• Journal of International Academy of Physical Therapy Research
• /
• v.8 no.1
• /
• pp.1095-1099
• /
• 2017

This study used both kinesiotaping and extracorporeal shock wave therapy on patients diagnosed with frozen shoulder - a common musculoskeletal disorder in adults - in order to observe the effects on the joint range of motion. 21 adult(male 12, female 9) were selected and distributed into randomized groups. One group received kinesiotaping (n=10) and the other group received kinesiotaping together with extracorporeal shockwave therapy (n=11). After a 6 week duration of receiving kinesiotaping and extracorporeal shockwave therapy, changes in the joint range of motion in the patients were observed. Post-treatment of frozen shoulder, the changes in abduction within the shoulder joint were as follows: in both groups there was a noticeable increase in the joint range of motion (p<.05). Post-treatment of frozen shoulder, the changes in external rotation within the shoulder joint were as follows: both groups showed a significant increase in the joint range of motion (p<.05). The result of suggest that, it can be inferred that both the extracorporeal shockwave therapy and kinesiotaping are effective in increasing the joint range of motion in patients with frozen shoulder.

• Korean Journal of Computational Design and Engineering
• /
• v.19 no.4
• /
• pp.340-346
• /
• 2014

There are many factors that contribute to hit probability of the gun shot of ground combat vehicles. Aiming accuracy is mainly affected by the dynamic state of the vehicle. The stabilization error of the turret under system vibration is one of the major factors that affect the aiming accuracy. The vibration of the vehicle is affected by both the state of the road and the speed of the vehicle. This paper analyzes the aiming accuracy of the gun equipped on the GCV when the vehicle drives on the different roads and at different speed. The vertical displacement and the pitch angle of the gun are calculated and the impact points of the target are calculated. Distribution of the impact points on the target is greatly influenced by the pitch rotation rather than vertical displacement. And this aiming errors result in the errors of point of impacts on the target after the bullet flies through the air under trajectory equations. The GCV is modeled using a half-car model with 6 D.O.F. and the specifications of the M2 machine gun are used in trajectory calculation simulation and the target is located in 1000 m away from the gun.

• The Journal of Korean Academy of Orthopedic Manual Physical Therapy
• /
• v.23 no.2
• /
• pp.69-74
• /
• 2017

Background: To compare the effects of scapular stabilization exercise on the range of motion, pain, and function in the shoulders of women with breast cancer surgery. Methods: Fifteen patients were performed scapular stabilizing training using dumbbells for 30 minutes daily, five times per week for 4 weeks. The range of motion, pain, and function in the shoulder were assessed. Goniometer was used for ROM of shoulder external rotation. Shoulder pain and disability index was used for pain and function of shoulder. Comparison of the pre and post intervention was calculated by a paired t-test. Results: After 4 weeks of training, range of motion, pain and function in the shoulder improved significantly in patients with breast cancer surgery (p<.05). Conclusion: These findings indicate the more favorable effects from scapular stabilization exercise in patients with breast cancer surgery.

• ETRI Journal
• /
• v.33 no.4
• /
• pp.600-610
• /
• 2011

This paper presents a novel approach to face detection by localizing faces as the goal-specific saliencies in a scene, using the framework of selective visual attention of a human with a particular goal in mind. The proposed approach aims at achieving human-like robustness as well as efficiency in face detection under large scene variations. The key is to establish how the specific knowledge relevant to the goal interacts with the bottom-up process of external visual stimuli for saliency detection. We propose a direct incorporation of the goal-related knowledge into the specification and/or modification of the internal process of a general bottom-up saliency detection framework. More specifically, prior knowledge of the human face, such as its size, skin color, and shape, is directly set to the window size and color signature for computing the center of difference, as well as to modify the importance weight, as a means of transforming into a goal-specific saliency detection. The experimental evaluation shows that the proposed method reaches a detection rate of 93.4% with a false positive rate of 7.1%, indicating the robustness against a wide variation of scale and rotation.

