• Journal of the Korean Society of Food Science and Nutrition
• /
• v.27 no.4
• /
• pp.668-674
• /
• 1998

Physico-chemical qualities of pyunyuk depending on the cooking time were evaluated to produce high quality and to reduce labor and processing time. Pork headmeat divided into two parts was cooked for 1~4hrs, trimmed and pressed with 110kg/$\textrm{cm}^2$(gauge pressure) for 3.5hrs at 1$0^{\circ}C$. The contents of general nutrients, yield, texture, color, fatty acid composition, gel structure, and sensory evaluation were observed. Deboning time was very dependent on cooking time. Optimum cooking time observed in this study was 2~2.5hrs for efficiency of deboning and yield. Excess cooking time resulted in low yield and working efficiency. Yield variation depending on the cooking time was 14.3~26.0% and it was reduced by increasing the cooking time. The content of moisture was 53.5~54.8% which was not significantly different by cooking time. The content of crude fat was 14.2~26.0% which was decreased by increasing the cooking time. The contents of crude protein(21.1~26.3%) and mineral(1.4~2.7%) were increased by increasing the cooking time. The color of pyunyuk was significantly different by cooking time(p<0.05). In the texture, hardness and chewiness of the pyunyuk cooked for 2hrs were significantly higher than others processed in this study(p<0.05). However cohesiveness and springiness were not different among pyunyuks. With sensory evaluation, hardness was similar among the pyunyuks cooked over 2hrs. The pyunyuk cooked for 1hr showed higher value in juiciness than the pyunyuk cooked for 3~4hrs(p<0.05). The % of saturated fatty acids was decreased by increasing the cooking time, and gel structure of pyunyuk cooked for 2hrs was the most compact among treaments. In conclusion, 2hrs was proper as a cooking time concerned with working efficiency and physico-chemical quality of pyunpyk.

• Microbiology and Biotechnology Letters
• /
• v.24 no.2
• /
• pp.217-221
• /
• 1996

Various treatments of naked barley with commercial liquefying enzymes have been emploved to reduce high viscosity of naked barley in cooking as a raw material for alcohol production and to increase alcohol yield. The enzyme BAN used for cooking and liquefaction of naked barley was able to make a reduction of one third of viscosity and to enhance alcohol yield of 4 l/Ton of raw material than the T120L was. Of course, alcohol yield depended in part on the applied saccharifying enzymes. The low temperature cooking of naked barley with BAN was favorable compared with high temperature cooking for both of reducing viscosity (210 vs. 237 cp) and final alcohol yield (Yp/so: 0.397 vs. 0.395 g/g) in industrial scale.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2006.06b
• /
• pp.295-303
• /
• 2006

The pulp yield was improved by about 4.5-5% when polysulfide (PS) and anthraquinone (AQ) were added to the kraft cooking liquor (white liquor). The exchange of the black liquor with fresh white liquor further increased the yield. The highest pulp yield was obtained when the PS cooking liquor containing 70% of total active alkali (AA) and 100% of AQ was used from the beginning of the reaction and the black liquor was exchanged with fresh white liquor containing the residual 30% of AA just after temperature reached $135^{\circ}C$. There was a good correlation between kraft pulp yields of a hardwood species and the ratios of the amount of xylose to glucose (X/G ratio), liberated by an acid hydrolysis of the pulps. However, the correlation was dependent on raw material wood species. Therefore, it is required in advance to establish a correlation between the yields and X/G ratios for raw material wood species of a target pulp in order to estimate pulp yield using X/G ratio. The X/G ratios of relatively high yield pulps showed higher values than those expected from the correlation. In a mill trial, the superiority of the PS-AQ isothermal cooking (ITC) process over the kraft ITC process was confirmed by examining X/G ratio of pulps obtained. The pulp yield in the PS-AQ ITC process was estimated at about 57.0%. This yield is very high, which indicates that reaction conditions of the PS-AQ ITC process are optimal.

