• Asian-Australasian Journal of Animal Sciences
• /
• v.4 no.2
• /
• pp.131-136
• /
• 1991

Four male swamp buffaloes weighing $460.5{\pm}44.6kg$ were used to study the effects of different cooling techniques on draught capacity. Each animal carted an 882 kg load on the same asphalt road for one hour during four different time periods: 9:00-10:00 A.M., 10:30-11:30 A.M., 2:00-3:00 P.M. and 3:30-4:30 P.M. Simultaneously, all animals were subjected to five different treatments on five days of similar environmental conditions. In Treatment 1, animals were put stationary in a field and did no work; in Treatment 2, animals were worked without any cooling method; in Treatment 3, fifteen-minute wallow was allowed to animals prior to working; in Treatment 4, animals were covered with wetted jute bags while working, and in Treatment 5, two buckets of water were poured over the buffaloes' trunks just prior to working. The experiment was conducted from April to July 1989, when the weather was very hot. It was found that cooling methods and working times did not affect the draught efficiency of buffaloes during the one hour, but did affect physiological traits. The work load had a larger partial effect on physiological responses of buffalo other than respiration rate than did climatic variables except on the respiration rate of the buffaloes. One cooling technique that seemed to slow the increase of body temperature while working was covering the buffalo's back with wetted jute bags. Animals working at different times had significant differences in the increase of physiological traits except pulse rate.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.8
• /
• pp.1487-1493
• /
• 2016

The susceptible, exposed, infectious, and recovered model (SEIR) is used extensively in the field of epidemiology. On the other hand, dissemination information among users through internet grows exponentially. This information spreading can be modeled as an epidemic. In this paper, we derive the mathematical model of SEIR in viral communication from the view of optimal control theory. Overall the methods based on classical calculus, In order to solve the optimal control problem, proved to be more efficient and accurate. According to Pontryagin's minimum principle (PMP) the Hamiltonian function must be optimized by the control variables at all points along the solution trajectory. We present our method based on the PMP and forward backward algorithm. In this algorithm, one should integrate forward in time for the state equations then integrate backward in time for the adjoint equations resulting from the optimality conditions. The problem is mathematically analyzed and numerically solved as well.

• Journal of Gifted/Talented Education
• /
• v.24 no.2
• /
• pp.191-215
• /
• 2014

The quality of gifted education depends on the quality of teachers in the field. Teachers in music (Korean traditional music) gifted education are significant variable in identifying students' giftedness and successful instruction. The purpose of this study was to explore the desirable components of teachers in music (Korean traditional music) gifted education and develop the evaluation criteria based on the desirable components. Previous research on the components of good teachers, teachers in gifted education and teachers in music (Korean traditional music) gifted education were reviewed. Based on literature review, the evaluation criteria of teachers in music (Korean traditional music) gifted education was developed. To collect opinions and derive consensus of the evaluation criteria, this research used Delphi method with a panels of 25 experts. The evaluation criteria classified with 3 dimensions, 8 categories, and 18 variables as the result.

• Korean Journal of Applied Biomechanics
• /
• v.29 no.4
• /
• pp.227-235
• /
• 2019

Objective: The purpose of this study was to evaluate the effect of passive-acute temperature therapy of the femoral muscle and dynamic warm-up on the countermovement jump performance. Method: Twenty male track and field athletes from national team underwent three treatments applied on the femoral muscles; cold temperature treatment, thermal treatment and dynamic warm-up. The variables extracted at 2 time points (pre-measurement and post measurement) were the temperature of the left and right femoral muscle, displacement & velocity of centre of mass, peak power out, range of motion and moment & power of the knee joint. Results: There was a statistically significant difference in the temperature of the femoral muscle according to measurement time which was high in the order of thermal treatment, dynamic treatment and cold treatment. The jump height was the highest in the dynamic warm-up with no statistically significant difference for the range of motion of the knee joint. The peak power out at dynamic warm-up and the power of the knee joint were statistically significant according to the treatment and measurement time. Conclusion: Local cold and thermal treatment of femoral muscles at ambient temperature did not improve jump performance, while dynamic warm-up was considered to be effective for maintaining the performance of the activities that require strong muscular power.

• 한국전산유체공학회:학술대회논문집
• /
• 2002.10a
• /
• pp.133-138
• /
• 2002

A 3-D axisymmetric computer program is developed to predict the NO behavior in SNCR system for the stoker incinerator with the waste treatment capacity, 200ton/day. To this end a turbulent reacting flow field calculation is made using proper assumption and empiricism. The stoker bed is assumed to be a homogeneous waste-volatilized gaseous state. The initial composition or reactants are assumed based on the data of the ultimate analysis. Turbulent is resolved by k-e model and turbulent reaction is handled by eddy-breakup model harmonized with empirical chemistry data for gaseous combustion, NO and urea reaction. The liquid droplet is traced by Lagrangian method incorporated by aerodynamic drag, Coriolis and crntrifugal forces. Radiation is treated by sensible heat loss model. Calculation results are in good agreement with experimental data at the outlet of post combustion chamber in Daejon 4th industrial complex. The flue gas shows the temperature range of $900\sim1000^{\circ}C$, velocity of 5m/s and NO concentration of 140ppm at the exit while the measured temperature, flue gas velocity and NO concentration are $967^{\circ}C$, $3\sim4m/s$ and $100\sim200ppm$respectively. Using the developed computer program a parametric study has been made with the variation of heat content of waste, castable length and SNCR variables for the determination of proper injector location. In general, the calculated results are consistent and physically acceptable.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.39 no.11
• /
• pp.1183-1189
• /
• 2015

This study focuses on the design of the tapered joints of a wind power turbine. The main variables of the tapered joint are the transmitted torque, shaft diameter, contact area of the tapered ring, and tightening torque of the bolts, which applies a compressive pressure from the hub to the shaft. The stress distribution of the taper fit was calculated under axisymmetric plane strain conditions because of the small taper angle. The axial displacement of the clamp can be calculated from the radial elastic deformation and the taper angle. The stress field of each ring is obtained from the cylinder stress equation. To verify the accuracy of the calculation, finite element (FE) analysis was performed, and the results of the calculation and FE analysis were compared. The hoop stress of the tapered surface showed a discrepancy of approximately 10, but the trends of the stress distributions of each component and the relative movement obtained by FE analysis were in good agreement with the analytical calculation results.