• Journal of Pharmacopuncture
• /
• v.3 no.2
• /
• pp.213-232
• /
• 2000

Hemiplegic shoulder pain(HSP) is one of the most frequent and difficult problems affecting poststroke hemiplegic patients. Honeybee venom acupuncture therapy(BVAT) is known for its pain relieving effects in arthralgia. To evaluate the effectiveness of BVAT on HSP, 24 patients were sequential1y allocated into BVA T treatment group and control group and monitored for 4 weeks at time interval of initial(T0), 1 week(T1), 2 weeks(T2) and 4 weeks(T4). In treatment group, 1:10000 honeybee venom solution 0.2㎖ was injected into acupoint(s) following Deqi three times a week. Kyonu(LI15) was used in the first week. Thereafter Kyonu(LI15) and Nosu(SI10) were used. Visual analogue scale of pain severity showed significant decrease in treatment group compared to control group at T2 and T4 evaluation. Painless passive range of motion of shoulder external rotation showed significant increase in treatment group compared to control group at T4 evaluation. Fugl-Meyer Motor Assessment of upper limb motor function and Modified Ashworth scale of the spasticity of upper limb showed no difference between two groups. BVAT showed as an effective therapy in HSP and further extensive clinical studies are expected.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.24 no.1
• /
• pp.10-15
• /
• 2016

This research was conducted structural analysis in order to analyze the impact of the gear in Urea pump when the water is frozen. Subject of study, gear was designed nine models, this gear is a spur gear, located in pump. Contact conditions and rotation conditions were set the gear's condition of restriction. Given 136 MPa pressure to external gear by water was set to the applied stress. The performing result of structural analysis, maximum stress and strain are appeared between two gears. At the same diameter, strain and stress are decreased gradually thicker. Because of the little part in crevice between gears, this parts of gears could be obtained conclusion to be generated maximum stress and strain.

• Journal of Satellite, Information and Communications
• /
• v.7 no.2
• /
• pp.25-29
• /
• 2012

In this paper, we implemented LED beam forming communication system controlled by stepping motor. ATMega1284 was used as a MCU of main control board which has two main external IO, one is RS232 for connection with PC, the other is PORT for connection with motor driving board. Stepping motor rotated 360 degree when provided 160 clock and its rotation radius was increased by Archimedian Spiral. So LED can provide its light anywhere in the space and its beam forming was controlled by PC connected with RS232 of main control board. The action of beam forming was verified via actual HW/SW implementation.

• Journal of the Korean Society of Physical Medicine
• /
• v.10 no.2
• /
• pp.1-7
• /
• 2015

PURPOSE: The aims of this study were to assess the intra-tester and inter-tester reliability and validity of hip range of motion using a smart phone in hip operative patients. METHODS: Twenty-five patients (eight total hip arthroplasty and seventeen femur neck fracture) participated in this study. The range of motions in active and passive hip flexion, abduction and external rotation were measured with a goniometer and smart phone over two times by two observers. The intra-tester and inter-tester reliability were evaluated using the intraclass correlation coefficient (ICC2,1). The validity was measured by Pearson's correlation coefficient RESULTS: The intra-observer reliability was good in all measured items (ICC>0.78). The inter-observer reliability was high with ICC (>0.90). All correlation coefficients of smart phone and goniometer was greater than 0.85 and showed a significant positive correlation (p<0.01). CONCLUSION: The range of motion measurement with a smart phone showed acceptable reliability. Therefore, it could be convenient and have economical benefits to measure the range of motion of the hip joint using a smart phone.

• PNF and Movement
• /
• v.13 no.2
• /
• pp.95-102
• /
• 2015

Purpose: The purpose of this study was to analyze the effect of arm flexion patterns of proprioceptive neuromuscular facilitation on muscle activation in the contralateral lower extremity. Open kinematic chain and closed kinematic chain positions were used. Methods: This study used an electromyogram (MP150, Biopac Systems, USA) to measure muscle activation in 20 healthy male students. Comparative analysis was completed on muscle activation of the vastus lateralis, biceps femoris, tibialis anterior, and gastrocnemius of the contralateral lower extremity. Open kinematic chain and closed kinematic chain positions were used with a unilateral arm flexion-abduction-external rotation pattern. Paired t-tests using the SPSS 12.0 for Windows analyzed the data produced by the electromyogram. Results: There was a statistically significant difference in muscle activation in the biceps femoris, gastrocnemius, and tibialis anterior when the open kinematic chain and closed kinematic chain positions were compared (p < 0.05). Conclusion: The biceps femoris, gastrocnemius, and tibialis anterior muscles showed greater muscle activation in the closed kinematic chain position when compared to the open kinematic chain position.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.25 no.4
• /
• pp.153-160
• /
• 2021

The connection of the steel structure serves to transmit external forces to the main components. The same is true for the behavior of modular systems composed mainly of steel or composite members. In this study, the joint performance of the composite and steel modules proposed was evaluated. The analytical models of the two joint types were constructed and were subjected to cyclic loading to assess the safety and the energy dissipation capacity of the joint types. The analysis results of the joints showed that the joints of the modular systems remain stable when the joint rotation reached the seismic performance limit state of the 0.02 rad required for steel intermediate moment frame. It was also observed that the joint of the composite modular system showed higher energy dissipation capacity compared with the steel modular system.