• Journal of Environmental Health Sciences
• /
• v.33 no.4
• /
• pp.242-249
• /
• 2007

Indoor air quality has become a topic of interest and concern. Especially changes in construction design and the increased use of synthetic products may result in an increasing of complaints and health effects about the quality of indoor air at home. In this study, nitrogen dioxide($NO_2$) and volatile organic compounds(VOCs) within new and established apartments on the basis of 4 years of building year were measured every 3 days consecutively during 60 days. We selected each 10 house in Seoul, Asan and Daegu, respectively, and produced risk numbers for hazard quotients, and predicted increases in incidence of cancer. The calculations were made for the adult with default exposure values and also made for a worst case scenario using Monte-Carlo simulation as describing the reasonable exposure(RME). Mean of Monte carlo analysis by benzene, in the construction under 4 years (male: $9.2{\times}10^{-5}$, female: $1.0{\times}10^{-4}$) and over 4 years (male: $6.8{\times}10^{-5}$, female: $8.3{\times}10^{-5}$) exceeded $10^{-6}$ of permitted standards in US EPA, RME of Monte carlo analysis. In construction under 4 yews (male: $9.9{\times}10^{-3}$, female: $9.6{\times}10^{-3}$) and over 4 years (male: $9.8{\times}10^{-3}$, female: $7.8{\times}10^{-3}$) exceeded $10^{-4}$ of maximum permitted standards in US EPA. The hazard index of non-carcinogenic pollutants by nitrogen dioxide, toluene, m,p-xylene and o-xylene, both male and female in apartment constructed under 4 yews and over 4 years was found less than the permitted standards of hazardous health effects in CTE. Significant cancer risks and non-cancer hazard quotients were predicted in under 4 yews of building year.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.7
• /
• pp.682-689
• /
• 2010

The purpose of this study was to determine any detrimental effects on surrounding environments by using bottom ash, waste tire, and mixture as a fill material to raise the ground level. Three different initial pHs (4, 6, 8) were applied to bottom ash and initial pH of 4 was used to waste tire and mixture. Among 7 heavy metals, Pb and Zn were exceeded drinking water standards but their concentrations decreased below drinking water standards within 1 PVE. Among 5 anions, sulfate exceeded 10 times of drinking water standards and further higher partition coefficients resulted in increased PVE of 8.21. For the mixture of bottom ash and waste tire, its concentrations of heavy metals and anions were decreased due to the dilution effect and lowered PVE from 8.21 (BA) to 5.89.

• Environmental Analysis Health and Toxicology
• /
• v.27
• /
• pp.8.1-8.10
• /
• 2012

Objectives: The goal was to model and quantify the atmospheric concentrations of volatile organic compounds (VOCs) as the result of the Hebei Spirit oil spill, and to predict whether the exposure levels were abnormally high or not. Methods: We developed a model for calculating the airborne concentration of VOCs that are produced in an oil spill accident. The model was applied to a practical situation, namely the Hebei Spirit oil spill. The accuracy of the model was verified by comparing the results with previous observation data. The concentrations were compared with the currently used air quality standards. Results: Evaporation was found to be 10- to 1,000-fold higher than the emissions produced from a surrounding industrial complex. The modeled concentrations for benzene failed to meet current labor environmental standards, and the concentration of benzene, toluene, orthometa- para-xylene were higher than the values specified by air quality standards and guideline values on the ocean. The concentrations of total VOCs were much higher than indoor environmental criteria for the entire Taean area for a few days. Conclusions: The extent of airborne exposure was clearly not the same as that for normal conditions.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.1D
• /
• pp.37-44
• /
• 2010

The present annexed parking lot standards for buildings in Parking Act are categorized in 9 groups with 13 parking standards in terms of recreation, culture and assembly, housing, factory, warehouse, and so on, in which same grouped facilities have same parking standards. These days diversity in building types and functions need more fractionated parking standards; however, most local governments focusing merely on applying strengthened parking standards in general without systematic rules of consistency. The current problem of parking standards being used is lack of regarding facility characteristics; expecially, a large sized high-tech manufacturing facility located in industrial site is still applied by same parking standards as normal manufacturing facility, even though most part of manufacturing process is automated and hence less manpower is employed. This paper presents a parking generation forecasting model for factory facilities in industrial site in terms of facility use and scale characteristics.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.34 no.2
• /
• pp.148-155
• /
• 2024

Objectives: Among the regulations that have recently attracted a lot of social attention in Regulation on Occupational Safety and Health Standards, we would like to specifically present the reasons why even companies with strong will to comply with regulations that are not effective or entail a number of legal problems, and suggest ways to improve them. Methods: The facts were confirmed and identified through various methods such as interviews and meetings with labor inspectors who enforce the Regulation on Occupational Safety and Health Standards and safety officials at industrial sites experiencing them. Results: Due to the lack of effectiveness in Regulation on Occupational Safety and Health Standards, there are not a few areas that do not function properly as a preventive standard. Although operating the regulatory nature of punishment as an administrative guideline without basing it on Regulation on Occupational Safety and Health Standards is a direct violation of the principles of the administration of the rule of law, there are many expedient ways to replace what should be placed in this rule as just an administrative guideline. Conclusions: It should be prioritized to explicitly stipulate effective regulations within the Regulation on Occupational Safety and Health Standards. In addition, as regulations on occupational safety and health standards play a large part in preventing industrial accidents, comprehensive and practical measures are indispensable rather than fragmented and formal measures to ensure that these rules function properly in the prevention industrial accidents.

