• The Journal of the Acoustical Society of Korea
• /
• v.13 no.2
• /
• pp.38-49
• /
• 1994

This paper proposes Echo canceller used in simultaneous two-way ('full-duplex') transmission of data signals over two-wire circuits which can be achieved by using a hybrid coupler. This Echo canceller uses sequential processing instead of parallel processing with conventional adaptive digital filter. This structure reduces the number of multipliers. Thus, this structure is much more suitable for IC implementation. This Echo canceller operates according to the 'Stochastic Iteration Algorithm(SIA).' SIA algorithm has merit of good performance and small hardware requirement.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.55 no.9
• /
• pp.401-408
• /
• 2006

In a multi-sensor multi-target tracking systems, the local sensors have the role of tracking the target and transferring the measurements to the fusion center. The measurements from the same target can arrive out of sequence called the out-of-sequence measurements(OOSMs). Out-of-sequence measurements can arise at the fusion center due to communication delay and varying preprocessing time for different sensor platforms. In general, the track fusion occurs to enhance the tracking performance of the sensors using the measurements from the sensors at the fusion center. The target informations can wive at the fusion center with the clutter informations in cluttered environment. In this paper, the OOSM update step with MPDA(Most Probable Data Association) is introduced and tested in several cases with the various clutter density through the Monte Carlo simulation. The performance of the MPDA with OOSM update step is compared with the existing NN, PDA, and PDA-AI for the air target tracking in cluttered and out-of-sequence measurement environment. Simulation results show that MPDA with the OOSM has compatible root mean square errors with out-of-sequence PDA-AI filter and the MPDA is sufficient to be used in out-of-sequence environment.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.3
• /
• pp.1007-1015
• /
• 2017

This paper proposes a new control technique of energy storage system (ESS) for smoothing the active power of renewable energy sources (RES) such as photovoltaic and wind turbine generation. As the penetration of RES into grid increases, it is difficult to maintain the permissible level of power quality, that is, voltage and frequency fluctuation in power systems. To solve this problem, ESS control methods using low pass filter (LPF) have been proposed for mitigating the fluctuation of RES output. However, those have a lot of drawbacks which need to be supplemented. Hence, this paper presents the improved active power control with additional reactive power control for maintaining power quality properly. The proposed method minimizes the capacity of ESS to be required for smoothing RES output fluctuation through mitigation of phase delay problem in LPF. In addition, the voltage regulation improves by using additional reactive power control. The proposed method was verified through simulation analysis using PSCAD/EMTDC.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.11a
• /
• pp.130-134
• /
• 1999

In this paper, we introduce a modified interference cancellation scheme for multiuser detection in CDMA. This detector uses successive interference canceller(SIC) and the divided received signal concepts. The active users are splits into two groups large signal power group and small signal power group- throughout ranking, matched filter, decision, regeneration. And each group is subtracted from the received signal respectively to obtain good BER performance. Each of the resulting signal is become respectively SICs input signal The computer simulation and analysis of structure demonstrate that the proposed SIC keeps the SICs BER performance, complexity and reduces SICs delay time.

• Journal of Power Electronics
• /
• v.15 no.4
• /
• pp.1093-1104
• /
• 2015

A standard repetitive controller (RC) is theoretically able to replace a bank of resonant controllers in harmonic signals tracking applications. However, the traditional RC has some drawbacks such as a poor dynamic response and a complex structure to compensate grid frequency deviations for an effective unified power quality conditioner (UPQC) control scheme. In order to solve these problems, an improved RC with an outstanding dynamic response and a simplified grid frequency adaptive scheme is proposed for UPQC control systems in this paper. The control strategy developed for the UPQC has delay time, i.e., one-sixth of a fundamental period (T_p/6), repetitive controllers. As a result, the UPQC system can provide a fast dynamic response along with good compensation performance under both nonlinear and unbalanced loads. Furthermore, to guarantee the excellent performance of the UPQC under grid frequency deviations, a grid frequency adaptive scheme was developed for the RC using a simple first order Padé's approximation. When compared with other approaches, the proposed control method is simpler in structure and requires little computing time. Moreover, the entire control strategy can be easily implemented with a low-cost DSP. The effectiveness of the proposed control method is verified through various experimental tests.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.17 no.5
• /
• pp.409-415
• /
• 2012

This paper presents a new software-based on-line dead-time compensation technique for a single-phase grid-connected photovoltaic (PV) inverter system. To prevent a short circuit in the inverter arms, a switching delay time must be inserted in the pulse width modulation (PWM) signals. This causes the dead-time effect, which degrades the system performance around zero-crossing point of the output current. To reduce the dead-time effect around the zero-crossing point of grid current, a harmonic mitigation of grid current is used as an additional part of the synchronous frame current control scheme. This additional task mitigates the harmonic components caused by the dead-time from the grid current. Simulation and experimental results are shown to verify the effectiveness of the proposed dead-time compensation method in the single-phase grid-connected inverter system.

