• Journal of the Korean Society of Marine Environment & Safety
• /
• v.26 no.6
• /
• pp.681-688
• /
• 2020

Approximately 6,000 chemicals are transported through the sea, including hazardous and noxious substances (HNS), which cause marine pollution and are harmful to marine life. The HNS discharged into the sea during the maritime transportation process undergoes physical and chemical changes on the sea surface and in seawater, and some types of HNS sink and are deposited on the seabed. The HNS deposited on the seabed adversely affects the benthic ecosystem, and hence, it is desirable to detect, treat, and recover the HNS on the seabed. Therefore, this study was conducted to analyze the performance requirements that should be considered as the top priority when developing a mechanical system for recovering the HNS deposited on the seabed. Various types of existing dredging devices used for collecting and recovering pollutants from river beds and seabeds were investigated, and 10 performance indices for the mechanical devices were selected. The new performance requirements for the development of the seabed-deposited HNS recovery system were proposed using performance indices. By considering the depth of water in domestic seaports, some of the performance requirements of the mechanical system for recovering deposited HNS from the seabed were obtained as follows: production rate (50-300 ㎥/hr), maximum operation depth (50 m), sediment type (most forms), percentage of solids (10 % or higher), horizontal operating accuracy (±10 cm), limiting currents (3-5 knots). These performance requirements are expected to be useful in the conceptual and basic design of mechanical systems for recovering seabed-deposited HNS.

• Journal of Korea Water Resources Association
• /
• v.38 no.4 s.153
• /
• pp.313-321
• /
• 2005

The elimination and erosion of cohesive sediments in port and reservoir water can so far be processed only with mechanical evacuation methods under extreme energy expenditure. The so-called flushing jets do not serve the purpose because they cannot set the material spaciously in motion despite high shear stresses at the bed. Therefore this study aims to examine the resuspension of the deposited fine material($Al_{2}O_3$) under presence of gas bubbles in order to decreased cohesive sediments in multipurpose dam, port and lakes. In the case of laboratory trial important parameters considered are supplied amount of air and the consolidation time of the solid materials. With increasing gas content alumina remains in suspension at high pH values in the laboratory test, where the particles fall mote rapidly without air addition.

• Korean Journal of Environmental Biology
• /
• v.37 no.3
• /
• pp.268-277
• /
• 2019

Severe damages will result in human society, when several different critical natural phenomena coincide. One example relates to the resting cysts of Alexandrium species (dinoflagellates that cause paralytic shellfish poisoning), which are preserved in surface sediments throughout Osaka Bay, Japan. These cysts have been found to accumulate particularly densely in shallow areas in the inner parts of Osaka Bay, where a tsunami caused by an earthquake could occur any time. Damage by a tsunami could cause a change of the coastal ecosystems at Osaka Bay including the resuspension of surface sediments containing resting Alexandrium tamarense cysts and the subsequent redistribution of the cysts in newly deposited sediment. Under certain environmental conditions, these cysts could germinate and form dense blooms, leading to paralytic shellfish poisoning. Such a scenario could also affect other coastal areas, including the southern coast of the Korean Peninsula.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2005.05b
• /
• pp.393-398
• /
• 2005

Suspended fine mineral particles are deposited at the areas with low flow velocity and low transportation capacity in rivers, reservoirs and lakes. It can be contaminated by heavy metals. Examples of problem fields art dredging of sediment, water pollutants, and maintenance of navigation channels and construction works. To deal with the settling problems it is necessary to understand tile physico-chemical characteristics of cohesive sediment under varying density of particle and ion addition(NaOH, HCl, NaCl), which is dissolved in river, because fine-grained cohesive sediment can lead to flocculation with the physico-chemical influences and takes different characteristics. Experiments with fresh and saline water are followed with fine-grained sediments(alumina and quartz) in settling columns. Settling velocity of suspended fine particles in still water was measured with a pressure sensor(maximum 10 mbar). Until the initial concentration of 20,000 mg/1 of alumina and quartz the settling velocity was on the increase. Above this initial concentration was it on the decrease. In an acid condition, which causes strong flocculation, average settling velocity of quartz powder was high. In an alkaline water low average settling velocity of it was observed. However, alumina behaved exactly contrarily.

• Journal of Wetlands Research
• /
• v.14 no.3
• /
• pp.375-384
• /
• 2012

The sedimentary processes of the Ganghwa tidal flat has been changed over 20 years because of the large-scale construction projects. The sedimentary environment of the Donggum tidal flat, located in the eastern part of Ganghwa tidal flat and in the lower reaches of Yeomha channel, was affected by changes the tidal current regime and estuarine circulation. These resulted an occurrence of rapid deposition in the tidal flat. The silt-clay laminated silt facies in the upper parts of two core sediments suggested that deposition had been relatively high in the tidal flat. The sedimentation rates from the cores using $^{210}Pb$ analysis were 3.25cm/year(st. 3) and 3.47cm/year(st. 5). However the short-term sediment accumulation rates from 2010 to 2012 were mostly less than 1cm/year, indicated that the sediments deposited relatively low rates. As a result, the sediment in the Donggum tidal flat rapidly accumulated during 2000s due to constructions of man-made structures. Recently, the increase of elevation in the tidal flat resulted to show relatively low sedimentation rate with seasonal variations.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.3
• /
• pp.595-605
• /
• 1994

The field observations. data analyses and numerical experiments are performed to investigate the short and long term beach deformation mechanisms in Haeundae beach. The schematic diagrams of deposition and erosion mechanism due to the attack of typhoons are described from the analysis on the beach widths and profiles. The short term beach deformation depends strongly on the characteristics of incident waves and wave-induced currents. The main incident wave and the calibration parameters of the shoreline change model are determined using the beach width data. Beacause the main incident wave approaches obliquly from the SE direction, the net westward longshore sediment transport occurs. Therefore the unbalance of longshore sediment budget in the east of the beach where the sediment source dose not exist causes a beach erosion. On the other hand, the deposited sand in the west is lost offshore by the storm wave action.

