• 한국농공학회논문집
• /
• 제55권6호
• /
• pp.37-46
• /
• 2013

Many factors about the stability for the reservoir embankments is determined when the facility is completed. Therefore the initial design of the embankment is important. Many researchers focused the effect of soil parameters although the cross section greatly affects the stability and can be controlled in design step. The objective of this research is to analysis of the effects for the safety factor of slope and seepage according to change cross-section in embankment. As a result, the quantity of seepage decreased as the gradient of downstream slope decreased and was proportional to the height of embankments. There was a linear relationship between the gradient of slope and the safety factor of slope. However the gradient of slope did not affect other side slope. All in a relationship, regressive equations with a high correlation coefficient were calculated and can be applied the simple estimation method of the stability using the cross-section. As results of analyzing the sensitivity, the friction angle and permeability critically effect for the slope stability and the seepage, respectively. The effect of the slope gradient was similar to major soil properties.

• 한국자기공명학회논문지
• /
• 제10권1호
• /
• pp.46-58
• /
• 2006

With a simple pulse sequence ($\pi/2$-{gradient, duration T}-acquisition) in solution NMR, detected signal has slowly grown up to percents of the equilibrium magnetization. The source of this unusual resurrection of dephased magnetization after a crushed gradient is cross-correlated effects of radiation damping and the distant dipolar field, which has been demonstrated by a numerical simulation and theoretical analysis.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2001년도 Proceedings of 2001 Korea-Japan Joint Seminar on Particle Image Velocimetry
• /
• pp.14-22
• /
• 2001

The frequency responses on the sub-pixel evaluation technique were investigated using the Monte-calro Simulation technique. The frequency response by the FFT based cross-correlation gives very good results, however, the gain loss does exist for the small displacement, (less than 0.5 pixel). While, the no gain loss is observed in the Direct Cross-correlation, however, the sub-pixel accuracy was limited to be about 0.1 pixel, i.e., it could not detect the small displacement. To detect the higher accurate sub-pixel displacement, the gradient based technique is the best. For the small interrogation area (e.g., 4x4), only the gradient technique can detect the small displacement correctly.

• 한국복합재료학회:학술대회논문집
• /
• 한국복합재료학회 1999년도 추계학술발표대회 논문집
• /
• pp.234-238
• /
• 1999

This study suggests the design of the functionally gradient composite, [0/90/0/core]$_s$ cross-ply laminate, to prevent stress concentration induced from the difference of rigidity between the bone and the artificial hip joint and to reinforce the wear property of the surface and the expectation of their mechanical properties. First, the four-point bending test is done about wet bones and dry bones to know the mechanical properties of the cortical bones. In result, the wet bone shows the viscoelastic behavior and the dry bone shows the elastic behavior. Moreover, we expect the properties of the proposed gradient composites as a function of carbon fiber volume fraction in each layer to apply Halpin-Tsai equation, CLPT(classical laminate plate theory), and Bernoulli beam theory etc. and decide the thickness ratio of each lamina in order to match Young's modulus of the anisotropic cortical bone with the proposed gradient composites.

• Steel and Composite Structures
• /
• 제13권1호
• /
• pp.71-89
• /
• 2012

The paper investigates beam lateral buckling stability according to linear and non-linear models. Closed form solutions for single-symmetric cross sections are first derived according to a non-linear model considering flexural-torsional coupling and pre-buckling deformation effects. The closed form solutions are compared to a beam finite element developed in large torsion. Effects of pre-buckling deflection and gradient moment on beam stability are not well known in the literature. The strength of singly symmetric I-beams under gradient moments is particularly investigated. Beams with T and I cross-sections are considered in the study. It is concluded that pre-buckling deflections effects are important for I-section with large flanges and analytical solutions are possible. For beams with T-sections, lateral buckling resistance depends not only on pre-buckling deflection but also on cross section shape, load distribution and buckling modes. Effects of pre-buckling deflections are important only when the largest flange is under compressive stresses and positive gradient moments. For negative gradient moments, all available solutions fail and overestimate the beam strength. Numerical solutions are more powerful. Other load cases are investigated as the stability of continuous beams. Under arbitrary loads, all available solutions fail, and recourse to finite element simulation is more efficient.

