• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.53 no.2
• /
• pp.174-180
• /
• 2020

The mouse bioassay has been used widely for the monitoring of paralytic shellfish toxins (PSTs) in many countries. However, this method shows low sensitivity and high limit of detection (LOD), as well as it cannot confirm toxic profiles. Recently, LC-MS/MS method was studied for the quantitative of PSTs, however, the method has any problems with unstable retention times by ionization suppression caused by high salt concentration in shellfish extracts. To establish an alternative method for PSTs analysis, we tried to original LC-MS/MS methods adding desalting operation using amorphous graphitized polymer carbon solid-phase extraction cartridges. The method validation was conducted to determine linearity, limit of detection, limit of quantification (LOQ), accuracy, and precision in quantifying PSTs. The correlation coefficients for all tested PSTs maintained over 0.999. The LODs and LOQs for all PSTs were about 0.19-1.05 ㎍/kg and 0.58-3.18 ㎍/kg, respectively. The accuracies for PSTs were 95.4-107.7% for saxitoxin group, 97.1-100.9% for gonyautoxin group, 99.0-100.8% for N-sulfocarbamoyl toxin group, and 96.8-104.6% for decarbamoyl toxin group. These results indicate that the modified LC-MS/MS method was appropriate for analyzing the PSTs in shellfish and tunicates.

• 보존과학연구
• /
• s.21
• /
• pp.77-99
• /
• 2000

Tumuli located in Chodang-dong in Kangreung City are sitesexcavated by the Museum of Kangreung University in 1993.Ofthese sites, a gilt bronze crown and gilt bronze sword with ring pommel with a tri-leaf ornament were excavated from the B-16tumulus. Underneath the gilt bronze crown was the gilt bronzes word with ring pommel with tri-leaf ornament, and these artifacts were treated with Polyurethane foams on the spot followed by special measures for conservation. This manuscript describes measures for conservation andanalysis with regard to the gilt bronze crown, gilt bronze sword with ring pommel with tri-leaf ornament and gilt bronze beltornaments. Bronze on the gilt bronze crown was completely corroded, therefore it was consolidated together with soil in the back of the artifact with Paraloid B72 after cleaning. Polyurethanefoams bottom was finished by applying the mixture of Epoxy resinAW106 and HV935K with soil. On the sword with ring pommel, the wooden part of the hilt was coated with Paraloid B72 (in Xylene) and the blade was consolidated with Paraloid NAD-10 30% after desalting with Sodium sesquicarbonate method. The gilt bronzebelt ornaments were treated with 3% Benzotriazole, coated with Paraloid B72 and then joined by using Cyanlacrylate. Specimens for the gilt bronze crown and gilt bronze belt ornaments were produced and gilding layers were examined under a metallographic microscope. The gilt bronze crown and the gilt bronze belt ornament maintained relatively good gilding quality with uniform gilding layers. Analysis of wood for the sheath of the sword with ring pommel revealed it to be Juglans mandshurica. Further more, analysis of constituents for a blue colored grassbead from dissolution of Polyurethane foams found it to be from the $Na_2O$-CaO-$AI_2O_3$-$SiO_2$ family.

• 한국태양에너지학회:학술대회논문집
• /
• 2012.03a
• /
• pp.364-369
• /
• 2012

The development of solar thermal energy used adsorption desalination technology have been examined as a viable option for supplying clean energy. In this study, the modelling of the main devices for solar thermal energy used and adsorption desalination system was introduced. Silica gel type adsorption desalination system is considered to be a promising low-temperature heat utilization system. The design is divided into three parts. First, the evaporator for the vaporization of the tap water is designed, and then the reactor for the adsorption and release of the steam is designed, followed by the condenser for the condensation of the fresh water is designed. In addition, new features based on the energy balance are also included to design absorption desalination system. In this basic research, One-bed(reactor) adsorption desalination plant that employ a low-temperature solar thermal energy was proposed and experimentally studied. The specific water yield is measured experimentally with respect to the time controlling parameters such as heat source temperatures, coolant temperatures, system switching and half-cycle operational times. Desalination is processes that permeate our daily lives, but It requires substantial energy input, powered either from electricity or from thermal input. From the environmental and sustainability perspecives, innovative thermodynamic cycles are needed to produce the above-mentioned useful effects at a lower specific energy input. This article describes the development of adsorption cycles for the production of desalting effects. We want that this adsorption system can be driven by low temperature heat sources at 60 to $80^{\circ}C$, such as renewable, solar thermal energy.

