• Journal of Bio-Environment Control
• /
• v.20 no.1
• /
• pp.40-44
• /
• 2011

This study was conducted to develop method of producing okra in the plastic house and the 11 cultivar of okra were planted in plastic house for selecting proper cultivar in Korea. As result of observing growth, commercial cultivar germinated better than wild collected. The germination rate in 'No 1', 'No 4' and 'No 5' were better than in 'No 2' and 'No 3'. The plant height of 'No. 4', which is one of wild collected, showed biggest plant height moreover 'Greensode'. The numbers of node, which could indicate to set fruit, showed 4.2~6.5 per plant in most cultivar and 'No 2' and 'No 5' could yield more than others. 'Greensode' was planted in plastic house for finding out suitable planting method. The seeds were soaked could germinate 100% and those were taken 8 days for germinating but control seeds needed 15 days to germinate. The yield of 'Greensode' which was planted in $45{\times}75cm$ with planted 3 and 4 per hill could best produce in plastic house.

• Journal of Bio-Environment Control
• /
• v.20 no.2
• /
• pp.72-77
• /
• 2011

The objective of the present study is to provide the basic data necessary for estimating the overall heat transfer coefficient of commercial plastic greenhouse. The heat flow through covering of greenhouses was measured and the variation of overall heat transfer coefficient was analyzed. Because the inside-outside temperature difference of greenhouse to indicate the stabilized overall heat transfer coefficient was different depending on the number of covering layers, the actual overall heat transfer coefficient should be decided in range of inside-outside temperature difference to make the coefficient constant for each covering method. The variation trend of the overall heat transfer coefficient according to the inside-outside temperature difference corresponded with the existing research results, but the specific values of temperature difference to present the stabilized overall heat transfer coefficient were different each other. The increase rates of overall heat transfer coefficient with wind speed were quite dissimilar among several research results and the quantity of heat loss through covering according to the wind speed in the double layers covered or curtained greenhouse was less than that in the single layer covered greenhouse. Because there was large variations among the values of overall heat transfer coefficient for the polyethylene film greenhouses, it was required to establish the standardized environmental condition for experiment measuring heat flow through covering in commercial greenhouse.

• Journal of Bio-Environment Control
• /
• v.20 no.2
• /
• pp.63-71
• /
• 2011

Pattern recognition of a cucumber were conducted to detect directly the binary images by using thresholding method, which have the threshold level at the optimum intensity value. By restricting conditions of learning pattern, output patterns could be extracted from the same and similar input patterns by the algorithm. The algorithm of pattern recognition was developed to determine the position of the cucumber from a real image within working condition. The algorithm, designed and developed for this project, learned two, three or four learning pattern, and each learning pattern applied it to twenty sample patterns. The restored success rate of output pattern to sample pattern form two, three or four learning pattern was 65.0%, 45.0%, 12.5% respectively. The more number of learning pattern had, the more number of different out pattern detected when it was conversed. Detection of feature pattern of cucumber was processed by using auto scanning with real image of 30 by 30 pixel. The computing times required to execute the processing time of cucumber recognition took 0.5 to 1 second. Also, five real images tested, false pattern to the learning pattern is found that it has an elimination rate which is range from 96 to 98%. Some output patterns was recognized as a cucumber by the algorithm with the conditions. the rate of false recognition was range from 0.1 to 4.2%.

• Journal of Bio-Environment Control
• /
• v.17 no.1
• /
• pp.20-25
• /
• 2008

This study was conducted to develop the industrial producing technology of sprout vegetables using the cut twigs of woody plants. We have cut the twigs of wild mulberry tree on 13 April,2006 to examine the sprouting rate as affected by the storage conditions on relative humidity of $40{\sim}50%$ and $80{\sim}90%$ under $4{\sim}6^{\circ}C$ temperature. And we have also investigated the sprouting growth following those storage period of twigs cut with $1{\sim}3$ buds. The longer storage periods, the less survival rate of wild mulberry twigs cut. The sprouting rate of cut twigs gathered on the day which had not stored at low temperature was 97.4%. And The sprouting rate at the relative humidity of $40{\sim}50%$ after storing at low temperature for 122 days were 34.2%, and that of at $80{\sim}90%$ relative humidity was 85.7%. The longer storage periods, the more the number, length and width of sprouts. Therefore, the twigs of a wild mulberry trees cut with $1{\sim}3$ buds were able to produce the sprout vegetables under the condition of temperature $4{\sim}6^{\circ}C$ and relative humidity $80{\sim}90%$.

