domain decomposition method is used in order to treat the large polygon model. The global domain of interest is divided into smaller domains where the problem can be solved locally. LU decomposition method is used to solve a set of small local problems and their local solutions are combined together using the weighting coefficients to obtain a global solution. In order to show the validity of the present study, various hole fillings are carried out fur the large and complex polygon model of arbitrary topology.

• The Journal of the Korean dental association
• /
• v.36 no.2 s.345
• /
• pp.144-150
• /
• 1998

The dental insurance had been enforced in Korea past 20 years. The major part of the insurance was filling, and the filling was divided into two parts-the cavity preparation and cavity filling, The Cavity filling was estimated into 6 levels according to the cavity types. But the tooth cavity preparations was not evaluated by the cavity types but merely only one-the one visit filling or cavity preparation. Korean dentists tend to turn away from the amalgam to the non-insurance treatments. The purpose of this study was to relate the cavity preparations and cavity fillings to the cavity types. So I measured the real time and surveyed the relative difficulties of cavity preparations from the 31 dentists according to the cavity types, who had been trained in conservative dentistry. The conclusion of this study was below. 1. The estimations of tooth cavity preparation was divided same as the cavity filling. 2. There must be reasonable considerations about the times and difficulties in cavity preparation. 3. There was differences between the premolars and molars, upper jaw and lower one. 4. Two or more cavities in one tooth must be evaluated according to the number of cavities, not in one cavity.

• The Journal of the Korean bone and joint tumor society
• /
• v.7 no.2
• /
• pp.73-79
• /
• 2001

Giant cell tumor is usually found around the knee joint, especially in the distal femur or proximal tibia. Despite being classified as benign, it has unusual biological behavior of local aggressiveness and tend to have severely destructive lesion and develop rare pulmonary metastasis. Therefore, when the patient is presented to the physician with an expansile lytic lesion of challenging clinicopathologic entity extending to subchondral bone, the physician faces up to difficulties in treatment. We report a case of 25 years old patient having recurrent giant cell tumor in the right distal femur which developed metastasis to lung. The primary bone lesion was treated with local curettage and fillings with methylmethacrylate, but when he returned to the hospital two years later, the recurrence had developed with lung metastasis.

• Transactions of the Korean hydrogen and new energy society
• /
• v.29 no.1
• /
• pp.32-40
• /
• 2018

There has been an measuring errors between state of charge (SOC; kg) value and mass flow meter (MFM) value in dispenser for hydrogen refueling station. Finally, we observed average 15.5% weight difference between these two values and the MFM readings show a 15.5% higher readout of the SOC readings. Each car was charged with average 2.66 kg of hydrogen fuel during this period. In the initial charging of the day shows less measuring value than the final charging with the maximum 0.038 kg times number of filling. There is no effects of atmosphere temperature change for the hydrogen filled weight during one full year such as January's cold winters and August's hot summers.

• Journal of Korean society of Dental Hygiene
• /
• v.15 no.3
• /
• pp.443-450
• /
• 2015

Objectives: The purpose of the study is to identify the relationship between happiness, subjective oral health condition and oral health behavior in Korean elderly people. Methods: A self-reported questionnaire was completed by 487 elderly people using facilities for the senior citizens in Gyeonggi-do from January 3 to November 28, 2014 by convenience sampling method. The questionnaire consisted of demographic characteristics of the subjects, subjective oral health status, oral health behavior, and happiness. Cronbach'a alpha in the happiness was 0.734 in the study. Results: Happiness was closely correlated with abscence of subjective periodontal diseases, dental fillings, and denture. The number of toothbrushing and dental health education had also influenced on happiness. Conclusions: In order to improve the quality of dental health in the elderly, it is necessary to develop a multilateral systematic dental health promotion program by Ministry of Health and Welfare.

• Kyungpook Mathematical Journal
• /
• v.47 no.3
• /
• pp.335-340
• /
• 2007

Let M be a hyperbolic 3-manifold such that ${\partial}M$ has at least two boundary tori ${\partial}_oM$ and ${\partial}_1M$. Suppose that M contains an essential orientable surface P of genus $g$ with one outer boundary component ${\partial}_oP$, lying in ${\partial}_oM$ and having slope ${\lambda}$ in ${\partial}_oM$, and $p$ inner boundary components ${\partial}_iP$, $i=1$, ${\cdots}$, $p$, each having slope ${\alpha}$ in ${\partial}_1M$. Let ${\beta}$ be a slope in ${\partial}_1M$ and suppose that $M({\beta})$ is toroidal. Let $\hat{T}$ be a minimal essential torus in $M({\beta})$, which means that $\hat{T}$ is pierced a minimal number of times by the core of the ${\beta}$-Dehn filling, among all essential tori in $M({\beta})$. Let $T=\hat{T}{\cap}M$ and denote by $t$ the number of components of ${\partial}T$. In this paper we prove: (i) if $t{\geq}3$, then ${\Delta}({\alpha},{\beta}){\leq}6+\frac{10g-5}{p}$, (ii) If $t=2$, then ${\Delta}({\alpha},{\beta}){\leq}13+\frac{24g-12}{p}$, (iii) If $t=1$, then ${\Delta}({\alpha},{\beta}){\leq}1$.

• Korean Journal of Digital Imaging in Medicine
• /
• v.17 no.1
• /
• pp.49-56
• /
• 2015

Temporal bone CT scan side skull fracture. In addition to the confirmation of the ossicles, such as fractures and dislocations, temporomandibular facial fractures, deformities surgery helps to establish a science plan. Cochlear implant surgery has been performed in the state before and after identifying purposes. Test methods are being implemented by the Conventional direct axial and Direct coronal scan, the basic method of Temporal bone CT. Helical scan is a fast Volumetric data obtained compared with the Conventional scan, the patient reduced the dose, and there are some advantages, such as reduced Beam hardening streak artifacts caused by dental fillings. This study is a comparative analysis by dose reduction for patients with a dose according to the conventional scan method and then effective from 2015 by helical scan method performed in 2014 through the retrospective survey, which was then optimized for the purpose of inspection.