• Progress in Superconductivity and Cryogenics
• /
• v.22 no.2
• /
• pp.7-11
• /
• 2020

When rivers and lakes are contaminated with numerous contaminants, usually the contaminants are finally deposited on the sediments of the waterbody. Many clean up technologies have been developed for the contaminated sediments. Among several technologies dredging is one of the best methods because dredging removes all the contaminated sediments from the water and the contaminated sediments can be completely treated with physical and chemical methods. However the most worried phenomenon is suspension of fine particles during the dredging process. The suspended particle can release contaminants into water and resulted in spread of the contaminants and the increase of risk due to the resuspension of the precipitated contaminants such as heavy metals and toxic organic compounds. Therefore the success of the dredging process depends on the prevention of resuspension of fine particles. Advanced dredging processes employ pumping the sediment with water onto a ship and release the turbid water pumped with sediment into waterbody after collection of sediment solids. Before release of the turbid water into lake or river, just a few minutes allowed to precipitate the suspended particle due to the limited area on a dredging ship. However the fine particle cannot be removed by the gravitational settling over a few minutes. Environmental technology such as coagulation and precipitation could be applied for the settling of fine particles. However, the process needs coagulants and big settling tanks. For the quick settling of the fine particles suspended during dredging process magnetic separation has been tested in current study. Magnetic force increased the settling velocity and the increased settling process can reduce the volume of settling tank usually located in a ship for dredging. The magnetic assisted settling also decreased the heavy metal release through the turbid water by precipitating highly contaminated particles with magnetic force.

• Journal of Environmental Science International
• /
• v.20 no.9
• /
• pp.1151-1163
• /
• 2011

The bed change analysis near the opening gate of a dam or weir to release deposited sediments have been conducted mostly using the numerical models. However, the use of unverified input parameters in the numerical model is able to produce the different results with natural and real conditions. Also, the bed changes near the opening gate of a dam or weir calculated with a numerical model could be varied depending on the geometry extent included the downstream area with supercritical flow in the model. In addition, the different time steps could provide different results in the bed change calculation, even though other conditions such as input parameters, geometries, and total simulation time were same. Therefore, in this study, hydraulic experiments were performed to validate the eddy viscosity coefficient which is the one of important input parameters in the RMA2 model and relevant to variation of simulation results. The bed changes were calculated using the SED2D model based on flow results calculated in the RMA2 model with the verified and selected eddy viscosity coefficient and also compared with experimental results. The bed changes near the opening gate were underestimated in the numerical model comparing with experimental results except only the numerical case without the modeling section of sediment release pipe and downstream area where the supercritical flow was produced. For the simulation of minimum time steps, different shapes of scour hole were produced in numerical and physical modeling.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.23 no.2
• /
• pp.145-154
• /
• 1990

Amounts of total suspended matter(TSM) around the Kori waters have been monitored for two years to understand the dispersal pattern of fine-grained sediment. Average concentration of the TSM is $3\~4\;mg/\iota$ in the surface and $3.5\~5\;mg/\iota$ in the near-bottom water. Semi-quantitative analysis for the four major clay minerals in TSM is also performed. The average relative abundance of each clay mineral such as illite, kaolinite, chlorite, and smectite is $65\%,\;17\%,\;17\%$, and $1\%$, respectively. It seems that the majority of recent fine-grained sediment deposited around the Kori area is derived from the Nakdong River. The texture of surface sediment is also dominated by fine-grained fraction leading up to $90\%$ of silt and clay content. The grain size decreases seaward progressively.

• Journal of the Mineralogical Society of Korea
• /
• v.26 no.2
• /
• pp.65-80
• /
• 2013

Sediment transport mechanism and distribution of organic sediments are elucidated by the study of particle size, mineralogy, organic matters and microfossils of the surface samples collected from seafloor adjacent Dokdo island. Shallow marine sediments are dominated by coarse- grained sediments including gravel and sand, and their sedimentation has mainly been controlled by traction. While the samples collected from oceanic zone are characterized by high contents of fine- grained sediments such as silt and mud in bulk sediments, and the changes of mineral compositions including clay minerals and feldspar, and the fine sediments have been deposited mainly by suspension. The change of organic sedimentary communities is detected between neritic and oceanic zone. Although marine organic matter is predominant in neritic zone, terrestrial organic matter is monopolized according to increasing water depth. This trend is associated with grain size of sediments. The results also suggest that high pollen concentrations in whole organic matters may played an important role in excessive organic carbon in sediment.