• Korean Journal of Pharmacognosy
• /
• v.20 no.1
• /
• pp.25-31
• /
• 1989

In order to establish the standard method for the preparation of processed Aconiti Tuber, Aconiti Tubers were processed under various conditions and the amount and the composition of alkaloids were determined by HPLC. The ratio of sum of benzoylhypaconine and benzoylmesaconine over the sum of acinitine, mesaconitine, benzoylmesaconine and benzoylhypaconine was used as a detoxification index ((BM+BH)${\times}$100/MA+AC+BM+BH). The adequate value of index was obtained from Japanese 'ka-gong bu-ja' which has been used in Japan. The processing procedure was largely devided into two categories. First is heat treating at $120^{\circ}$ and 1. 2 lbs for 60 min. Second is treatment with various kinds of alkaline solutions followed by heat treatment at $120^{\circ}$ and 1. 2 lbs for 60 min. Among the source of processed Aconiti Tubers, dried bu-ja and yom bu-ja, dried bu-ja was more adequate than yom bu-ja because yom bu-ja has the lower value of index than dried bu-ja and lost active components through the desalting periods. Dried bu-ja whish was treated with alkaline solutions followed by heat treatment has the detoxification index, 50% and dried bu-ja which was treated only with hear has 71. 8%. Compared to the value of index of Japanese 'ka-gong bu-ja', 72%, the dried bu-ja treated with heat at $120^{\circ}$ and 1, 2 lbs for 60min was the most adequate. The $LD_{50}$ value of the processed bu-ja was higher than 15 g crude drugs/kg, p.o. in mice.

• Journal of Korean Society of Water and Wastewater
• /
• v.27 no.6
• /
• pp.771-778
• /
• 2013

Gas hydrate (GH) process is a new desalination technology, where GH is a non- stoichiometric crystalline inclusion compounds formed by water and a number of gas molecules. Seawater GH is produced in a low temperature and a high pressure condition and they are separated from the concentrated seawater. The drawback of the GH process so far is that salt contents contained in its product does not meet the fresh water quality standard. This means that the GH process is not a standalone process for seawater desalination and it needs the help of other desalting process like reverse osmosis (RO). The objective of this study is to investigate the effect of GH process on energy saving for RO process in seawater desalination. The GH product water quality data, which were obtained from a literature, were used as input data for RO process simulation. The simulation results show that the energy saving effect by the GH process is in a range of 68 % to 81 %, which increases as the salt removal efficiency of the GH process increases. Boron (B) and total dissolved solids (TDS) concentrations of the final product of the hybrid process of GH and RO were also investigated through the RO process simulation to find relavant salt rejection efficiency of the GH process. In conclusion, the salt rejection efficiency of the GH process should exceed at least 78% in order to meet the product water quality standards and to increase the energy saving effect.

• Journal of Korean Society of Water and Wastewater
• /
• v.34 no.3
• /
• pp.183-190
• /
• 2020

Although membrane bio-reactor (MBR) has been widely applied for wastewater treatment plants, the membrane fouling problems are still considered as an obstacle to overcome. Thus, many studies and commercial developments on mitigating membrane fouling in MBR have been carried out. Recently, high voltage impulse (HVI) has gained attention for a possible alternative technique for desalting, non-thermal sterilization, bromate-free disinfection and mitigation of membrane fouling. In this study, it was verified if the HVI could be used for mitigation of membrane fouling, particularly the internal pore fouling in MBR. The HVI was applied to the fouled membrane under different conditions of electric fields (E) and contact time (t) of HVI in order to investigate how much of internal pore fouling was reduced. The internal pore fouling resistance (R_f) after HVI induction was reduced as both E and t increased. For example, R_f decreased by 19% when the applied E was 5 kV/cm and t was 80 min. However, the R_f decreased by 71% as the E increased to 15 kV/cm under the same contact time. The correlation between E and t that needed for 20% of R_f reduction was modeled based on kinetics. The model equation, E^1.54t = 1.2 × 10³ was obtained by the membrane filtration data that were obtained with and without HVI induction. The equation states the products of En and t is always constant, which means that the required contact time can be reduced in accordance with the increase of E.

