• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2001년도 High Temperature Superconductivity Vol.XI
• /
• pp.19-19
• /
• 2001

• 한국소음진동공학회논문집
• /
• 제14권10호
• /
• pp.939-944
• /
• 2004

The numerical methods including the performance analysis and the noise prediction of the centrifugal compressor impeller are coupled with the optimization design skill, which consists of response surface method, statistical approach, and genetic algorithm. The flow-field Inside of a centrifugal compressor is obtained numerically by solving Wavier-Stokes equations. and then the propagating noise is estimated from the distributed surface pressure by using Ffowcs Williams-Hawkings formulation. The quadratic response surface model with D-optimal 3-level factorial experimental design points is constructed to optimize the impeller geometry for the advanced centrifugal compressor. The statistical analysis shows that the quadratic model exhibits a reasonable fitting quality resulting in the impeller blade design with high performance and low far-field noise level. The influences of selected design variables, objective functions, and constraints on the impeller performance and the impeller noise are also examined as a result of the optimization process.

• 한국가시화정보학회지
• /
• 제8권4호
• /
• pp.19-25
• /
• 2010

The flow field measurements were conducted on the planes between impeller blades, and the gap between the impeller and turbine blades under speed ratio of 0.4. The study showed that high velocity regions move from locations near the suction surface of the impeller to the pressure blade, shroud corner as flow progresses from the mid-chord of impeller passage to exit and out into the gap region. Planes 3 through 5 also showed flow reversal occurring in the area near the shell surface and progress far into the impeller passage from the impeller passage exit, near shell surface. This affected the converter efficiency negatively. This study would aid in the construction of higher accuracy CFD models of this complex turbomachinery device.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2014년도 추계학술대회 논문집
• /
• pp.240-242
• /
• 2014

This paper presents the system which can be predicted 3-D underwater radiated noise pattern using submarine hull velocity and can be analyzed the counter detected performance for threats in real time. To verify the developed system the tests were done in a water tank for structure like a submarine. The far field radiated noise pattern predicted using the developed system is compared with the result calculated using the near field measurement system, these results have shown good agreement.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 춘계학술대회논문집
• /
• pp.344-347
• /
• 2006

Noise reduction and control is an important problem in the performance of underwater acoustic system and on the habitability of the passenger ship for crew and passenger. Furthermore, sound generated by a propeller is critical in underwater detection and is often related to the survivability of the vessel especially for military purpose. Generally propeller noise is often the dominant noise source of marine vehicle. The flow field is analyzed with potential-based panel method, and then the time dependent pressure and sheet cavity volume data are used as the input for Ffowcs Williams-Hawkings formulation to predict the far-field acoustics. Through this study, the dominant noise source of underwater propeller is analyzed, which will provide a basis for proper noise control strategies.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1997년도 춘계학술대회논문집; 경주코오롱호텔; 22-23 May 1997
• /
• pp.594-601
• /
• 1997

Propeller fans are commonly equipped in outdoor units of air-conditioners to provide effective cooling in a dried heat exchanger. A new design technique was developed to satisfy requirements of aerodynamic and aeroacoustic performance, which employs the intersection method of two cylinders for mean camber line. Three proto-types of propeller fan including Palm-Shaped, Highly-Swept(PSHS) fan (proto 3)were not only to provide low lift forces for dipole sound, but also to reduce the organized tip vortices interacting with the fan guide causing narrow-banded rotating instabilities. Cross-correlation technique was applied to study flow noise source characteristics for three proto-type fans designed. The cross-correlations between a microphone at far field and a hot-wire sensor at near field show that flows near hub region of proto 3 fan are less organized and the flow structures especially at high flow rate coefficients for proto 3 fan are less correlated with noise generated than other proto-types fans.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1997년도 춘계학술대회논문집; 경주코오롱호텔; 22-23 May 1997
• /
• pp.636-642
• /
• 1997

Laminar vortex shedding behind a circular cylinder with and without splitter plates attached to the circular cylinder at low Reynolds numbers are simulated by solving the unsteady incompressible Navier-Strokes equations. The Strouhal number, lift and drag rapidly change with the splitter plate. Far-field noise from the vortex shedding behind the cylinder is computed using the Lighthill acoustic analogy and the Curle's solution for the Lighthill equation. The acoustic source functions are obtained from the computed near-field velocity and pressure. Numerical results show that the volume quadrupole noise is small at low Mach numbers, compared with the surface dipole noise. Also the amplitude and frequency of the acoustic density fluctuations are varied with the length of splitter plates. The scattering effects at the edge of a splitter plate are considered by using the half-plane Green's function.

• Korean Journal of Hydrosciences
• /
• 제2권
• /
• pp.39-59
• /
• 1991

Scour at bridge pier is a complicated three-dimensional problem involving interaction of fluld force on movable aid nonuniformily distributed sand grains. Although several analytical solution approaches, experimental research and field investigations for scout at piers have been conducted, no comprehensive and universally acceptable solution is so far available. Even though many methods and equations for predicting scour at piers are available in the literature, hydraulic and/or bridge design engineers are often at a loss over which method or equation is applicable for the specific bridge sites. To provide better understanding about scour phenomena and better predicting of scour at piers, intensive research is conducted through comprehensive review of published literature. Based on the research the state-of-the-art of pier scour prediction for design application is provided as a design guide for practicing engineers in this field. Recommendations for applying aggradation and degradation, contraction scour, and local scour prediction methods or equations are suggested. It is hoped that this paper may provide good information for the prediction of scour at piers.

• International Journal of Automotive Technology
• /
• 제3권2호
• /
• pp.53-56
• /
• 2002

A new generation of the BMW child seat and occupant detection system SBE2 far a smart airbag system is described. The SBE2 system consists of two subsystems: OC (Occupant Classification) and FDS (Field Detection System). The OC system is a force sensitive sensor array that measures a pressure profile. The FDS system detects child seat and occupant according to the change of electrical field generated by four capacitive plates. Combining the signals from both subsystems, the BMW SBE2 system can distinguish fully automatically between a child seat and a person.

• 천문학회보
• /
• 제36권2호
• /
• pp.85.1-85.1
• /
• 2011

The magnetic field at the surface of the Sun is concentrated in magnetic features that often have spatial extents of 100 km or less. The study of the fine scale structure of the Sun's magnetic field has been hampered by the limited spatial resolution of the available observations. This has recently changed thanks to various new high-resolution facilities, among them the SUNRISE observatory, built around the largest solar telescope to leave the ground, and containing two science instruments. SUNRISE successfully had its first long-duration science flight on a stratospheric balloon in June 2009 and a host of scientific results have been obtained from the data. After a brief introduction to the Sunrise mission, an overview of selected results obtained so far will be given. A reflight at higher solar activity is currently being prepared.