• International Journal of Air-Conditioning and Refrigeration
• /
• v.6
• /
• pp.136-147
• /
• 1998

An experimental facility consisting of two 3$\times$4.4$\times$2.8m rooms identical in construction is built. Each room has a control system and storage tank supplying hot water to the radiant floor heating system. The facility enables simultaneous comparison of two different control strategies each implemented in a separate room. The operating performance of three kinds of flow control scheme is tested and compared in this study: (ⅰ) conventional on-off control based on feedback from room air temperature (ⅱ) TPSC(two parameter switching control )(ⅲ) TPOC(two parameter on-off control). Results show that TPSC and TPOC using room air and surface temperature sequentially as feedback signal to control hot water supply is the better temperature regulation scheme than conventional control based on feedback from only room air temperature. They are good candidates for the room with radiant floor heating system under continuous and intermittent heating mode.

• Journal of information and communication convergence engineering
• /
• v.9 no.6
• /
• pp.641-646
• /
• 2011

In this paper, we investigate a power control problem which is very critical in underlay-based spectrum sharing systems. Although an underlay-based spectrum sharing system is more efficient compared to an overlay-based spectrum sharing system in terms of spectral utilization, some practical problems obstruct its commercialization. One of them is a real-time-based power adaptation of secondary transmitters. In the underlay-based spectrum sharing system, it is essential to adapt secondary user's transmit power to interference channel states to secure primary users' communication. Thus, we propose a practical power control scheme for secondary transmitters. The feedback overhead of our proposed scheme is insignificant because it requires one-bit signaling, while the optimal power control scheme requires the perfect information of channel states. In addition, the proposed scheme is robust to feedback delay. We compare the performance of the optimal and proposed schemes in terms of primary user's outage probability and secondary user's throughput. Our simulation results show that the proposed scheme is almost optimal in terms of both primary user's outage probability and secondary user's throughput when the secondary user's transmit power is low. As the secondary user's transmit power increases, the primary user's outage probability of the proposed scheme is degraded compared with the optimal scheme while the secondary user's throughput still approaches that of the optimal scheme. If the feedback delay is considered, however, the proposed scheme approaches the optimal scheme in terms of both the primary user's outage probability and secondary user's throughput regardless of the secondary user's transmit power.

• Proceedings of the KIEE Conference
• /
• 1999.07c
• /
• pp.1094-1097
• /
• 1999

This paper presents a new PID control scheme based on the feedback of averaged derivatives to realize a noise-free differential control. The PID(Proportional, Integral and Differential) control is still one of the control methods in most wide use. In the paper, the conventional PID control adopting filtering technique is analyzed with new interpretation of filtering function. In order to overcome the drawbacks of the conventional PID control, this paper introduces the feedback of averaged derivatives in the noisy environment, and suggests a new PID control scheme using delay components to realize a noise-free differential control. The proposed PID control yields good performance much similar to the original system response in case of no noises. The proposed control scheme has been tested for the load frequency control of power systems.

• 제어로봇시스템학회:학술대회논문집
• /
• 1993.10a
• /
• pp.1199-1205
• /
• 1993

It has been well known that the assumption of full state availability is one of the most important restrictions to the practical realization of VSCS. And several attempts to alleviate the assumption had been made. However, it is not easy to find a positive scheme among them. Recently, an output feedback variable structure control system(OFVSCS) was proposed and the effectiveness of the scheme was validated for the disturbance free systems. The purpose of this study is to propose a robust OFVSCS that have the robust properties against process parameter variations and external distrubances by extending the basic OFVSCS and to evaluate its control performances through power system stabilizer design example. The ROFVSCS is composed of dynamic switching function and output feedback switching control inputs that are constructed by the use of the unknown vector modeling technique. With the proposed scheme, existence of sliding mode is guaranteed and any nonzero bias can be suppressed in the face of disturbances and process parameter variations as far as well-known matching condition is satisfied. Due to the fact that the ROFVSCS is driven by small number of measured informations, the practical application of VSCS for the systems with unmeasurable states and for high order systems that conventional schemes cannot be applied, is possible with the proposed scheme. It is noticeable that the implementation cost of VSCS can be considerably reduced without sacrifice of control performances by adopting ROFVSCS since there is no need measure the states with high measurement cost.

• 제어로봇시스템학회:학술대회논문집
• /
• 1989.10a
• /
• pp.1140-1145
• /
• 1989

A general dynamic iterative learning control scheme is proposed for a class of nonlinear systems. Relying on stabilizing high-gain feedback loop, it is possible to show the existence of Cauchy sequence of feedforward control input error with iteration numbers, which results in a uniform convergance of system state trajectory to the desired one.

• Journal of KSNVE
• /
• v.7 no.6
• /
• pp.1007-1013
• /
• 1997

This paper presents active vibration control scheme of multi-mode forced vibration using piezocetamic sensors and actuators. The control scheme adopted is the Positive Position Feedback (PPF) control. Among various vibration control techniques. PPF control technique makes use of generalized displacement measurements to accomplish the vibration suppression. Two independent controllers are implemented to control the first and the second modes of the beam under external excitation. Experimental results for various damping ratios and feedback gains of the PPF controllers are compared with respect to the contorl efficiency. The results indicate that steady state vibration under wide band excitation can be controlled effectively when multiple sets of PZT sensors and actuators were used with PPF control technique.

• 제어로봇시스템학회:학술대회논문집
• /
• 2002.10a
• /
• pp.107.6-107
• /
• 2002

$\textbullet$ An autonomous mobile robot was controlled through the Internet. $\textbullet$ For the direct control, the feedback data should be provided properly. $\textbullet$ Therefore, an efficient communication scheme should be defined. $\textbullet$ To overcome the transmission delay, the highly abstracted message format was used. $\textbullet$ As the feedback data, the real image sequences may suffer the transmission delay or loss of content. $\textbullet$ To resolve this, the feature information was used to construct the synthetic feedback information. $\textbullet$ By doing this, the operator could feel the hands-on control with an Internet-based robot.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.5
• /
• pp.852-857
• /
• 2008

A new adaptive neuro-control algorithm for a SISO strict-feedback nonlinear system is proposed. All the previous adaptive neural control algorithms for strict-feedback nonlinear systems are based on the backstepping scheme, which makes the control law and stability analysis very complicated. The main contribution of the proposed method is that it demonstrates that the state-feedback control of the strict-feedback system can be viewed as the output-feedback control problem of the system in the normal form. As a result, the proposed control algorithm is considerably simpler than the previous ones based on backstepping. Depending heavily on the universal approximation property of the neural network (NN), only one NN is employed to approximate the lumped uncertain system nonlinearity. The Lyapunov stability of the NN weights and filtered tracking error is guaranteed in the semi-global sense.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.534-534
• /
• 2000

This paper proposes a dynamic compensation scheme for input-constrained feedback linearizable nonlinear systems to cope with the windup phenomenon. Given a feedback linearizing controller for such a nonlinear system designed without considering its input constraint, an additional dynamic compensator is proposed to account for the constraint. This dynamic anti-windup is based on the minimization of a reasonable performance index, and some stability properties of the resulting closed-loop are presented.

• Proceedings of the KAIS Fall Conference
• /
• 2005.05a
• /
• pp.191-193
• /
• 2005

In this paper new, inverter control system for TG feedback a formula Control was developed. The motor control system with TG feedback controller as an effect of load disturbance, it is very difficult to guarantee the robustness of control system. The function of the implementation we TG feedback type, and temperature scheme. The Inverter Control System approach is based on master-slave control concept. To show validity of the developed new inverter control system, several experiments are illustrated.