• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05a
• /
• pp.438-441
• /
• 2006

Since the behavior of structural members subjected to blast load shows different responses, the effect of impulse as well as peak load should be considered in the damage analysis. The threshold on P-I diagram that causes specific damage level divides the diagram into the failure zone and the non-failure zones. In this study, numerical analysis is performed based on single-degree-of-freedom (SDOF) techniques to generate rational P-I diagram considering material non-linearity and dual failure modes (flexure and direct shear) of RC beams. From the comparison with existing test results it is concluded that proposed numerical method is good to derive failure mode of RC beam under blast load.

• Korean Journal Plant Pathology
• /
• v.11 no.2
• /
• pp.101-106
• /
• 1995

Deep blue fluorescence of resorcin blue-stained callose was observed only in the potato leafroll virus (PLRV)-infected potato plants, but not in other potato viruses investigated. The plant sections stained with aniline blue showed non-specific fluorescence regardless of PLRV infection, which means that aniline blue is not suitable for the staining of callose induces by PLRV infection. The fluorescence of resorcin blue-stained callose was more easily detectable than autofluorescence by a direct fluorescence detection method because of its deep blue color. The lateral branch of lower leaves was turned out to be the best material for fluorescence observation of all plant parts tested. In comparison of diagnostic efficacy of this technique to enzyme-linked immunosorbent assay (ELISA), PLRV infected potato plants showed corresponding increment of the fluorescence of resorcin blue stained callose as absorption values in ELISA increased. In the future, the criteria measuring the fluorescence objectively are thought to be determined for the practical application to the diagnosis of potato leafroll disease.

• Mycobiology
• /
• v.35 no.4
• /
• pp.191-195
• /
• 2007

The colonization pattern and extent of decay produced in paddy stubble by soil inhabiting mycoflora were done by using nylon net bag technique. Among the three methods used for isolation of fungi, dilution plate technique recorded the highest number of fungi followed by damp chamber and direct observation method. Nutrient availability and climatic conditions (temperature, humidity and rainfall) influenced the occurrence and colonization pattern of fungi. Maximum fungal population was recorded in October ($48.99{\times}10^4/g$ dry litter) and minimum in May ($11.41{\times}10^4/g$ dry litter). Distribution of Deuteromycetous fungi was more in comparison to Zygomycetes, oomycetes and ascomycetes. In the early stage of decomposition Mucor racemosus, Rhizopus nigricans, Chaetomium globosum and Gliocladium species were found primarly whereas at later stages of decomposition preponderance of Aspergillus candidus, Torula graminis, Cladosporiun cladosporioides and Aspergillus luchuensis was recorded.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.11a
• /
• pp.1048-1052
• /
• 2003

This study aims to derive frequency weighting curves for the estimation of driver's discomfort by steering wheel vibration in the vertical and rotational direction with respect to a steering column. Subjective tests for the determination of equal sensation curves, inverse of frequency weighting curves, for the two kinds of vibrations were performed using the sinusoidal signals with reference amplitudes from 0.2m/s$^2$ to 0.4 m/s$^2$ in the frequency range from 5㎐ to 100㎐. Twelve subjects joined at the tests, and median values of the twelve judgments were used to determine the frequency weighting curves. Second experiment was followed to determine relative magnitude between the two frequency weighting curves by direct comparison of discomfort due to the two kinds of vibrations at 50㎐, which showed discomfort by the rotational vibration was 1.5 times of that by the vertical vibration.

• Journal of the korean Society of Automotive Engineers
• /
• v.13 no.6
• /
• pp.72-81
• /
• 1991

In this study, the analytic investigation of the unsteady flow in the intake and exhaust pipes has been carried out using the method of characteristics in one direction to predict volumetric efficiency. Based on the calculated volumetric efficiency, three zone predictive analysis using Wiebe function was applied to predict the engine performance and the results were compared with experiment. Mixture in the cylinder is subdivided into three zones during combustion process in this analysis; adiabatic core zone, thermal boundary layer zone and unburned zone. In each zone, pressure, temperature and gas composition have been calculated. In conclusion, it is possible to take account of the intake and exhaust pipe tuning effect in predicting the engine performance, by the analytic solution of the unsteady flow in the pipes, and comparison of prediction with experimental results shows a good agreement on the pressure variation in the intake and exhaust pipes which has a direct influence on the volumetric efficiency and performance of the engine.

