• The Transactions of the Korean Institute of Power Electronics
• /
• v.22 no.2
• /
• pp.181-184
• /
• 2017

This study analyzes the turn-on and turn-off transients of a metal-oxide-semiconductor field-effect transistor (MOSFET) with high-switching frequency systems. In these systems, the voltage distortion becomes serious at the output terminal of a Vienna rectifier by the turn-off delay of the MOSFET. The current has low-order harmonics through this voltage distortion. This paper describes the transient of the turn-off that causes the voltage distortion. The algorithm for reducing the sixth harmonic using a proportional-resonance controller is proposed to improve the current distortion without complex calculation for compensation. The reduction of the current distortion by high-switching frequency is verified by experiment with the 2.5-kW prototype Vienna rectifier.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.501-502
• /
• 2007

This paper describes a distance relay that operates in conjunction with a current transformer (CT) compensation algorithm. A distance relay detects a fault based on the ratio of the voltage to the current. If a CT saturates, the calculated impedance becomes larger. This causes maloperation or operating time delay of the distance relay. A compensating algorithm estimates the correct secondary current from the severely distorted currents even when the measurement CTs are used. The correct current is estimated by adding the calculated magnetizing current to the measured secondary current. Test results show that the proposed distance relay can detect a fault without the operating time delay even when the secondary currents are extremely distorted because of use of measurement CTs.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4B
• /
• pp.387-393
• /
• 2009

In this paper, we have considered the network performance of the VoIP service with the measurement by an emulator, and analyzed the major factors to affect its performance. Also, we have used the measured values to investigate the traffic variations, where their values were observed in the commercial operated network after the delay, jitter and packet loss, and loss compensation methods were applied as the dominant elements. It is expected that our presented results will be a good data to provide the high-quality of voice service in the Internet.

• Proceedings of the KIPE Conference
• /
• 1996.06a
• /
• pp.109-112
• /
• 1996

In this paper, we composed utility interactive photovoltaic generation system of current source inverter, and controlled that low harmonic and high power factor are hold by supposing control and compensation method which is concerned with synchronous signal distortion and modulation delay. And we put parallel resonant circuit into dc link, so, magnitude of direct reactance was reduce by restraining direct current pulsation which had accumulation of pulsating power in alternating electrolytic condenser. Also we controlled that modulation factor is operated around maximum output of solar cell.

• Proceedings of the IEEK Conference
• /
• 1998.06a
• /
• pp.639-642
• /
• 1998

This paper proposes a new wide-band beamforming which has guassian weighting. For the prupose of measurement this beam is formed by using all sensors toghether, not octave-by-octave. Weighting is applied to each sensor before time-delay compensation as a frequency-dependent function. As the resutls of the simulation of the proosed algorithm for nested linear array having 17 sensors for each octave, it is confirmed that beam can be formed with all sensors together and uniform directivity index can be achieved by proposed algorithm.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.825-828
• /
• 1999

In this paper, we design the analog phase shifter for the elimination of the ghost signal. Compensation of the delay between the reference signal and the relatively delayed signal is possible. This phase shifter uses the vector summing method. We use for the attenuator in our system FETs. The phase shifter is operated at the 200MHz and composed by lumped elements. The proposed analog phase shifter is simulated by the HP ADS software.

• 제어로봇시스템학회:학술대회논문집
• /
• 1990.10a
• /
• pp.831-836
• /
• 1990

Real-time implementations of active noise controller are proposed and tested. For compensation of time delay of feed-back path, the n-step ahead prediction is applied. And predicting source noise and reflection noise respectively, reflection noise can be cancelled. For real-time processing, the DSP56001(Digital Signal Processor) is used. Experimental results show that the proposed controller is stable and of good performance.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.10a
• /
• pp.541-544
• /
• 2001

The difference of transfer mode between TDMA and ATM causes cell delay variation(CDV) to be generated in the receiving station. I proposed a optimization method of timestamps for discrete-timestamps mechanism to compensate CDV and an application method in multiple timestamps mechanism.

• Proceedings of the KIPE Conference
• /
• 2013.07a
• /
• pp.532-533
• /
• 2013

본 논문에서는 다단 멀티레벨 컨버터(Cascaded Multilevel Converter) 방식으로 개발된 STATCOM에서 Phase-Shifted PWM 시 발생할 수 있는 개별 Cell 인버터의 출력 전압 위상 지연을 보상하여 시스템의 성능을 개선하였다.

• Proceedings of the Korea Institute of Convergence Signal Processing
• /
• 2003.06a
• /
• pp.296-299
• /
• 2003

This paper shows a novel and simple IIR/FIR QMF(quadrature mirror filter) filter banks, mixed IIR and FIR structure. Here, FIR filters used for phase compensation. In this paper, we introduced analysis and synthesis filter banks, which used FIR linear phase filters and all pass filters. In result, phase response of analysis and synthesis filter banks become approximately linear characteristic. Simultaneously, a liasing distortion can be completely canceled.