• Proceedings of the Korea Concrete Institute Conference
• /
• 1997.04a
• /
• pp.265-271
• /
• 1997

Marine concrete structures have been exposed to salt from ocean environments. Chloride-penetration into marine concrete structures should accelerate the corrosion of reinforcement steel, which may severely affect the durability of them. Major concerns are to develop durable concrete for high corrosion resistance of reinforcing steel embedded in concrete. The objective of this experimental study is to investigate adequate usage of corrosion inhibitors by evaluating corrosion level in 80 specimen located in the labatory and in the site. 80 specimen of cube 20${\times}$20${\times}$11.5 and 63 specimen of slab 30${\times}$30${\times}$10 are made for this study.

• Journal of the Korean Ceramic Society
• /
• v.48 no.4
• /
• pp.328-333
• /
• 2011

The influence of Al-doped ZnO (AZO) thin films degraded under high temperature and damp heat on the performance deterioration of Cu(In,Ga)$Se_2$ (CIGS) solar cells was investigated. CIGS solar cells with AZO/CdS/CIGS/Mo structure were prepared on glass substrate and exposed to high temperature ($85^{\circ}C$) and damp heat ($85^{\circ}C$/85% RH) for 1000 h. As-prepared CIGS solar cells had 64.91% in fill factor (FF) and 12.04% in conversion efficiency. After exposed to high temperature, CIGS solar cell had 59.14% in FF and 9.78% in efficiency, while after exposed to damp heat, it had 54.00% in FF and 8.78% in efficiency. AZO thin films in the deteriorated CIGS solar cells showed increases in resistivity up to 3.1 times and 4.4 times compared to their initial resistivity after 1000 h of high temperature and damp heat exposure, respectively. These results can be explained by the decreases in carrier concentration and mobility due to diffusion or adsorption of oxygen and moisture in AZO thin films. It can be inferred that decreases in FF and conversion efficiency were caused by an increase in series resistance, which resulted from an increase in resistivity of AZO thin films degraded under high temperature and damp heat.

• Archives of Plastic Surgery
• /
• v.38 no.1
• /
• pp.89-92
• /
• 2011

Purpose: Electrical burn of scalp is uncommon. Much more, chronically exposed dura in unstable burn scar is quite exceptional. Hence, we report a case of chronically exposed dura following electrical burn. Methods: A 63-year-old man presented with an about 40 years history of an ulcerative lesion arising from electrical burn scar with 'squeeze like sensation' around wound. Wound was about $6{\times}8$ cm. Area in the center was $3{\times}3$ cm nonviable dura without sequestrum. Tangential excision with an intraoperative neurosurgical consultation and transposition flap under general anesthesia was done. Intraoperative biopsy was done. The wound was diagnosed as chronic osteomyelitis, not Marjolin ulcer. Flap was taken successfully. But after 5 days, infectious discharge had been appeared during 2 weeks, despite irrigation and drainage. As flap was re-evaluated, we could see remnant necrotic dura. After that, latissimus dorsi muscle free flap with meshed split thickness skin graft was transferred without excision of necrotic dura. Results: Flap was taken successfully. Follow-up at 10 weeks has been uneventful, with good and stable coverage of the wound. Conclusion: It is true that complete excision of devitalized tissue with sagittal sinus obliteration is prerequisite to flap taken. But necrotic dura was tangentially excised instead of total dura excision, because, posterior two-thirds of the sagittal sinus was involved underneath. Muscle is rich in blood vessels and decrease the recipient-site bacterial count effectively. In this case, muscle flap with skin graft without total dura excision is an alternative treatment.

• Journal of Environmental Health Sciences
• /
• v.24 no.2
• /
• pp.88-99
• /
• 1998

