• Proceedings of the KIEE Conference
• /
• 2001.05a
• /
• pp.42-45
• /
• 2001

The islanding protection for distributed resources (DR) becomes an important and emerging issue in power system protection since the distributed generator installations are rapidly increasing and most of the installed systems are interconnected with distribution network. In order to avoid the negative impacts on distributed network resulting from islanding operations of DR, it is necessary to detect the loss of mains (LOM) effectively. This paper presents a new LOM detection method using the rate of change in total harmonic distortion (THD) of current. The proposed method effectively detects LOM of the DR unit operating in parallel with the distribution network. We also verified the efficiency of the proposed method using the radial distribution network of IEEE 34 bus model.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.17 no.1
• /
• pp.21-26
• /
• 2012

In recent years, DC distribution systems are becoming hot issue due to the increase in digital loads and DC generation systems according to the expansion of renewable energy technologies. However, removing the fault current in DC grids is comparably difficult since the current in DC grids has no zero-crossing point like in AC grids. Thus, developing dedicated DC circuit breakers for DC grids is necessary to get safety for people and electrical facilities. This paper proposes magnet arc extinguishing method to develop a 300[$V_{DC}$]/10[A] DC circuit breaker. The performance of the proposed DC circuit breaker was verified by an experimental circuit breaker test system built in this research.

• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.136-137
• /
• 2017

Maximum power point tracking (MPPT) under partial shading condition (PSC) is a challenging process in the PV array system. The shaded PV panel makes different peak patterns on the P-V curve and misguides the MPPT algorithm. Various kinds of global MPP (GMPP) detecting algorithms are used to overcome this issue. Generally, too frequent execution of GMPP tracking algorithm reduces the achievable power of PV panel due to time spent on the scanning process. Thus, partial shading detection algorithm is essential for efficient utilization of solar energy source. While conventional method only detects fast shading patterns, the proposed algorithm always shows superb performance regardless of the speed of partial shading patterns.

• Proceedings of the KIEE Conference
• /
• 1994.11a
• /
• pp.382-384
• /
• 1994

Wireless communication has become a hot issue for its simplicity. Using light wave instead of micro wave has many advantages. It is simple to design a circuit because we can make a circuit with discrete components such as photo diode, photo detector, OP Amp[2]. And we can have many communication channels for we can use every frequency domain. In this paper, we design the wireless communication system and analyze the pulse signal. Then using ray tracing technology we simulate the distribution of light beam.

• Proceedings of the KIEE Conference
• /
• 1995.07a
• /
• pp.451-454
• /
• 1995

Increasing the transfortation efficiency is very important issue in railway system. Speed-up of train and shortage of headway can be its solution. Headway can vary with blocksection length, characteristics of the railway and signalling systems. Safety braking distance needed for passenger's safety is very important factor in block section division method. In this study, basic block section division program was developed with the differential ratio of braking distance resulted by grade value of the track. More complete block section division program is going to be developed by the help of experienced experts.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.27 no.1
• /
• pp.18-25
• /
• 2022

The cold staring issue of permanent magnet synchronous motors (PMSM) is a chronic problem in the field of PMSM sensorless drives. A traditional starting method, called the I-F method, is widely adopted because of its simple structure. However, when using this method, the pre-defined magnitude and frequency of the starting current should be changed according to the condition of the load and machine inertia. In this paper, a smart and simple algorithm for the cold starting of PMSM is proposed. In the proposed method, an integrated control angle from the estimated electrical rotor speed is used for vector control such as the indirect vector control of the induction machine. Thus, very stable cold starting is performed regardless of the machine load condition or inertia changing.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.7
• /
• pp.943-949
• /
• 2013

Recently, an electric vehicle (EV) has been become a huge issue in the automotive industry. The EV has many electrical units: electric motors, batteries, converters, etc. The DC distribution power system (DPS) is essential for the EV. The DC DPS offers many advantages. However, multiple loads in the DC DPS may affect the severe instability on the DC bus voltage. Therefore, a voltage bus conditioner (VBC) may use the DC DPS. The VBC is used to mitigate the voltage transient on the bus. Thus, a suitable control technique should be selected for the VBC. In this research, Current controller with fixed switching frequency is designed and applied for the VBC. The DC DPS consist of both a resistor load and a boost converter load. The load variations cause the instability of the DC DPS. This instability is mitigated by the VBC. The simulation results by Matlab simulink and experimental results are presented for validating the proposed VBC and designed control technique.

• Tribology and Lubricants
• /
• v.40 no.4
• /
• pp.111-117
• /
• 2024

Due to global CO₂ emission reductions and fuel efficiency regulations, the trend toward transitioning from internal combustion engine vehicles to electric vehicles (EVs) has accelerated. Consequently, the problem of EV failures has become a focal point of active research. The parasitic capacitance generated during motor-shaft rotation induces voltage that deteriorates the raceway and ball surfaces of bearings, causing electrical damage in EVs. Despite numerous attempts to address this issue, most studies have been conducted under high viscosity lubricant and low load conditions. However, due to factors such as high-speed operation, rapid acceleration and deceleration, motor heating, and motor system-decelerator integration, current EV applications have shown diminished stability in lubrication films of motor bearings, thereby leveraging the investigation to address the risk of electrical damage. This study investigates the electrical damage to rolling bearing elements in EV motor drive systems. The experimental analysis focuses on the effects of electric currents and operational loads on bearing integrity. A test rig is designed to generate high-rate voltage specific to a motor system's parasitic capacitance, and bearing samples are exposed to these currents for specified durations. Component evaluation involves visual inspections and vibration measurements. In addition, a predictive model for electrical failure is developed based on accumulated data, which demonstrates the ability to predict the likelihood of electrical failure relative to the duration and intensity of current exposure. This in turn reduces uncertainties in practical applications regarding electrical erosion modes.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.24 no.10
• /
• pp.733-738
• /
• 2012

It is important issue to reduce the electric energy to save the operating cost of HVAC system. Even if electrical energy is the clean energy, it is difficult and takes high cost for storage of electricity. These cause the high peak load of electric energy for HVAC in summer season. In korea, government impose the electric charge with several grade for the purpose of cut-off the peak load of electricity. Government has a policy to support to design and install the heat/ice storage system using midnight electricity. In this study, analysis of cooling load and operating characteristics for ice storage system are performed. And, also economical efficiency is compared between ordinary charge system of electricity and midnight rate charge of electricity. The systematic and economical supports are needed for expansion of usage of energy saving equipments.

• Proceedings of the KIEE Conference
• /
• 2003.07d
• /
• pp.2254-2258
• /
• 2003

In recent years, the case to install small water treatment facility to every local area has increased. A key issue in the successful implementation of the control systems for the water treatment plants is the choice of control architecture. Within the framework of distributed control system(DCS), this paper presents a new development of intelligent control module and its novel application to open control architecture for water treatment plants. This control system so called NCS(Network Based Control System) with standard networks system with LonTalks protocol of ANSI/EIA 709.1, regulatory control function and information dispatch function has suitable functionality to operate these distributed water treatment facility effectively. This paper describes the case where NCS is applied for the filters system in water treatment facility of Heong Sung area.