• Journal of Electrical Engineering and Technology
• /
• 제9권5호
• /
• pp.1614-1622
• /
• 2014

A novel equivalent flux sliding-mode observer (SMO) is proposed for dual three-phase interior permanent magnet synchronous motor (DT-IPMSM) drive system in this paper. The DT-IPMSM has two sets of Y-connected stator three-phase windings spatially shifted by 30 electrical degrees. In this method, the sensorless drive system employs a flux SMO with soft phase-locked loop method for rotor speed and position estimation, not only are low-pass filter and phase compensation module eliminated, but also estimation accuracy is improved. Meanwhile, to get the regulator parameters of current control, the inner current loop is realized using a decoupling and diagonal internal model control algorithm. Experiment results of 2MW-level DT-IPMSM drives system show that the proposed method has good dynamic and static performances.

• ETRI Journal
• /
• 제19권2호
• /
• pp.35-47
• /
• 1997

A power amplifier operating at 3.3 V has been developed for CDMA/AMPS dual-mode cellular phones. It consists of linear GaAs power MESFET's, a new gate bias control circuit, and an output matching circuit which prevents the drain terminal of the second MESF from generating the harmonics. The relationship between the intermodulation distortion and the spectral regrowth of the power amplifier has been investigated with gate bias by using the two-tone test method and the adjacent channel leakage power ratio (ACPR) method of CDMA signals. The dissipation power of the power amplifier with a gate bias control circuit is minimized to below 1000 mW in the range of the low power levels while satisfying the ACPR of less than -26 dBc for CDMA mode. The ACPR of the power amplifier is measured to be -33 dBc at a high output power of 26 dBm.

• 전자공학회논문지
• /
• 제53권10호
• /
• pp.40-47
• /
• 2016

본 논문에서는 휴대기기에 적합한 모드 전환 제어 가능한 듀얼 모드 벅 변환기를 제안한다. 기존의 모드 제어 회로는 부하의 변동이 급격하거나 천천히 변동하거나 둘 중 하나의 조건에서만 모드 전환이 이루어지는 문제점을 슬로우 클럭을 이용한 모드 제어 회로 기법으로 해결하였다. 그리고 PFM(Pulse Frequency Modulation) 모드에서 PWM(Pulse Width Modulation) 벅 변환기로 전환할 때에도 카운터를 사용하여 고부하를 감지할 수 있도록 하였으며 3비트의 디지털 신호로 20mA~90mA내에서 모드 전환 시점을 선택할 수 있도록 설계하였다. 이 회로는 BCDMOS 0.18um 2-poly 3-metal 공정으로 제작되었으며, 측정 결과 입력전압 3.7V, 출력전압 1.2V 부하 전류 10uA~500mA 범위에서 32mV 이하의 출력 전압 리플을 가지며 86%의 최대 전력 변환 효율을 나타내었다.

• 전기학회논문지
• /
• 제67권4호
• /
• pp.531-537
• /
• 2018

This paper propose a bidirectional dc-to-dc converter employing dual inductor for current ripple reduction. Conventional bidirectional dc-to-dc converter uses a single inductor for two different modes; boost and buck; therefore it is difficult to satisfy the optimized inductance value for each mode. To improve this problem, the proposed converter adds two switches, a diode, and one inductor. By proper switching of the additional switch, the proposed converter operates with a inductor in boost mode, but it works with dual inductor in buck mode. Hence in both modes the proposed bidirectional converter can be operated with optimized inductance values. Most of all the optimized inductance in buck mode can reduce the current ripple and its effective value(rms), which are directly related to the temperature increase resulted in short lifetime of battery. To verify the validity of the proposed approach, we first analyzes the operation of the proposed converter theoretically, and implement computer-aided simulations and experiments using a prototype.

• 제어로봇시스템학회논문지
• /
• 제14권1호
• /
• pp.7-12
• /
• 2008

A GNSS(Global Navigation Satellite System) using GPS provides us with very useful information concerning the positioning of users in many sectors such as transportation, social services, the justice system and customs services, public works, search and rescue systems and leisure. A GNSS using the Galileo satellite is due to work in 2008 and expected to be used in various fields such as aviation, marine transportation, land surveying, resources development precise agriculture, telemetics, and so on. In this paper, we discuss the implementation and testing of a combined GPS/Galileo receiver which we named KSTAR V1.0. Each tracking module of GPS/Galileo dual mode correlator has the five track arms which consist of Very Early code, Early code, Prompt code, late code, and Very late code. Each of 24 tracking modules can be assigned to GPS and/or Galileo signal by changing mode selection register. The basic correlator integration dump period is set to 1ms for GPS C/A code and fast Galileo signal tracking. The performance of the developed combined GPS/Galileo receiver was tested and evaluated using the IF (Intermediated Frequency)-level GPS/Galileo signal generator.