• Food Science of Animal Resources
• /
• v.37 no.3
• /
• pp.410-417
• /
• 2017

The effect of dietary fiber enrichment (wheat bran) and cooking methods (oven, steam and microwave) on functional and physico-chemical properties of raw nuggets formulation as well as nutritional, color and textural properties of chicken nuggets were analyzed in this study. Among different cooking methods used for nuggets preparation, steam cooked nuggets had significantly (p<0.05) higher water holding capacity (56.65%), cooking yield (97.16%) and total dietary fiber content (4.32%) in comparison to oven and microwave cooked nuggets. The effect of cooking methods and wheat bran incorporation was also noticed on textural properties of the nuggets. Hardness, firmness and toughness values of oven and steam cooked nuggets were significantly (p<0.05) higher than microwave cooked nuggets. Among nuggets prepared by different cooking methods, cohesiveness of microwave cooked nuggets was found to be significantly (p<0.05) highest, whereas, oven cooked nuggets had significantly (p<0.05) highest gumminess and chewiness values. Steam cooked nuggets were found to be better among all nuggets due to their higher cooking yield and dietary fiber content.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.29 no.3
• /
• pp.34-42
• /
• 1997

This study was carried out to investigate the proper cooking conditions of soda-anthraquinone and alkaline sulfite-anthraquinone pulping of rice-straw, and get basic data f9r the use of rice-straw chemical pulp through the test of characteristics and physical properties of pulps made in the various cooking conditions From the experimental results , we can conclude as follows. In the soda-anthraquinone pulping of rice-straw, the optimum cooking conditions were 60 min. at $150^{\circ}C$ in the amount of caustic soda of 20% with the addition of anthraquinone(0.05%). And total yield, Kappa No. and brightness of pulp made in the condition above mentioned were 41.9%, 7.7 and 51.1 respectively. In the alkaline sulfite-anthraquinone pulping of rice-straw, the proper mixing ratio of cooking chemical(caustic soda : sodium sulfite) was 50:50. And the optimum cooking conditions were 60 min. at $150^{\circ}C$ in the amount of cooking chemical of 20% with the addition of anthraquinone(0.05%). At that time, the total yield, Kappa No, and brightness of pulp were 50.1%, 9.1 and 40.2 respectively. As a result, the alkaline sulfite-anthraquinone pulping was superior to the soda-anthraquinone pulping in the aspect of yield, but inferior in the viewpoints of Kappa No. and brightness. For the comparison of qualities of pulps made in the various cooking methods and conditions, the physical properties of four sorts of pulps were tested. As a result, soda-anthraquinone pulps were superior to alkaline sulfite-anthraquinone pulps in the various strengths excluding tear strength and brightness. On the other hand, pulps made in the condition of addition of cooking chemical of 20% were superior to pulps in the dosage of 15% in the aspects of all the strengths and brightness.

• Advances in Energy Research
• /
• v.8 no.4
• /
• pp.233-241
• /
• 2022

Biodiesel is a non-polluting and non-toxic energy source that can replace conventional diesel. However, the higher production cost and raw material scarcity became challenges that obstruct the commercialization of biodiesel production. In the current investigation, fried cooking oil is used for biodiesel production in a hydrodynamic cavitation reactor, thus enhancing raw material availability and helping better waste oil disposal. However, due to the cavitation effect inside the reactor, the hydrodynamic cavitation reactor can give biodiesel yield above 98%. Thus, the use of orifice plates (having a different number of holes for cavitation) in the reactor shows more than 90% biodiesel yield within 10 mins of a time interval. The effects of rising temperature at different molar ratios are also investigated. The five-hole plate achieves the highest yield for a 4.5:1 molar ratio at 65℃. And the similar result is predicted by the response surface methodology model; however, the optimized yield is obtained at 60℃. The investigation will help understand the effect of hydrodynamic cavitation on biodiesel yield at different molar ratios and elevated temperatures.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.31 no.3
• /
• pp.83-89
• /
• 1999

Bast fibers of paper mulberry ( Broussonetia Kazinoki Sieb) were cooked with a weak alkaline salt, potassium carbonate which has been known as a major inorganic component of the traditional lye, and its cooking characteristics were investigated . The bast fiber was easily cooked by potassium carbonate. The pulp yield was rapidly decreased up to 20-30 mol of potassium carbonate, but the Kappa number was slowly decreased with increasing of potassium carbonate. The potassium carbonate pulps were easily defibered at low cooking chemical charge of 25mm on and high pulp yield of about 80%. These results were confirmed that pectin was easily removed during the potassium carbonate cooking. In contrast, when sodium carbonate was used as a cooling agent, the bast fiber was only partially defibered. Thus, sodium carbonate was a less effective cooling chemical of the bast fiber. The results of this experiment indicated that potassium carbonate could not only be used as a good cooling agent of bast fiber, but also as an alternative agent of sodium hydroxide.

