• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.4
• /
• pp.443-451
• /
• 2010

This paper describes a fully integrated CMOS low-IF mobile-TV RF tuner for Band-III T-DMB/DAB applications. All functional blocks such as low noise amplifier, mixers, variable gain amplifiers, channel filter, phase locked loop, voltage controlled oscillator and PLL loop filter are integrated. The gain of LNA can be controlled from -10 dB to +15 dB with 4-step resolutions. This provides a high signal-to-noise ratio and high linearity performance at a certain power level of RF input because LNA has a small gain variance. For further improving the linearity and noise performance we have proposed the RF VGA exploiting Schmoock's technique and the mixer with current bleeding, which injects directly the charges to the transconductance stage. The chip is fabricated in a 0.18 um mixed signal CMOS process. The measured gain range of the receiver is -25~+88 dB, the overall noise figure(NF) is 4.02~5.13 dB over the whole T-DMB band of 174~240 MHz, and the measured IIP3 is +2.3 dBm at low gain mode. The tuner rejects the image signal over maximum 63.4 dB. The power consumption is 54 mW at 1.8 V supply voltage. The chip area is $3.0{\times}2.5mm^2$.

• Fire Science and Engineering
• /
• v.33 no.6
• /
• pp.186-189
• /
• 2019

NFSC 202 stipulates that if a loudspeaker or wiring on one floor of a building is shorted because of fire, it should not interfere with the fire notification on the other floors. To address this problem, this study proposes an ultrasonic transmitter/receiver consisting of an ADC, HPF, and LPF in an emergency broadcasting system that can operate regardless of the volume level of the amplifier output loudspeaker capacity. After transmitting the transmission frequency at -12 dB (110 kHz), it is received at -18 dB by transmitting -12 dB in case of short circuit depending on the frequency characteristics. Typically, depending on the loudspeaker capacity, it is received from -24 dB to -66 dB. In case of disconnection, it exceeds -66 dB and no data are received. It is also possible to check the track status during fire or general broadcasting. Thus, it was confirmed that the system is suitable for NFSC 202 regulations. Furthermore, as the current system is replaced, the inspection or test criteria should be amended or revised.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.6
• /
• pp.303-309
• /
• 2014

Chaos communication system can improve a system security due to characteristics of non-periodic, non-predictability, broadband signal and easy implementation. Also, chaos signal is sensitive to initial conditions of chaos map. By these reasons, security of chaos communication system is superior to digital communication system. BER performance of COOK modulation system is better than other chaos modulation systems, even if COOK modulation system uses an asynchronous receiver. However, security and safety of COOK modulated signal are worse than other chaos modulation systems, because information bits can be easily predicted from COOK modulated signal. In this paper, for security improvement of COOK modulated signal, we propose a novel Scrambling COOK modulation system by applying the scrambling method. Conventional COOK modulated signal can be predicted, because chaos signal is generated when data is only 1. However, proposed system cannot be predicted, because chaos signal is generated when data is 0 or 1. Therefore, security and safety of transmitted signal in scrambling COOK modulation system is superior to conventional COOK modulation system.

• Journal of Satellite, Information and Communications
• /
• v.10 no.3
• /
• pp.38-43
• /
• 2015

This paper describes a GPS signal generator that can generate multiple satellite signals in real time at the RF level. It realizes the verified software algorithm on a FPGA. The algorithm models orbits and environmental errors such as ionospheric and tropospheric multipath. The position of a simulated receiver is one of simulation parameters. The hardware which consists of a digital logic board and an analog board can generate 16 simulated satellites signals at the same time. The users can generate spoofing signals and jamming signals as well as satellite signals by using the windows-based control software. In addition, the software provides GIS-based simulation scenarios editing tools. We verified the generator by using commercial receivers. As an application, we configured generators as indoor positioning systems and tested them in a building. To improve the accuracy of indoor systems is our further study.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.7
• /
• pp.797-804
• /
• 2012

In this paper, we propose a QAPM(Quadrature Amplitude Position Modulation) modulation using compressive sensing for the purpose of power efficiency improvement. QAPM modulation is a combination technique of QAM (quadrature amplitude modulation) and PPM(Pulse Position Modulation). Therefore it can decrease the transmission power and improve BER performance. Moreover, even if the band width is widened when the number of positions is increased, high sparsity characteristic caused by position number can be applied to compressive sensing technique. Compressive sensing has recently studied as a method that can be successfully reconstructed from the small number of measurements for sparse signal. Therefore, the proposed system can lower price of receiver by reducing sampling rate and has performance improved by using QAPM modulation. And the results are confirmed through simulations.

