• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2011년도 추계학술발표대회 논문집
• /
• pp.348-353
• /
• 2011

Recently the renewable energy has been used widely and the importance of renewable sources is bigger than before. So the government enforced a law to the public buildings to install the renewable energy facilities. The capacity of facilities is 5% of total construction cost until April 13, 2011. Since then, the government changed the law from 5% of total construction cost to 10% of predicted energy usage because of the practical use of the renewable energy facilities. So, in this study, the comparative analysis is conducted according to the law to the building installed PV system through the EnergyPlus simulation.

• 동력기계공학회지
• /
• 제19권1호
• /
• pp.76-82
• /
• 2015

An analysis model is developed using a commercial software 'simulationX' for designing hydraulic-pneumatic system of heave compensator for offshore drilling operations. Reliability verification of the analysis model for the test equipment of 1/5 scale compensator was conducted by comparing test results and simulation results. An analysis of full scale heave compensator is developed on the basis of verified a model. Then, the results of simulation were analyzed to obtain following conclusion. The displacement of crown block about excitation input amplitude (${\pm}3,000mm$) of the steward platform using a 'simulationX' is attenuated under ${\pm}35mm$, and the compensation rate is 98.7%. In this study, goal of a compensation rate is more than 95%. The previously results are satisfied with the objectives of compensation rate.

• 전기학회논문지P
• /
• 제62권1호
• /
• pp.18-22
• /
• 2013

This paper describes the information for quantitative simulation of weakly ionized plasma. We must grasp the meaning of the plasma state condition to utilize engineering application and to understand materials of plasma state. Using quantitative simulations of weakly ionized plasma, we can analyze gas characteristic. In this paper, the electron transport characteristic in $CH_4$ has been analysed over the E/N range 0.1~300[Td], at the 300[$_{\circ}\;K$] by the two term approximation Boltzmann equation method and Monte Carlo Simulation. Boltzmann equation method has also been used to predict swarm parameter using the same cross sections as input. The behavior of electron has been calculated to give swarm parameter for the electron energy distribution function has been analysed in $CH_4$ at E/N=10, 100 for a case of the equilibrium region in the mean energy. A set of electron collision cross section has been assembled and used in Monte Carlo simulation to predict values of swarm parameters. The result of Boltzmann equation and Monte Carlo Simulation has been compared with experimental data by Ohmori, Lucas and Carter. The swarm parameter from the swarm study are expected to sever as a critical test of current theories of low energy scattering by atoms and molecules.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2019년도 학술발표회
• /
• pp.163-163
• /
• 2019

The rapidly growing global population increases the awareness of water, energy, and food security worldwide. The concept of Water, Energy, and Food nexus (hereafter, WEF nexus) has been widely introduced as a new resources management concept that integrate the water, energy, and food in a single management framework. Recently, WEF nexus analyzes not only the interconnections among the resources, but also considers the external factors (such as environment, climate change, policy, finance, etc) to enhance the resources sustainability by proper understanding of their relations. A nation-level resources management is quite complex task since multiple regions (e.g., watersheds, cities, and counties) with different characteristics are spatially interconnected and transfer the resources each other. This study proposes a multiple region WEF nexus simulation and transfer model. The model is equipped with three simulation modules, such as local nexus simulation module, regional resources transfer module, and optimal investment planning module. The model intends to determine an optimal capital investment plan (CIP), such as build-up of power plants, water/waste water treatment plants, farmland development and to determine W-E-F import/export decisions among areas. The objective is to maximize overall resources sustainability while minimize financial cost. For demonstration, the proposed model is applied to a semi-hypothetical study area with three different characterized cities. It is expected the model can be used as a decision support tool for a long-term resources management planning process.

• 한국수소및신에너지학회논문집
• /
• 제32권4호
• /
• pp.219-227
• /
• 2021

Hydrogen isotopes, which are used as raw materials in fusion reaction, participate in the reaction only in small amount, and most of them are released together with impurities. In order to recover and reuse only hydrogen isotopes from this exhaust gas, a recovery process is required, and most of the hydrogen isotopes can be recovered using a Pd Membrane. In this study, the recovery rate of hydrogen isotopes was measured through the first and second stage Pd membrane experiments. In the case of the experiment using a single stage Pd membrane, about 99.2%, and in the case of the first stage and second stage Pd membrane connection experiments, a recovery rate of 99.9% or more was obtained. Therefore, the recovery rate of Pd membrane process applied to hydrogen can be applied to hydrogen isotopes. In addition, the simulation model was established using aspen custom modeler, a commercial software, and the validity of the simulation was checked by applying the references and experimental data. The simulation results based on the experimental data showed a difference of 2% or less.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.1008-1013
• /
• 2009

The theoretical simulation to predict the variation of supplying heat according to control methods of DHS(District Heating System) have been done by TRNSYS(A Transient System Simulation Program) 16. The physical system for DHS consists of primary and secondary supplying heating loop which is divided by based on heat exchanger for heating demand of building. The simulation results showed that control of secondary supplying heat had influenced more than primary supplying heat control to total energy consumption of DHS. And the outside temperature reset control of primary supplying heating loop could be reduced until about 4% overheating of each zone.