• Journal of Power Electronics
• /
• v.17 no.3
• /
• pp.798-810
• /
• 2017

This paper presents a combined system of a small-capacity inverter and multigroup delta-connected thyristor switched capacitors (TSCs). The system is referred to as a hybrid static compensator (HSC) and has the functions of dynamic reactive power compensation and harmonic suppression. In the proposed topology, the load reactive power is mainly compensated by the TSCs. Meanwhile the inverter is meant to cooperate with TSCs to achieve continuous reactive power compensation, and to filter the harmonics generated by nonlinear loads and the TSCs. First, the structure and mathematical model of the HSC are discussed Then the control method of the HSC is presented. An improved reduced order generalized integrator (ROGI)-based selective current control method is adopted in the inverter to achieve high-performance reactive and harmonic current compensation. Meanwhile, a switch control strategy is proposed to implement precise and fast switching of the TSCs and to avoid changing the time delay needed by the conventional switch strategy. Experiments are implemented on a 20 KVA HSC prototype and the obtained results verify the validity of the proposed HSC system.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.377-381
• /
• 2006

A seismic survey for gas hydrate have performed over the East sea by the KIGAM since 1997. General indicator of gas hydrate in seismic data is commonly inferred from the BSR(Bottom Simulating Reflector) that occurred parallel to the sea floor, amplitude decrease at the top of the BSR, amplitude blanking at the bottom of the BSR, decrease of the interval velocity and the reflection phase reversal at the BSR. In this paper we had analyzed optimum parameters of the field data to detect the 9as hydrate. Shot delay correction is applied 95ms, spherical divergence correction is applied velocity library 3, bandpass filter is applied 25-30-115-120Hz deconvolution operator length is applied 60ms, lag is 6ms and accurate velocity analysis NMO correction, stack is performed. Geobit 2.11.0 developed by the KIGAM was used for all data processing. Processing results say that the BSR occurred parallel to the sea floor were shown at 3,150m/s of two way travel time from the sea floor through shot point 5,000-5,610, and identified the interval velocity decrease around BSR and the reflection phase reversal corresponding to the reflection at the sea floor.

• Journal of Integrative Natural Science
• /
• v.11 no.4
• /
• pp.192-196
• /
• 2018

The mobile agent paradigm can be exploited in a variety of ways, ranging from low-level system administration tasks to middle ware to user-level applications. Mobile agents can be useful in building middle-ware services such as active mail systems, distributed collaboration systems, etc. An active mail message is a program that interacts with its recipient using a multimedia interface, and adapts the interaction session based on the recipient's responses. The mobile agent paradigm is well suitable to this type of application, since it can carry a sender-defined session protocol along with the multimedia message. Mobile agent communication is possible via method invocation on virtual references. Agents can make synchronous, one-way, or future-reply type invocations. Multicasting is possible, since agents can be aggregated hierarchically into groups. A simple check-pointing facility has also been implemented. Another proposed solution is to use multi agent computer systems to access, filter, evaluate, and integrate this information. We will present the overall architectural framework, our agent design commitments, and agent architecture to enable the above characteristics. Besides, the each information needed a mobile agent system such as text, graphic, image, audio and video etc, constructed a great capacity multimedia database system. However, they have problems in establishing connections over multiple subnetworks, such as no end-to-end connections, transmission delay due to ATM address resolution, no QoS protocols. We propose a new connection management scheme in the thesis to improve the connection management involved of mobile agent systems.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.12
• /
• pp.39-47
• /
• 2010

This paper proposes a fully-utilized block-based 2D DWT architecture, which consists of four 1D DWT filters with two-channel QMF PR Lattice structure. For 100% hardware utilization, we propose a new method which processes four input values at the same time. On the contrary to the image-based 2D DWT which requires large memories, we propose a block-based 2D DWT so that we only need 2MN-3N of storages, where M and N stand for filter lengths and width of the image respectively. Furthermore, the proposed architecture processes in horizontal and vertical directions simultaneously so that it computes the DWT for an $N{\times}N$ image within a period of $N^2(1-2^{-2J})/3$. Compared to existing approaches, the proposed architecture shows 100% of hardware utilization and high throughput rate. However, the proposed architecture may suffer from the long critical path delay due to the cascaded lattices in 1D DWT filters. This problem can be mitigated by applying the pipeline technique with maximum four level. The proposed architecture has been designed with VerilogHDL and synthesized using DongbuAnam $0.18{\mu}m$ standard cell.