• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제13권7호
• /
• pp.3433-3446
• /
• 2019

Aiming at the high complexity of traditional single-channel demodulation algorithm for PCMA signals, a new demodulation algorithm based on neural network is proposed to reduce the complexity of demodulation in the system of non-cooperative PCMA communication. The demodulation network is trained in this paper, which combines the preprocessing module and decision module. Firstly, the preprocessing module is used to estimate the initial parameters, and the auxiliary signals are obtained by using the information of frequency offset estimation. Then, the time-frequency characteristic data of auxiliary signals are obtained, which is taken as the input data of the neural network to be trained. Finally, the decision module is used to output the demodulated bit sequence. Compared with traditional single-channel demodulation algorithms, the proposed algorithm does not need to go through all the possible values of transmit symbol pairs, which greatly reduces the complexity of demodulation. The simulation results show that the trained neural network can greatly extract the time-frequency characteristics of PCMA signals. The performance of the proposed algorithm is similar to that of PSP algorithm, but the complexity of demodulation can be greatly reduced through the proposed algorithm.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제14권7호
• /
• pp.2891-2903
• /
• 2020

Phase-generated carrier (PGC) demodulation algorithm is the main demodulation methods in Fiber-optic interferometric sensors (FOISs). The conventional PGC demodulation algorithms are influenced by the carrier phase delay between the interference signal and the carrier signal. In this paper, an automatic carrier phase delay synchronization (CPDS) algorithm based on orthogonal phase-locked technique is proposed. The proposed algorithm can calculate the carrier phase delay value. Then the carrier phase delay can be compensated by adjusting the initial phase of the fundamental carrier and the second-harmonic carrier. The simulation results demonstrate the influence of the carrier phase delay on the demodulation performance. PGC-Arctan demodulation system based on CPDS algorithm is implemented on SoC. The experimental results show that the proposed algorithm is able to obtain and eliminate the carrier phase delay. In comparison to the conventional demodulation algorithm, the signal-to-noise and distortion ratio (SINAD) of the proposed algorithm increases 55.99dB.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 학술회의 논문집 정보 및 제어부문 A
• /
• pp.71-74
• /
• 2003

The signal processing algorithm for a PSD(Position Sensitive Detector) using amplitude modulation/demodulation is addressed in this paper. Dark currents and external noises such as daylight and fluorescent lights are eliminated by using amplitude modulation/demodulation and a low pass filter. The proposed amplitude modulation/demodulation method for a PSD sensor is compared with pulse amplitude modulation method. The proposed amplitude modulation is proved to be more accurate and robust than PAM method by analysis and experiments. Multiple measurements using one PSD sensor by amplitude modulation/demodulation is also addressed. The Power variation of light source is compensated by normalization process using a divider.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 춘계학술대회논문집
• /
• pp.397-402
• /
• 2003

The FM demodulation method for a bulk homodyne laser interferometer is presented. The Doppler frequency that represents the surface velocity of a vibrating object is obtained by using the bulk homodyne laser interferometer, and converted to the voltage signal by using the proposed analogue FM demodulation circuit. The DC offsets of the interferent signals that are obtained from the bulk homodyne interferometer are eliminated by using a simple subtraction. The new method for compensation of the asymmetry of each channels is presented. The light power variation of the interferometer is normalized by using the Auto Gain Controller(AGC). The proposed FM demodulation algorithm is proved by the theoretical method, and validated by the experimental results. In experiments, the proposed FM demodulation algorithm is compared with the conventional demodulation methods.

• 전자공학회논문지A
• /
• 제31A권7호
• /
• pp.29-35
• /
• 1994

The performance of continuous phase modulation signals is well known for the coherent demodulation. But the carrier recovery circuits of the coherent receiver have long acquisition time and the receiver experiences high error floors for fading channels. In this paper, we propose the differential demodulation of 2-h continuous phase modulation signals. The sets of modulation indices of 2-h phase codes adequate to the differential demodulation for differentially encoded input are obtained and the average bit error probability in Additive White Gaussian Noise environments is derived and analyzed.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제10권12호
• /
• pp.5401-5421
• /
• 2016

Both low-density parity-check (LDPC) codes and the multiple access technique of spatially coupling data transmission (SCDT) can be expressed in bipartite graphs. To improve the performance of iterative demodulation and decoding for SCDT, a novel joint sparse graph (JSG) with SCDT and LDPC codes is constructed. Based on the JSG, an approach for iterative joint demodulation and decoding by belief propagation (BP) is presented as an exploration of the flooding schedule, and based on BP, density evolution equations are derived to analyze the performance of the iterative receiver. To accelerate the convergence speed and reduce the complexity of joint demodulation and decoding, a novel serial schedule is proposed. Numerical results show that the joint demodulation and decoding for SCDT based on JSG can significantly improve the system's performance, while roughly half of the iterations can be saved by using the proposed serial schedule.