• Progress in Superconductivity and Cryogenics
• /
• v.20 no.2
• /
• pp.16-19
• /
• 2018

Comprehensive utilization of zinc smelting iron slag not only solves environmental problems but also creates huge economic benefits. This study was conducted on the enrichment and recovery of ${\alpha}-Fe_2O_3$ from zinc smelting iron slag by superconducting HGMS technology. Several variables such as slurry flow velocity, slag concentration, magnetic field intensity and the amount of dispersing agent were tested in magnetic separation. In the experiments, obtained optimal magnetic separation parameters were 1.60 T of magnetic flux intensity, 600 mL/min of slurry flow velocity of, 15 g/L of slag concentration of, 0.10 g/L of dispersing agent. Under this condition, the content of ${\alpha}-Fe_2O_3$ was increased from 86.22% to 94.39% that can approach the Chinese national standard requirements (A level) of iron oxide red. It was concluded that using superconducting HGMS technology was an effective method for the purification of ${\alpha}-Fe_2O_3$ from zinc smelting iron slag.

• Advances in aircraft and spacecraft science
• /
• v.5 no.3
• /
• pp.363-383
• /
• 2018

One-dimensional (1D) models of incompressible flows, can be of interest for many applications in which fast resolution times are demanded, such as fluid-structure interaction of flows in compliant pipes and hemodynamics. This work proposes a higher-order 1D theory for the flow-field analysis of incompressible, laminar, and viscous fluids in rigid pipes. This methodology is developed in the domain of the Carrera Unified Formulation (CUF), which was first employed in structural mechanics. In the framework of 1D modelling, CUF allows to express the primary variables (i.e., velocity and pressure fields in the case of incompressible flows) as arbitrary expansions of the generalized unknowns, which are functions of the 1D computational domain coordinate. As a consequence, the governing equations can be expressed in terms of fundamental nuclei, which are invariant of the theory approximation order. Several numerical examples are considered for validating this novel methodology, including simple Poiseuille flows in circular pipes and more complex velocity/pressure profiles of Stokes fluids into non-conventional computational domains. The attention is mainly focused on the use of hierarchical McLaurin polynomials as well as piece-wise nonlocal Lagrange expansions of the generalized unknowns across the pipe section. The preliminary results show the great advantages in terms of computational costs of the proposed method. Furthermore, they provide enough confidence for future extensions to more complex fluid-dynamics problems and fluid-structure interaction analysis.

• Journal of Soil and Groundwater Environment
• /
• v.22 no.4
• /
• pp.1-8
• /
• 2017

Efficient groundwater management requires accurate information about the water volume used. The pumped volume of groundwater can be indirectly estimated using empirical formulae based on electric power consumption. The purpose of this study is to test the accuracy of this indirect method. The Haean basin in Gangwon is located in a rural area, where majority of the groundwater extracted is used for irrigation. The pumped volume of groundwater indirectly estimated from electricity usage using these empirical formulae was compared with the actual pumped volume determined by conducting experiments on April 29 and May 19, 2017. The field survey collected data on electricity usage, pumped volume, and groundwater levels. Based on this measured data, correlations were calculated between electricity usage and pumping volume, as well as groundwater level and pumping rate. The results show that electricity usage and pumped volume measured for both wells (YHE1 and YHE2) are highly correlated (r=0.99, p<0.001). However, for YHE1, notably, the correlation between the groundwater level and pumping rate was not significant, and only some correlations were identified for these variables for the YHE2 test well. The average error with respect to the estimation of the actual pumped volume from the existing formula (1) and formulae (2) and (3) are +399% and -88%, respectively. To reduce these errors, these formulae need to consider other factors affecting the pumped volume.

• The Journal of Asian Finance, Economics and Business
• /
• v.8 no.3
• /
• pp.11-21
• /
• 2021

In the last few years, there is growing interest in the field of simultaneous equation estimation in finance due to the endogeneity problem caused by measurement errors, simultaneity, or omitted variables. This study aims to discuss the endogeneity problem in corporate financing decisions and investigate the interrelationship of financial decision-making such as investment decision, dividend decision, and external financing decision in Pakistan Stock Exchange (PSX) using two-stage least squares (2SLS) and generalized method of moment (GMM) estimation. The Bruech-Pagan test shows that the data has no heteroskedasticity issue and 2SLS is a better approach in the context of this study as compared to the GMM approach, and internal instruments are also sufficiently strong and valid. The three financial decision-making attributes are not jointly determined, and the dividend is influenced by one-sided investment. In the emerging stock market context, external financing and investment are not inter-related and did not affect each other. The question of whether the simultaneous equation estimation can be useful in the context of the emerging stock markets and newly-growing firms remains unanswered. The inclusive evidence shows that the theoretical link in the emerging stock market is difficult to prove like in developed stock markets.