• Journal of Bio-Environment Control
• /
• v.23 no.3
• /
• pp.256-261
• /
• 2014

This study was carried out to determine the effect of the artificial pollination on fruit set, seed formation and fruit quality in kiwifruit and to confirm the effective pollination time for optimal fruit set in the shelter greenhouse cultivation. Also, the effect of artificial pollination practice by the pollen diluent solution was tested. By artificial pollination, fruit set, seed formation, and fruit quality was improved both in the open field condition and in the shelter greenhouse cultivation. In order to find the effective pollination period (EPP), artificial pollination was carried out every day until 7 days after full bloom. Number of seeds and fruit set rate and fruit growth of kiwifruit were no significantly different until 4 days after full bloom (DAFB), but, those of kiwifruit from 5 DAFB significantly decreased. Consequently, the effective pollination period of kiwifruit in the shelter greenhouse was 4 days after full bloom. Also, artificial pollination by the pollen diluent solution was showed the similar fruit set and fruit quality compare to that by lycopodium powder. Accordingly, artificial pollination by the pollen diluent solution should be very effective practice for labor saving in kiwifruit cultivation.

• Journal of Bio-Environment Control
• /
• v.22 no.3
• /
• pp.270-278
• /
• 2013

The objective of the present study is to provide data needed to decide covering method to be able to increase the thermal insulation and light transmittance efficiency of commercial greenhouse. The thermal insulation effect, PPF transmittance and quantity of condensation water were estimated in experimental tomato greenhouses covered with three types of coverings of single layer, air inflated and conventional double layers covering. The overall heat flow of air inflated double layers greenhouse was similar to that of conventional double layers greenhouse, but the temperature between covering material and thermal screen in air inflated double layers greenhouse was lower than that in conventional double layers greenhouse at the same outside temperature condition due to air leakage through the gap of roof vent. The overall heat transfer coefficients acquired by experiment that was performed in single layer and conventional double layers greenhouses were close to those obtained from model experiment. Even though the PPF transmittance of air inflated double layers greenhouse was lower than that of single layer greenhouse, which was greater than that of conventional double layers greenhouse. The quantity of condensation water on covering surface of single layer greenhouse was greater than that of air inflated double layers greenhouse due to lower covering surface temperature.

• Journal of Bio-Environment Control
• /
• v.22 no.3
• /
• pp.228-233
• /
• 2013

This study was conducted to examine the effect of light intensity and photoperiod of white LEDs as the artificial light source on the growth of leaf lettuce (Lactuca sativa L.) 'Seonhong Jeokchukmyeon' in a closed-type plant production system. Seedlings, transplanted at a density of $20cm{\times}20cm$ in a completely randomized design, were grown under white LEDs (FC Poibe Co. Ltd., Korea), at one of the 3 light intensities (100, 200, or $300{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$), and each with one of 3 photoperiods [12/12, 18/6, or 24/0 (Light/Dark)]. Plants were cultured for 22 days under the condition of $21{\pm}2^{\circ}C$, $60{\pm}10%$ RH, and $400{\pm}50{\mu}mol{\cdot}mol^{-1}\;CO_2$. The greatest leaf length and width, fresh and dry weights, and total anthocyanin content were obtained in the 24/0 photoperiod, regardless of the light intensity. Length of the longest root, fresh and dry weights, and number of leaves were greater in light intensity of $200{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ than 100 or $300{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$. Chlorophyll value was the greatest in the photoperiod 12/12 than 18/6 or 24/0. The results obtained suggest that plant grew the best kept by light intensity at 200 or $300{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$, and photoperiod of 12/12 or 18/6.