• Food Science of Animal Resources
• /
• v.30 no.1
• /
• pp.42-48
• /
• 2010

This research was conducted to evaluate the effects of cooking conditions on quality characteristics of Soo-Yuk, a traditional Korean food. The cooking conditions were as follows: boiled until the core temperature of a sample in $20^{\circ}C$ cold water reached at $75^{\circ}C$ (T1); boiled until the core temperature of a sample in $90^{\circ}C$ boiling water reached at $75^{\circ}C$ (T2); and boiled with sample from $20^{\circ}C$ to $100^{\circ}C$ and kept at $98^{\circ}C$ for 25 min (T3, Korean traditional method). The sample cooked at $90^{\circ}C$ water (T2) had the fast cooking time, and the highest cooking yield and moisture content. Soo-yuk boiled in $100^{\circ}C$ water (T3) showed the longest cooking time, the lowest cooking yield and moisture content, and the highest shear force. The instrumental color showed a significant difference among the cooking conditions. The sarcomere length of soo-yuk boiled in $100^{\circ}C$ water (T3) was the shortest, but the myofibrillar fragmentation index and thiamine content of the sample cooked at $90^{\circ}C$ (T2) were the highest. In sensory evaluation, the evaluation of soo-yuk boiled in $98^{\circ}C$ water (T3) was of superior flavor and overall acceptability.

• Food Science of Animal Resources
• /
• v.40 no.2
• /
• pp.231-241
• /
• 2020

The current study investigated the effects of timing of NaCl (2%) and sodium tripolyphosphate (STPP, 0.5%) addition and cooking rates on color and pigment properties of ground chicken breasts. Four treatments were tested as follows: treatment 1, no NaCl and STPP added and stored for 7 d; treatment 2, NaCl+STPP added on 0 d and stored for 7 d; treatment 3, NaCl added on 0 d and STPP added on 7 d; and treatment 4, stored for 7 d and NaCl+STPP added. All samples were cooked at a fast (5.67℃/min) or slow cooking rate (2.16℃/min). Regardless of the timing of NaCl and STPP addition, reflectance ratios of nitrosyl hemochrome, cooking yield, pH values, oxidation-reduction potential, and percent myoglobin denaturation were similar (p>0.05) across treatments 2, 3, and 4. The highest CIE a^⁎ values were observed in treatment 4 (p<0.05), while treatment 2 was effective in reducing the redness in cooked chicken products. The fast cooking rate resulted in lower CIE a^⁎ values and higher CIE L^⁎ values and cooking yield in cooked chicken breasts compared to the slow cooking rate. Our results indicate that adding NaCl and STPP to meat, followed by storing and cooking at a fast rate, may result in inhibiting the pink color defect sporadically occurred in cooked ground chicken breasts.

• Asian-Australasian Journal of Animal Sciences
• /
• v.23 no.10
• /
• pp.1380-1385
• /
• 2010

Buffalo meat patties with two fat levels, F1 (15% added fat) and F2 (5% added fat and 3% tapioca starch), were cooked in a pre-heated hot air oven (HO) at $175{\pm}2^{\circ}C$ for 15 min, in a microwave oven (MO) for 70 sec and by pressure cooking (PC) at 15 psi pressure for 10 min. and compared for physico-chemical, processing, sensory and microbiological quality attributes. F2 had significantly (p<0.05) higher value for the moisture and moisture protein ratio than F1. However, MO and PC patties had significantly (p<0.05) higher moisture content than HO-cooked buffalo meat patties irrespective of fat content. Highest fat percentage was in MO patties while the minimum was in PC patties. Moisture and fat retention and cooking yield were highest in MO patties irrespective of added fat content in the formulation. Cooking yield and dimensional parameters were better maintained in F2 than F1. Sensory scores viz. appearance and color, flavour, juiciness and texture for HO patties were better than other cooking methods. Sensory panelists rated overall acceptability of HO patties very good to excellent, whereas PC and MO patties were rated as good to very good irrespective of fat content. Microbiological quality was comparable in both groups irrespective of cooking methods used.