• 전자공학회논문지A
• /
• 제33A권5호
• /
• pp.1-9
• /
• 1996

In this paper, we propose an efficient computational algorithm that can reduce significantly the computational complexity of the ML optimum multiuser detector known as the most excellent detector in synchronous code division multiple access channels. The proposed detector uses the sequential detection algorithm based on the alternating maximization appraoch to obtain the ML estimates. As initial estimates for this sequential algorithm, we can use the estimated values obtained by the conventional single-user detector, the linear decorrelating multiuser detector, or the decorrelating decision-feedback muliuser detector, the linear decorrelating multiuser detector, or the decorrelating decision-feedback multiuser detector. We have performed computer simulations in order to see the convergence behaviors and the detection performance of the propsoed algorithm in terms of initial algorithms and the number of users, and then to compare the computational complexity with that of the ML optimum multiuser detector. From the results, we have seen that the proposed alternating maximization detector has nearly equal detction performance with that of the ML optimum multiuser detctor in only a few iteration.

• ETRI Journal
• /
• 제29권1호
• /
• pp.110-112
• /
• 2007

As an alternative to the classic linear detector which only assumes noise variance, a new robust detector with noise variance estimation censoring input signals over AWGN is proposed. The results demonstrate that analytic detection probability matches the simulation results for the linear detector and that the new robust detector shows better performance than the linear detector when the number of samples increases.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2006년도 춘계종합학술대회
• /
• pp.615-618
• /
• 2006

본 논문에서는 직접 변환 방식인 six-port의 RF 출력 신호를 검파하고 요구 대역폭에서 입력 주파수 신호에 대한 진폭 및 위상차를 선형적으로 출력하는 광역 power detector를 설계 제작한다. Six-port 출력단에 접속되는 power detector는 높은 정합도를 갖고 반사파로 인한 Six-port 간 위상 불일치를 방지하고, 넓은 대역폭에서 낮은 VSWR을 유지하여야 하는 광역 특성을 갖는 power detector 설계가 필요하다. L-band의 강제 정합 회로와 Ku-band의 정합 회로 그리고 isolator와 정합 회로를 갖는 power detector 회로를 구성하여 요구하는 Six-port 형 power detector 성능을 평가한다.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2004년도 ICCAS
• /
• pp.1689-1693
• /
• 2004

This paper proposes a vehicle detector with a magnetoresistive (MR) sensor. The detector consists of a MR sensor and mechanical and electronic apparatuses. Composed of six magnetically variable resistors, the MR sensor senses disturbance of the earth's magnetic field caused by a moving vehicle over itself and then produces an output indicative of the moving vehicle. Experiments have been carried out with three stages. At the first stage, the outputs of the sensor have been analyzed to show the validity of the detector's circuit and the detecting method. At the second stage, the detector has been tested on a local highway in Korea. Through the field tests, the outputs of the detector in response to various kinds of moving vehicles have been collected and analyzed. At the final stage, to verify the performance of the detector, traffic volumes on the highway have been measured with the detector and compared with the exact traffic volumes in a highly congested traffic.

• Journal of Electrical Engineering and Technology
• /
• 제6권5호
• /
• pp.658-665
• /
• 2011

In the present paper, a novel fast peak detector for single- or three-phase unsymmetrical voltage sags is proposed. The proposed detector is modified from a single-phase digital phase-locked loop based on a d-q transformation using an all-pass filter (APF). APF generates a virtual phase with $90^{\circ}$ phase delay. However, this virtual phase cannot reflect a sudden change of the grid voltage in the moment of voltage sag, which causes a peak value to be significantly distorted and to settle down slowly. Specifically, the settling time of the peak value is too long when voltage sag occurs around a zero crossing, such as phase $0^{\circ}$ and $180^{\circ}$. This paper describes the operating principle of the APF problem and proposes a modified all-pass filter (MAPF) to mitigate the inherent APF problem. In addition, a new fast peak detector using MAPF is proposed. The proposed detector is able to calculate a peak value within 0.5 ms, even when voltage sag occurs around zero crossing. The proposed fast peak detector is compared with the conventional detector using APF. Results show that the proposed detector has faster detection time in the whole phase range. Furthermore, the proposed fast peak detector can be effectively applied to unsymmetrical three-phase voltage sags. Simulation and experimental results verify the advantages of the proposed detector and MAPF.

• 대한안전경영과학회지
• /
• 제23권3호
• /
• pp.97-102
• /
• 2021

This study developed a scenario to understand the reaction rate and operational time according to RTI value of rate of rise detector in each type in case of fire mattress. In the results of analyzing the reaction rate and operational time of detector in each scenario, in case when installing a single detector, the elevated temperature per minute was raised to 8℃/min ~ 9℃/min. In case when installing two detectors, it was raised to 9℃/min ~ 10℃/min. In case when installing three detectors, it was raised to 10℃/min. The horizontal distance between detector and mattress was 1.8m~2.5m. Whenever the number of detectors was increased, the horizontal distance was decreased. The operational time of detector was within maximum 540 seconds and minimum 420 seconds. As the research tasks in the future, there should be the researches on the effects of reaction rate of detector on the evacuation in case of fire through the result value of RSET by setting up the latency until the detector operates, and the researches on the safety by understanding if the operational time of detector is suitable for the evaluation standard of performance-centered design.