• Journal of Bio-Environment Control
• /
• v.29 no.1
• /
• pp.1-8
• /
• 2020

The influence of growth regulators (NAA and BA) and sucrose concentrations (0, 3, 5, 7, 9%) on in vitro rapid-propagation of virus-free sweet potato [Ipomoea batatas (L.) Lam.] was investigated with single-node or shoot-tip culture of two cultivars ('Matnami' and 'Shinhwangmi'). The survival rate and growth of shoot-tip explant was also investigated under the presence or absence of light (blue and red LED = 7:3, 150±5 μmol·m^-2·s^-1 PPFD) during minimal-growth in vitro conservation at 15℃. Vine length, vine diameter, fresh weight and dry weight were enhanced without callusing of explant in the MS medium supplemented with 0.2-0.5 mg·L^-1 BA. The growth of single-node and shoot-tip explants were significantly enhanced with the increase of vine length, number of leaf, number of root, fresh weight, and dry weight in the solid medium containing 5% sucrose and 0.2 mg·L^-1 BA. Vine elongation of shoot-tip explants were highest in the liquid medium containing 3% sucrose than the solid medium. The survival rate of minimal-growth in vitro conservation was 100% in 5 months under the presence of light (LED, 150±5 μmol·m^-2·s^-1 PPFD) at 15℃, but the explants in dark condition died in 3 months. The light was absolutely necessary for the in vitro conservation under minimal-growth conditions of virus-free sweet potato plantlets at 15℃, and the high density of explants (10 plantlets per Petri Dish) was increased the efficiency of mass conservation.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.3
• /
• pp.223-229
• /
• 2015

Surface modification is a technology to form a new surface layer and overcome the intrinsic properties of the base material by applying thermal energy or stress onto the surface of the material. The purpose of this technique is to achieve anti-corrosion, beautiful appearance, wear resistance, insulation and conductance for base materials. Surface modification techniques may include plating, chemical conversion treatment, painting, lining and surface hardening. Among which, a surface modification process using electrolytes has been investigated for a long time in connection with research on its industrial application. The technology is highly favoured by various fields because it provides not only high productivity and cost reduction opportunities, but also application availability for components with complex geometry. In this study, an electrochemical experiment was performed on the surface of 5083-O Al alloy to determine an optimal electrolyte temperature, which produces surface with excellent corrosion resistance under marine environment than the initial surface. The experiment result, the modified surface presented a significantly lower corrosion current density with increasing electrolyte temperature, except for $5^{\circ}C$ of electrolyte temperature at which premature pores was created.

• Journal of Soil and Groundwater Environment
• /
• v.10 no.1
• /
• pp.58-64
• /
• 2005

Several tests were conducted to determine the optimum operational conditions of soil washing techniques for floe-forming arsenic-contaminated soils, collected from D abandoned Iron-mine in Korea. The optimum cut-off size was 0.15 mm $(sieve\;\#100)$, about $94\%$ of the mass of soils. Both sodium hydroxide and hydrochloric acid were effective to remove arsenic and the optimum mixing ratio (soil [g] : washing solution [mL]) was 1:5 for both washing agents. Arsenic concentrations, determined by KST Methods, for the dried floe solids obtained from flocculation at pH 5-6 were $990\~1,086\;mg/kg$ dry solids, which were higher concentrations than at the other pH values. Therefore, batch tests for sequential washings with or without removing floc were conducted to find the enhancement of washing efficiencies. After removing floe with 0.2 M HCl, sequential washings of 1 M HCl followed by 1 M NaOH showed the best results (15 mg/kg dry soil). The arsenic concentrations of washing effluent from each washing step were about $2\~3\;mg/L$. However, when these acidic and basic effluents were mixed together, arsenic concentration was decreased to be less than $50\;{\mu}g/L$, due to the pH condition of coagulation followed by precipitation for arsenic removal.