• Journal of the Korean Geosynthetics Society
• /
• v.20 no.4
• /
• pp.113-124
• /
• 2021

Underground environmental infrastructure and energy production facilities, which are recognized as avoidable facilities such as landfills, are emerging as an important social issue due to urbanization and economic growth. In order to safely construct a large-scale plant facility in the underground space, it is necessary to increase the utilization of the limited space layout and minimize unnecessary columns. In this study, the plant modularization method(Pipe Rack Module) was reviewed to solve the problems of work constraints, assembly and demolition, process system interconnection, and maintenance that occur when plant facilities are underground. In addition, plant module analysis was performed by applying various load conditions (earthquake load, device load, earth pressure load, etc.) to improve spatial layout usability and secure structure stability. Based on the analysis results under various boundary condition, the implications regarding the minimum installation interval and module arrangement (draft) of basic modules required for the construction of an underground combined plant were derived.

• Journal of Space Technology and Applications
• /
• v.2 no.2
• /
• pp.121-136
• /
• 2022

Automatic Identification System used in ship communication is required for marine control way, including monitoring of vessel operation in coastal and exchanging of information for safety navigation between them. But, it uses a very high frequency band of approximately 160 MHz, and at the same time, due to the curvature of Earth, there is a limit to the communication distance. Several demonstrations were made successfully over satellite, but not much work has been done yet through cube-satellite which has low-orbit at 500 km altitude. Here, we demonstrate a reception test of AIS (automatic identification system) receiver for a cube-satellites using software-defined radio (SDR). We collected AIS data from ship at port of Busan, Korea, using R8202T2 SDR and established to transmit them using Adam-Pluto and Matlab Simulink. The process of weakening the signal strength to a satellite was constructed using attenuator. Through above process, we demonstrated whether AIS data was successfully received from the AIS payload.

• Advances in aircraft and spacecraft science
• /
• v.9 no.5
• /
• pp.449-462
• /
• 2022

Space-telescopes placed in the Sun-Earth second Lagrange point (L2) observe the sky following a scan strategy that is usually based on a spin-precession motion. Knowing which regions of the sky will be more observed by the instrument is important for the science operations and the instrument calibration. Computing sky observation parameters numerically (discretizing time and the sky) can consume large amounts of time and computational resources, especially when high resolution isrequired.This problem becomesmore critical if quantities are evaluated at detector level instead of considering the instrument entire Field of View (FoV). In previous studies, the authors have derived analytic solutions for quantities that characterize the observation of each point in the sky in terms of observation time according to the scan strategy parameters and the instrument FoV. Analytic solutions allow to obtain results faster than using numerical methods as well as capture detailed characteristics which can be overseen due to discretization limitations. The original approach is based on the analytic expression of the instrument trace over the sky. Such equations are implicit and thusrequiresthe use of numeric solversto compute the quantities.In this work, a new and simpler approach for computing one ofsuch quantities(mean observation time) is presented.The quantity is first computed for pure spin motion and then the effect of the spin axis precession is incorporated under the assumption that the precession motion is slow compared to the spin motion.In this sense, this new approach further simplifies the analytic approach, sparing the use of numeric solvers, which reduces the complexity of the implementation and the computing time.

• Current Photovoltaic Research
• /
• v.11 no.3
• /
• pp.67-74
• /
• 2023

The earth-abundant element-based Cu₂ZnSn(S,Se)₄ (CZTSSe) thin film solar cells (TFSCs) have attracted greater attention in the photovoltaic (PV) community due to their rapid development in device power conversion efficiency (PCE) >13%. In the present work, we demonstrated the fine-tuning of the bandgap in the CZTSSe TFSCs by altering the sulfur (S) to the selenium (Se) chalcogenide ratio. To achieve this, the CZTSSe absorber layers are fabricated with different S/(S+Se) ratios from 0.02 to 0.08 of their weight percentage. Further compositional, morphological, and optoelectronic properties are studied using various characterization techniques. It is observed that the change in the S/(S+Se) ratios has minimal impact on the overall Cu/(Zn+Sn) composition ratio. In contrast, the S and Se content within the CZTSSe absorber layer gets altered with a change in the S/(S+Se) ratio. It also influences the overall absorber quality and gets worse at higher S/(S+Se). Furthermore, the device performance evaluated for similar CZTSSe TFSCs showed a linear increase and decrease in the open circuit voltage (V_oc) and short circuit current density (J_sc) of the device with an increasing S/(S+Se) ratio. The external quantum efficiency (EQE) measured also exhibited a linear blue shift in absorption edge, increasing the bandgap from 1.056 eV to 1.228 eV, respectively.

