• 펄프종이기술
• /
• 제38권5호
• /
• pp.16-23
• /
• 2006

• 한국환경과학회:학술대회논문집
• /
• 한국환경과학회 2019년도 정기학술대회 발표논문집
• /
• pp.54-54
• /
• 2019

• 대한환경공학회지
• /
• 제22권3호
• /
• pp.535-546
• /
• 2000

주암호는 광주 전남지역의 주민생활이나 공 농업활동에 기반이 되는 중요한 수자원의 역할을 하고 있으나, 주암호에 유입되는 오염물질로 말미암아 호수의 수질은 점점 악화되고 있는 실정이다. 주암호의 수질개선대책을 수립하기 위한 예비단계로서 호수의 수질모델링을 실시하여 수질이 장래에 어떻게 변화될 것인지를 확인할 필요성이 있다. 수질모델링 작업에 이용할 수 있는 컴퓨터 프로그램은 여러 종류가 있으나, 각 프로그램에서 요구하는 오염물질 유입량, 수리 수문 등의 압력자료(Input data)는 불확실성을 포함하고 있으며, 이러한 불확실성은 예측결과(장래수질)의 불확실성을 초래하게 된다. 수질모델링에서 불확실성이 발생하는 주요원인은 활용할 수 있는 정보의 부족, 미래상황 및 예측모델의 불확실, 그리고 전문가 지식의 한계 때문이다. 따라서 본 연구의 목적은 퍼지이론을 응용하여 수질예측 모델에서 요구하는 입력자료들의 불확실성 정도를 해석하고, 이를 수질예측 모델에 그대로 결합시킬 수 있는 방법을 개발하는 것이다. 이러한 방법의 적용은 불확실성을 고려하지 않는 방법들에 비해 합리적이고 현실성 있는 주암호의 장래수질을 예측하는데 도움이 될 것이다.

• 한국정밀공학회지
• /
• 제23권6호
• /
• pp.72-80
• /
• 2006

Electric Power Steering (EPS) mechanism has become widely equipped in passenger vehicle due to the increasing environmental concerns and higher fuel efficiency. This paper describes the development of concurrent simulation technique and simulation integration technique of EPS control system with a dynamic vehicle system. A full vehicle model interacting with EPS control algorithm was concurrently simulated on a single bump road condition. The dynamic responses of vehicle chassis and steering system resulting from road surface impact were evaluated and compared with proving ground experimental data. The comparisons show reasonable agreement on tie-rod load, rack displacement, steering wheel torque and tire center acceleration. This concurrent simulation capability was employed fur EPS performance evaluation and calibration as well as for vehicle handling performance integration and synthesis.

• 한국군사과학기술학회지
• /
• 제7권2호
• /
• pp.32-40
• /
• 2004

In this paper, a simulation model for FLAS(Fixed Linear Arrays System) is presented and methods for effectiveness analysis are studied to analyze the valid target detection effectiveness of this system. The simulation model is constructed taking the FLAS operational specification into account, and thus the change in system specification is effectively reflected on the simulation results. The computational burden is reduced by using the pre-processed simulation parameters which are calculated from the real environmental database. Also, the cell effectiveness and TMOE(Total Measurement of Effectiveness) are computed. The target detection effectiveness of FLAS can be simulated under the multiple target interference simulation. It is shown that the presented algorithm is suitable for the underwater system which needs the simulation model for the optimum system design.

• Computers and Concrete
• /
• 제24권6호
• /
• pp.571-578
• /
• 2019

This study aimed to investigate the permeable nature of pervious concretes (PC) through the moving particle simulation (MPS) method. In the simulation, the complex structure of a pervious concrete was virtually demonstrated as a lattice model (LM) of spherical beads, where the test of permeability was conducted. Results of the simulation were compared with the experimental ones for validation. As a result, MPS results showed the permeability index of the LM as almost twice as big as the actual PCs. A proposed virtual model was created to prevent the stuck of water flow in the MPS simulation of PC or LM. Successful simulation results were demonstrated with the model.