• Journal of ILASS-Korea
• /
• v.18 no.1
• /
• pp.61-65
• /
• 2013

In case of GDI engine, shape of injected fuel and injection mass are one of the most important factors for good fuel efficiency and power. But it should be too inefficient and difficult to acquire injection mass data by experiment because condition in engine vary with temperature, pressure, and so on. So, this paper suggests the AMESim (Advanced Modeling Environment for Simulation of Engineering Systems) as simulation program to calculate injection mass. For both simulation and experiment, n-heptane is used as fuel. In AMESim, I modeled the GDI injector and simulated several cases. In experiment, I acquired the injection mass using Bosch method to apply ambient pressure. The AMESim show reasonable result in comparison with experimental data especially at injection pressure 15 MPa. Other conditions are also in good accord with experimental data but error is a little bit large because the injection mass is so low.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.559-564
• /
• 2002

This paper describes a new algorithm named as ray following algorithm which is applied for high-resolution satellite image simulation. The problems of the conventional ray tracing algorithm are pointed out especially when terrain elevations vary abruptly. The proposed algorithm follows the directional ray vector sequentially and thoroughly in order to determine the crossing point of the ray with the terrain surface. This way of sequential height comparison method is regarded as the only way to obtain accurate surface cross-section when a highly variant digital surface model is used. The experimental results show and compare the validities of the conventional and proposed algorithms.

• Journal of the Korean Society for Precision Engineering
• /
• v.7 no.2
• /
• pp.65-73
• /
• 1990

Speckle photography is a simple non-contacting method for analysing surface displacement. In its basic form, the object to be studied is illuminated with a beam of laser light from any convenient direction, and a double exposure photography of the surface recorded on the fine-grain film, the object is undergone the displacement to be measured between exposures. Like this, it allows the strain field to be evaluated in two dimensions. A direct experimental comparison of speckle photography with theoretical value on a notched tensile test specimen showed that serious errors could, however, occur due to local surface tilting and due to aberra- tions of the imaging lens. Methods of minimising these effects and those of the speckle de-correlation which occurs by the various conditions are discussed.

• Korean Journal of Pharmacognosy
• /
• v.31 no.4
• /
• pp.416-420
• /
• 2000

Ursolic acid was isolated from Prunellae Herba (Prunella vulgaris var. lilacina) and identified by direct comparison with an authentic sample. A method of analysis for the evaluation of ursolic acid was developed based on extraction of ground plant material, followed by quantitative determination using capillary gas chromatography of the TMS derivative. Quantitative analysis by GC after derivatisation under mild silylating conditions showed 0.31% ursolic acid in 20 samples collected throughout regions of Korea while no ursolic acid was detected in the samples of the whole plant of Thesium chinense, a substitute for Prunellae Herba in southern regions of Korean peninsula.

• The Korean Journal of Food And Nutrition
• /
• v.12 no.4
• /
• pp.364-369
• /
• 1999

The changes of phenolics in Korean apple(Fuji) during maturation were analyzed by HPLC and spec-tropotometry. The phenolics were separated through C18 Sep-Pak cartridge in series. Chlorogenic acid caffeic acid p-coumaric acid ferulic acid and ($\pm$)-catethin were indentified by the direct comparison with authentics on HPLC. The total amounts of phenolics were determined by Folin-Dennis's method. The amounts ranged from 70.19mg% to 97.57mg% of wet basis. The concentration of phenolics in apple decreased during the early stage of development and then remained relatively constant during matu-ration .