• Journal of Animal Reproduction and Biotechnology
• /
• v.38 no.1
• /
• pp.32-37
• /
• 2023

This study has evaluated the genomic estimated breeding value (GEBV) of the commercial Hanwoo population using the genomic best linear unbiased prediction (GBLUP) method and genomic information. Furthermore, it analyzed the accuracy and realized accuracy of the GEBV. 1,740 heads of the Hanwoo population which were analyzed using a single nucleotide polymorphism (SNP) Chip has selected as the test population. For carcass weight (CWT), eye muscle area (EMA), back fat thickness (BFT), and marbling score (MS), the mean GEBVs estimated using the GBLUP method were 3.819, 0.740, -0.248, and 0.041, respectively and the accuracy of each trait was 0.743, 0.728, 0.737, and 0.765, respectively. The accuracy of the breeding value was affected by heritability. The accuracy was estimated to be low in EMA with low heritability and high in MS with high heritability. Realized accuracy values of 0.522, 0.404, 0.444, and 0.539 for CWT, EMA, BFT, and MS, respectively, showing the same pattern as the accuracy value. The results of this study suggest that the breeding value of each individual can be estimated with higher accuracy by estimating the GEBV using the genomic information of 18,499 reference populations. If this method is used and applied to individual selection in a commercial Hanwoo population, more precise and economical individual selection is possible. In addition, continuous verification of the GBLUP model and establishment of a reference population suitable for commercial Hanwoo populations in Korea will enable a more accurate evaluation of individuals.

• International Journal of Highway Engineering
• /
• v.15 no.4
• /
• pp.155-165
• /
• 2013

PURPOSES : Benefits for improvement of travel time reliability obtained from construction of new highways should be considered as a major factor in the feasibility study for highway constructions. The purpose of this study is to develop a method of estimation for the value of travel time reliability. METHODS : Highway type (urban/rural highway) and traffic flow type(interrupted/uninterrupted) was considered to estimate he value of travel time reliability. And Double-bounded Dichotomous Choice among Contingent Valuation Method(CVM) was applied to survey the willingness-to-pay of drivers when travel time reliability is improved. Finally the value of travel time reliability was estimated using the results of survey and logit model. The value of travel time reliability was estimated considering travel objectives, time constraint travel and non-time constraint travel. RESULTS: The value of travel time reliability of business trip is higher than that of non-business trip. The value of travel time reliability of time constraint travel is higher than that of non-time constraint travel. The value of travel time reliability in urban area is higher than that in rural area. CONCLUSIONS: It was concluded that the proposed method in this study is more realistic and proper to estimate the value of travel time reliability because it reflects the situations of time constraint travel and non-time constraint travel.

• Journal of Advanced Marine Engineering and Technology
• /
• v.5 no.1
• /
• pp.28-33
• /
• 1981

The characteristics of typical 35 kinds of domestic anthracites among 155 kinds are studied to find the calculation formula for the required quantity of air and the combustion gas quantity. 1) The author's calculation formulae are as follows: ${A_0}={\frac{1, 000}{1, 064}}{H_1}+0.086(Nm^3/kg)$ ${G_0}={\frac{1, 000}{1, 110}}{H_1}+0.234(Nm^3/kg)$(1) Theoretically required quantity of air (2) Theoretical quantity of combustion gas 2) Theoretical quantity of air in combustion of domestic anthracite is always estimated more with Rosin's formula than author's one in the typical domestic anthracites which have the lower calorific value between 3, 000-8, 000 Kcal/kg and the difference of the calculated quantity of air becomes small, as the calorific value increases. 3) Theoretical quantity of combustion gas is estimated more by author's formula than by Rosin's one with the domestic anthracites which have more calorific value than 6, 700 Kcal/kg and is estimated less in the under range of the above calorific value. 4) Theoretical quantity of required air and quantity of combustion gas of domestic anthracite show ${\pm}$4% difference by Rosin's formulae in comparison with results of actual analysis, and about ${\pm}$1.5% by the author's one.

