• Journal of Korean Society of Transportation
• /
• v.19 no.6
• /
• pp.195-205
• /
• 2001

The objective of the paper is to analyze the traffic characteristics for freeway merging area. Freeway merging area is different from basic section due to ramp vehicles. Therefore, to understand the traffic characteristics of (leeway merging area, this study focused on two factors including critical time headway required in merging maneuver and maximum possible merging volume. In this paper, new model that adopts critical time headway instead of critical time gap in calculating the maximum possible merging volume based on probability function was developed In previous studies, for calculating the maximum possible merging volume, it was considered that merging vehicles could merge freely if a given time gap was greater than the critical time gap. Also, the critical time gap was used as the same value in all traffic flow conditions. But, a time gap required in merging maneuver could be changed, even to the same driver, because difference of relative speed varies in different traffic flow conditions. So, in some cases, the critical time gap could be insufficient value in merging maneuver. Therefore, in this study. a calculating procedure for critical time headway in all traffic flow conditions was presented. Also, the maximum possible merging volume and capacity for freeway merging area were calculated by using the previously found critical time headway.

• Proceedings of the KSR Conference
• /
• 2006.11b
• /
• pp.1495-1500
• /
• 2006

A signal system is critical point of transport capacity and train operation in urban rail transit. Today the moving block system by radio is taking place of the fixed block system by track circuit for efficiency and short headway in underground railway and right rail transit. In this study, assuming specification of a train, track and control system, the minimum headway on the moving block system and the fixed block system is researched for the maximum transport capacity.

• Proceedings of the KOR-KST Conference
• /
• 1998.10a
• /
• pp.236-244
• /
• 1998

When the capacity and traffic operation at signalized intersections are analyzed in Korea, the unprotected left-turn saturation flow rate, which is an important parameter for the analysis, is estimated form the USHCM model. thus, exact analysis of the left-turn is not possible because of the difference of traffic environments between two contries. In order to improve this problem, it is undertaken in this study to develop techniques for the estimation of unprotected left-turn saturation flows based on Korean drivers' data. As study intersections, signalized or unsignalized intersections on the 6, 4 and 2 lane streets are selected. the data for the saturation flow measurement and gap-acceptance behavior analysis are inputed in a notebook computer on the sites. The critical acceptance gaps of the 6, 4, and 2 lane streets are analyzed to be 6.0 secs, 4.6 secs, and 4.3 secs respectively. the average minimum headway of the left-turn vehicle was observed to be 2.6 secs. As the model to estimate unportected left-turn saturation flows, the drew model is recommended for 6 and 4 lane streets, and a graph is suggested for the 2-lane street. As the values of the parameters of the Drew model, the 2.6 secs of this study is recommended for the average minimum headway of the left-turn. But, the critical acceptance gap varies according to the approach speed of opposing traffic and driver population, it requires field survey to measure the gap of an intersection; however, the values of the gaps studied in this study may be used for the general intersections in urban area in Korean.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.1
• /
• pp.243-250
• /
• 2014

Modern roundabouts referred to as relatively safer and more efficient traffic facility than the signalized intersections have been recently deployed and operated and accordingly more research efforts to improve its safety and efficiency have been made so far. This paper introduces a new traffic information system named as Smart Roundabout coupled with Connected Vehicle technique like Vehicle-to-Roadside communication, which has not been attempted before and evaluates its performance with a microscopic simulation model, VISSIM. The proposed system functions to collect driving information of circulating vehicles in the roundabout such as location, speed, critical headway, etc. and help approaching vehicles decide whether to enter the roundabout with an on-board equipment instrumented in the individual vehicle on the basis of calculated gap acceptance of interest. This new system is expected to secure more safety and increase the capacity of the modern roundabout.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.5
• /
• pp.1111-1121
• /
• 2015

Roundabouts face a congestion problem when there are unbalanced traffic conditions, especially during peak times. The congestion at roundabouts results in long delay times and low level of service. Some research has addressed congestion problems of the metering roundabout, however, few studies have focused on the congestion issues of the double signals metering roundabout. This research bridges this gap through analyzing the congestion issues of the Old Belair double signals roundabout in Adelaide. The research proposes a new analysis method based on a four-nodes intersection in order for double signals roundabout analysis to be carried out as follows: firstly, at the modeling stage, a connection of four individual intersections, adjustment of lane geometry, input of directional traffic volumes, priority and phase time set up are proposed. Secondly, for calibration, PFF, critical gap, follow-up headway and extra bunching values have been applied. The results from the analysis show that the new method is able to analyze the delay time, level of service, degree of saturation and allow for further analysis.