• 한국환경과학회지
• /
• 제16권8호
• /
• pp.959-971
• /
• 2007

The three-dimensional eco-hydrodynamic model was applied to estimate the autochthonous COD caused by production of phytoplankton in Jinhae Bay. A residual current was simulated, using a hydrodynamic model, to have a sightly complicated pattern in the inner part of the bay, ranging from 0.001 to 5 cm/s. In the outer part of the bay, the simulated current flowed out to the south sea with a southward flow at a maximum of 25 cm/s. The results of the ecological model simulation of COD levels showed high concentrations, exceeding 4 mg/L, in the inner bay of Masan, an area of wastewater discharge, and lower levels, approaching less than 1 mg/L, closer to the outer part of the bay. The simulation results of Autochthonous COD by two methods using ecological modeling, showed high ratio over 70% of total COD. Therefore, it is more important to consider nutrients than organic matters in the region for control COD standard.

• 한국환경과학회지
• /
• 제19권7호
• /
• pp.829-841
• /
• 2010

The estimation of a biogenic volatile organic compound (BVOC, especially isoprene) and the influence of isoprene emissions on ozone concentrations in the Greater Busan Area (GBA) were carried out based on a numerical modeling approach during a high ozone episode. The BVOC emissions were estimated using a biogenic emission information system (BEIS v3.14) with vegetation data provided by the forest geographical information system (FGIS), land use data provided by the environmental geographical information system (EGIS), and meteorological data simulated by the MM5. Ozone simulation was performed by two sets of simulation scenarios: (1) without (CASE1) and (2) with isoprene emissions (CASE2). The isoprene emission (82 ton $day^{-1}$) in the GBA was estimated to be the most dominant BVOC followed by methanol (56) and carbon monoxide (28). Largest impacts of isoprene emissions on the ozone concentrations (CASE2-CASE1) were predicted to be about 4 ppb in inland locations where a high isoprene was emitted and to be about 2 ppb in the downwind and/or convergence regions of wind due to both the photochemical reaction of ozone precursors (e.g., high isoprene emissions) and meteorological conditions (e.g., local transport).

• 대한환경공학회지
• /
• 제30권11호
• /
• pp.1123-1131
• /
• 2008

본 연구는 대기 중 PM2.5의 미량금속 중 As을 중성자방사화분석법을 이용하여 분석할 때 발생되는 측정불확도를 ISO GUM 방법과 MCS 방법을 모두 적용하여 비교, 평가하였다. 불확도의 요인은 ISO GUM을 엄격하게 준용하여 파악하였으며 특정일에 채취된 PM2.5 내 As 농도에 대해 두 방법의 계산 결과가 4% 미만으로 크게 다르지 않는 것으로 나타났다. 연구기간 중 채취된 총 60개의 PM2.5 시료에 대해 As 농도의 확장불확도를 역시 MCS 방법을 이용하여 산출하였는데, 연구지역에서의 As의 개별 농도값에 대한 95% 신뢰구간의 확장불확도는 대부분 10%의 범위에서 존재하는 것으로 나타났다. 확장불확도에 대한 표준불확도 요인의 기여율은 계측통계오차(62.3%), 검출효율(18.5%), 시료 채취 시 유량(12.3%), flux 변동(2.3%), 특정감마선 방출률(1.8%) 등의 순으로 크게 나타났다.

• 한국물환경학회지
• /
• 제25권5호
• /
• pp.792-802
• /
• 2009

The objective of this study is to construct the watershed management system with link of the non-point sources model and to estimate delivery ratio duration curves for various pollutants. For the total water pollution load management system, non-point source model should be performed with the study of the characteristic about non-point sources and loadings of non-point source and the allotment of pollutant in each area. In this study, daily flow rates and delivered pollutant loads of Nakdong river basin are simulated with modified TANK model and minimum variance unbiased estimator and SWAT model. Based on the simulation results, flow duration curves, load duration curves, and delivery ratio duration curves have been established. Then GIS analysis is performed to obtain several hydrological geomorphic characteristics such as watershed area, stream length, watershed slope and runoff curve number. As a result, the SWAT simulation results show good agreements in terms of discharge, BOD, TN, TP but for more exact simulation should be kept studying about variables and parameters which are needed for simulation. And as a result of the characteristic discharges, pollutants loading with the runoff and delivery ratios, non-point sources effects were higher than point sources effects in the small-scale test bed of Nakdong river basin.