• Journal of Broadcast Engineering
• /
• v.22 no.3
• /
• pp.350-365
• /
• 2017

Steganography is a technique for secret data communication, which is not perceived by third person between a receiver and a transmitter. It has been developed for thousands of years for the transmission of military, diplomatic or business information. The development of digital media and communication has led to the development of steganography techniques in modern times. Technic of image steganography include the LSB, which fixes the number of embedded bits into a pixel, and PVD, which exploits the difference value in the neighboring pixel pairs. In the case of PVD image steganography, a large amount of information is embedded fluidly by difference value in neighboring pixel pairs and the designed range table. However, since the secret information in order is embedded, if an error of the number of embedded bits occurs in a certain pixel pair, all subsequent information will be destroyed. In this paper, we proposes the method, which improve the vulnerability of PVD property about external attack or various noise and extract secret information. Experimental process is comparison analysis about stego-image, which embedded various noise. PVD shows that it is not possible to preserve secret information at all about noise, but it was possible to robustly extract secret information for partial noise of stego-image in case of the proposed PVD image steganography with locally-fixed number of embedding bits.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.811-815
• /
• 2005

IPSec(Internet Protocol Security) is a framework for a set of protocols for security at the network or packet processing layer of network communication. IPSec is providing authentication, integrity and confidentiality security services. The specifications for Internet Key Exchange(IKEv1) were released to the world. Some criticisms of IKEv1 were that it was too complex and endeavored to define too much functionality in one place. Multiple options for multiple scenarios were built into the specification. The problem is that some of the included scenarios are rarely if ever encountered. For IPsec to work, the sending and receiving devices must chare a Public Key. This is accomplished through a protocol known as Internet Security Association and Key Management Protocol/Oakley(ISAKMP/Oakley), which allows the receiver to obtain a public key and authenticate the sender using digital certificates. This thesis is a study on the performance improvement of the security transmission using the SSFNet(Scalable Simulation Framework Network Models)

• Journal of radiological science and technology
• /
• v.31 no.3
• /
• pp.223-228
• /
• 2008

The most critical point in the medical use of radiation is to minimize the patient's entrance dose while maintaining the diagnostic function. Low-energy photons (long wave X-ray) among diagnostic X-rays are unnecessary because they are mostly absorbed and contribute the increase of patient's entrance dose. The most effective method to eliminate the low-energy photons is to use the filtering plate. The experiments were performed by observing the image quality. The skin entrance dose was 0.3 mmCu (copper) filter. A total of 80 images were prepared as two sets of 40 cuts. In the first set (of 40 cuts), 20 cuts were prepared for the non-filter set and another 20 cuts for the Cu filter of signal + noise image set. In the second set of 40 cuts, 20 cuts were prepared for the non-filter set and another 20 cuts for the Cu filter of non-signal image (noisy image) with random location of diameter 4 mm and 3 mm thickness of acryl disc for ROC signal at the chest phantom. P(S/s) and P(S/n) were calculated and the ROC curve was described in terms of sensitivity and specificity. Accuracy were evaluated after reading by five radiologists. The number of optically observable lesions was counted through ANSI chest phantom and contrast-detail phantom by recommendation of AAPM when non-filter or Cu filter was used, and the skin entrance dose was also measured for both conditions. As the result of the study, when the Cu filter was applied, favorable outcomes were observed on, the ROC Curve was located on the upper left area, sensitivity, accuracy and the number of CD phantom lesions were reasonable. Furthermore, if skin entrance dose was reduced, the use of additional filtration may be required to be considered in many other cases.