• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.05a
• /
• pp.479-482
• /
• 2007

This paper presents experimental analysis of a friction-driven wheel responsible for generating wheel squeal. Creep and squeal noise generating mechanism are influenced by friction conditions of attack angle, loading force, driving velocity and surface roughness. Squeal noise phenomena has been examined under the laboratory condition by the model rig. Creep characteristics and squeal noise were observed by varying relative velocity of the wheel with respect to the rail and friction coefficient.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.517-520
• /
• 2008

A voltage-programming pixel circuit, which compensates the threshold voltage shift of TFTs and the degradation of OLED, is proposed for large sized a-Si:H active matrix organic light emitting diode (AMOLED) applications. Considering threshold voltage variation (or shift), OLED degradation and reverse bias annealing, HSPICE simulation results indicate that luminance error of every gray level is less than 0.4 LSB under the condition of +1V threshold voltage shift and from -0.2 LSB to 2.6 LSB within 30% degradation of OLED in the case of 40-inch full HDTV condition.

• International Journal of Safety
• /
• v.5 no.1
• /
• pp.17-23
• /
• 2006

An investigation was carried out to determine the effect of the thickness of the air-gap installed between the roof metal sheet and the headliner on booming noise in passenger cars. In addition, a way of offering quieter driving condition to drivers and passengers was studied. It was found that a very thin air-gap corresponding to approximately 3/100 of the height of the passenger compartment causes noticeable change in the coupled resonance frequencies and acoustic responses. Furthermore, a guideline is proposed for determining an optimal air-gap thickness during design stage of the air-gap beneath the roof metal sheet for reducing booming noise.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.10 no.2
• /
• pp.12-20
• /
• 2007

The aiming ability is a key to improve the accuracy performance of the gun pointing system in the ground military vehicle. This paper describes the new detection method of chatter vibration using disturbance acceleration in the pointing structure. In order to analysis the vibration trends of the pointing system occurred while the vehicle driving, acceleration data obtained from vehicle was processed by using data processing algorithm with moving average and Hilbert transform. The specific mode constants of acceleration were obtained from various disturbances. Vehicle velocity, road condition and property of pointing structure were considered as factors which make the change of vibration trend in vehicle dynamics. Finally, back propagation neural networks have been applied to the pattern recognition of the classification of vibration signal in various driving conditions. Results of signal processing were compared with other condition result and analysed.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.25 no.3
• /
• pp.28-33
• /
• 2002

Several studies indicated that an independent visual background (IVB) reduced simulator sickness (SS) and balance disturbance associated with exposure to virtual environments (VEs) and motion simulators. A recent study showed that an IVB comprised of an earth-fixed grid was less effective in a complex driving simulator than in a simple VE. Subjects' post-experiment reports indicated that the VE motion "induced" motion of the earth-fixed grid m. This led to the suggestion that an IVB comprised of clouds would be less subject to induced motion and therefore would alleviate nausea more effectively than a grid IVB. Clouds are "natural" and are usually perceived as relatively stable, whereas a grid has no inherent stability. 12 subjects were exposed to complex motion through a simulated environment in a driving simulator under 3 IVB conditions: grid, less clouds, many clouds. They reported less nausea when the many-cloud IVB was used relative to the grid IVB condition. grid IVB condition.

• Journal of the Korean Society of Safety
• /
• v.8 no.4
• /
• pp.3-15
• /
• 1993

A multi-cylinder four cycle spark ignition engine equipped with on exhaust gas recirculation(EGR) system to reduce nitric oxide emission and to improve fuel consumption rate has been comprehensively simulated In a computer program including intake and exhaust manifolds. To achieve these goals, this program was tested against experiments performed on a standard production four cylinder four cycle gasoline engine with EGR system. As EGR rate Increased, the maximum temperature of combustion chamber and NO omission concentration decreased under each driving condition. But the emission concentration of CO didn't change much through whole district in spite of the increase of EGR rate. Fuel consumption rate improved under each driving condition according to the increased of EGR rate until 10 percent EGR rate. Therefore the degree of EGR depend not only on the NO emission but also on the economy and the engine performance criteria of the engine.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2001.11b
• /
• pp.861-865
• /
• 2001

Generally the noise and vibration characteristics of 4WD vehicle is closely related to the characteristics of driveline such as bending mode, torsional mode, unbalance and nonuniformity of propeller shaft. In this paper the 4WD vehicle which has body vibration problem in high speed driving condition was tested. The sources of the body vibration and its transfer path are investigated by experimental approach. According to the experimental assessment, the body vibration is caused by the nonuniformity of joint of propeller shaft. And this paper presents a kinematic model of a vehicle driveline for the optimization of a driveline characteristics. Finally the optimized result of the drive line has been verified through the experiment.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.1
• /
• pp.148-156
• /
• 2014

The objective of this study is to compare NOx emissions from light duty diesel vehicles measured from on-road tests that conducted under various driving routes and seasonal conditions. We measured real-driving NOx emissions using PEMS, portable emissions measurement system, under the urban, rural and motorway road traffic conditions. On-road tests were repeated at summer, fall and winter season. The accumulated driving distance is more than 1,200 km per each vehicle. Route average NOx emission factors were compared among nine route-season combinations. The emission characteristics of each combinations were investigated using time series mass emission rates and vehicle operation-based emission rates and activities, which is based on U.S. EPA's MOVES model. Most concerned route-season combination is "urban road condition at summer", which shows two to eleven times higher NOx emissions than other combinations. The emission rates and activities under low speed operating conditions should be managed in order to reduce urban-summer NOx. From a NOx control strategy perspective, the exhaust gas recirculation, EGR, is observed to be properly operated under wide range of vehicle driving conditions in Euro-5 vehicles, even if the air conditioner turns on. In high power demanding conditions, the effect of overspeeding could be more critical than that of air conditioner activation.

• Journal of Korean Society of Transportation
• /
• v.26 no.5
• /
• pp.195-204
• /
• 2008

When the drivers try to read an information on road signs, they can reach their destinations successfully. In this situation, human factors, road signs and geometric condition regarded as the most important factors for a safe driving should be a well-balanced relationship mutually. This research aims to prove the factors obstructing a safe driving, while drivers try to read an information on road signs for the next destination. For this sake, driving simulator was used and human factors, road signs etc. were considered in this experiment. The statistical analysis indicated what factors disturb a safe driving. The probability function using a Logistic Model was presented in this study. This result and experience will be used as a basic data in designing better road signs.

• Proceedings of the Optical Society of Korea Conference
• /
• 1996.09a
• /
• pp.103-103
• /
• 1996