• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.12
• /
• pp.1310-1315
• /
• 2006

This study examines algae removal and reduction using ultrasonic. Experiments were carried out on frequency: 28 kHz single-wave, 40 kHz multi-wave; intensity: 10, 15, 20, 25, 30 W/L; algae concentration: 500, 1000, 1700/ml; exposure time: 1, 3, 5, 7, 10, 15, 20 min. Also, We investigated algae removal and reduction in single cistern where raw water including algae was directly exposed to ultrasonic and in the double cisterns located in 4 cm from ultrasonic vibrator. The algae type used in this study was Melosira genus of Bacillariophceae. The Bacillariophceae is the representative algae which causes blockage of filter basin. Because of its resistance against oxidizers, it flows into the filter basin after sterilization. As a result of this study, the form of Bacillariophceae was completely destroyed and dissolved after the application of ultrasonic waves unlike the sterilization using oxidizers. Removal efficiency of algae using ultrasonic waves increased in proportion to intensity and exposure time of ultrasonic waves, and in double cisterns is better than single cistern.

• Journal of Conservation Science
• /
• v.36 no.2
• /
• pp.103-111
• /
• 2020

To compare the cleaning effect of solvents such as water and ethanol used to clean lacquer relics, the components extracted with various solvents were analyzed. A freshly dried lacquer sample and a lacquer sample exposed to ultraviolet radiation for 24 days were treated with water, ethanol, acetone, and hexane, and the dissolved material was detected by pyrolysis-gas chromatography-mass spectrometry. The amount extracted was significantly higher in acetone and ethanol than in hexane, a nonpolar solvent. Water, a highly polar solvent, was relatively efficient for extracting low-molecular-weight materials. After experiencing 24 days of ultraviolet radiation, the lacquer exhibited a significant increase of extracted materials compared with the nonexposed one. This may be due to the degradation of the urushiol chain in the form of polymers, resulting in the formation of low-molecular-weight polar substances, including dicarboxylic acids. In addition to the deterioration status of lacquer relics, such solvent extraction properties will be a crucial consideration in selecting the appropriate cleaning solvent.

• Journal of the Korean Applied Science and Technology
• /
• v.21 no.2
• /
• pp.117-123
• /
• 2004

According to increase of using quantity, people interested in the environmental influence by synthetic detergent. The main visible form when synthetic detergent dissolved in water is generating foams. This foam makes coating over water surface and prevents oxygen penetrating in water and make water more polluted with that result. To analyze, components and origins of the foam, and to make clear its environmental influence in this study. The analyzing objects are introducing water of sewage treatment plant from the a tributary to the Han River. After analysis, reached the conclusion like below, Analyzing foams and introducing water by sublation method, average return rate of standard LAS (1.0ppm) is 90%. LAS contents of foams analyzed by UV photometric method and HPLC method are 35.0ppm and 44.5ppm each, and AOS contents of foams analyzed by the same method are 0.6ppm and 0.4ppm each. We can find out by this study's analyzing results that the main components of foams are anion surfactant, it's content and in case of capric acid linoleic acid, it's contents.

• Proceedings of the KOSOMBE Conference
• /
• v.1997 no.05
• /
• pp.447-450
• /
• 1997

A new technique for the preparation of porous vascular prostheses was investigated. Polyurethane solution (10 to 14wt%) was injected into a mold. After freezing at low temperature $(0^{\circ}C\sim-40^{\circ}C)$, solvent was dissolved out with water at $0^{\circ}C$ to form porous tubes. The average pore size $(<10{\mu}m)$and pore occupation (10% to 51%) were easily changed by changing polyurethane concentration, freezing temperature, and freezing methods. This technique can give a proper pore size $(30\sim60{\mu}m)$ for tissue ingrowth, and suitable compliances for matching with arteries and veins. This method might give a desired compliant graft for artificial implantation with the presently valid medical polymers.