• Journal of Korean Academy of Nursing Administration
• /
• v.8 no.2
• /
• pp.283-293
• /
• 2002

Purpose: The purpose of this study was to define cost-countable perioperative nursing activities and to analyze the cost of each nursing activities based on the Resource-Based Relative Value Scale (RBRVS). Method: Researcher and 3 research assistants observed and documented the 83 operating patients in order to measure nursing time for each of the perioperative nursing activities. And then, 35 operating room nurses with at least one year of perioperative nursing experience were observed for the RBRVS of perioperative nursing activities. Finally, the direct and indirect nursing costs were estimated. Result: Nursing costs of 25 nursing activities were estimated using the RBRVS. Most expensive nursing activities were delivery of the instrument and implement for OP team (9,780 won per hour) and behavior of wash, pack, disinfect the instrument (6,770). Conclusion: Based on the relative values of each perioperative nursing activities estimated in this study, proper medical reimbursement system should be established in a near future.

• Journal of Environmental Health Sciences
• /
• v.16 no.2
• /
• pp.1-10
• /
• 1990

This study was performed to evaluate a applicability of TCM(Texas Climatological Model) model to a industrial area sush as CUNSAN and a possibility to provide necessary informaitons for air quality management. The air pollutants were measured at 6 sampling sites of GUNSAN industrial area from june to july in 1989. The model was checked by comparing the observed data with estimated data. The meteorological data for wind direction and wind speed were obtained from the observatory station in GUNSAN. The results are summarized as follows. 1. Average concentrations of air pollutants at all sampling sites were SO$_{2}$ 0.011-0.019 ppm. NO$_{2}$ 0.012-0.017 ppm. CO 0.6-1.0 ppm. TSP 45.8-64.2 $\mu$g/m$^{3}$. 2. The emission amounts show that point source are in general higher than area source. 3. As a results of correlation analysis, relationship between SO$_{2}$ concentration in the observed value and estimated value showed positive significance.(r = 0.766) 4. The sulfer content of the 1.6% at present to 0.8%, which means a 53.3% reduction. By controlling stack height could be lowered 14.5%, but the effective way of emission control is use of the lower sulfer fuels than controlling stack height. 5. The ratio between SO$_{2}$ contration in the observed value and estimated value showed 1.05. There-fore, the TCM model was quite effective in predicting air quality in GUNSAN industrial area.

• Proceedings of the KIEE Conference
• /
• 2006.07b
• /
• pp.783-784
• /
• 2006

In case of a difference exist between the experimental value and estimated value of back-emf, there can be a difference of turn number or residual flux density of permanent maget of the motor. In order to presume the turn number, the average length for each coil is used to calculate the resistance. However in producing the motor, doc to the tension of coil, the outer diameter of coil becomes smaller, and then the resistance estimated by average length for each coil is not correct. Therefore in this paper, through the comparison of experiment value and estimated value of inductance, a method of presuming the turn number and PM's residual flux density of an IPM motor is presented. The inductance of IPM motor changes with the rotor position, therefore the rotor part is taken out and then the inductance in open circuit condition is measured. In the analytical calculation, 3D FEM(Finite Element Method) is used, which can consider the leakage flux of end turns in frinzing effect.

• Journal of the Korean Data and Information Science Society
• /
• v.25 no.1
• /
• pp.255-261
• /
• 2014

Many studies have estimated a mixture of binomial distributions. This paper considers an extension, a mixture of shifted binomial distributions, and the estimation of the distribution. The range of each component binomial distribution is rst evaluated and then for each possible value of shifted parameters, the EM algorithm is employed to estimate those parameters. From a set of possible value of shifted parameters and corresponding estimated parameters of the distribution, the likelihood of given data is determined. The simulation results verify the performance of the proposed method.

