• Journal of the Korean Institute of Gas
• /
• v.20 no.5
• /
• pp.89-95
• /
• 2016

Keeping the gas pipelines in the common utility tunnel is useful because it has a lower risk of corrosion than conventional burial, and can prevent from excavating construction. But, explosions in common utility tunnels can cause greater damage from the blast overpressure compared to outdoor explosions, due to nature of the confined environment. Despite this fact, however, research on common utility tunnels has been limited to fire hazard and little has been studied on the dangers of explosions. This study developed scenarios of methane gas explosion caused by gas leak from gas piping within the common utility tunnel followed by unknown ignition; the study then calculated the extent of the impact of the explosion on the facilities above, and suggested the needs for designing additional safety measures. Two scenarios were selected per operating condition of safety devices and the consequence analysis was carried out with FLACS, one of the CFD tools for explosion simulation. The overpressures for all scenarios are substantial enough to completely destroy most of the buildings. In addition, we have provided additional measures to secure safety especially reducing incident frequency.

• Journal of the Korean Society for Railway
• /
• v.19 no.6
• /
• pp.765-776
• /
• 2016

In this study, a standard section of a railway bridge abutment wall was designed to satisfy the external stability condition in accordance with the design criteria; this design was used to compare and analyze the active earth pressure and to calculate various types of earth pressure acting on the virtual back (wall, plane) according to the frictional angle of the backfill materials. Also, the external stability, member force and construction cost were analyzed according to the frictional angle of the backfill materials using various theories of earth pressure such as Rankine, Coulomb, Trial Wedge, and Improved Trial Wedge. As for the results, it was found that lateral earth pressure at the virtual back plane was higher than at the virtual back wall, and that these values decreased with the increase of the frictional angle of the backfill materials. The increasing of the frictional angle of the backfill materials decreased the active earth pressure (according to Rankine, Coulomb, Trial Wedge, and Improved Trial Wedge results), and the member force as well as the construction cost were reduced.

• Environmental Engineering Research
• /
• v.23 no.1
• /
• pp.28-35
• /
• 2018

$17{\alpha}-ethinylestradiol$ (EE2), a synthetic estrogen which interfere the endocrine and reproductive function in living organisms, has been found extensively to be deposited into municipal wastewater treatment plants and the environment via human excretion. EE2 has long been known to be efficiently cometabolized by ammonia-oxidizing bacteria (AOB) during ammonia ($NH_3$) oxidation. Current study aims to investigate the effect of culture history on the biotransformation of EE2 by nitrifying sludge which was enriched under different ammonia loading rates in continuous flow reactors. Result showed that past growth condition largely affected not only the metabolic rate of $NH_3$ oxidation but also EE2 cometabolism. Sludge previously acclimated with higher $NH_3$ loads as well as sludge dominated with AOB belong to high growth cluster (Nitrosomonas europaea-Nitrosococcus mobilis) showed higher rate of EE2 biotransformation than those one being acclimated with lower $NH_3$ loads because of its ability to provide more reducing power from $NH_3$ oxidation. Moreover, the correlation between the degradation rates of $NH_3$ and EE2 was higher in sludge being acclimated with higher load of $NH_3$ in comparison with other sludge. Implication of the findings emphasized the role of volumetric $NH_3$ loading rate in determining EE2 removal in wastewater treatment system.

• Journal of the Korean Society of Systems Engineering
• /
• v.14 no.1
• /
• pp.72-82
• /
• 2018

Generally speaking, because of complexity of engineering process, the systems engineering may be not easy to understand clearly and not easy to perform also. The status of systems engineering infrastructure of the some Korean industry is not matured yet, i.e., the systems engineering process, method, tool and environment is not implemented consistently within the steel making industry. These difficulties are more severe at the concept and basic design phase than the detail design phase relatively. Korean industry has lots of development project for the precedented systems and usually has matured domain knowledge for the precedented systems. Even though there is a mature domain knowledge of the precedented systems, the development project will lead to failure under the condition of engineering system is not well equipped. For the project success, it is very important to have a proper engineering execution system especially for the concept design and basic phase, which has a high abstraction and a large influence on the whole project. This paper proposes a minimized design process that can be easily applied to the concept and basic design phase of the precedented systems, instead of complex system engineering processes. This paper also proposes the application case of the minimized design process and methods for a Blast Furnace System.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.11 no.3
• /
• pp.121-130
• /
• 2016

Amidst a competitive environment, success and innovation of a company hinge on establishment of competitive strategies through CEO's capabilities for discovering new businesses. In other words, several alternatives that are being considered as new businesses and the ensuing selection that a top management makes lead to a company's success and innovation. Examples of this are numerous among global corporations as well as Korean small and medium-sized enterprises (SMEs). This research has analyzed the role of a CEO to be a condition for success in the growth and innovation of a company. Starting from the topic of entrepreneurship, the research on the role of a CEO has been actively conducted in context with the latest innovations. A prime example involves research related to the innovativeness of a CEO. In this regard, this research was an empirical analysis on the impact that a CEO's ability to discover new business opportunities and competitive strategies has on the performance of a firm. This analysis was conducted based on nationwide data of 286 large conglomerates and smaller-sized companies alike. Based on the analysis, "experimenting" and "association", among abilities of discovery, have been found to strengthen competitive strategies. Also in the context of abilities needed for discovery, differentiation strategy has a greater effect on a firm's performance than the cost leadership strategy. Furthermore, the mediating effect of competitive strategies was prominently displayed in experimenting and corporate performance.

