• Fire Science and Engineering
• /
• v.20 no.3 s.63
• /
• pp.65-70
• /
• 2006

From the beginning of the construction stage, the fire protection regulation for the nuclear power plants conforms to the design requirements for the acquisition of the license permit. This regulation is based on the plant status of the normal operation, but it is not enough to be used as an application standard for fire protection at the transient mode of the plant and the outage time for refueling as well as for the plant decommissioning. While the advanced fire protection requirement that has been developed in America recently suggests the performance-based requirement and management rule applicable to the overall life time of the plant, it simply represents the conceptual application. It means that it can not be treated as appropriate standards because it does not deal with the qualitative and quantitative approach in specific ways. By the way, with the use of the performance-based fire risk analysis, the dynamic behavior of the heat and smoke at the fire compartment of the nuclear power plants can be analyzed and the thermal effect to the safety-related equipment and cables can be evaluated as well. At this paper, it suggests the ways to change the applicable fire protection regulations and the required evaluation items for the fire risk resulted from the plant configuration change with an intent to introduce the state-of-the-art quantitative fire risk analysis technology at the domestic nuclear power plants.

• Journal of the Korea Concrete Institute
• /
• v.15 no.2
• /
• pp.273-279
• /
• 2003

The purpose of this study is to clarify the effect of the monomer ratio on properties of the polymer-modified mortars using methylmethacrylate-butyl acrylate(MMA/BA) latexes, and to obtain basic data necessary to develop appropriate latexes for cement modifiers. From the test results, we knew that the pore volume of polymer-modified mortars using MMA/BA latexes at bound MMA contents of 60 and 70 percent is 7.5∼75nm and the fine pore volume is increased with an increase in the polymer-cement ratio. The total pore volume of polymer-modified mortars using MMA/BA latexes is linearly reduced with an increase in the bound MMA content and increased in the polymer-cement ratio. In general, the superior compressive strength of polymer-modified mortars using MMA/BA latexes is obtained at a bound MMA content of 70 percent and a polymer-cement ratio of 15%. And, the water absorption and chloride ion penetration depth are greatly affected by the polymer-cement ratio rather than the bound MMA content. The important factors affecting the properties of polymer-modified mortars using MMA/BA latexes polymerized with various monomer ratios are the variations of the pore size distribution with changing bound MMA content and the polymer-cement ratio.

• Journal of the Korea Concrete Institute
• /
• v.15 no.2
• /
• pp.335-343
• /
• 2003

In the previous experimental study, it is verified that the ultimate strain of concrete (${\varepsilon}$$_{cu}$=0.003) and coefficient of equivalent stress block (${\beta}$$_1$) can be used for the analysis of RC beams under biaxial and uniaxial bending moment. However, the characteristics of stress distribution of non rectangular compressed area in the RC columns are different to those of rectangular compressed area. The properties of compressive stress distribution of concrete have minor effect on the pure bending moment such as beams, but for the columns subjected to combined axial load and biaxial bending moment, the properties of compressive stress distribution are influencing factors. Nevertheless, in ACI 318-99 code, the design tables for columns subjected to axial loads with bidirectional eccentricities are based on the parameters recommended for rectangular stress block(RSB) of rectangular compressed areas. In this study the characteristics of stress distribution through both angle and depth of neutral axis are observed and formulated rationally. And the modified parameters of rectangular stress block(MRSB) for non rectangular compressed area is proposed. And the computer program using MRSB for the biaxial bending analysis of RC columns is developed and the results of MRSB are compared to RSB and experimental results respectively.

• Journal of the Korea Concrete Institute
• /
• v.24 no.5
• /
• pp.553-558
• /
• 2012

Airborne chlorides are transported to inland by sea wind to be attached to seashore concrete structure surface then penetrated into concrete structure members. Since the surface attached chloride amount are dependent on the amount of airborne chlorides, the prediction of distribution of airborne chlorides is important information in preventing chloride corrosion problems in seashore concrete structures. The prediction of surface chloride amount from airborne chlorides environment is extremely difficult than concrete directly in contact with seawater. In addition, their penetrating tendency is different from that of concrete immersed in seawater. In this study, properties of surface and penetrated chlorides under airborne chlorides environment are investigated. Concrete specimens were manufactured and exposed to marine environment for 3 years. The specimens were analyzed at the time durations of 1, 2, and 3 years to check surface chloride amount to penetrated chloride depth. The results revealed that there were certain differences according to surface roughness of concrete and with and without washing effect due to rainfalls. The evaluation results showed that penetrated chlorides depend on amount of airborne chlorides and duration of exposure. In addition, a notable tendency of having deeper chloride penetration and higher chloride content in concrete members under long-term exposure was observed.