• The Bulletin of The Korean Astronomical Society
• /
• v.45 no.1
• /
• pp.45.2-46
• /
• 2020

Various processes, such as space weathering and granular convection, are occurring on asteroids' surfaces. Estimation of the surface exposure timescale is essential for understanding these processes. The Hayabusa mission target asteroid, (25143) Itokawa (Sq-type) is the only asteroid whose age is estimated from remote sensing observations as well as sample analyses in laboratories. There is, however, an unignorable discrepancy between the timescale derived from these different techniques. The ages estimated based on the solar flare track density and the weathered rim thickness of regolith samples range between 102 and 104 years [1][2]. On the contrary, the ages estimated from the crater size distributions and the spectra cover from 106 to 107 years [3][4]. It is important to notice that there is a common drawback of both age estimation methods. Since the evidence of regolith migration is found on the surface of Itokawa [5], the surficial particles would be rejuvenated by granular convection. At the same time, it is expected that the erasure of craters by regolith migration would affect the crater size distribution. We propose a new technique to estimate surface exposure age, focusing on the bright mottles on the large boulders. Our technique is less prone to the granular convection. These mottles are expected to be formed by impacts of mm to cm-sized interplanetary particles. Together with the well-known flux model of interplanetary dust particles (e.g., Grün, 1985 [6]), we have investigated the timescale to form such mottles before they become dark materials again by the space weathering. In this work, we used three AMICA (Asteroid Multi-band Imaging Camera) v-band images. These images were taken on 2005 November 12 during the close approach to the asteroid. As a result, we found the surface exposure timescales of these boulders are an order of 106 years. In this meeting, we will introduce our data analysis technique and evaluate the consistency among previous research for a better understanding of the evolution of this near-Earth asteroid.

• Korean Journal of Hazardous Materials
• /
• v.2 no.1
• /
• pp.12-17
• /
• 2014

With a rapid growth of domestic industry in korea, now about 25,000 kinds of chemicals are being distributed, and it has been known that just about 15% of them has toxic substances. Recently, South Koreans have an anxiety about the stability and accidents of chemicals because chemical accidents like Gumi hydrofluoric acid accident have occurred. The U.S. has adopted the systems like EPCRA (Emergency Planning and Community Right-to-Know Act), TRI (Toxic Release Inventory) and TSCA (Toxic Substances Control Act), and is also managing the hazardous chemicals by providing the information about them to its people and site workers. Japan's Ministry of Health, Labor and Welfare also has adopted J-CHECK system and is implementing it to let Japanese people know the information of safety of chemicals about REACH. However, the Korean government has a difficult situation to mediate the different idea with the Korean industry to make lower statute of Pre-legislation registration & evaluation of chemicals that will be implemented and Chemical Material Control Association that is being implemented. Especially city and country areas located in the industrial areas need political improvement focusing on vulnerable area through the check about current situation of hazardous chemicals of jurisdiction and management method, but the information about the management situation of small scale work places is insufficient. Therefore this study set up the urgent management area in Ansan Smart Hub through NFPA code according to the types of accident and dander characteristics of each chemical being used in the companies that have less than 50 workers and deal with chemicals located in Ansan Smart Hub in Gyeonggi-do.

• Journal of The Geomorphological Association of Korea
• /
• v.18 no.3
• /
• pp.121-129
• /
• 2011

This work is to elucidate in typological aspect main geomorphological processes in the morphogenetic system of Mongolian steppe zone. Its morphogenesis manifest interaction of intense gelifraction and active erosion either by slope run-off or by wind. Intense gelifraction owes both to cold temperature regime with great amplitude, and to moisture associated with snow fall. Erosion of material produced by gelifraction is assured by surface run-off of summer rainfall and spring eolian activities. The geomorphological landscape sculptured by such morphogenetic processes manifest low-relief smooth slopes. This feature reveals that intense gelifraction keeps abreast with removal of weathering product by surface run-off and wind.