• Journal of the Korea Convergence Society
• /
• v.7 no.4
• /
• pp.9-17
• /
• 2016

This study is to analyze korea credit card market and the China credit card market, and predict future economic activity by developing the Algorithm for future economic trend Estimation As a results, there is no significant correlation between personal income growth and the credit card usage amount, and significant correlation between the credit card per capita and the credit card usage amount, in korea. there is significant correlation between personal income growth and the credit card usage amount, and between the credit card per capita and the credit card usage amount in china. it could be predicted that the china credit card market would be increased and the rate of increase would be gradually increased over the next five years, under the condition without constraints in the external environment.

• Membrane and Water Treatment
• /
• v.11 no.3
• /
• pp.207-215
• /
• 2020

Vivianite (Fe₃²⁺(PO₄)2·8H₂O) and green rust ([Fe₄²⁺Fe₂³⁺(OH)^-₁₂][SO₄^2-·2H₂O]^2-), ferrous containing minerals, could remove aqueous U(VI) in 5 min. and the efficiencies of green rust were roughly 2 times higher than that of vivianite. The zeta potential measurement results implies that the better performance of green rust might be attributed to the favorable surface charge toward uranyl phosphate species. The removal behaviors of the minerals were well fitted by pseudo-second order kinetic model (R² > 0.990) indicating the dominant removal process was chemical adsorption. Effects of Ca²⁺ and CO₃^2- at pH 7 were examined in terms of removal kinetic and capacity. The kinetic constants of aqueous U(VI) were 8 and 13 times lower (0.492 × 10^-3 g/(mg·min); 0.305 × 10^-3 g/(mg·min)) compared to the value in the absence of the ions. The thermodynamic equilibrium calculation showed that the stable uranyl species (uranyl tri-carbonate) were newly formed at the condition. Surface investigation on the reacted mineral with uranyl phosphates species were carried out by XPS. Ferrous iron and U(VI) on the green rust surface were completely oxidized and reduced into Fe(III) and U(IV) after 7 d. It suggests that the ferrous minerals can retard U(VI) migration in phosphate-rich groundwater through the adsorption and subsequent reduction processes.

• Journal of the Society of Disaster Information
• /
• v.16 no.2
• /
• pp.291-298
• /
• 2020

Purpose: The purpose of this study is to suggest a smart city strategy through smart growth considering the human, social and cultural meaning. It seeks opportunities to develop the cities that has not grown by integrating the ICT, a new growth tool for smart cities, into the spatial and physical renewal project. Method: Analyzing policy and strategy of smart living lab and digital cultural contents on the smart growth process under the experience in Amsterdam and Paris. Results: Smart city is expected to be reflected not only the technical aspects but the social characteristics of the city in order to enhance the living environment of the citizens by embracing diverse viewpoints throughout the city. It examines the smart growth plan in the improvement of the living conditions of the citizens. Conclusion: Planning smart city is to discover the smart city adaptability that can enhance the capability of cities to improve the life condition and quality of citizens by applying the core strategies and specialized programs with community service and urban marketing, which are emerging as smart cities based on ICT technologies.

• KIEAE Journal
• /
• v.15 no.6
• /
• pp.27-36
• /
• 2015

Purpose: The definition and factors of passive design being the sustainable method of building plan through the preceding research is deducted and the effect of passive design within the public library by applying the deducted factors in the case of built public libraries and further the realization plan of green library aimed to be reviewed in this research. Method: This study is to induce common elements of architecture plan for public library and passive design, and assess application level of re-classified elements of sustainable public library in order to analyze present condition of passive design applied on facilities of public library. First, related laws and planning standards of public library will be reviewed, then the definition of passive design will be considered using advanced research. Through advanced research related to planing elements and passive design for library induced from various plans for library standards, a common ground of induced passive design element will be transformed into assessment items and practices to be analyzed. Result: Libraries which are and are not preliminarily certified by G-SEED will be compared with each other in order to analyze the effects of passive design on G-SEED. Even though various passive elements such as load reduction of air conditioning and energy efficiency exist, there are no assessment tool within G-SEED. The fact that there are only standards for temporary methods such as utilization of construction material and installation of equipment highlights the challenges in quantitative evaluation.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.4
• /
• pp.18-29
• /
• 2015

The purposes of this research and development are as follows: first, to provide pleasant driving environments inside tunnels; second, to improve the current illumination environments lacking in diffusion luminance meters to meet tunnel lighting standards; and, third, to reduce the consumption of tunnel lighting energy accounting for approximately 65% of tunnel maintenance costs because of inadequate visual environments and tunnel operations. Further details are listed below. Firstly, an image luminance meter for tunnels that can implement the L20-method which is a tunnel luminance method that follows the international standards of CIE88, which was developed in order to improve and change the existing illumination-based tunnel lighting operation system to a luminance-based system. (The margin of error of below 5% according to the results of a test by an authorized agency and field test). Secondly, early illumination control is possible since the lighting control system that can be operated based on luminance enables interlocking control of the inside and outside of a tunnel using ethernet communication. Thirdly, guidelines for field application of the system are proposed. In addition, the luminance inducers of tunnels are found and the reflexibility of each facility that may reduce luminance of the boundaries is also proposed. Fourthly, as a result of a test bed, power consumption of luminance-based lighting operations decreased by 15.6% compared to illumination-based operations. Applying the feedback controls and maintenance factors of internal/external luminance meters, it reduced by 36.4%. Therefore, we became able to provide a luminance-based lighting operation system that complies with tunnel lighting design standards and provides a visual environment for drivers.