• Convergence Security Journal
• /
• v.13 no.3
• /
• pp.9-15
• /
• 2013

Calculating of matching cost is an important for efficient stereo matching. To investigate the performance of matching process, the concepts of the existing methods are introduced. Also we analyze the performance and merits of them. The simplest matching costs assume constant intensities at matching image locations. We consider matching cost functions which can be distinguished between pixel-based and window-based approaches. The Pixel-based approach includes absolute differences (AD) and sampling-intensitive absolute differences (BT). The window-based approach includes the sum of the absolute differences, the sum of squared differences, the normalized cross-correlation, zero-mean normalized cross-correlation, census transform, and the absolute differences census transform (AD-Census). We evaluate matching cost functions in terms of accuracy and time complexity. In terms of the accuracy, AD-Census method shows the lowest matching error ratio (the best solution). The ZNCC method shows the lowest matching error ratio in non-occlusion and all evaluation part. But it performs high matching error ratio at the discontinuities evaluation part due to blurring effect in the boundary. The pixel-based AD method shows a low complexity in terms of time complexity.

• Journal of Periodontal and Implant Science
• /
• v.27 no.4
• /
• pp.767-783
• /
• 1997

Guided tissue regeneration, bone graft procedures, and application of growth factors have been used to regenerate lost periodontal tissues. Recently, enamel matrix derivative has been introduced into periodontal regeneration procedures in expectation of promoting new bone and cementum formation. The purpose' of this study was to evaluate the effect of enamel matrix derivative in 1-wall intrabony defects in beagle dogs. For this purpose, each dog was anesthesized using intravenous anesthesia and mandibular 1st, 3rd premolars were extracted. 2 months later, the 1-wall intrabony defects(mesio-distal width: 4mm, depth: 4mm) were created on the distal side of 2nd premolars and mesial side of 4th premolars. The control group was treated with debridement alone, and experimental group was treated with debridement and enamel matrix derivative application. The healing processes were histologically and histometrically observed after 8 weeks and the results were as follows : 1. The length of junctional epithelium was $0.94{\pm}0.80mm$ in the control group, $0.57{\pm}0.42mm$ in the experimental group, with no statistically significant difference between groups. 2. The connective tissue attachment was $1.36{\pm}0.98mm$ in the control group. $0.38{\pm}0.43mm$ in the experimental group, with statistically significant difference between groups(P<0.05). 3. The new cementum formation was $2.49{\pm}1.06mm$ in the control group, $3.59{\pm}0.74mm$ in the experimental group. with statistically significant difference between groups(P<0.05). 4. The new bone formation was $1.92{\pm}0.97mm$ in the control group, $2.32{\pm}0.59mm$ in the experimental group. with no statistically significant difference between groups. Within the limitation to this study protocol, enamel matrix derivative application in 1-wall intrabony defect enhanced new cementum formation. Although there was no statistically significant difference, enamel matrix derivative also seems to be effective in inhibition of apical migration of junctional epithelium and new bone formation.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.29 no.4
• /
• pp.592-599
• /
• 2002

Objective : The purpose of this study was to evaluate the effects of several light curing methods and several adhesives on the microleakage of composite resin restorations in primary teeth. Materials and methods : In 150 extracted human primary anterior teeth, O-shaped cavities were prepared in the labial surface ; the cavity diameter and depth were 1.6mm. The cavities were filled with light-activated composite resin, Compoglass. Four kinds of adhesives were used. Each filling materials were polymerized with three light cure methods. The restorations were polished using Sof-Lex discs(3M Co., USA). The samples were thermocycled 1,000 times between $5^{\circ}C$ and $55^{\circ}C$ with a 1-minute dwell time. Then, they were immersed in a 2% methylene blue solution(pH 7) for 12hours. Subsequently they were sectioned labio-lingually through the center of the restoration with a diamond saw at low speed with a water coolant, and evaluated by stereomicroscopy. Microleakage analyses were done, using scores from 0 to 4. Results : Results showed the least microleakage in Compoglass group(P<0.05). There were less microleakage in SBMP group among the adhesive groups, but no significant difference was observed(P>0.05). And there were no significant differences among the groups depending on curing methods(P>0.05).

