• Journal of Pharmaceutical Investigation
• /
• v.32 no.2
• /
• pp.73-80
• /
• 2002

Cefuroxime axetil is a cephalosporin antibiotic having a high activity against a wide spectrum of Grampositive and Gram-negative microorganisms. It is a cephalosporin antibiotic which exist as 2 diastereoisomers: diastereoisomer A and B. It shows polymorphism of three forms: a crystalline form having a melting point of about $180^{\circ}C$, a substantially amorphous form having a high melting point of about $135^{\circ}C$ and a substantially amorphous form having a low melting point of about 70^{\circ}C$. The crystalline form of cefuroxime axetil is slightly soluble in water because diastereoisomer A has lower solubility than B in water. Substantially amorphous form of which there are no difference in solubility between diastereoisomer A and B has better solubility than crystalline form, but it forms a thicker gel than crystalline form upon contact with an aqueous medium. Based on this reason, cefuroxime axetil is not readily absorbable in the gastrointestinal tract, rendering its bioavailability on oral administration very low. The object of this study was to develop an improved non-crystalline cefuroxime axetil composition having a high physicochemical stability and bioavailability. A non-crystalline cefuroxime axetil solid dispersant showing no peak on a Differential Scanning Calorimetry (DSC) scan is prepared by dissolving cefuroxime axetil and a surfactant in an organic solvent; suspending a water-insoluble inorganic carrier in the resulting solution; and spray drying the resulting suspension to remove the organic solvent, said solid dispersant having an enhanced dissolution and stability of cefuroxime axetil and being useful for the preparation of a pharmaceutical composition for oral administration. Tablet was formulated with this cefuroxime axetil solid dispersant, disintegrants and other ingredients. It disintegrated and dissolved easily and dynamically in dissolution medium, so showed a good dissolution profile.

• Textile Coloration and Finishing
• /
• v.9 no.6
• /
• pp.18-25
• /
• 1997

The change of crystalline structure and mechanical properties of i-PP films which had before isothermally annealed at various temperature and times have been studied. The following results were abtain The crystallinity and crystallite size of the samples showed increasing above the annealing temperature of 13$0^{\circ}C$ and these are equilibrated after an annealing time of 30min. When the crystalline form was at annealling condition were below 13$0^{\circ}C$, 2min, subsequently achieving an $\alpha$, $\beta$ mixing form and at 13$0^{\circ}C$, 10min, the crystalline form entered an $\alpha$ form transition. It is achieved a typical $\alpha$ form at 15$0^{\circ}C$. The value of T'm was increasing until 13$0^{\circ}C$ but it was not founded at 15$0^{\circ}C$. The slopes which represented crystalline form in an Avrami plot differed from each other within the range of this experiment.

• Archives of Pharmacal Research
• /
• v.23 no.4
• /
• pp.381-384
• /
• 2000

It is well recognized that physicochemical properties of drugs are affected by the type of polymorphic crystalline form of drugs. Clarithromycin is known to exist in at least three polymorphic crystalline forms. Since conventional means to obtain the most thermodynamically stable form (Form II) for the antibiotics is known to be associated with a low purity of the stable form, we developed a novel method to improve the purity of the crystalline form by a modification of the preparation process. The new method involved a simple recrystallization of clarithromycin in solvents having 5-12 carbon atoms (e.g., hexane and heptane) or ethers with 4-10 carbon atoms (e.g., isopropyl ether) and, thus, less likely to be associated with the problem in purity of resulting crystal. Differential scanning calorimetry and powder X-ray diffraction were used to compare the crystalline form of the resultant powder with Form IIcrystal prepared by the conventional method. The crystal prepared by the new method was identical to Form IIcrystal of the conventional method as evidenced by the lack of the exothermic peak near 11$0^{\circ}C$ in differential calorimetry scan, indicating that Form IIcrystal could be readily prepared by the new process. Therefore, these data indicated that the improvement in the purity of the Form IIcrystal for clarithromycin as well as a significant cost reduction is likely by the novel method.