• 전자공학회논문지D
• /
• 제35D권12호
• /
• pp.30-40
• /
• 1998

극 저 에너지 실리콘 이온 주입 시뮬레이션을 통하여 실리콘 내부에서 발생하는 격자 손상에 대하여 고전분자 동역학을 사용하여 시뮬레이션 하였다. 또한 최근에 개발된 EDIP 전위식이 실리콘 충돌 계산에 적합한지 여부를 분자 동역학을 사용하여 계산하였다. EDIP 전위식은 평형상태 계산에 알맞지만 충돌을 계산하는데는 적합하지 않았다. 또한 MDRANGE를 실리콘 공정에 맞도록 향상시켜 200eV, 500eV, 그리고 1000eV 에너지 붕소 이온 주입 시뮬레이션을 수행하여 실리콘 기판의 온도, 기울기 각도 및 에너지에 따른 붕소의 분포를 계산하였다. 1000eV 이하 에너지 붕소 이온 주입에서도 체널링 현상에 대한 고려가 필요하다는 것을 알 수 있었다.

• 한국태양에너지학회 논문집
• /
• 제39권3호
• /
• pp.29-45
• /
• 2019

As the solar energy market grows, the need to investigate the potential of photovoltaic system is being highlighted. However, due to the lack of plain field, the system on top of buildings is being exploited. This paper analyzes the potential to install PV systems on the rooftops. First of all, with the aid of a photovoltaic system simulation software, buildings were designed in a specific area based on the architectural data. And then, with the same software, the potential to install photovoltaic system was explored by placing PV modules on the buildings' rooftops. The installation potential was calculated and simulated with consideration for obstacles on the rooftops. The parameters are composed of available area for system installation, area utilization rate, PV system power capacity, operation yield hour per day and performance ratio. In the simulation, 5 sites were analyzed based on their architectural data. In the end, reliable data that can be utilized were collected for the potential to install the system with the photovoltaic system simulation software.

• Nuclear Engineering and Technology
• /
• 제27권6호
• /
• pp.853-858
• /
• 1995

노심 천 이 현상의 모사계산을 위해서는 노심상태 의 초기조건을 실제노심과 일치시켜야 하는데 특히, 제논동특성이 관심의 대상이 되는 천이현상에 있어서는 직접적인 추정이 불가능한 노심내 제논분포의 초기상태가 천이현상의 해석결과에 커다란 영향을 미치게 된다 초기상태의 노심이 정확히 제논 평형상태에 있지 않는 경우 노심의 시간에 따른 변화를 잘 예측하기 위해서는 비평형 제논분포를 모사하는 초기화가 필수적이다. 본 연구에서는 천이현상 이전에 관측된 비평형 제논진동을 등가 제논진동으로 모사하여 천이현상을 보다 정확히 예측할 수 있는 제논 초기화 기법을 개발하였으며 영광 3, 4호기 시운전 시험에서 입수된 실측자료를 통하여 그 적용성을 입증 하였다.

• 한국시뮬레이션학회논문지
• /
• 제21권4호
• /
• pp.47-56
• /
• 2012

본 연구에서는 센서 네트워크용 병렬 시뮬레이터인 PASENS(Parallel SEnsor Network Simulator)를 이용하여 센서 네트워크에 이용되는 라우팅 알고리즘 중에서 계층적 라우팅 프로토콜의 대표적인 방식인 LEACH(Low-Energy Adaptive Clustering Hierarchy)와 그의 변형인 TL-LEACH(Two Level Low-Energy Adaptive Clustering Hierarchy), M-LEACH(Multihop Low-Energy Adaptive Clustering Hierarchy), 그리고 LEACH-C(LEACH-Centralized)의 전력 소모량과 데이터의 수신율을 비교하고 분석하였다. 시뮬레이션을 이용한 분석 결과에 따르면, M-LEACH 라우팅 프로토콜의 경우에는 여러 센서 노드들을 통하여 데이터가 전달되기 때문에 일정한 크기 이상의 넓은 공간에서 높은 수신율을 보였으며, LEACH-C 라우팅 프로토콜은 싱크 노드(서버)가 전체 센서 노드의 잔여 에너지와 위치를 고려하여 클러스터 헤드를 결정하기 때문에 좁은 공간에서 보다 오랜 수명을 필요로 하는 센서 네트워크를 구축하는데 가장 효율적이라는 것을 확인 할 수 있었다.