This study was undertaken to find out the bio-effects due to be a radiation fractionated exposure. The experimental animals were divided into the control group and the radiation exposure groups of 20cGy, 40cGy and 80cGy with 220 male Sprague-Dawley rats at 6 weeks old. The radiation exposure groups were fractionated exposed from each 20cGy, 40cGy and 80cGy for every 5 days. The chromosome aberrations, the frequency of SCE, the changes of body weight, hematological values and enzyme activities were investigated for the fractionating exposure times and the time after fractionated exposure. The results were summarized as follows 1. The body weight of the radiation exposure groups were significantly decreased compared with control group according to the increasing fractionated exposure times, and it was the lowest values at the immediately after the end of the fractionating exposed, but it was recovered with the level of control group at 3rd weeks gradually increased 1st week after fractionated exposure. 2. The values of WBC, RBC, Hb and Hct in the radiation exposure groups were significantly decreased than those the control group, but the values of GOT, GPT, ALP, and LDH in the radiation exposure groups were significantly increased than those of the control group. 3. The frequency of chromosomal aberration were increased according to the increasing fractionated exposure dose, and it showed the highest at 5th days after fractionated exposed. The types of chromosomal aberration were occurred such as a numerical abnormality, deletion, break and duplication, it was not recovered immediately and maintained high frequency than the control group. 4. The frequency of SCE were significantly increased according to the increasing fractionated exposure dose in 20cGy, 40cGy and 80cGy groups. But it was recovered the level of control group at 7th days after fractionated exposure. According to the above results, this study could confirm that the frequency of chromosomal aberration and SCE were increased with fractionated exposure dose, the other hand, the changes of body weight, hematological values and enzyme activity values were significantly affected according to the increasing fractionated exposure dose.

• Archives of Pharmacal Research
• /
• v.21 no.1
• /
• pp.46-53
• /
• 1998

When NIH3T3 cells were exposed to mild heat and recovered at $37^{\circ}C$ for various time intervals, they were thermotolerant and resistant to subsequent stresses including heat, oxidative stresses, and antitumor drug methotrexate which are apoptotic inducers. The induction kinetics of apoptosis by stresses were determined by DNA fragmentation and protein synthesis using $[35^S]$methionine pulse labeling. We investigated the hypothesis that thermotolerant cells were resistant to apoptotic cell death compared to control cells when both cells were exposed to various stresses inducing apoptosis. The cellular changes in thermotolerant cells were examined to determine which components are involved in this resistance. At first, the degree of resistance correlates with the extent of heat shock protein synthesis which were varied depending on the heating times at $45^{\circ}C$ and recovery times at $37^{\circ}C$after heat shock. Secondly, membrane permeability change was observed in thermotolerant cells. When cells prelabeled with $[^{3}H]$thymidine were exposed to various amounts of heat and recovered at $37^{\circ}C$ for 1/2 to 24 h, the permeability of cytosolic $[^{3}H]$thymidine in thermotolerant cells was 4 fold higher than that in control cells. Thirdly, the protein synthesis rates in thermotolerant and control cells were measured after exposing the cells to the same extent of stress. It turned out that thermotolerant cells were less damaged to same amount of stress than control cells, although the recovery rates are very similar to each other. These results demonstrate that an increase of heat shock proteins and membrane changes in thermotolerant cells may protect the cells from the stresses and increase the resistance to apoptotic cell death, even though the exact mechanism should be further studied.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2000.02a
• /
• pp.150-150
• /
• 2000

The adsorption geometry and the electronic property of Mg grown at room temperature on the Si(111)-7$\times$7 surface with various coverages have been studied by scanning tunneling microscopy (STM) and low energy electron diffraction (LEED). At low Mg coverage, the Mg atoms preferentially adsorb at the center adatom sites of the faulted half of the Si(111)-7$\times$7 surface. The adsorbed Mg atom acts as nucleophile with respect to Si atoms thus forms a stable ionic bond with the substrate Si atoms. Above 1 Ml, the 7$\times$7 surface starts to be disrupted and an amorphous Mg overlayer is formed. The LEED shows either $\delta$7$\times$7 or 1$\times$1 pattern at this coverage. When more Mg atoms were exposed, a flat and broad {{{{ { 2} over {3 } }}}}{{{{ SQRT { 3} }}}}$\times${{{{ { 2} over {3 } }}}}{{{{ SQRT { 3} }}}}R30$^{\circ}$region evolves. A flat silicide is formed at first and multi-level Mg islands having hexagonal step edges develop with increasing coverage. The scanning tunneling spectroscopy (STS) confirms the electronic properties of these Mg films on the si(111) 7$\times$7 surface at various coverages.

• Journal of Computing Science and Engineering
• /
• v.8 no.2
• /
• pp.107-118
• /
• 2014

One interesting problem regarding wireless local area network (WLAN) ad-hoc networks is the effective mitigation of hidden nodes. The WLAN standard IEEE 802.11 provides request to send/clear to send (RTS/CTS) as mitigation for the hidden node problem; however, this causes the exposed node problem. The first 802.11 standard provided only two transmission rates, 1 and 2 Mbps, and control frames, such as RTS/CTS assumed to be sent at 1 Mbps. The 802.11 standard has been enhanced several times since then and now it supports multi-rate transmission up to 65 Mbps in the currently popular 802.11n (20 MHz channel, single stream with long guard interval). As a result, the difference in transmission rates and coverages between the data frame and control frame can be very large. However adjusting the RTS/CTS transmission rate to optimize network throughput has not been well investigated. In this paper, we propose a method to decrease the number of exposed nodes by increasing the RTS transmission rate to decrease RTS coverage. Our proposed method, Asymmetric Range by Multi-Rate Control (ARMRC), can decrease or even completely eliminate exposed nodes and improve the entire network throughput. Experimental results by simulation show that the network throughput in the proposed method is higher by 20% to 50% under certain conditions, and the proposed method is found to be effective in equalizing dispersion of throughput among nodes.

