• Steel and Composite Structures
• /
• v.50 no.4
• /
• pp.419-428
• /
• 2024

Prefabricated partially-encased composite (PEC) structural component is widely used in construction industry due to its superior structural performance and easy assembly characteristic. However, the solid web in traditional PEC components tends to split concrete into two halves, thus potentially reduces structural integrity and requires double concrete pouring. To overcome the above disadvantages, a new PEC beam with open-web π-shaped steel is proposed in this paper. Four open-web PEC beams with varying sectional height, flange thickness and web void rate were constructed and tested under flexural loads. During experimental tests, all beams exhibited typical flexural failure modes with strong moment capacities and excellent ductility. Owing to the unique construction form of web opening, steel-concrete bonding properties were enhanced and very small relative steel-concrete slips were observed. Experimental results also showed that the flexural capacity of such PEC beams increased with the increase of the sectional height and flange thickness, while was not affected by the web void rate. At last, a flexural capacity formula of the open-web PEC beam was proposed based on the whole section plastic rule. The formula results agreed well with experimental results.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.12
• /
• pp.6447-6454
• /
• 2013

Seawater intake systems have significant problems due to seawater pollution, suspended solids, unstable intake and maintenance etc. An underground type seawater intake system was newly developed to overcome the existing weaknesses and was facilitated in Gyukpo port. In this study, to check the performance of the new system, the samples for water quality and the 3-D numerical modeling test were conducted. The five times test included the COD, total nitrogen, total phosphorus, pH, and suspended solid for the intake system. The analyses show that the COD, total nitrogen, total phosphorus, PH showedminor changes before and after. On the other hand, the change in suspended solids was significant and water was purified below 5 mg/l, first level fisheries water, after. The numerical model adopted the RNG $k-{\epsilon}$ algorithm and the CFX model based on the finite volume method. The porosity algorithm was used to reproduce filtered-sand, outer diameter, and thickness. The numerical results showed that the double pipe is advantageous in that it provides a uniform pressure between the inner and outer pipe for the flow to be stable. In addition, the use of multiple intake pipes did not interfere with the discharge reduction of 0.98 at the both intake pipes compared with the central intake pipe.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.233-233
• /
• 2017

Algal communities are important to maintain the aquatic ecosystems function. Algae have short life cycles, they respond quickly to environmental change and their diversity and density can indicate and the quality of their habitat. The bloom forms before the rice seedings have emerged, it may present a physical barrier that prevents the seedlings from penetrating the floodwater. Wind may also move the algal bloom, pushing the young plants beneath the surface. Another harmful action develops when the water dries up and the algae form a layer at the bottom of the field. The layer envelops the seedlings, which are not yet deeply rooted, and drag them to the surface when the water is let in again. Soil utilization pattern can be the mail facter affecting soil physico-chemical properties, especially in soil phosphorus (P). Solid content of the algae culture solution increased with the increase in the nitrogen rather the phosphors concentration. Phosphoric acid was treated with conventional treatments (100-0%, before transplanting time-tillering stage), 50-50%, 0-100%, and un-treated. The herbicide was treated on the 7 DAT (day after transplanting). Green algae samples were collected 20 DAT. Total phosphoric acid was the highest at 0.06 in 50-50% treatment in 20 DAT. The amount of green algae was about twice (9.8 mg/20ml) that of un-treated. Total number of green algae was 54 species(Green algae 35 species, Euglena 9 species, Stone wheel 10 species). Among the phosphoric acid treatment methods, the number of occurrences of green algae were the highest with 39 species in 0-100%, followed by 50-50%, 28 species, conventional treatments, 22 species, non-treatment, 18 species, respectively. Rice Yield was not significantly different by phosphoric treatment time, but slightly higher than un-treated. The maximal algal biomass was observed about 2weeks or 1 month after transplanting; the subsequent decrease of the biomass was related to the consumption by grazers and to a deficient light under the rice canopy. Maximal algal growth was observed just before tillering. To estimate the suitable method of phosphorus application in puddled-soil drill seeding of rice, available phosphorus appearance of algal water bloom, and rice yield were investigated in paddy soil of rice-barley double cropping system.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.3
• /
• pp.240-244
• /
• 2007

