• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2007년도 추계학술대회논문집
• /
• pp.820-823
• /
• 2007

In the wavenumber domain, each point on a radiation sphere indicates a plane wave of the frequency corresponding to radius of the sphere and the position on the sphere shows propagating direction of the plane wave. This concept is extended from the research by Choi[1] where he focus acoustic potential energy at a point on a radiation sphere. Here we propose the method to focus the energy at a point on the radiation sphere, as a result, we can easily generate a plane wave which propagates to any direction that we want.

• 한국수소및신에너지학회논문집
• /
• 제11권3호
• /
• pp.127-136
• /
• 2000

Molecular dynamics simulations have been carried out to investigate the scattering and penetration properties of hydrogen ions with the normal incident angle to Ni (100) surface. The initial kinetic energies of hydrogen ions range from 100 to 1,600 eV. The simulation results are used to assess the applicabilities of theoretical predictions based on the binary collision approximation, and, in the high kinetic regime, theoretical results for scattering energies were shown to he a good agreement with molecular simulations. The angle dependencies on both scattering and penetration distributions were found in the longitudinal direction, but not in the azimuthal direction except for the high kinetic energy of 1,600 eV.

• 한국농촌건축학회논문집
• /
• 제5권2호
• /
• pp.1-9
• /
• 2003

Local Agenda 21 insists Local National role for earth environmental preservation. It is effect in earth environment important code that each local government promotos Local Agenda 21. Local agenda requires changes in lifestyle from everyone, such as limiting use of energy.Local agenda is difficult to define. But the goal of agenda development can guide furure policy. In this study, investigated local agenda actural condition and housing present condition, energy consumption. It is analyzed practice item of city and architecture local agenda. It is also proposed data of architecture and presented direction of architecture local agenda.

• 로봇학회논문지
• /
• 제6권3호
• /
• pp.230-236
• /
• 2011

In previous researches, the self-stability was studied for the spring-mass model and the two segment leg model. In these researches, it was presented that the spring-mass model has the self-stable region at relatively high speed running and the two segment leg model has the self-stable region at relatively low speed running. If the model was run in the self-stable region, the cost of transport is zero ideally. That is, actually, only the energy loss is needed to compensate for running. This means that the energy efficiency is high, running in the self-stable region. We want to have high energy efficiency at low and high speed running. So, in this paper, we propose the design direction of the three segment leg having the self-stable region at low and high speed running. And we prove the self-stable region of the three segment leg designed by the proposed design direction.

• 한국수소및신에너지학회논문집
• /
• 제26권5호
• /
• pp.453-462
• /
• 2015

In this study, a methodology is investigated for the development of social responsibility program employed by major domestic companies under social pressure. It is true, however, that its infancy in history and lack of experience makes it difficult to run novel programs for the companies on their own and it naturally leads to copying and/or slight modification of what others do. Utilizing widely accepted SWOT analysis, stakeholders analysis and PDCA Cycle, a methodology for the successful programs with sustainability is proposed by reflecting business nature and strategic direction. Three real cases are analyzed. In addition, relationship and position with social welfare organizations is elucidated.

• Journal of Magnetics
• /
• 제18권3호
• /
• pp.283-288
• /
• 2013

This paper presents structural topology optimization that is being applied for the design of electromagnetic vibration energy harvester. The design goal is to maximize the root-mean-square value of output voltage generated by external vibration leading structures. To calculate the output voltage, the magnetic field analysis is performed by using the finite element method, and the obtained magnetic flux linkage is interpolated by using Lagrange polynomials. To achieve the design goal, permanent magnet is designed by using topology optimization. The analytical design sensitivity is derived from the adjoint variable method, and the formulated optimization problem is solved through the method of moving asymptotes (MMA). As optimization results, the optimal location and shape of the permanent magnet are provided when the magnetization direction is fixed. In addition, the optimization results including the design of magnetization direction are provided.