• Journal of Aquaculture
• /
• v.16 no.3
• /
• pp.151-158
• /
• 2003

This study was conducted to estimate the effects of residual chlorine dioxide ($CIO_2$) in chlorinated seawater on survival and physiological responses (hematocrit: Ht, hemoglobin: Hb, serum electrolyte and glucose levels, and osmolality) of olive flounder, Paralichthys olivaceus. All the flounders were exposed for 10 min to different concentrations of residual $CIO_2$ just after chlorination for 1 min in each experimental aquarium (EA). ClO$_2$-free seawater was continuously supplied to each EA after 10 min exposure to $CIO_2$. By means of probit analysis, the median lethal times (LT$_{50}$, min) of flounder exposed to 0.43 and 0.51 ppm $CIO_2$, were at 103 and 32 min, respectively. In the range from 0.34 to 0.51 ppm $CIO_2$, the values of Ht, Hb, electrolytes and osmolality of fish exposed to $CIO_2$ were significantly elevated as elapsed time and residual concentrations of $CIO_2$ increased after chlorination. The levels of Ht, Hb, electrolytes and osmolality in flounder exposed to 0.27 ppm $CIO_2$ were not significantly different compared to control fish, which were maintained in $CIO_2$-free seawater; however, the levels of serum glucose were significantly increased with elapse times.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.5
• /
• pp.491-499
• /
• 2008

It is really urgent to develop wastewater treatment system which is economically efficient, occupies small area for buildup, can be easily operated, discharges small amount of sludge due to the more strict water quality standard, the expensive water and energy cost and so on. This study on treatment of wastewater including nonbiodegadable materials using white-rot fungus biofilm were designed to investigate the submerged type of biofilm, hydraulic retention times, recycle rates, and module turning times. Removal efficiencies of fully exposed biofilm type in atmosphere are similar to submerged biofilm of aeration type. The optimum conditions of white-rot fungus biofilm of fully exposed type in atmosphere are HRT 3$\sim$4 hr, recycle rate 6$\sim$10 Q, module turning times 0.5$\sim$2 times/min. At this time, removal efficiencies of organics were COD$_{Cr}$ 65.0$\sim$69.9%, NBDCOD 70.4$\sim$72.7%, BOD$_5$ 88.8$\sim$90.1%, SS 84.2$\sim$90.4%. Moreover average effluent concentration of BOD$_5$(8.9 mg/L) satisfied water quality standard of heavy water(BOD$_5$ less than 10 mg/L) but concentration of NBDCOD(29.6 mg/L) was higher than water quality standard of heavy water(NBDCOD less than 20 mg/L).

• Textile Coloration and Finishing
• /
• v.23 no.4
• /
• pp.241-249
• /
• 2011

Cotton fabrics was treated with persimmon juice by padding and their dyeability and functionality were assessed including antibacterial activity and deodorization ratio. The merit of padding-based dyeing was easier color reproduction over traditional hand dyeing where various colors and color fastness to light and laundering are hard to obtain. With larger number of padding, the dyed fabrics showed deeper red-yellow colors, which had low brightness and high chromatic colors. The dyed cotton fabrics had a perspiration fastness of 4~5 rating, a rubbing fastness of 3~4 rating, and a washing fastness of 4 rating, As the number of padding and exposed time to sunlight or UV light increase, the values of K/S and ${\Delta}E$ increased and the colors became much deeper gradually. The color development had completed about 70 hours exposure to UV. Among the light sources, the dyed fabrics exposed to UV light showed deeper yellow-red color than those of exposed to sunlight. The cotton fabrics treated with premordants like Al, Cr, Cu, and Sn revealed strong yellow colors, especially the fabrics treated with Fe mordant showed greenish red-yellow colors. As the padding times of dyeing with persimmon juice increased, stiffness and water repellent property were enhanced in warp and weft directions, respectively. Also, the dyed fabrics have good antibacterial activity and deodorization.