• Proceedings of the KSRS Conference
• /
• 1999.11a
• /
• pp.107-114
• /
• 1999

The large-scale distribution of crops Is usually determined by climate. We present the results of a climate-crop prediction based on spatial bio-physical process model approach, implemented in a GIS (Geographic Information System) environment using several regional and global agriculture-environmental databases. The model utilizes daily climate data like temperature, rainfall, solar radiation being generated stocastically by in-built model weather generator to determine the daily biomass and finally the crop yield. Crops are characterized by their specific growing period requirements, photosynthesis, respiration properties and harvesting index properties. Temperature and radiation during the growing period controls the development of each crop. The model simulates geographic/spatial distribution of climate by which a crop-growing belt can also be determined. The model takes both irrigated and non-irrigated area crop productivity into account and the potential increase in productivity by the technical means like mechanization is not considered. All the management input given at the base year 1995 was kept same for the next twenty-year changes until 2015. The simulated distributions of crops under current climatic conditions coincide largely with the current agricultural or specific crop growing regions. Simulation with assumed weather generated derived climate change scenario illustrate changes in the agricultural potential. There are large regional differences in the response across the country. The north-south and east-west regions responded differently with projected climate changes with increased and decreased productivity depending upon the crops and scenarios separately. When water was limiting or facilitating as non-irrigated and irrigated area crop-production effects of temperature rise and higher $CO_2$ levels were different depending on the crops and accordingly their production. Rise in temperature led to yield reduction in case of maize and rice whereas a gain was observed for wheat crop, doubled $CO_2$ concentration enhanced yield for all crops and their several combinations behaved differently with increase or decrease in yields. Finally, with this spatial modeling approach we succeeded in quantifying the crop productivity which may bring regional disparities under the different climatic scenarios where one region may become better off and the other may go worse off.

• Asian Journal of Atmospheric Environment
• /
• v.5 no.2
• /
• pp.65-78
• /
• 2011

Ozone ($O_3$) is a main component of photochemical oxidants, and a phytotoxic anthropogenic air pollutant. In North America and Europe, the current concentration of $O_3$ has been shown to have significant adverse effects on vegetation. In this review, we summarize the experimental studies on the effects of $O_3$ on the growth and photosynthetic activity of Japanese forest tree species to understand the present knowledge and provide sound basis for future research toward the assessment of $O_3$ impacts on Japanese forest ecosystem. Since the 1990s, several Japanese researchers have conducted the experimental studies on the effects of ambient levels of $O_3$ on growth and physiological functions such as net photosynthesis of Japanese forest tree species. Although the sensitivity to $O_3$ of whole-plant growth is quite different among the species, it was suggested that the current ambient levels of $O_3$ in Japan are high enough to adversely affect growth and photosynthetic activity of Japanese forest tree species classified into high $O_3$ sensitivity group such as Japanese beech. The N load to soil has been shown to reduce the sensitivity to $O_3$ of Japanese larch and increase that of Japanese beech. To establish the critical level of $O_3$ for protecting Japanese forest tree species, therefore, it is necessary to take into account the N deposition from the atmosphere. There is little information on the combined effects of $O_3$ and other environmental factors such as elevated $CO_2$ and drought on growth and physiological functions of Japanese forest tree species. Therefore, it is necessary to promote the experimental study and accumulate the information on the combined effects of $O_3$ and any other abiotic environmental factors on Japanese forest tree species.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.8
• /
• pp.1-7
• /
• 2009

This study is intended to propose the environment friendly lighting which can be excluded the element of obtrusive light(glare, spill light) and to make the sight environment of the external and internal road more comfortable as newly approaching the lower positioned lighting from the current high pole lighting. Taking account of the current situation of putting the stress on the road sight scene. It is proposed the study focused on the aesthetic design for playing a role of scenery. For this, it is searched used situation of the low light at interior of the country and abroad and tried to find the improvement. Also it is tried find out how to raise the effectiveness. And throughout the site inspection and the data searching about the road facility of a road to be installed the low height lighting, it is suggested the standard of the lighting installation and the direction for the future on the light design and development of the low height lighting which is suitable for the domestic situation.

• Health Policy and Management
• /
• v.20 no.1
• /
• pp.37-63
• /
• 2010

Public expenditures on long-term care are a matter of concern for Korea as in many other countries. The expenditure is expected to accelerate and to put pressure on public budgets, adding to that arising from insufficient retirement schemes and other forms of social spending. This study tried to foresee how much health care spending could increase in the future considering demographic and non-demographic factors as the drivers of expenditure. Previous projections of future long-term expenditure were mainly based on a given relation between spending and age structure. However, although demographic factors will surely put upward pressure on long-term care costs, other non-demographic factors, such as labor cost increase and availability of informal care, should be taken into account as well. Also, the possibility of dynamic link between health status and longevity gains needs to be considered. The model in this study is cell-base and consists of three main parts. The first part estimated the numbers of elderly people with different levels of health status by age group, gender, household type. The second part estimated the levels of long-term care services required, by attaching a probability of receiving long-term care services to each cell using from the sample from current year. The third part of the model estimated long-term care expenditure, along the demographic and non-demographic factors' change in various scenarios. Public spending on long-term care could rise from the current level of 0.2~0.3% of GDP to around 0.44~2.30% by 2040.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.6
• /
• pp.70-77
• /
• 2015

This paper describes the experimental results obtained from various installation conditions of cascaded metal oxide varistor(MOV)-based SPDs with the objectives to analyze the coordination of the cascaded surge protective devices(SPDs) and to propose the proper selection and installation methods of the cascaded SPDs. The residual voltage, discharge current and energy sharing between the upstream and downstream SPDs in the $10/350{\mu}s$ direct lightning current wave were measured and discussed. The coordination of cascaded MOV-based SPDs is closely related to the varistor voltage and installation methods of SPDs. In cascaded SPDs without dedicated decoupling elements, the natural impedance of leads connecting two SPDs can act as a decoupler for the coordination of MOV-based SPDs. Even if the varistor voltage of the upstream SPD is higher than that of the downstream SPD at long distances between two SPDs, the energy coordination of cascaded SPDs could effectively be fulfilled in the conditions of large surge currents and the optimum voltage protection level can be achieved. Consequently, if the distance between voltage limiting type SPDs is long, the coordination of the cascaded SPDs should be determined by taking into account the decoupling effects due to the intrinsic inductance of leads connecting the upstream and downstream SPDs.