• International Journal of Highway Engineering
• /
• v.15 no.5
• /
• pp.217-226
• /
• 2013

PURPOSES : Under the capacity conditions with balanced approach flows, roundabouts give less delay than existing signalized intersections; however, flows over 450 vehicles/hour/lane with unbalanced approach flow conditions, roundabouts efficiency drops due to the short time difference between the critical gap and the follow-up headway. The purpose of this study is developing a roundabout Signal Metering operation method by considering approach lanes degree of saturation. METHODS : A four-way-approach with one-lane roundabout is selected to compare the Signal Metering performance for the case of 16 different unbalanced flow conditions. Based on these traffic conditions, the performance is evaluated for 64 different cases of Signal Metering combinations by using SIDRA software. A degree of saturation(V/C ratio) sum for two adjoined approaches is used for the performance index of choosing Metered Approach and Controlling Approach. RESULTS : When the V/C ratio sum is 0.29~0.81 and Metered Approach flow is less than Controlling Approach flow, the average delay saving per vehicle is about 7 seconds; however, after this rage the delay saving decreases gradually until the V/C ratio sum reaches around 1.0. The range of V/C ratio sum 0.93~1.09 provides average delay saving per vehicle about 3 seconds. In case of V/C ratio sum is grater than 1.0 and the flows of Metered Approach is grater than Controlling Approach, the average delay per vehicle increases 3~11 times respectively. CONCLUSIONS : As expected, the Signal Metering provides substantial improvements in delay saving for the case of V/C ratio sum is 0.3~1.0 under the traffic flow conditions of Metered Approach is less than Controlling Approach.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.2D
• /
• pp.227-234
• /
• 2009

At present, the length of deceleration lane at freeway diverging areas are designed based on the design speed of main lines and ramps. This is possible on assumption that diverging vehicles decelerate at deceleration section after moving to shoulder lane in advance. But with high diverging volume, several vehicles will try to change to exit lane at the same time. This will cause the distribution of main lane flows or some vehicles may encounter short deceleration length because they miss the proper time to change the lane. The purpose of this study is to establish a design guideline of the length of deceleration section considering the volume of diverging traffic. Also, the results of analysis by the FRESIM simulation model shows that some improvements in respect of delays, speeds and speed deviations of mainline and deceleration lane.

• Proceedings of the KIEE Conference
• /
• 2005.10b
• /
• pp.56-58
• /
• 2005

This paper for the Train control system which has been used in the railway system for the purpose of headway control is regarded as safety-critical system, which is based on embedded controller. Therefore, for the maintainability, the maintenance time shall be predicted correctly in order to improve availability of railway system and the predictive values shall be proved through the test. In conclusion, for the maintainability of train control system, the solution for exact prediction based on related international standard and the system for justification of derived predictive values shall be proposed.

• Proceedings of the KSR Conference
• /
• 2008.06a
• /
• pp.390-398
• /
• 2008

While road traffic of sharp rise of an international oil price and capital Seoul reaches to critical point, and a use passenger drives recklessly on the subway which is a cradle of public transportation, the depths analyzes an electric power feed system regarding a ground wealth electric car line of the subway Line 2 East Section which is a long distance (Seongsu $\sim$ Gangbyeon), and future, electric power supply Feeder Distribution Center prepares to Operational Headway shortening along an ATO signal method change by feeder increase supplement, and ensure safety to an electric power supply system, and will solve inconvenience of safe operation and use passenger.

• Journal of Korean Society of Transportation
• /
• v.31 no.3
• /
• pp.65-73
• /
• 2013

Exclusive median bus lanes were installed to mitigate congestions on urban traffic networks. However, capacity analysis of signalized intersections having exclusive median bus lanes have not been provided in current capacity analysis process(analyses). This study aims to develop a method of capacity analysis for lane groups consisting of only buses at the signalized intersections having exclusive median bus lanes. Finding basic saturation flow rates for buses is critical since the operational characteristics between automobiles and buses are fairly different. A total of 8 intersections in Seoul were chosen as study sites. Saturation headways, distances between bus-stop and stopline, and grades of each approach were measured at the sites. It was found that the basic saturation headway and the basic saturation flow rate of buses were 3.27 s/veh and 1,100pc/h/ln, respectively. Adjustment factor for upstream bus-stop locations was estimated with 0.50 and 0.75 when the distances between bus-stop and stopline are 20m and 70m, respectively. This study explains that bus saturation flow rates are decreased in half if the bus stop locates within 20 meters from stop lines.