We investigated the diffraction grating efficiency by the Diode Pumped Solid State(DPSS 532 nm) laser beam wavelength to improve the diffraction efficiency on $As_{40}Ge_{10}Se_{15}S_{35},\;Ag/As_{40}Ge_{10}Se_{15}S_{35}$ and $As_{40}Ge_{10}Se_{15}S_{35}/Ag/As_{40}Ge_{10}Se_{15}S_{35}$ thin film. Diffraction efficiency was obtained from DPSS laser, used (P:P)polarized laser beam on each thin films. As a result, for the laser beam intensity in $0.24mW/cm^2$, single $As_{40}Ge_{10}Se_{15}S_{35}$ thin film shows the highest value of 0.161% diffraction efficiency at 300 s and for laser beam intensity in $2.4mW/cm^2$, it was recorded with the fastest speed of 50 s(0.013%), which the diffraction grating forming speed is faster than that of $0.24mW/cm^2$ beam. $Ag/As_{40}Ge_{10}Se_{15}S_{35}$ double layer and $As_{40}Ge_{10}Se_{15}S_{35}/Ag/As_{40}Ge_{10}Se_{15}S_{35}$ multi-layered thin film also show the faster grating forming speed at $2.4mW/cm^2$ and higher value of diffraction efficiency at $0.24mW/cm^2$.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.9
• /
• pp.876-880
• /
• 2015

In 2016, the IMO's new rules for an 80% reduction in NOx emissions in newly built ships will necessitate the use of LNG as a clean fuel. So far, the developed European countries have led the development of LNG bunkering ships and related facilities. An LNG bunkering system stores LNG in a horizontal or vertical IMO "C"-Type tank insulated with perlite powder, and a vacuum in the annular space between the double walls, like the cryogenic liquid nitrogen tank. Current storage tanks have high heat leakage, evaporating over 2.0% daily, and are difficult to build with the required vacuum. A more efficiently insulated storage tank could reduce the evaporation rate. This research carried out thermal analysis on a new effective insulation method that separates high vacuum in the annular space between two tanks with a solid insulation material, such as urethane foam, lining the outer vessel. This highly efficient insulation system obtained an evaporation rate of 0.03% per day under a $10^{-3}torr$ vacuum, and an evaporation rate of 0.11% at $10^{-45}torr$. Even if the space loses its vacuum, the new insulation system showed a lower evaporation rate of 4.12% than the present perlite system of 4.9%. This newly developed tank can increase the efficiency of LNG storage tank and may help keep LNG bunkering systems safe.

• Resources Recycling
• /
• v.30 no.1
• /
• pp.44-52
• /
• 2021

This study investigated the effect of the type of alkaline precipitant used on the synthesis of lithium hydroxide by examining the behavior of lithium hydroxide produced using lithium sulfate recovered from a waste lithium secondary battery as a raw material. The double-replacement reaction (DRR) process was used to remove the impurities contained in the lithium salt precursor of lithium sulfate and to improve the efficiency of the synthesis of lithium hydroxide. The experiment was conducted by control the molar ratio of the precursor ([Li]/[OH]), the reaction temperature, and the composition of the alkaline precipitant (KOH, Ca(OH)2, Ba(OH)2) used for the production of highly-crystalline lithium hydroxide. A secondary solid-liquid separation was performed following the reaction to remove the impurities generated, and the purified aqueous solution of lithium hydroxide was evaporated to remove the moisture and obtain the product as a powder. The crystallinity and synthesis behavior of the product were examined.