• 전력전자학회논문지
• /
• 제20권6호
• /
• pp.573-579
• /
• 2015

A control algorithm of thyristor dual converter power system is proposed in this study for a railway power substation. The thyristor dual converter can use regenerative power without an additional system using control algorithm. An autonomous voltage and mode change method is also proposed to provide uninterrupted power to the railway. A 10 kW reduced model of the thyristor dual converter power system is built and tested to verify the validity of the proposed control algorithm.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2015년도 추계학술대회
• /
• pp.465-467
• /
• 2015

본 논문에서는 환경센서를 기반으로 한 스마트폰 연동형 듀얼모드 전원 스트립 제어기를 구현한다. 화재현황통계에 따르면 주거시설의 미확인 전기사고화재가 23.4%를 차지하고 있다. 사용자 부주의로 발생하는 이러한 화재사고를 줄이고 인명과 재산을 보호하기 위해서는 사용자의 편의성을 높인 스마트한 전원제어기술이 필요하다. 이를 위해 논문에서 구현한 듀얼모드 전원 스트립 제어기는 온도, 조도, 습도센서와 같은 환경센서로부터 수집된 데이터를 기반으로 사용자의 스마트폰과 연동하여 전원 스트립의 ON-OFF 동작을 두 가지 방식(수동모드/자동모드)으로 제어한다. 수동모드는 사용자가 스마트폰에 표시된 환경센서 데이터를 보고 강제적으로 전원 스트립의 ON-OFF 동작을 제어하고, 자동모드는 사용자가 미리 설정해 둔 임계치(threshold)를 환경센서 데이터가 벗어날 경우 자동으로 전원 스트립의 ON-OFF 동작을 제어한다. 실험실 테스트를 통해 전원 스트립 제어기의 듀얼모드가 성공적으로 동작함을 확인하였다.

• Journal of Power Electronics
• /
• 제14권6호
• /
• pp.1217-1223
• /
• 2014

A novel half load-cycle worked dual input single output (DISO) DC/AC inverter is presented. The basic circuit consists of a dual buck regulator, which works in continuous current mode. The working principle of DISO DC/AC inverter has been used. The control method applied for half load-cycle worked DISO DC/AC inverter has been studied. The control effects of the open-loop proportional control and closed-loop proportional-integral control are compared by using PSIM software. The parameters are adopted in the realistic simulation and experiment test. Moreover, the waveforms, such as voltage of modulation reference signal and output voltage, were given. The simulation and experiment results proved that the half load-cycle worked DISO DC/AC inverter could achieve good performance, gain a line frequency of 50 Hz, and verify the correctness of theoretical analysis.

• 전기학회논문지
• /
• 제66권9호
• /
• pp.1437-1443
• /
• 2017

Electric energy is consumed or regenerated according to an operation of electric rail cars in urban railway power substations. A thyristor dual converter system is used to deal with the electric energy. Since the AC input voltage of power substations is $22.9kV{\pm}10%$, the magnitude of the AC voltage fluctuates according to load conditions, so the secondary side voltage of the DDY transformer also fluctuates. In the thyristor dual converter, the response characteristics of the DC output voltage and the DC output current are changed based on an initial firing angle in the cross mode conversion between the forward mode and the reverse mode. Therefore, this paper proposes the initial firing angle tracking algorithm considering fluctuation of the AC input voltage. The effectiveness of the proposed algorithm is verified by a simulation compared with the conventional algorithm.

• 전기전자학회논문지
• /
• 제14권1호
• /
• pp.40-46
• /
• 2010

This paper describes a clock and data recovery (CDR) circuit that supports dual data rates of 2.7Gbps and 1.62Gbps for DisplayPort standard. The proposed CDR has a dual mode voltage-controlled oscillator (VCO) that changes the operating frequency with a "Mode" switch control. The chip has been implemented using $0.18{\mu}m$ CMOS process. Measured results show the circuit exhibits peak-to-peak jitters of 37ps(@2.7Gbps) and 27ps(@1.62Gbps) in the recovered data. The power dissipation is 80mW at 2.7Gbps rate from a 1.8V supply.