• Korean Journal of Human Ecology
• /
• v.4 no.1
• /
• pp.36-45
• /
• 2001

This study was performed to determine the changes of maternal iron status during pregnancy cross sectionally, and to evaluate the appropriateness of the cut-off points of hemoglobin (Hb). hematocrit (Hct), serum transferrin receptor (sTfR) and sTfR : ferritin ratio for assessing iron deficiency status based on serum ferritin level (< 12${\mu}g$/L). Serum Hb concentrations in the first trimester were significantly higher (p < 0.05) than those in the second and third trimester. Serum levels of iron and ferritin in the third trimester were significantly lower (p < 0.05) than those in the first and second trimester. On the other hand, sTfR:ferritin ratios in the third trimester were significantly higher (p < 0.05) than those in the first and second trimester. sTfR concentrations did not change significantly during pregnancy. The appropriate cut-off points of Hb were 11.5g/dL for whole period of pregnancy. 12.0g/dL for 1st trimester. and 11.5g/dL for both 2nd and 3rd trimester. The good cut-off points of Hct were 34% for whole period of pregnancy. 36% for 1st trimester. and 34% for both 2nd and 3rd trimester The suitable cut-off points of TIBC were 400${\mu}g$/dL for whole period of pregnancy. 360${\mu}g$/dL for 1st trimester, and 400${\mu}g$/dL for both 2nd and 3rd trimester. Any cut-off point of sTfR could not be selected because of its low sensitivity and specificity. The proper cut-off point of sTfR : ferritin ratio was 600 or 650 for all the periods determined except the first trimester. In conclusion, there were no reliable cut-off levels of sTfR and those of sTfR : ferritin ratio showed low specificity. The cut-off values of Hb and Hct for assessing iron deficiency were slightly higher than the values used to evaluate anemia. Thus, if appropriate cut-off levels were applied, Hb. Hct, or TIBC might be useful indices for evaluating iron deficiency as well as anemia.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.21 no.5
• /
• pp.447-454
• /
• 2011

This paper reports a filtered velocity feedback(FVF) controller, which is an alternative to direct velocity feedback(DVFB) controller. The instability problems due to high frequency response under DVFB can be alleviated by the suggested FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The FVF controller and the dynamics of clamped beams under forces and moments are first formulated. The effects of the design parameters(cut-off frequency, gain, and damping ratio) on the stability and the performance are then investigated. The cut-off frequency should be selected not to affect the system stability. The magnitude of the open loop transfer function(OLTF) at the cut-off frequency should be small. As increasing the gain of the FVF controller, the magnitude of the OLTF is increased, so that the closed loop response can be reduced more. The enhancement of the OLTF at the cut-off frequency is reduced but the phase behavior around the cut-off frequency is distorted, as the damping ratio is increased. The control performance is finally estimated for the clamped beam. More than 10 dB reductions in velocity response can be achieved at the modal frequencies from the first to eighth modes.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.264-270
• /
• 2011

This paper reports a filtered velocity feedback (FVF) controller, which is an alternative to direct velocity feedback (DVFB) controller. The instability problems due to high frequency response under DVFB can be alleviated by the suggested FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The FVF controller and the dynamics of clamped beams under forces and moments are first formulated The effects of the design parameters (cut-off frequency, gain, and damping ratio) on the stability and the performance are then investigated. The cut-off frequency should be selected not to affect the system stability. The magnitude of the open loop transfer function (OLTF) at the cut-off frequency should be small. As increasing the gain of the FVF controller, the magnitude of the OLTF is increased, so that the closed loop response can be reduced more. The enhancement of the OLTF at the cut-off frequency is reduced but the phase behavior around the cut-off frequency is distorted, as the damping ratio is increased The control performance is finally estimated for the clamped beam. More than 10dB reductions in velocity response can be achieved at the modal frequencies from the first to eighth modes.

• Journal of Power System Engineering
• /
• v.17 no.1
• /
• pp.58-63
• /
• 2013

The aerodynamic performance of double inlet sirocco fan is strongly dependent upon the design factors of impeller and scroll. In this paper, the change of scroll size was adopted to investigate the aerodynamic performances of double inlet sirocco fan and indoor PAC. Especially, a scroll expansion angle and a cut-off clearance ratio were considered to change the scroll size. In addition, the installation depth between double inlet sirocco fan and indoor PAC was considered. As a result, the total pressure efficiency of double inlet sirocco fan shows about 62%~73% according to the change of scroll expansion angles. Moreover, the flowrate performance of indoor PAC is the best at the condition of a scroll expansion angle of 8°, an installation depth of 15 mm and a cut-off clearance ratio of 8%.

• Journal of the Korean Society of Radiology
• /
• v.12 no.5
• /
• pp.677-682
• /
• 2018

This study evaluated the usefulness of the elasticity score and elasticity ratio in the differential diagnosis of benign and malignant lesion in breast elastography. We performed a retrospective analysis based on the results of core needle biopsy histology. The Mann-Whitney U test was used to confirm the difference between the 5-degree elasticity score and the Fisher's Exact test. ROC curve analysis was used to determine the elasticity score and the best cut-off value of the elasticity ratio for the prediction of malignant lesions. There was a statistically significant difference (p= .000) between the homogeneity of the elasticity score and the difference of the elasticity ratio between the benign and malignant lesion groups. On the ROC curve analysis, the elasticity score and the elasticity ratio for predicting benign and malignant lesion were determined as AUC 0.806, 0.824, cut-off value 3, 4.4 (p= .001). Therefore, the elasticity score and elasticity ratio may be useful in the differential diagnosis of breast mass.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1998.10b
• /
• pp.668-673
• /
• 1998