• 전기학회논문지
• /
• 제62권6호
• /
• pp.756-761
• /
• 2013

This paper propose the new demodulation method that can detect resolver signal's peak at the time of position estimation when the position information is required during current controller period. The proposed method is performed in a synchronous demodulation way with exciting signal and also cover a capability which can compensate the lag element of exciting signal caused by the resolver's inductive component and filter circuit. This paper carried out the experiment to investigate the validity and performance of the suggested method by using the test board made up of DSP and demodulation circuit. The test results show that the proposed method is theoretically clear and work completely as expected from making sure of sampling resolver signal's peak at the time of position estimation. In addition, Software position tracking algorithm is executed with the demodulated signals generated by the suggested method and an exact position can be estimated.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제7권4호
• /
• pp.767-783
• /
• 2013

This paper aims at designing a selective demodulation scheme based on Log-likelihood Ratio threshold (SDLT) instead of the conventional adaptive demodulation (ADM) scheme, by using rateless codes. The major difference is that the Log-likelihood ratio (LLR) threshold is identified as a key factor to control the demodulation rate, while the ADM uses decision region set (DRS) to adjust the bit rate. In the 16-QAM SDLT scheme, we deduce the decision regions over an additive white Gaussian channel, corresponding to the variation of LLR threshold and channel states. We also derived the equations to calculate demodulation rate and bit error rate (BER), which could be proven by simulation results. We present an adaptation strategy for SDLT, and compare it with ADM and adaptive modulation (AM). The simulation results show that our scheme not only significantly outperforms the ADM in terms of BER, but also achieves a performance as good as the AM scheme. Moreover, the proposed scheme can support much more rate patterns over a wide range of channel states.

• Journal of the Optical Society of Korea
• /
• 제14권3호
• /
• pp.240-244
• /
• 2010

In this work, we used PWM sampling for demodulation of a fiber-optic interferometric current transformer. The interference signal from a fiber-optic CT is sampled with PWM triggers that produce a 90-degree phase difference between two consecutively sampled signals. The current-induced phase is extracted by applying an arctangent demodulation and a phase unwrapping algorithm to the sampled signals. From experiments using the proposed demodulation, we obtained phase measurement accuracy and a linearity error, in AC current measurements, of ~2.35 mrad and 0.18%, respectively. The accuracy of the proposed method was compared with that of a lock-in amplifier demodulation, which showed only 0.36% difference. To compare the birefringence effects of different fiber-optic sensor coils, a flint glass fiber and a standard single-mode fiber were used under the same conditions. The flint glass fiber coil with a Faraday rotator mirror showed the best performance. Because of the simple hardware structure and signal processing, the proposed demodulation would be suitable for low-cost over-current monitoring in high voltage power systems.

• 한국통신학회논문지
• /
• 제38B권10호
• /
• pp.824-831
• /
• 2013

델타 구동 GMSK는 바이폴라 델타 신호로 가우시안 펄스를 생성하고 $+T_b/2$와 $-T_b/2$ 사이의 차분 신호로 위상변조하는 방식이다. 이러한 방식에 대한 복조는 기존의 GMSK와는 다르게 설계해야 한다. 본 논문에서는 인접한 비트 간의 위상 변화를 검출하고 위상 영역을 경판정한 다음에 상태 전이로 이진 데이터를 복원하는 방식을 설계하였다. AWGN 채널에 대한 전산모의실험 결과, 이진 데이터의 런 랭스에 의한 비트 오율의 영향이 확인되었으며, 이론적인 코히어런트 복조의 BER과 비교해서 $BT_b$=0.3에 대하여 2[dB] 정도의 성능 저하가 있는 것으로 분석되었다.