• 풍력에너지저널
• /
• 제9권4호
• /
• pp.40-46
• /
• 2018

In this study, a three-dimensional Navier-Stokes simulation around Wido Island was performed to analyze the wake effect behind an island. A 10 m/s wind speed and pressure boundary conditions were assigned for the inflow and outflow boundary conditions, respectively. Wido Island was modeled using GIS data. A prevailing wind from the north-northwest direction was determined based on QuikSCAT satellite data. A computational domain of $40km{\times}20km{\times}5km$ covering Wido Island was applied for numerical analysis. Sixty points were specified to extract the wind speed data. A wind speed profile inside the atmospheric boundary layer was compared with a wind profile using a simple power law. It turns out that the wake effect decreases the mean wind speed by 5% more or less, which corresponds to a 14% decrease in wind energy. Thus, the installation of a meteorological mast or development of a wind farm behind Wido Island is not highly recommended.

• 풍력에너지저널
• /
• 제4권1호
• /
• pp.46-52
• /
• 2013

The wind generally includes turbulence characteristics in nature. So the yaw errors between wind turbine direction and wind direction occur due to turbulence fluctuation. The yaw errors affect the fatigue load of wind turbine system and power reduction. The components of turbulence intensity are different from those of each site where the wind turbines are installed. We studied that the fatigue load and power efficiency are improved by controlling yaw motions. In this study, we controlled the averaged yaw error time according to site conditions by turbulence intensity.

• 대한기계학회논문집A
• /
• 제24권2호
• /
• pp.279-289
• /
• 2000

Residual stress induced in U-bending and tube-to-tubesheet joint processes of PWR's row-1 heat exchanger tube was measured by X-ray method and Hole-Drilling Method(HDM). Compressive residual stresses(-) at the extrados surface were induced in U-bending, and its maximum value reached -319 MPa in axial direction at the position of $\psi$ = $0^{\circ}$. Tensile residual stresses(+) of $\sigma_{zz}$ = 45 MPa and $\sigma_{\theta\theta}$ = 25 MPa were introduced in the intrados surface at the position of $\psi$ = $0^{\circ}$. Maximum tensile residual stress of 170 MPa was measured at the flank side at the position of $\psi$ = $90^{\circ}$, i.e., at apex region. It was observed that higher stress gradient was generated at the irregular transition regions (ITR). The trend of residual stress induced by U bending process of the tubes was found to be related with the change of ovality. The residual stress induced by the explosive joint method was found to be lower than that by the mechanical roll method. The gradient of residual stress along the expanded tube was highest at the transition region (TR), and the residual stress in circumferential direction was found to be higher than the residual stress in axial direction.

• Journal of Radiation Protection and Research
• /
• 제41권3호
• /
• pp.260-267
• /
• 2016

Background: This study analyzes the differences in the annual averaged atmospheric dispersion factor and ground deposition factor produced using two classification methods of atmospheric stability, which are based on a vertical temperature difference and the standard deviation of horizontal wind direction fluctuation. Materials and Methods: Daedeok and Wolsong nuclear sites were chosen for an assessment, and the meteorological data at 10 m were applied to the evaluation of atmospheric stability. The XOQDOQ software program was used to calculate atmospheric dispersion factors and ground deposition factors. The calculated distances were chosen at 400 m, 800 m, 1,200 m, 1,600 m, 2,400 m, and 3,200 m away from the radioactive material release points. Results and Discussion: All of the atmospheric dispersion factors generated using the atmospheric stability based on the vertical temperature difference were shown to be higher than those from the standard deviation of horizontal wind direction fluctuation. On the other hand, the ground deposition factors were shown to be same regardless of the classification method, as they were based on the graph obtained from empirical data presented in the Nuclear Regulatory Commission's Regulatory Guide 1.111, which is unrelated to the atmospheric stability for the ground level release. Conclusion: These results are based on the meteorological data collected over the course of one year at the specified sites; however, the classification method of atmospheric stability using the vertical temperature difference is expected to be more conservative.