• Asia-Pacific Journal of Business
• /
• v.11 no.2
• /
• pp.207-233
• /
• 2020

Purpose - The purpose of this paper analyzes the relationship between the Corporate Social Responsibility(CSR) and Corporate Value to estimate whether the characteristics of Firm can change this relationship. Design/methodology/approach - This paper utilizes the total 776 firms' data over the period 2014-2018, and develops a new ESG index which was estimated by PCA. Findings - First, the estimated ESG index implies that Large company has the highest value of CSR, while Medium sized and Small company have the relatively low one. And comparing to the case of 2014, the trend of ESG index in Large company does not decrease in 2018. Second, there is a clear and significant non linear relationship between CSR and corporate value, it implies that the U-shaped exists in the Korean Firms. Such a tendency is mush stronger in the Large company. Third, the new ESG index indicates that it takes more time to increase Firm value in the Medium sized and Small company while there is a high possibility of increasing value in Large company from the little gab between the threshold points and mean value of ESG. Research implications or Originality - The non linear tendency between the Corporate Social Responsibility and Corporate Value is strongly affected by Firm size and the relative high quintile of ESG, but it is less affected by Firm history.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.6
• /
• pp.784-788
• /
• 2006

Microsatellite polymorphism and the genetic relationship were estimated using genotype information of 305 horses from 11 microsatellite loci. The breeds include the indigenous Korean breeds, Korean native horse (102) and Jeju racing horse (56) together with Japan Hokkaido horse (5), Mongolian horse (19), Thoroughbred horse (108), Quarter horse (11) and Przewalskii horse (4). Allelic frequencies, the number of alleles per locus were estimated by direct counting from observed genotype, and genetic variability was computed using the CERVUX software and DISPAN. The number of alleles per locus varied from 6 (HMS6) to 18 (ASB17) with an average value of 10.45 in horse breeds. The expected total heterozygosity ($H_T$) and coefficient of gene differentiation ($G_{ST}$) ranged 0.764-0.921 (the average value was 0.830) and 0.102-0.266 (the average value was 0.180) in horse breeds, respectively. Four populations (Przewalskii horse, Japan Hokkaido horse, Quarter horse, Thoroughbred horse) showed lower heterozygosity than the average value (the average value was 0.710). The expected heterozygosity within breed ($H_S$) and mean no. of observed alleles ranged from $0.636{\pm}0.064$ (Japan Hokkaido horse) to $0.809{\pm}0.019$ (Mongolian horse), and from 2.73 (Przewalskii horse) to 8.27 (Korean native horse), respectively. The polymorphic information content (PIC) ranged from 0.490 (Przewalskii horse) to 0.761 (Mongolian horse) with an average value of 0.637 in horse breeds. The results showed three distinct clusters with high bootstrap support: the Korean native horse cluster (Korean native horse, Mongolian horse), the European cluster (Przewalskii horse, Thoroughbred horse), and other horse cluster (Jeju racing horse, Japan Hokkaido horse, and Quarter horse). A relatively high bootstrap value was observed for the Korean native horse cluster and European cluster (87%), and the Korean native horse and Mongolian horse (82%). Microsatellite polymorphism data were shown to be useful for estimating the genetic relationship between Korean native horse and other horse breeds, and also be applied for parentage testing in those horse breeds.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.1
• /
• pp.49-55
• /
• 1988

To provide a quantitative parameter of evaluating diagnosis of the liver diseases accurately, the ultrasonic attenuation coefficient was estimated from liver phantoms, 15 normal human livers and 30 liver disease patients. Two kind of phantoms(No.1: 1552m/s, No.2: 1562m/s) which have velocity (1560m/s) similar to that in human liver were constructed and their ultrasonic attenuation coefficients were determined. In this paper the spectral-shift approach and spectral-difference approach were used for estimating ultrasonic attenuation coefficient, \ulcornerdB/Cm.MHz). These two approaches were utilized to esitmate for 15 normal humans without any liver disease and 30 liver disease patients. The results indicate that the two types of phantoms produce the value of near the suggested value of 0.5 and the attenuation coefficients of hepatoma, normal liver, corrhosis, fatty liver and hepatitis show decreasing value in order named, suggesting that the present study can be of clinical value incorrelating the estimated attenuation coefficidents with the liver diseases.