• Journal of Korea Water Resources Association
• /
• v.39 no.7 s.168
• /
• pp.563-574
• /
• 2006

Economic theory tell us, consumers always make a choice to maximize their utility. In the market system, consumers' choices are revealed and policy maker taking into account the aggregated consumers choice such as price, supply and demand. However, water resources as a public goods, therefore typically there is no market and does no aggregated information for residential water use. This study explore the consumers' willingness to pay for higher quality for residential water. Over 1,000 households responded for this survey and willingness to pay has been estimated. Furthermore, consumers' behaviors of residential water are examined. Consumers are willing to reduce the amount of water use with more than 50% of increasing water price, but stay almost constant with less than 25% of increasing which mean that current price level is not high enough to derive water saving. If consumers can have better quality of water, they willing to pay additional 16%, $153\;won/m^3/month$, more than their current price. Based on the derived information, we suggested policy direction for residential water policy.

• Journal of the Korea Concrete Institute
• /
• v.14 no.6
• /
• pp.1010-1021
• /
• 2002

The current ACI design code does not take into account the contribution of concrete for the torsional moment of reinforced concrete(RC) beams subjected to pure torsion. This code is not capable of evaluating the inter-effects between concrete and torsional reinforcement on the torsional resistance of the RC beams. Some test results indicated that the current ACI code was not successful in predicting the observed torsional moment of the RC beams with reasonable accuracy. The research reported in this paper provides an evaluation equation to predict the torsional moment of the RC beams subjected to pure torsion. The proposed equation is derived from the equilibrium as well as compatibility equations of the truss model for the cracked RC beams. Comparisons between the observed and calculated torsional moments of the 66 tested beams, showed reasonable agreement.

• Progress in Superconductivity and Cryogenics
• /
• v.17 no.2
• /
• pp.25-30
• /
• 2015

In order to realize economical applications, it is important to reduce the ac loss of 2G high-temperature superconductor coated conductors. It seems to be reasonable that a multi-filamentary wire can decrease the magnetization loss. In this study, we prepared two samples of YBCO coated conductors with striations. We measured local superconducting properties of both samples by using Low Temperature Scanning Laser and Hall Probe Microscopy (LTSLHPM). The distribution of the local critical temperature of samples was analyzed from experimental results of Low Temperature Scanning Laser Microscopy (LTSLM) near the superconducting transition temperature. According to LTSLM results, spatial distributions of the local critical temperature of both samples are homogeneous. The local current density and the local magnetization in samples were explored from measuring stray fields by using Scanning Hall Probe Microscopy (SHPM). From SHPM results, the remanent field pattern of the one bridge sample in an external magnetic field confirms the Bean's critical state model and the three bridge sample has similar remanent field pattern of the one bridge sample. The local magnetization curve in the three bridge sample was measured from external fields from -500 Oe to 500 Oe. We visualized that the distribution of local hysteresis loss are related in the distribution of the remanent field of the three bridge sample. Although the field dependence of the critical current density must be taken into account, the relation of the local hysteresis loss and the remanent field from Bean's model was useful.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.7
• /
• pp.31-36
• /
• 2004

In comparison with in-plane lasers, predicting the output power and differential quantum efficiency of Vertical-Cavity Surface-Emitting Lasers(VCSELs) is very difficult due to the distributed Bragg reflector(DBR) layers. Therefore, effective cavity model and transfer matrix method have been adapted in order to calculate the output power and differential quantum efficiency The effective cavity model is inappropriate to calculate output power and differential quantum efficiency while it is practically adequate to calculate the threshold gain and threshold current density The reason is that the effective cavity model can not take account of the absorption in GaAs stack layer right below the metal aperture. In this paper, we have compared the threshold current and differential quantum efficiency calculated by using transfer matrix method with effective cavity model and we have made a study of the validity of the effective cavity model. Finally, we have confirmed the versatility of the transfer matrix method with these studies.

• Journal of Broadcast Engineering
• /
• v.20 no.5
• /
• pp.718-727
• /
• 2015

In this paper, we present a novel segmentation method that can extract new foreground objects from a current frame in real-time. It is performed by detecting differences between the current frame and reference frame taken from a fixed camera. We minimize computing complexity for real-time video processing. First DCT (Discrete Cosine Transform) is utilized to generate rough binary segmentation maps where foreground and background regions are separated. DCT shows better result of texture analysis than previous methods where texture analysis is performed in spatial domain. It is because texture analysis in frequency domain is easier than that in special domain and intensity and texture in DCT are taken into account at the same time. We maximize run-time efficiency of DCT by considering color information to analyze object region prior to DCT process. Last we use Guided filter for natural matting of the generated binary segmentation map. In general, Guided filter can enhance quality of intermediate result by incorporating guidance information. However, it shows some limitations in homogeneous area. Therefore, we present an additional method which can overcome them.