• Journal of the Korea Institute of Building Construction
• /
• v.1 no.2
• /
• pp.146-153
• /
• 2001

Radical development has been made in the every field of our society for the past scores of year. Radical development of industry and lining environment has mass-produced various toxic wastes . Which comes to the fore as a serious environmental problem. The purpose of this is to suggest the optima mix design by studying the utility of a toxic waste, plated sludge as a building material and deciding the standards of quality and use of cement and evaluating the properties of mortar and concrete in which plated sludge mixed. From an experiment, compressive strength required high early strength cement or special cement. Watertightness proved to be excellent. Heavy metals, such as Cd, Pb, Cu came out below an environmental standard. Cr+6 exceeded an environmental standard under a steam curing, but came out below an environmental under a standard curing. The higher replacement rate was, the lower frost, fusion and resistance were. Thus, got better results above the goal by condition. It was possible that plated sludge was replaced and solidified to aggregate. Therefore, it is necessary to define the standards of quality on strength, replacement rate of wastes, water permeability, endurance in other to solidify plated sludge to concrete products.

• Journal of Environmental Impact Assessment
• /
• v.17 no.6
• /
• pp.321-333
• /
• 2008

Considering risks and artificial enrichments of metals in the soils of the study area, the study aims to analyze geology, grain size and geochemistry. Geology is mainly composed of gneisses and phyllites of metamorphic rocks, sandstones, siltstones, shales, tuffs of sedimentary ones and granites and andesites of igneous ones in the area. In the area, mean contents of metals are not meaningful in accordance with petrogenesis. The soil textures of the area are of S, lS and sL of sandy soil, L, scL, cL of loam and C, zC and sC of clayey soil. Mean contents of Ni, Cr, Co and Cu are meaningfully high in loam and clayey soil relative to sandy soil, whereas Ni, Zn, Cd contents are higher in clayey soil than in loam. Those differences imply the metallic contents are dependent to grain size. Based on the metal contents in the soils of the study area, Cu and Zn in loams and Pb in sandy soils are corresponded to soil contamination warning standards, and As showing 75mg/kg of maximum content in loams is assigned to soil contamination countermeasure standards, respectively. Artificial enrichment factor minimized wall rock and grain size relations is over 1 in Cr, Ni and Cu, but the factor is below 1 in average of other metals.

• Journal of Environmental Science International
• /
• v.15 no.7
• /
• pp.659-667
• /
• 2006

This research aims at applicability of adsorption process in order to satisfy the restricted Effluent Quality Standards for dyeing wastewater. The dyeing wastewater treated by biological process with carrier imbedded microorganisms was directly applied to the activated carbon adsorption in Process A, The dyeing wastewater treated by Fenton oxidation for the effluent of biological process was applied to the adsorption in Process B. It was found that the optimum conditions of adsorption with granular activated carbon are $20^{\circ}C$ and 120 minutes for the batch experiment. Langmuir equation was fitted better than Freundlich equation to the experimental data. The breakthrough time of adsorption column was determined by color rather than $COD_{Mn}$ for both Process A and Process B. The results revealed that the breakthrough time of adsorption for two processes was extended by the treatment of Fenton oxidation for dyeing wastewater treated by biological treatment than the direct application of dyeing wastewater treated by the biological treatment. Adsorption process can be applied in order to meet the restricted Effluent Quality Standards for dyeing wastewater.

• World Technopolis Review
• /
• v.3 no.3
• /
• pp.139-152
• /
• 2014

The current transportation regime is largely based on two alternatives: (1) fixed route public transit, and (2) private ownership of internal combustion engine (ICE) powered vehicles per households. This paper analyzes one possible transportation alternative, Micro Electric Vehicles or MEVs, and compares with the ICE vehicles in terms of social, economic and environmental benefits, especially emphasizing its environmental advantage over ICE vehicles for future sustainability. While some representative models of MEVs exist in a limited market capacity, but global technical standards are generally insufficient and non-homogenous across nations, which restricts the development of the proposed transportation sector. The focus of this paper is to analyze the characteristics and potential benefits of MEVs in economical and environmental perspectives, including development status and technical standards, with a particular focus in the E.U., the U.S., Japan, and Korea. Based on the data of analysis, this paper aims to derive and propose a cooperative and adaptive global policy framework designed to speed up adoption and expansion of the global MEV market, including passenger and utility vehicles. We propose MEV to be a new mobility segment in the global transportation market because of their advantage in environmental impact, sustainability, overall cost of ownership, and safety.

• Korean Journal of Environmental Agriculture
• /
• v.14 no.3
• /
• pp.351-373
• /
• 1995

The objective of this paper is to present relevant information and data from domestic and foreign references and to propose legal standards on pesticide residues in order to mitigate the pesticide contamination in the water environment. Among 200 pesticide ingredients in use in Korea, items necessary for standard setting were selected and theoretical residue limits were computed. The results are summarized as follows. In advanced countries, drinking water standards are established on the basis of health index ADI and water intake, whereas standards for surface water are established temporarily on the basis of different parameters, inconsistent with different countries. Pesticide residue limits applicable in Korea were proposed for 24 pesticides in drinking water(health basis) and for 25 pesticides in surface water(ecotoxicological basis), as selected by risk priority. It was recommended to accumulate scientific data by persistent research efforts in order to maintain the justification of the pesticide residue limits in water and relevant research topics to be undertaken in future were proposed.