• Journal of the Korean Society of Industry Convergence
• /
• v.2 no.2
• /
• pp.61-68
• /
• 1999

The variety of crystalline structure and mechanical properties of PP filament treated with dry heat treatment at different draw ratio has been studied. Crystalline structure and mechanical properties of annealed PP filament at different draw ratio has been examined by XRD, UTM, and density method. Heat treatment has been carried out $100^{\circ}C$, $120^{\circ}C$ $140^{\circ}C$ for 30min. in dry oven. From the results of this study, it found the following facts. It was found that the crystallinity and crystallite size of (110) plane of sample were increased with increasing of annealed temperature and draw ratio. The crystalline form of annealed sample which was undrawn showed ${\alpha}$, ${\beta}$ mixing form below $120^{\circ}C$ and showed ${\alpha}$ form at $140^{\circ}C$. But the crystalline form of annealed sample which was drawn showed ${\alpha}$ form at $120^{\circ}C$. Initial modulus and tensile strength were increased with increasing of annealing temperature, and the degree of orientation was decreased with decreasing of annealing temperature.

• Proceedings of the Polymer Society of Korea Conference
• /
• 2006.10a
• /
• pp.345-345
• /
• 2006

It is well known that poly(glutamate)s with long n-alkyl side chains form thermotropic liquid crystalline state by melting of the side-chain crystallites and also poly(glutamate)s such as poly(${\gamma}-benzyl\;L-glutamate$ )(PBLG), poly(${\gamma}-n-alkyl\;L-glutamate$), etc. in solvent form the isotropic, biphasic and liquid crystalline phases which contains cholesteric and columnar liquid crystalline forms depending on the polypeptide concentration. Although there is no diffusion study for PBLG in liquid crystalline state, because it is difficult to observed $^{1}H$ spectrum of PBLG in liquid crystalline state for its very short $^{1}H\;T_{2}$. In this study, the diffusional behavior of rodlike PBLG in concentrated solution is successfully elucidated as studied by the field-gradient $^{1}H$ NMR methods.

• Archives of Pharmacal Research
• /
• v.27 no.3
• /
• pp.357-360
• /
• 2004

Four crystal forms of ketorolac have been obtained by recrystallization in organic solvents under variable conditions. Different ketorolac polymorphs and pseudo polymorph were characterized by X-ray powder diffraction crystallography (XRD), Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA). In the dissolution studies in water at $37{\pm}0.5^{\circ}C$ four crystal forms showed different patterns. The solubility of Form I were the highest. The solubility decreased in rank order: Form I> Form II > Form III > Form IV. Form land Form III were shown to have a good physical stability at room temperature for 60 days. However, Form II is converted to Form III and Form IV is converted to Form I after 60 days storage. Therefore, these observations indicate that crystalline polymorphism for ketorolac is readily inter-convertible and the relationship may have to taken into consideration in the formulation of the drug.

• Journal of Sensor Science and Technology
• /
• v.17 no.6
• /
• pp.437-446
• /
• 2008

Single crystalline ${ZnIn_2}{Se_4}$ layers were grown on thoroughly etched semi-insulating GaAs (100) substrate at $400^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating ${ZnIn_2}{Se_4}$ source at $630^{\circ}C$. The crystalline structure of the single crystalline thick films was investigated by the photoluminescence (PL) and Double crystalline X-ray rocking curve (DCRC). The carrier density and mobility of ${ZnIn_2}{Se_4}$ single crystalline thick films measured from Hall effect by van der Pauw method are $9.41{\times}10^{16}cm^{-3}$ and $292cm^2/V{\cdot}s$ at 293 K, respectively. The temperature dependence of the energy band gap of the ${ZnIn_2}{Se_4}$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)$=1.8622 eV-$(5.23{\times}10^{-4}eV/K)T^2$/(T+775.5 K). After the as-grown ${ZnIn_2}{Se_4}$ single crystalline thick films was annealed in Zn-, Se-, and In-atmospheres, the origin of point defects of ${ZnIn_2}{Se_4}$ single crystalline thick films has been investigated by the photoluminescence (PL) at 10 K. The native defects of $V_{Zn}$, $V_{Se}$, $Zn_{int}$, and $Se_{int}$ obtained by PL measurements were classified as a donors or acceptors type. And we concluded that the heat-treatment in the Se-atmosphere converted ${ZnIn_2}{Se_4}$ single crystalline thick films to an optical p-type. Also, we confirmed that In in ${ZnIn_2}{Se_4}$/GaAs did not form the native defects because In in ${ZnIn_2}{Se_4}$ single crystalline thick films existed in the form of stable bonds.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.120-121
• /
• 2009