• Journal of Powder Materials
• /
• v.20 no.3
• /
• pp.197-202
• /
• 2013

A novel route to prepare Nd-Fe-B magnetic particles by utilizing both spray drying and reduction/diffusion processes was investigated in this study. Precursors were prepared by spray drying method using the aqueous solutions containing Nd salt, Fe salt and boric acid with stoichiometric ratios. Precursor particles could be obtained with various sizes from 2 to $10{\mu}m$ by controlling concentrations of the solutions and the average size of $2{\mu}m$ of precursors were selected for further steps. After heat treatment of precursors in air, Nd and Fe oxides were formed through desalting procedure, followed by reduction processes in Hydrogen ($H_2$) atmosphere and with Calcium (Ca) granules in Argon (Ar) successively. Moreover, diffusion between Nd and Fe occurred during Ca reduction and $Nd_2Fe_{14}B$ particles were formed. With Ca amount added to particles after $H_2$ reduction, intrinsic coercivity was changed from 1 to 10 kOe. In order to remove and leach CaO and residual Ca, de-ionized water and dilute acid were used. Acidic solutions were more effective to eliminate impurities, but Fe and Nd were dissolved out from the particles. Finally, $Nd_2Fe_{14}B$ magnetic particles were synthesized after washing in de-ionized water with a mean size of $2{\mu}m$ and their maximum energy product showed 9.23 MGOe.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.6
• /
• pp.1561-1567
• /
• 2010

In this study, we have developed a new detection method using Si field effect transistor (FET)-type biosensors, which enables the direct monitoring of antigen-antibody binding within very high-ionic-strength solutions such as 1$\times$PBS and human serum. In the new method, as no additional dilution or desalting processes are required, the FET-type biosensors can be more suitable for ultrasensitive and real-time analysis of raw sample solutions. The new detection scheme is based on the observation that the strength of antigen-antibody-specific binding is significantly influenced by the ionic strength of the reaction solutions. For a prostate specific antigen (PSA), in some conditions, the binding reaction between PSA and anti-PSA in a low-ionic strength reaction solution such as 10 ${\mu}M$ phosphate buffer is weak (reversible), while that in high-ionic strength reaction solutions such as 1$\times$PBS or human serum is strong.

• Korean Journal of Food Science and Technology
• /
• v.8 no.3
• /
• pp.141-146
• /
• 1976

1) The purified enzyme was obtained with the specific activity 126.5 u/mg protein (about 45 times of the original activity) and the yield of 4.2%, by means of salting out with ammonium sulfate (0.5 saturation) of the crude enzyme solution, desalting by Sephadex G 25, CM cellulose columm chromatography, concentration by Sephadex G 25, and gel filtration by Sephadex G 75. 2) In the acrylamide gel disc electrophoresis of the purified enzyme, the main band and two obscure ones on the both side of the main band appeared, which indicated that the enzyme was considerably purified compared with its crude enzyme solution, even if it is not referred to as a pure protein.

• Journal of Powder Materials
• /
• v.12 no.5 s.52
• /
• pp.336-344
• /
• 2005

In the present study, the focus is on the effect of cobalt oxide powder in the carbothermal reduction of the titanium-cobalt-oxygen based oxide powder by solid carbon for the optimizing synthesis process of ultra fine TiC/Co composite powder. The titanium-cobalt-oxygen based oxide powder was prepared by the combination of the spray drying and desalting processes using the titanium dioxide powder and cobalt nitrate as the raw materials. The titanium-cobalt-oxygen based oxide powder was mixed with carbon black, and then this mixture was carbothermally reduced under flowing argon atmosphere. Changes in the phase structure and thermal gravity of the mixture during carbothermal reduction were analysed using XRD and TGA. Titanium-cobalt-oxygen based oxide powder desalted at $600^{\circ}C$ had a mixture of $TiO_2\;and\;Co_{3}O_4$. And the one desalted at $800^{\circ}C$ had a mixture of $TiO_2\;and\;CoTiO_3$. In the case of the former powder, the reduction of cobalt oxide powder in the titanium-cobalt-oxygen based oxide powder occurred at lower temperature than the latter one. However, the carbothermal reduction of titanium dioxide powder in the titanium-cobalt-oxygen based oxide powder with a mixture of $TiO_2\;and\;Co_{3}O_4$ occurred at higher temperature than the one with a mixture of $TiO_2\;and\;CoTiO_3$. And also, the former powder showed a lower TiC formation ability than the latter one.