• Journal of Ginseng Research
• /
• v.24 no.1
• /
• pp.23-28
• /
• 2000

To develop a dry alcohol containing red ginseng extract, dry alcohols composed of ethanol, water, dextrin and sodium lauryl sulfate were prepared using spray dryer, and their ethanol contents and encapsulation efficiencies were determined. An optimal dry alcohol containing red ginseng extract was chosen and the feeling for its oral administration was evaluated. Dextrin at dextrin/water weight ratios below 1.6/l and ethanol at ethanol/water weight ratios below 1/1 remarkably Increased both the ethanol contents and encapsulation efficiencies of dry alcohols. However dextrin at dextrin/water weight ratios above 1.6/1 and ethanol at ethanol/water weight ratios above 1/1 slightly decreased the both parameters. It might be due to the low solubility of dextrin in ethanol and limited diffusion coefficient of ethanol to the dextrin shell. furthermore, 0.5% (w/w) sodium lauryl sulfate gave the maximum ethanol content of dry alcohol. The more increased amounts of red ginseng extract were added, the more increased amounts of ginsenoside Rb1 but the more decreased amounts of ethanol were encapsulated in dry alcohols. A dry alcohol containing red ginseng extract was prepared with dextrin/ethanol/water (1/1/1, w/w/w) mixed solution, in which 0.5% (w/w) sodium lauryl sulfate and 20% (w/w) red ginseng extract were dissolved. It contained the ethanol contents of31.17$\pm$ 1.33% (w/w) and ginsenoside Rbl of 243.0$\pm$7.0 $\mu$g/g. It gave the moderate taste of red ginseng extract at Its oral administration with or without water Thus, the dry alcohol containing red ginseng extract can be further developed as a more convenient dosage form for red ginseng extract.

• Journal of Korean Society on Water Environment
• /
• v.23 no.5
• /
• pp.636-641
• /
• 2007

A pilot-scale biofilm nitiritation reactor was operated with the reject water from a large wastewater treatment plant. The effects of various operating parameters including pH, temperature, dissolved oxygen, solids and organic concentrations were examined. A stable nitritation was achieved at operating pH range of 7.3 to 8.8 with an alkalinity addition. Higher operating temperature of $35{\pm}0.7^{\circ}C$ achieved more stable nitritation compared to $30{\pm}0.2^{\circ}C$. It has been noticed that nitrite accumulation maintained with DO, solids and organic concentrations range of 0.8 to 3.9 mg/L, 3,400 to 11,000 mg/L, and 86 to 572 mg/L, respectively. It seems that the accumulation of nitrite was caused by both the inhibition of $NO_2{^-}$ oxidizers due to free ammonia and the maintenance of the high operating temperature of $35^{\circ}C$ which promote to accumulate the $NH_4{^+}$ oxidizers in the reactor. According to microbial community analysis of fluorescence in situ hybridization and INT-Dehydrogenase measurements, more nitrifiers were presented in attached form compared to suspended growth.

• Journal of Korean Society on Water Environment
• /
• v.25 no.1
• /
• pp.142-150
• /
• 2009

The distribution of organic nitrogen and its decomposition rate were studied in the Youngsan River and the Sumjin River system in Korea. Samples were conducted seasonally in June, August, December of 2006, and February of 2007. Collected samples were incubated for 20 days in a dark chamber ($20{\pm}1^{\circ}C$) and analyzed the changes of nitrogen form (particulate organic nitrogen, dissolved organic nitrogen, ammonia, nitrite, and nitrate). The mean total nitrogen (TN) concentration in the Youngsan River and the Sumjin River were $2.62mgN{\cdot}L^{-1}$ and $1.53mgN{\cdot}L^{-1}$, respectively. TN comprised of 65% DIN and 35% ON. The decomposition coefficients of organic nitrogen were also determined by two different fitting models. The decomposition rates of nitrogen species (TON, LPON, LDON, ${NH_4}^+$ and ${NO_2}^-$) ranged from 0.024 to $1.043day^{-1}$ in the Youngsan River and 0.008 to $0.693day^{-1}$ in the Sumjin River, respectively. The result of this study can give a guide to the selection of parameters in the calibration processes of water quality models.