Single crystalline $ZnIn_2Se_4$ layers were grown on thoroughly etched semi-insulating GaAs(100) substrate at $400^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating, $ZnIn_2Se_4$ source at $630^{\circ}C$. After the as-grown $ZnIn_2Se_4$ single crystalline thin films was annealed in Zn-, Se-, and In-atmospheres, the origin of point defects of $ZnIn_2Se_4$single crystalline thin films has been investigated by the photoluminescence(PL) at 10 K The native defects of $V_{Zn}$, $V_{Se}$, $Zn_{int}$ and $Se_{int}$ obtained by PL measurements were classified as a donors or acceptors type. And we concluded that the heat-treatment in the Se-atmosphere converted $ZnIn_2Se_4$ single crystalline thin films to an optical p-type. Also, we confirmed that In in $ZnIn_2Se_4$/GaAs did not form the native defects because In in $ZnIn_2Se_4$ single crystalline thin films existed in the form of stable bonds.

• Fibers and Polymers
• /
• v.3 no.1
• /
• pp.18-23
• /
• 2002

The structure development and dynamic properties of fibers produced by high-speed spinning of P(EN-ET) random copolymers were investigated. The as-spun fibers were found to remain amorphous up to the spinning speed of 1500 m/min, and subsequent increases in speed resulted in the crystalline domains containing primarily $\alpha$ crystalline modification of PEN. The f modification was not found up to spinning speeds of 4500 m/min. On the other hand, annealing of constrained fibers spun at the 2100 m/min at 180,200, and 240^{\circ}C$ exhibited $\beta$-form crystalline structure, while the annealed fibers spun in 600-1500 m/min range exhibited dominantly $\alpha$-form. However $\beta$-form crystals disappeared above the spinning speed of 3000 m/min. With increasing spinning speeds from 600 to 4500 m/min, the storage modulus of as-spun fibers increased continuously and reached a value of about 10.4 spa at room temperature. The tan $\delta$curves showed the $\alpha$-relaxation peak at about 155-165^{\circ}C$, which is considered to correspond to the glass transition. The $\alpha$-relaxation peaks became smaller and broader, and shift to higher temperatures as the spinning speed increases, meaning that molecular mobility in the amorphous region is restricted by increased crystalline domain.

• YAKHAK HOEJI
• /
• v.22 no.1
• /
• pp.22-26
• /
• 1978

The purposes of this investigation were to study the characteristic properties of bismuthoxynitrate formed by hydrolysis of bismuthnitrate according to various reaction conditions and to propose the property difference between synthesized pearl pigment and bismuthsubnitrate as pharmaceuticals by means of X-ray diffraction, IR, DTA and TGA. The pearl pigment could be obtained by reaction of bismuth nitrate-diluted nitric acid solution with cold water (5.deg.) agitation at lower pH. The pearl pigment was BiO. NO$_{3}$. 2H$_{2}$O. in composition and crystalline form was thin plate of monoclinic system and its combination with water was assumed to be hydrated hydrous form between Bi-H$_{2}$O bond. On the other hand, bismuthsubnitrate was 5BiO.4NO$_{3}$.6H$_{2}$O in composition and crystalline form was pillar of rhombic system and the bond between Bi and H$_{2}$O molecules was assumed to be hydrous form. The different properties between two compounds in structure are presumed to be caused by the hydrolysing conditions of bismuthnitrate respectively.