• Parasites, Hosts and Diseases
• /
• v.22 no.1
• /
• pp.85-95
• /
• 1984

This study was performed to investigate the intestinal parasites (especially cestoda) in the guts of Theragra chalcogramma in Korea. The cestode larvae collected were morphologically observed and measured, and at the same time, microscopical study was done with the section slides of the cestode larvae. They were identified on the basis of the descriptions by Schmidt and Yamaguti. The results obtained in this study are as follows: 1. The cestode larvae were identified as Khawia sinesis, Eulacistorhynchus chiloscyllius, Tentacularia coryphaenga, Pssudonybelinia odontasantha and Nybelinia Zingualis. These are new species reported in Korea. 2. The characteristics of Khawia sinesis are its scolex lacking loculi and broad, fat and fimbriate shape. Its neck is not separated from the body but a little constricted. 3. Eulacistorhynchus chiloscyzzius is characterized by fairly long and acraspedote scolex. The bulbs are long; retractor muscles are attached to bases of the bulbs. The two bothridia are oval or round in shape and lacking posterior notch. The tentacles are long and poeciloacanthus; double chainette present. 4. Tentacularia coryphaenea is characterized by its long craspedote and subcylindrical scolex. The bothridia are separated, without free borders and spinous. The tentacles are short, slender, armed with solid hooks in spirals, similar except the base of tentacle. The tentacle sheaths are not twisted. The bulbs are ellipsoidal. 5. Pseudonybelinia odontacantha is characterized by its craspedote scolex. The tentacles are inserted near anterior margin of bothridia and armed with hooks in spirals ascending left to right. The hooks are similar, throughout tentacle, with feeble curve and provided with a tooth-like protuberance on the ventral side. The bulbs are three times longer than its width. The posterior margins of bothridia have a pair of eversible ciliated pits; or fossettes. 6. Nybelinia lingualis is characterized by its short and craspedote scolex. The bothridia are separated, with free boarders. The tentacles are cylindrical, armed with solid and similar hooks in quincunxes.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.35 no.1
• /
• pp.21-26
• /
• 2002

The behavior of the biological water treatment process on start-up operation was evaluated in the integrated recirculating aquaculture system consisting of a double drain type rearing tank ($2.5 m^3$), a sedimentation tank, a floating bead filter, a foam separator and a rotating biological contactor. A system was stocked with nile tilapia (Oreochromis niloticus) at an initial rearing density of $2\%$ for 2 weeks for acclimated rotating biological contactor. The total ammonia nitrogen (TAN) level increased to $13.6 g/m^3$ on day 4 after adding feed and was decreased to $0.3 g/m^3$ on day 7. The total suspended solid was completely removed during overall experimental period.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.35 no.1
• /
• pp.27-34
• /
• 2002

The performances of fish culture were evaluated in the integrated recirculating aquaculture system consisting of a double drain type rearing tank ($2.5 m^3$), a sedimentation tank, a floating bead filter, a foam separator and a rotating biological contactor. A system was stocked with nile tilapia at an initial rearing densities of $5\%$ (A), $5\%$ (B) and $7\%$ (C) oyer 30 days. Feed coefficient was 1.62, 1,79 and 1.80 and average daily growth rate was $0.452\%$, 0.u5% and $0.423\%$, respectively. The level of TAN was maintained below $1 g/m^3$ for $5\%$ of initial rearing density and $2-4 g/m^3$ for $7\%$. The dissolved oxygen level ($2-4 g/m^3$) was not optimum but should not be inhibitory to fish growth. The total suspended solid was completely removed during overall experimental period.

• Korean Chemical Engineering Research
• /
• v.53 no.6
• /
• pp.672-676
• /
• 2015

Spherical phospholipid bilayers, vesicles, were formed with respect to phase of each layer via a double emulsion technique. The conversion of phosphatidylcholine (PC) to phosphatidic acid (PA) at the outer layer, caused by phospholipase D (PLD), induced a curvature change in the vesicles, which eventually led them to fuse each other. The effect of the lipid layer physical-properties on the PLD-induced vesicle fusion was investigated using the fluorescence intensity change. 8-Aminonaphthalene-1,3,6-trisulfonic acid disodium salt(ANTS) and p-Xylene-bis(N-pyridinium bromide)(DPX) were encapsulated in the vesicles, respectively, for the quantification of the fusion. The fluorescence scale was calibrated with the fluorescence of a 1/1 mixture of ANTS and DPX vesicles in NaCl buffer taken as 100% fluorescence (0% fusion) and the vesicles containing both ANTS and DPX as 0% fluorescence (100% fusion), considering the leakage into the medium studied directly in a separate experiment using vesicles containing both ANTS and DPX. It was observed that the fusion occurred to the liquid-phase of the inner layer only. The fusion behaviors were very similar for both solid and liquid of the outer layer. However, the leakage was faster for the solid-phase outer-layer than the liquid-phase outer-layer. The difference in the leakage seems to be caused by the lipid concentration and the lateral diffusivity in the layer.