• 한국컴퓨터정보학회논문지
• /
• 제27권10호
• /
• pp.19-28
• /
• 2022

본 논문에서는 실시간 고성능 다중 객체 추적을 수행하기 위해 최적의 TBD (Tracking-by-detection) 메커니즘을 결정할 수 있는 Detector Scheduler를 제안한다. Detector Scheduler는 서로 다른 프레임 간의 특징량 차이를 측정하는 것으로 검출기 실행 여부를 결정하여 전체 추적 속도를 향상한다. 하지만, Detector Scheduler의 학습에 필요한 GT (Ground Truth) 생성이 어렵기 때문에 Detector Scheduler를 추적 결과만을 통해 학습 가능한 자가 학습 방법을 제안한다. 제안된 자가 학습 방법은 프레임 간의 객체 카디널리티와 객체 외형 특징량의 비유사도가 커질 때 검출기를 실행할 수 있도록 의사 레이블을 생성하고 제안된 손실함수를 통해 Detector Scheduler를 학습한다.

• 대한방사선기술학회지:방사선기술과학
• /
• 제27권2호
• /
• pp.21-27
• /
• 2004

본 연구에서는 현재 국내에서 사용되고 있는 여러 기종의 CT장치를 대상으로 하여 CT검사로 인한 방사선피폭 정도를 실험을 통하여 알아보고, 외국의 사례와 비교함으로써 CT장치의 성능관리의 하나인 피폭선량 기준 설정에 필요한 기초 데이터를 제시하고자 서울시 및 경기도에 위치한 병의원 및 종합병원에서 가동 중인 32대의 CT장치를 대상으로 CTDI값을 측정한 결과 다음과 같았다. 1) Head phantom의 100 mAs 당 $CTDI_W$값은 $8.1{\sim}19.1\;mGy$ 범위였고, 평균 $13.5{\pm}3.2\;mGy$였다. 그리고 body phantom의 $CTDI_W$값은 $3.7{\sim}10.9\;mGy$ 범위였고, 평균 $7.1{\pm}2.0\;mGy$였다. 2) Single detector CT와 multi detector CT의 $CTDI_W$값을 비교해 보면, multi detector CT가 single detector CT에 비해 head phantom에서는 평균 3.2 mGy(약 1.26배), body phantom에서는 평균 2.1 mGy(약 1.34배) 높았다. 3) Channel 수에 따른 $CTDI_W$값 비교에서는 head pahantom에서는 4 channel CT가 가장 높았으며, 8 channel CT, 16 channel CT, single detector CT순이었으며, body phantom에서는 역시 4 channel CT와 8 channel CT, 16 channel CT, single detector CT순이었다.

• Nuclear Engineering and Technology
• /
• 제55권5호
• /
• pp.1718-1733
• /
• 2023

The virtual Frisch-grid method for room-temperature radiation detectors has been widely used because of its simplicity and high performance. Recently, side electrodes were separately attached to each surface of the detectors instead of covering the entire detector surface with a single electrode. The side-electrode structure enables the measurement of the three-dimensional (3D) gamma-ray interaction in the detector. The positional information of the interaction can then be utilized to precisely calibrate the response of the detector for gamma-ray spectroscopy and imaging. In this study, we developed a 3D position-sensitive 5 × 5 × 12 mm³ cadmium-zinc-telluride (CZT) detector and applied a flattening method to correct detector responses. Collimated gamma-rays incident on the surface of the detector were scanned to evaluate the positional accuracy of the detection system. Positional distributions of the radiation interactions with the detector were imaged for quantitative and qualitative evaluation. The energy spectra of various radioisotopes were measured and improved by the detector response calibration according to the calculated positional information. The energy spectra ranged from 59.5 keV (emitted by ²⁴¹Am) to 1332 keV (emitted by ⁶⁰Co). The best energy resolution was 1.06% at 662 keV when the CZT detector was voxelized to 20 × 20 × 10.

• 한국통신학회논문지
• /
• 제28권4C호
• /
• pp.392-396
• /
• 2003

This paper proposes an optimum noncoherent detector for M-ary nonorthogonal, unequal energies, unequal priori probabilities nonlinear modulation signals. Theretical derivations are given in detail. Under above conditions, there is not any previous papers to explore the corresponding optimum noncoherent detector. The detector proposed in this paper can be regarded as a generic optimum detector which can be applied to nonorthogonal nonlinear M-ary communication systems.