• Journal of the korean academy of Pediatric Dentistry
• /
• v.41 no.4
• /
• pp.283-291
• /
• 2014

Patients with extreme anxiety who are unable to cope with dental treatment under non-pharmacological behavioral management method may require sedation, or other forms pharmacological behavioral management method. The aim of this retrospective study was to investigate the effect of concomitant administration of 0.1 mg/kg intramuscular midazolam with or without sevoflurane insufflation sedation on sedation depth and cardiopulmonary function in pediatric patients. We analysed the records of anesthesia on patients who received dental treatment under deep sedation using sevoflurane insufflation from January 2013 to March 2014. Thirty-six children, aged 3 to 6 years, undergoing dental treatment were sedated using either sevoflurane insufflation alone (Group S, n = 18) or a combination of intramuscular injection of 0.1 mg/kg midazolam plus sevoflurane insufflation (Group SM, n = 18). Upon comparison, the average entropy value of group SM was lower than that of group S, but there were no statistically significant difference between the two groups (p > 0.05). The average heart rate and mean arterial pressure of group SM were higher than those of group S (p < 0.05). Concomitant intramuscular injection of 0.1 mg/kg midazolam with sevoflurane insufflation sedation is not sufficient to enhance the quality of sedation.

• Journal of the Korean Geosynthetics Society
• /
• v.15 no.2
• /
• pp.25-33
• /
• 2016

This study was a basic research to obtain the knowledge of physical properties of the upper sedimented sandy soil in the Nakdong river delta area. The characteristics of shear strength and permeability with fine content and relative density were also investigated. The upper sedimented sandy soil near paddy and lower soft clay layers showed high percentage of fine content, and the rest parts had about 5% of fine content. The specific gravity regardless of depth and location was almost constant. The upper sedimented sandy soil mostly had particle size about 0.1 ~ 0.4mm regardless of sedimentation environment and has illite, a clay mineral, in the entire soil samples. The results of direct shear tests on remolded specimens of the upper sedimented sandy soil revealed that the friction angle and cohesion increased with relative density, but its effect was not significant. The fine content was significant, that as increasing it, the friction angle decreased and cohesion increased linearly. The permeability decreased with relative density and fine content, and the permeability of soil containing more than 15% of fine content was independent on the relative density.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.20
• /
• pp.8815-8822
• /
• 2014

Background: The incidence of stomach cancer in India is highest in the state of Mizoram. In this population based matched case-control study, we evaluated the relationship between CYP450 2E1 RsaI polymorphism and risk of stomach cancer taking into considering various important dietary habits along with tobacco, alcohol consumption and H. pylori infection status. Materials and Methods: A total of 105 histologically confirmed stomach cancer cases and 210 matched healthy population controls were recruited. CYP2E1 RsaI genotypes were determined by PCR-RFLP and H. pylori infection status by ELISA. Information on various dietary, tobacco and alcohol habits was recorded in a standard questionnaire. Results: Our study revealed no significant association between the CYP2E1 RsaI polymorphism and overall risk of stomach cancer in Mizoram. However, we observed a non-significant protective effect of the variant allele (A) of CYP2E1 against stomach cancer. Tobacco smokers carrying C/C genotype have three times more risk of stomach cancer, as compared to non-smokers carrying C/C genotype. Both Meiziol and cigarette current and past smokers who smoked for more than 10 times per day and carrying the (C/C) genotype are more prone to develop stomach cancer. Smoke dried fish and preserved meat (smoked/sun dried) consumers carrying C/C genotype possesses higher risk of stomach cancer. No significant association between H. pylori infection and CYP2E1 RsaI polymorphism in terms of stomach cancer was observed. Conclusions: Although no direct association between the CYP2E1 RsaI polymorphism and stomach cancer was observed, relations with different tobacco and dietary risk habits in terms of developing stomach cancer exist in this high risk population of north-eastern part of India. Further in-depth study recruiting larger population is required to shed more light on this important problem.