• Journal of the Korean Society of Safety
• /
• v.32 no.2
• /
• pp.112-116
• /
• 2017

Present study investigated the influence of time step size, turbulent eddy viscosity, and the number of layer on rapid and unsteady propagation of dam break flow. When the time step size had a value such that it resulted in Cr of 0.89, a significant numerical oscillation was observed in the vicinity of the wave front. Higher turbulent viscosity ensured smooth and mild slope of velocity and water stage compared with the flow behavior by no viscosity. The vertical velocity at the lower layer positioned near the bottom showed lower velocity compared with other layers.

• 한국전산유체공학회:학술대회논문집
• /
• 2011.05a
• /
• pp.65-67
• /
• 2011

The moment-of-fluid (MOF) method is a new volume-tracking method that accurately treats evolving material interfaces. The MOF method uses moment data, namely the material volume fraction, as well as the centroid, for a more accurate representation of the material configuration, interfaces and concomitant volume advection. In this paper, unstructured mesh extension of the MOF method is to be presented. The MOF method is coupled with a stabilized finite element incompressible Navier-Stokes solver for two materials. The effectiveness of the MOF method is demonstrated with a free-surface dam-break problem.

• Journal of computational fluids engineering
• /
• v.19 no.2
• /
• pp.79-85
• /
• 2014

An air-water free surface flow simulation by using the Lattice Boltzmann Method(LBM) has not been studied a lot compared with the done by the Navier-Stoke equation. This paper shows the LBM is as one of the application tools for the free surface movement over an obstacle. The Mezo scaled application tool has been developed with two dimensional and nine discretized velocity direction using conventional lattice Bhatnagar-Gross-Krook model. Boundary conditions of a halfway-based for solid wall and a kinematic-based for interface are adopted. A validation case with a trapezoidal shape bump to make a comparison between freesurface movements from computational results and experimental ones was described with grid size dependency.

• The Journal of the Korea Contents Association
• /
• v.13 no.3
• /
• pp.428-434
• /
• 2013

With the increase of the frequency in large-scale floods and natural disasters, the demands for highly accurate numerical river models are also rapidly growing. Generally, flows in rivers are modeled with previously developed and well-established numerical models based on shallow water equations. However, the so-far-developed models reveal a lot of limitations in the analysis of discontinuous flow or flow which needs accurate modeling. In this study, the numerical shallow water model based on the discontinuous Galerkin method was applied to the simulation of one-dimensional transcritical flow, including dam break flows and a flow over a hump. The favorable agreement was observed between numerical solutions and analytical solutions.

• Journal of the Korean Society of Safety
• /
• v.31 no.2
• /
• pp.76-82
• /
• 2016

A 2-D hydrodynamic model for predicting the movement of debris flow was developed. The developed model was validated against a dam break flow problem conducted in EU CADAM project, and the performance of the model was shown to be satisfactory. In order to suggest structural alternative for hazardous zone vulnerable to debris flow disaster, two types of initial mass distribution and two shapes of defensive structure were considered. It was found that 1) the collapse of debris mass initiated with square pyramid shape induced more damage compared with that of cubic shape; and 2) a defensive structure with semi-circular shape was vulnerable to debris flow disaster in terms of debris control or primary defense compared with that of rectangular-shaped structure.

• Korean Journal of Hydrosciences
• /
• v.8
• /
• pp.31-40
• /
• 1997

Flow carrying capacity of water distribution systems is getting reduced by deterioration of pipes in the systems. The objective of this paper is to present a managerial decision-making model for the rehabilitation of water distribution systems with a mininum cost. The decisions made by the model also satisfy the requirements for discharge and pressure at demanding nodes in the systems. Replacement cost, pipe break repair cost, and pumping cost are considered in the economic evaluation of the decision along with the break rate and the interest rate to determine the optimal replacement time for each pipe. Then, the hydraulic integrity of the water distribution system is checked for the decision by a pipe network simulator, KYPIPE, if discharge and pressure requirements are satisfied. In case the system does not satisfy the hydraulic requirements, the decision made for the optimal replacement time is revised until the requirments are satisfied. The model is well applied to an existing water distribution system, the Seoul Metropolitan Water Supply System (1st Phase). The results show that the decisions for the replacement time determined by the economic analysis are accepted as optimal and hydraulic integrity of the system is in good condition.

• Journal of Korea Water Resources Association
• /
• v.47 no.12
• /
• pp.1177-1185
• /
• 2014

This study suggests a new hydrostatic pressure distribution corrected for nonuniform flow over a channel of large slope. For analyzing shallow-water flows over large slope accurately, it is developed a finite-volume model incorporating the pressure distribution to the shallow water equations. Traveling speed of the hydraulic jump downstream a parabolic bump in the drain case is quite reduced by the weakened bottom gradient source term in the model with the pressure correction. In simulating the dam-break flow over a triangular sill, it is identified that the model with pressure correction could capture the water surface by the digital imaging measurements more than the model without that. Due to the pressure correction decreasing the reflected flows on and increasing overflows over the sill, there are good agreements in the experiment and the simulation with that. Therefore, this model is expected to be applied to such practical problems as flows in the spillway of dam or run-up on the beach.

• Journal of Korea Water Resources Association
• /
• v.38 no.2
• /
• pp.155-166
• /
• 2005

Upwind schemes are very well adapted to the discontinuous flow and have become popular for applications Involving dam break flow, transcritical Slow, etc. However, upwind schemes have been applied mainly to the idealized problems not to the natural channels with irregular geometry so far because of the error due to source terms. In this paper, the new type of upwind discretization of source terms, which uses the normalized Jacobian to discretize the source terms, is proposed. As results of tests to flows with source terms by the upwind models, the method proposed in this paper is proved as efficient and accurate. This generalized method for differencing source terms is simple and might beapplicable to diverse type of flux upwind discretization scheme in finite difference method.

• Journal of Korea Water Resources Association
• /
• v.42 no.12
• /
• pp.1079-1089
• /
• 2009

The objective of this study is to develop the accurate, robust and high resolution two-dimensional numerical model that solves the computationally difficult hydraulic problems, including the wave front propagation over dry bed and abrupt change in bathymetry. The developed model in this study solves the conservative form of the two-dimensional shallow water equations using an unsplit finite volume scheme and HLLC approximate Riemann solvers to compute the interface fluxes. Bed-slope term is discretized by the divergence theorem in the framework of FVM for application of unsplit scheme. Accurate and stable SGM, in conjunction with the MUSCL which is second-order-accurate both in space and time, is adopted to balance with fluxes and source terms. The exact C-property is shown to be satisfied for balancing the fluxes and the source terms. Since the spurious oscillations in second-order schemes are inherent, an efficient slope limiting technique is used to supply TVD property. The accuracy, conservation property and application of developed model are verified by comparing numerical solution with analytical solution and experimental data through the simulations of one-dimensional dam break flow without bed slope, steady transcritical flow over a hump and two-dimensional dam break flow with a constriction.

• Journal of Korea Water Resources Association
• /
• v.34 no.2
• /
• pp.187-195
• /
• 2001

In this study, a numerical model describing the shallow-water equations is newly developed by using a TVD scheme. The model has a second-order accuracy in time and space and is free from nonphysical oscillations, even in the vicinity of large gradients. Because a upwind based TVD scheme requires a Riemann solver, the HLLC scheme is employed in this model. To calibrate the applicability and accuracy, the developed model is used to simulate dam-break waves in an ideal channel and a sloshing flow n a paraboloidal basin. Agreements between numerical predictions and analytical solutions are very resonable.