The specimen of current study has the same type with the 3-span slabs of Burns et al used in the study by Mojtahedi/Gamble, which laid a ground for the revision of the ACI318-77 code to the ACI 318-83 code. But those specimens was failed prematurely before it reached the ultimate strength which the specimen had. The reason is that bonded reinforcements were cut off where there is no need for the flexural reinforcement. As results. the slabs failed ultimately where the reinforcements was cut off. Thus, the tendon stresses of failure may have been much smaller than the values which culd reach if the bonded reinforcements were extended beyond the theoretical cut off points. On the based on the fact mentioned above. the specimens which had the same conditions as the specimens of Burns et al were used in the current study, but in which the reinforcements were distributed in a sequence for the reinforcements not to be cut anywhere in the 3-span. As a results, it was known that the current ACI code, revised by the result of Mojtahedi/Gamble's study, overestimated the effect of span/depth ratio on the members with high span/depth ratio. Thus it was concluded that the effect of span/depth ratio on the ultimate stress of unbonded tendon regulated by the current ACI code must be reconsidered and reevaluated.

• Journal of Sasang Constitutional Medicine
• /
• v.34 no.4
• /
• pp.27-37
• /
• 2022

Objectives The purpose of this study is to propose a method to more specifically identify Sasang constitutional risk factors of metabolic syndromes by adjusting the cut-off value of Korea Sasang Constitutional Diagnostic Questionnaire (KS-15). Methods Data of 1997 participants in Korean medicine Daejeon Citizen Cohort study (KDCC) were analyzed. Metabolic syndrome was defined according to the NCEP-ATP III, lifestyle information, and hematologic information including KS-15 and demographic characteristics were used as covariates. Results The 179 subjects with metabolic syndrome accounted for 9.0% of the total. As a result of determining the Sasang constitution for the KS-15 response based on the cut-off values (approximate 0.33), 0.5, and 0.6 of the constitutional score, when performed at the 0.6 cut-off model, the odds ratio of TE was 2.46 which showed a statistically significantly higher risk than the borderline group. For the accuracy of the model and the Area under the curve (AUC), the model accuracy based on the original cut-off of the KS-15 was 0.902 and AUC was 0.737. The accuracy of the model with cut-off of 0.5 and with of 0.6 were 0.904 and 0.902, respectively, and the AUCs were 0.687 and 0.741, respectively. Conclusion In this study, we confirmed that it is effective to increase the cut-off value of KS-15 to 0.6 in the metabolic syndrome risk model. It is expected that this could increase the accuracy of identifying high-risk groups for metabolic syndrome.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.181-181
• /
• 2012

The microwave probe for measuring plasma density is widely used for its advantages: First, it is not affected by the reactive gas. Second, it can measure local plasma parameters such as plasma density, plasma potential and plasma temperature. Third, it is simple and robust. A cut-off probe is the one of the most promising microwave probe. Recently, Kim et al. reveals the physics of the cut-off probe but the effect of the sheath on the determination of the plasma density is not explained. In this presentation, for taking account of sheath effects on determination of plasma density from the cut-off peak, a simplified circuit modeling and an E/M simulation are conducted. The results show that occupation ratio of sheath volume between two tips of the cut-off probe and subsequence pressure condition mainly change position of the cut-off peak with respect to plasma frequency. Magnitude of relative voltage taken on the impedance of sheath and the impedance of bulk plasma can explain this effect. Furthermore, effects of gap size, tip radius, and tip length ware revealed based on above analysis.

• Journal of the Korean Society of Radiology
• /
• v.13 no.4
• /
• pp.539-546
• /
• 2019

Liver biopsy is invasive and it is a risk of complications. Nevertheless, liver biopsy is gold standard for predicting liver fibrosis. To compensate for these shortcomings, in this study, the liver fibrosis stage was divided using Fibroscan(R) in 200 chronic hepatitis C patients. And, the usefulness and cut-off values of fibrosis index based on four factors(FIB-4), AST to platelet ratio index(APRI) and AST/ALT ratio(AAR) calculated as serum tests were investigated by analyzing ROC curve. As a result, using FIB-4 and APRI rather than AAR is appropriate for evaluation of liver fibrosis. And using APRI to predict significant Fibrosis(F2) and FIB-4 is considered useful for predicting cirrhosis(F4). By applying the advantages of the serum based liver fibrosis marker, which are convenient and repeatable, liver fibrosis follow-up term can be reduced, and furthermore, the prevalence of liver cirrhosis and hepatocellular carcinoma(HCC) can be reduced.

• Journal of the Korean GEO-environmental Society
• /
• v.23 no.5
• /
• pp.33-39
• /
• 2022

For a slag-cement-bentonite (slag-CB) cut-off wall, GGBS replaces a part of the cement mixed to build a CB cut-off wall, which is used to block the flow and leakage of pollutants or groundwater; prevent seawater infiltration; and repair or reinforcement an aged embankments. Slag-CB cut-off walls are used in various applications in different fields where groundwater control is required due to its excellent characteristics. Such properties include high strength, low permeability, high durability and chemical resistance. However, despite these advantages, slag-CB cut-off walls are not extensively studied in Korea and thus are not applied in many cases. Particularly, GGBS, which replaces cement in a mixture, has different properties depending on its country of production. Consequently, it is necessary to perform various studies on slag-CB cut-off walls that use GGBS produced in Korea in order to increase its usability. This study has evaluated the bleeding rate, setting time, strength, and permeability in relation to the cement replacement rate of GGBS produced in Korea for slag-CB cut-off walls, with the aim to increase its usability. The evaluation found that slag-CB cut-off walls, made of a mixture containing GGBS produced in Korea, have a lower bleeding rate and permeability, and higher strengththan CB cut-off walls. It was also analyzed that such improved performance is more effective with a higher cement replacement rate of GGBS.