• Journal of the Korean Chemical Society
• /
• v.33 no.3
• /
• pp.287-294
• /
• 1989

The optimum condition for the separation of priority pollutant phenols using isocratic elution has been determined. The elution behavior of eleven phenols has been also studied to interpret the retention. The reversed phase liquid chromatographic methods were performed on a ${\mu}$-Bondapak $C_{18}$ column with methanol-water, acetonitrile-water, and THF water mixtures as mobile phases. The COF method, where Snyder's solvent triangle concept was combined with a mixture-design statistical technique, was used to optimize the strength and selectivity of solvents for the separation of phenols. The optimum solvent composition, which gives a complete separation of eleven phenols, was found to be $MeOH:ACN:H_2O$ = 7:40:53. The plots of ln k' vs. -${\Delta}H^{\circ}$ and ${\Sigma}{\pi}$ of phenols showed relatively good linearities. Effect of van der Waals volume, pi-energy and hydrogen bonding on the retention of phenols were investigated. The following equation with the correlation coefficient of 0.9927 for ACN-water solvent system was obtained; $log^{k'}=2.515{\times}10^{-2}VWV-1.301{\times}10^{-1}E-3.674{\times}10^{-1}$

• Clean Technology
• /
• v.17 no.4
• /
• pp.389-394
• /
• 2011

A compact adsorption-based process for removal of carbon dioxide and nitrogen from natural gas has been discussed. Among the adsorption-based processes, especially, the pressure swing adsorption (PSA) process has been a suitable unit operation for the purification and separation of gas because of low operation energy and cost. A step cycle is made up of pressurization, feed, equalization, blowdown and rinse. In this work, the PSA process is composed of zeolite 13X and carbon molecular sieve (CMS) for removal of carbon dioxide and nitrogen from mixed gas containing $CH_4/CO_2/N_2$ (75:21:4 vol%). A CMS selectively removes carbon dioxide and a zeolite 13X separates nitrogen from methane. CMS is investigated experimentally due to the high throughput of the faster diffusing component ($CO_2$). The gas composition of top, bottom and feed tank was measured with the gas chromatography (GC) using TCD detector, helium as carrier gas and packed column for analysis of methane, carbon dioxide, and nitrogen.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2012.05a
• /
• pp.65-65
• /
• 2012

Copper zinc tin sulfide ($Cu_2ZnSnS_4$, CZTS) is a very promising material as a low cost absorber alternative to other chalcopyrite-type semiconductors based on Ga or In because of the abundant and economical elements. In addition, CZTS has a band-gap energy of 1.4~1.5eV and large absorption coefficient over ${\sim}10^4cm^{-1}$, which is similar to those of $Cu(In,Ga)Se_2$(CIGS) regarded as one of the most successful absorber materials for high efficient solar cell. Most previous works on the fabrication of CZTS thin films were based on the vacuum deposition such as thermal evaporation and RF magnetron sputtering. Although the vacuum deposition has been widely adopted, it is quite expensive and complicated. In this regard, the solution processes such as sol-gel method, nanocrystal dispersion and hybrid slurry method have been developed for easy and cost-effective fabrication of CZTS film. Among these methods, the hybrid slurry method is favorable to make high crystalline and dense absorber layer. However, this method has the demerit using the toxic and explosive hydrazine solvent, which has severe limitation for common use. With these considerations, it is highly desirable to develop a robust, easily scalable and relatively safe solution-based process for the fabrication of a high quality CZTS absorber layer. Here, we demonstrate the fabrication of a high quality CZTS absorber layer with a thickness of 1.5~2.0 ${\mu}m$ and micrometer-scaled grains using two different non-vacuum approaches. The first solution-processing approach includes air-stable non-toxic solvent-based inks in which the commercially available precursor nanoparticles are dispersed in ethanol. Our readily achievable air-stable precursor ink, without the involvement of complex particle synthesis, high toxic solvents, or organic additives, facilitates a convenient method to fabricate a high quality CZTS absorber layer with uniform surface composition and across the film depth when annealed at $530^{\circ}C$. The conversion efficiency and fill factor for the non-toxic ink based solar cells are 5.14% and 52.8%, respectively. The other method is based on the nanocrystal dispersions that are a key ingredient in the deposition of thermally annealed absorber layers. We report a facile synthetic method to produce phase-pure CZTS nanocrystals capped with less toxic and more easily removable ligands. The resulting CZTS nanoparticle dispersion enables us to fabricate uniform, crack-free absorber layer onto Mo-coated soda-lime glass at $500^{\circ}C$, which exhibits a robust and reproducible photovoltaic response. Our simple and less-toxic approach for the fabrication of CZTS layer, reported here, will be the first step in realizing the low-cost solution-processed CZTS solar cell with high efficiency.