• 대한의용생체공학회:의공학회지
• /
• 제16권2호
• /
• pp.149-156
• /
• 1995

동맥전단부를 연구할수있는 새로운 실험방법과 기계역학적 분석방법을 제시하였다. 지금까지동맥역학적 연구는 대부분이 동맥의 길이방향과 원주방향에 대한것이 이였다. 두께방향의 변형은 포아손비라든지 비압축성가정으로 이론적으로 결정되었다. 또한 두께에 걸친 변형의 변화도 무시되었다. 그러나 병리학적인 의미에서 동맥의 두께에 걸친 변형도와 변형의 분포는 중요한 의미를 가진다. 그러므로 본연구에서 제안된 실험방법과 장치는 두께전반에 걸친 변형을 측정할수 있게 했다. 또한 전단부의 부위별 변형도의 관찰이 가능하고 병리적인 동맥경화증에 대한 현상과 역학적현상을 상관시킬 수 있음에 중요한 의미를 들 수 있다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.628-631
• /
• 2001

Current lead is one of the first proposed devices for the application of High Temperature-Superconductor(HTSC). The current lead provides high current for electrical machine using superconductor from room temperature. Its characteristics that is zero resistance and low heat transfer rate under critical temperature lead to research for the replacement of existing current lead with HTSC. In this paper, we investigated the temperature distributions of stacking type and rod type current lead with each cross-section area and length using Nastran program and compared each temperature distribution. It is obtained from this paper that stacking type current lead has flat temperature gradient and than rod type one and more stable operation as current lead is closely related with its cross-section area and length.

• 한국산학기술학회논문지
• /
• 제21권2호
• /
• pp.189-194
• /
• 2020

본 논문에서는 신경망을 학습하는 데 가장 많이 사용되고 있는 경사하강법에 대해 분석하였다. 학습이란 손실함수가 최소값이 되도록 매개변수를 갱신하는 것이다. 손실함수는 실제값과 예측값의 차이를 수치화 해주는 함수이다. 경사하강법은 오차가 최소화되도록 매개변수를 갱신하는데 손실함수의 기울기를 사용하는 것으로 현재 최고의 딥러닝 학습알고리즘을 제공하는 라이브러리에서 사용되고 있다. 그러나 이 알고리즘들은 블랙박스형태로 제공되고 있어서 다양한 경사하강법들의 장단점을 파악하는 것이 쉽지 않다. 경사하강법에서 현재 대표적으로 사용되고 있는 확률적 경사하강법(Stochastic Gradient Descent method), 모멘텀법(Momentum method), AdaGrad법 그리고 Adadelta법의 특성에 대하여 분석하였다. 실험 데이터는 신경망을 검증하는 데 널리 사용되는 MNIST 데이터 셋을 사용하였다. 은닉층은 2개의 층으로 첫 번째 층은 500개 그리고 두 번째 층은 300개의 뉴런으로 구성하였다. 출력 층의 활성화함수는 소프트 맥스함수이고 나머지 입력 층과 은닉 층의 활성화함수는 ReLu함수를 사용하였다. 그리고 손실함수는 교차 엔트로피 오차를 사용하였다.

• 대한기계학회논문집B
• /
• 제22권6호
• /
• pp.823-831
• /
• 1998

In order to investigate the impulsive noise at the exit of high-speed railway tunnel and the pressure transients inside the tunnel, numerical calculations using a Total Variation Dimishing difference scheme were applied to axisymmetric unsteady compressible flow field. Some compression wave forms were assumed to model the compression wave produced in real high-speed railway tunnel. The numerical data were extensively explored to analyze the peak over-pressure and maximum pressure gradient in the pressure wavefront. The effect of the distance and cross-sectional area ratio between two-continuous ducts on the characteristics of the pressure waves were investigated. The peak over-pressure inside the second duct decreases for the distance and cross-sectional area ratio between two tunnels to increase. The peak over-pressure and maximum pressure gradient of the pressure wavefront inside the second duct increase as the maximum pressure gradient of initial compression wave increases. The present results were qualitatively well agreed with the results of the previous shock tube experiment.

• 대한기계학회논문집
• /
• 제18권4호
• /
• pp.1031-1038
• /
• 1994

Characteristics of pulsatile flow and heat transfer have been studied numerically in the constant heat flux curved tube with periodic pressure gradient. As the Womersley number increases, the phase difference between the pressure gradient and the cross section averaged axial velocity becomes larger. In case of the Womersley number $\beta = 2$, when cross section averaged axial velocity reaches periodic state with time, the reverse and the natural flow coexist at phase angle, $\lambda = 1.44\pi$ and $\lambda =1.96\pi$. For all the Womersley numbers of present investigation, the time variation of wall temperature near inner wall is higher than that of near outer wall, independent of phase angle.