• Journal of Korean Society on Water Environment
• /
• v.25 no.5
• /
• pp.713-719
• /
• 2009

A natural wetland in the Nakdong River basin which effectively removes non-point source pollutants was investigated for 2 years to understand wetland topography, vegetation types, and water quality characteristics. The water depth of the natural wetland was in the range of 0.5~1.9 m which is suitable for the growth of non-emergent hydrophytes. The wetland has a high length to width ratio (3.3:1) and a relatively large wetland to watershed area ratio (0.057). A broad-crested weir at the outlet increases the retention time of the wetland whose hydrology is mainly dependent on storm events. The concentrations of dissolved oxygen in the growing season and the winter season showed anoxic and oxic conditions, respectively. Diurnal variations of DO and pH in the growing season were also observed due to weather change and submerged plants. COD and TP concentrations were low in the winter season due to low inflow rate and increased retention time. Increased TP concentrations in the spring season were caused by degradation of dead wetland plants. Nitrogen in the wetland was mostly in organic nitrogen form (>75%). During the growing season, ammonium concentration was high but nitrate nitrogen concentration was low, possibly due to anoxic and low pH conditions which are adverse conditions for ammonificaiton and nitrification. The results of this study can be used as preliminary data for design, operation, monitoring and management of a constructed wetland which is designed to treat diffuse pollutants in the Nakdong river watershed.

• Journal of the Korean Chemical Society
• /
• v.16 no.1
• /
• pp.40-45
• /
• 1972

An electron spin resonance study has been made on lysozyme in. frozen aqueous solutions irradiated with $_{60}Co$ r-rays in air at $77^{circ}K.$ Water resonances are dominant when the concentration and the temperature are both below 20% and $130^{circ}K$ respectively. More solute radicals are produced in the solution of higher concentration. Majority of the solute radicals results from direct hit of the radiation. The same types of radicals are induced at $77^{circ}K$ whether the substances are irradiated in the dry state or in frozen aqueous solution. Based on these results, it is assumed that the number of ESR centers produced by the secondary intermolecular radical reacions and stabilized in aqueous solutions may depend on the concentration of the solution, and the presence of water may facilitate the secondary radical reactions occuring in the solute molecules after heat treatment. Majority of the solute radicals above around $193^{circ}K$ are believed to react with oxygen to form peroxytype radicals. However, when the solution is subiected to heat-treatment at $265^{circ}K$ after irradiation at $195^{circ}K$ the peroxy-type resonance was not observed, suggestin that an appreciable amount of oxygen is condensed into the ice, at $77^{circ}K.$ in addition to the oxygen that has already been dissolved in solution and react with solute free radicals during the process of heat-treatment. When the solution contains $H_2O_2$, no water resonance but $HO_2$, type resonance was observed probably indicating that the radiation-induced OH radicals are trapped in $H_2O_2$ aggregates and react readily with $H_2O_2$ molecules to poroduce $HO_2$ type radicals even at $77^{circ}K.$.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.28 no.2
• /
• pp.85-90
• /
• 2018

For the recovering rare earths in the spent nickel-metal hydride batteries, 10 M NaOH is added to the solution leached with sulfuric acid. The rare earth powders were precipitated at rate of 98 % at the condition of pH 2.0 or less. The recovered rare earth complex precipitate increased the leaching rate to nitric acid by heat treatment at $800^{\circ}C$ for 4 hours. Subsequently secondary precipitation was performed by adding oxalic acid to the solution in which the rare earth complex precipitate was dissolved. The re-precipitated rare earth powders were converted into oxide form through heat treatment at $800^{\circ}C$ for 4 hours with purity of 99.5 %.