• Journal of the Korean Chemical Society
• /
• v.43 no.3
• /
• pp.321-327
• /
• 1999

The STS materials, emphasized in the 6th curriculum, in the chemistry part of middle school science textbooks were analyzed. The average value of the STS content of textbook was 13.2%. In the study of chapter of textbook, 15.9% of STS materials was included in the chapter of ？reaction of materials?, 12% in "character and separation of materials", and 10.8% in "composition of materials". When the STS topics classified by Piel were analyzed, the results were as follows; 40.2% on sociology of science, 28.8% on environmental quality and utilization of natural source, 20.4% on effects of technological developments, and 12.9% on energy. However, the topic on human engineering was only included in a textbook, and the topics on space research and national defence were not included in any textbooks. When the STS materials were analyzed by student activities of SATIS, the number of activities was 71. Most activities were consisted of solving problems and decision, simulation and data analysis, and there was no research design and role playing.

• Korean Journal of Materials Research
• /
• v.9 no.10
• /
• pp.1018-1024
• /
• 1999

The effects of operating temperature and stress on degradation of components in high temperature steam generator were investigated. Several 2.25CrlMo tubes which had operated over 20 years and an unused 9CrlMoVNb tube were tested. For the former samples, the amount of $\textrm{M}_{6}\textrm{C}$ carbide and its size are increased with the aging or operating time. The precipitation behavior of carbides ($\textrm{M}_{2}\textrm{O}$, $\textrm{M}_{6}\textrm{C}$) is changed with the operating temperature of the tubes. However, unused 9CrlMoVNb samples show a different carbide precipitation process due to high chromium, vanadium, and niobium contents. The amount of Cr-rich $\textrm{M}_{23}\textrm{C}_{6}$ carbide is significantly increased with aging time, but that of $\textrm{M}_{6}\textrm{C}$ type carbide is rarely changed with aging time at elevated temperatures.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.16 no.4
• /
• pp.43-49
• /
• 2008

Objective of this study was to monitor the hydrogen sulfide production rate and concentration in anaerobic co-digestion of swine manure and food waste for biogas production in order to alternate the petroleum based energy. Anaerobic co-digestion for biogas production was performed in serum bottles at 2% volatile solids (VS) concentration and various mixing ratios of two substrates(swine manure: food waste = 100:0 ~ 0:100). Although hydrogen sulfide production rates were varied with digestion periods at different treatments, it was observed that hydrogen sulfide produced in the swine manure alone was lower at 2.4 fold than that of food waste. For effects of hydrogen sulfide concentration in the different mixing ratios of swine manure to food waste, the higher food waste ratio the higher hydrogen sulfide concentration. Also its average concentrations were varied from 0.1452% in the swine waste only to 0.3420% in the food waste alone. For the composition ratio of bio-gas in their anaerobic co-digestion, it appeared that there was 53.2% of $CH_4$, 23.9% of $CO_2$, 0.3% of $H_2S$ and 22.7% of miscellaneous gases including moisture.

• Microbiology and Biotechnology Letters
• /
• v.38 no.4
• /
• pp.448-454
• /
• 2010

This study investigated the effect of PCE and TCE as electron acceptors on the bacterial composition of dechlorinating communities. The enrichment cultures reductively dechlorinating PCE and TCE were developed from three environment samples using acetate as electron donor. The cultures were prepared by sequential enrichment, which was seeded with sediment and dredged soil. Denatured gradient gel electrophresis (DGGE) of 16S rRNA gene fragment was used to compare the microbial communities of these three enrichment cultures. After incubation for 4 weeks, the removal efficiencies of PCE and TCE were highest from Yeocheon site (87.37% and 84.46%, respectively). PCE and TCE as electron acceptors affected the bacterial diversity and community profiles in the enrichment cultures. DGGE analysis showed that the dominant bacteria in PCE and TCE enrichment were belonged to Clostridium sp., Desulfotomaculum sp., and uncultured bacteria.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.12 no.3
• /
• pp.207-211
• /
• 1983