• Korean Journal of Materials Research
• /
• v.33 no.10
• /
• pp.377-384
• /
• 2023

Exploring earth-abundant, highly effective and stable electrocatalysts for electrochemical water splitting is urgent and essential to the development of hydrogen (H₂) energy technology. Iron-cobalt layered double hydroxide (FeCo-LDH) has been widely used as an electrocatalystfor OER due to its facile synthesis, tunable components, and low cost. However, LDH synthesized by the traditional hydrothermal method tends to easily agglomerate, resulting in an unstable structure that can change or dissolve in an alkaline solution. Therefore, studying the real active phase is highly significant in the design of electrochemical electrode materials. Here, metal-organic frameworks (MOFs) are used as template precursors to derive FeCo-LDH from different iron sources. Iron salts with different anions have a significant impact on the morphology and charge transfer properties of the resulting materials. FeCo-LDH synthesized from iron sulfate solution (FeCo-LDH-SO₄) exhibits a hybrid structure of nanosheets and nanowires, quite different from other electrocatalysts that were synthesized from iron chloride and iron nitrate solutions. The final FeCo-LDH-SO₄ had an overpotential of 247 mV with a low Tafel-slope of 60.6 mV dec^-1 at a current density of 10 mA cm^-2 and delivered a long-term stability of 40 h for the OER. This work provides an innovative and feasible strategy to construct efficient electrocatalysts.

• The Journal of the Convergence on Culture Technology
• /
• v.10 no.1
• /
• pp.559-563
• /
• 2024

Currently, in Korea, large-scale, deep excavations are being carried out adjacent to structures due to overcrowding in urban areas. for adjacent excavations in urban areas, it is very important to ensure the safety of earth retaining structures and underground structures. accordingly, an automated measurement system is being introduced to manage the safety of subway tunnel structures. however, the utilization of automated measurement system results is very low. existing evaluation techniques rely only on the maximum value of measured data, which can overestimate abnormal behavior. accordingly, in this study, a vast amount of automated measurement data was analyzed using the Gaussian probability density function, a technique that can quantitatively evaluate. highly reliable results were derived by applying probabilistic statistical analysis methods to a vast amount of data. therefore, in this study, the safety evaluation of subway tunnel structures due to adjacent excavation work was performed using a technique that can process a large amount of data.

• Journal of Science Education
• /
• v.32 no.2
• /
• pp.1-16
• /
• 2008

The purpose of this study was to analyze about STS contents in the next generation science textbook for 10th grade according to curriculum revision 2007 and high school science textbooks focused on the Earth Science which were published according to the 7th curriculum. The contents of STS were analyzed by the STS topics of Yager(1989), Piel's standard(1981), and student activities by SATIS. The results of this study are the same as follows: 'The next generation science textbook' was shown that 20.9% is STS material amount in average by Yager's standard. 'High school science textbooks' were shown that 11.3% is STS material amount in average. Based on the STS topics by Yager's standard, most of STS content is focused on 'Relativity with local community', 'Application of science' and 'Cooperative work on real problems'. However, there is rare contents such as 'Multiple dimensions of science', 'Practice with decision-making strategies' and 'Evaluation concerned for getting and using information' in the next generation science textbook. In high school science textbooks were shown that 'Applicability of science' is the highest and 'Relativity with local community' is the next high contents. Based on the STS topics by Piel's standard, most of STS contents are focused on 'Environmental quality', 'Space research' and 'National defence' in the next generation science textbook. But high school science textbooks are focused on 'Natural resources' and 'Technology development'. The activities were analyzed by SATIS student activities. The major categories of activities included in the next generation science textbook were 'Investigation', 'Simulation' and 'Data analysis'. But, there were rare activities like 'Roleplaying', 'Research design' and 'Simulation' in high school science textbooks.