An attempt was made to find out the possibility of utilizing water-melon seed as resources of food fats and protein. The water-melon seed contained 40.40% of crude fat and 28.36% of crude protein. The lipid fraction obtained by silicic acid column chromatography was composed of about 97.35% neutral lipid, and the main components of neutral lipid by thin layer chromatography were triglyceride(50.40%), diglyceride(21.84%) and sterol(11.48%). The predominant fatty acids of total and major lipid classes were linoleic acid(55.30-67.85%), palmitic acid(12.07-28.12%) and oleic acid(9.06-16.40%), whereas stearic acid and linolenic acid were detected as small amounts. The salt soluble protein of watermelon seed was highly dispersible in 0.02M sodium phosphate buffer containing about 0.7M $MgSO_4$, and the extractability of seed protein was about 27%. Glutamic acid and arginine were major amino acids, and the essential amino acids such as lysine, threonine, valine, methionine, isoleucine, leucine and phenylalanine were also detected. The electrophoretic analysis showed 6 bands in water-melon seed protein, and the collection rate of the main protein fraction purified by sephadex G-100 and G-200 was 52.4%. The amino acids of the main fraction protein were also mainly composed of glutamic acid and arginine. The molecular weight for the main protein of the water-melon seed was estimated to be 120,000.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.15 no.1
• /
• pp.15-21
• /
• 1986

This study was conducted to research the industrial utilizaion of the maize germs separated in the manufacture of the cornstarch. The maize germs contained crude protein (25.3%) and crude fat (19.2%), with the 512 Kcal/100g of determined food energy values. It was found to have the valuable amounts of essential minerals, such as the content of calcium and phosphorus were low (53.0, 12.3mg%), while those of potassium (495.4mg%), magnesium (95.0mg%), zinc (48.3ppm) and manganese (45.2ppm) were plentiful. It was noted that the iodine value was 44.0, saponification value 292.3, acid value 1.5 and peroxide value about 3.3. The lipid fractions obtained by silicic acid column chromatography were mainly composed of neutral lipid, whereas, the contents of glycolipid and phospholipid were scarcely. The major fatty acids in total lipids were linoleic $(60{\sim}62.5%)$, oleic $(20{\sim}22.5%)$ and palmitic $(10{\sim}13.5%)$ acids. The content of the unsaturated fatty acids was more predominant than that of the saturated fatty acids. The content of the insoluble proteinous nitrogen (32.5%) was the most abundant. whereas, the contents of soluble proteinous nitrogen (12.7%) and peptide proteinous nitrogen (3.3%) were low. The major amino acids of the maized germs were glutamic, glycine, alanine and aspartic. It has been identified by the SDS-disc electrophoresis that the protein of maized germs had $5{\sim}6$ bands. Compared with standard substances, the molecular weight of the main protein was estimated to be $14,500{\sim}24,500$.

• Journal of the Korean Chemical Society
• /
• v.40 no.5
• /
• pp.295-301
• /
• 1996

A series of solid solutions of the $CaGa_1-xFexO_3-y$ system with the compositions of x=0.25, 0.50, 0.75, and 1.00 has been prepared at $1150^{\circ}C$ under an atmospheric air pressure. The structure, nonstoichiometric chemical formula, and the distribution of cations for the solid solutions are determined by X-ray diffraction analysis, Mohr salt titration, Mossbauer spectroscopic analysis. Their physical properties are discussed with electrical conductivity and magnetic measurements. The crystal system of all the compositions is a brownmillerite orthorhombic system from the X-ray diffraction analysis and the reduced lattice volume increases linearly with x value except that of the composition of x=0.25. All the solid solutions do not contain $Fe^{4+}$ ion and the mole number of oxygen vacancies or y value is 0.50 from Mohr salt analysis. The oxidation state of Fe ion, the coordination state, the structure change in the Brownmillerite-type structure, and the distribution of $Ga^{3+}$ and $Fe^{3+}$ ions are discussed with Mossbauer spectroscopic analysis. The electrical conductivity increases and activation energy decreases, as x value increases. The traditional semiconducting property of this system is described in terms of band theory. The compositions of x=0.50∼1.00 show a thermal magnetic hysteresis in the magnetic measurement with the cooling conditions, which is discussed in terms of the space group and Dzyaloshinsky-Moriya interaction.