• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.5
• /
• pp.155-164
• /
• 2015

This paper describes a design and implementation of CABAC decoder, which would handle HEVC syntax elements in adaptively pipelined-parallel computation manner. Even though CABAC offers the high compression rate, it is limited in decoding performance due to context-based sequential computation, and strong data dependency between context models, as well as decoding procedure bin by bin. In order to enhance the decoding computation of HEVC CABAC, the flag-type syntax elements are adaptively pipelined by precomputing consecutive flag-type ones; and multi-bin syntax elements are decoded by processing bins in parallel up to three. Further, in order to accelerate Binary Arithmetic Decoder by reducing the critical path delay, the update and renormalization of context modeling are precomputed parallel for the cases of LPS as well as MPS, and then the context modeling renewal is selected by the precedent decoding result. It is simulated that the new HEVC CABAC architecture could achieve the max. performance of 1.01 bins/cycle, which is two times faster with respect to the conventional approach. In ASIC design with 65nm library, the CABAC architecture would handle 224 Mbins/sec, which could decode QFHD HEVC video data in real time.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.1
• /
• pp.27-41
• /
• 2011

This research proposes new tram signal coordination model, called MAXBAND MILP-Tram for a passive tram signal priority strategy. The proposed model was formulated based on the MAXBAND model that was a traditional arterial signal optimization model. The model could calculate the bandwidth solutions for both general-purpose-lane traffic and median-tram-lane traffic. Lower progression speed are applied for the tram traffic considering lower running speed and dwell time at the stations. A phase sequence procedure determines the green times and left-turn phase sequences for tram traffic in median tram lane. To estimate the performance of the MILP-Tram model, the control delay of trams were estimated using the micro simulation model, VISSIM. The analysis results showed 57 percent decrease of the tram compared to the conventional signal timing model. The delay for car, however, increased 18 percent. The sensitivity analysis indicated that the passive tram signal priority strategy using the offset and phase sequence optimization was effective in reducing the person delay under the congested traffic condition.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.105-105
• /
• 2009

$ZrO_2$ is one of the most attractive high dielectric constant (high-k) materials. As integrated circuit device dimensions continue to be scaled down, high-k materials have been studied more to resolve the problems for replacing the EY31conventional $SiO_2$. $ZrO_2$ has many favorable properties as a high dielectric constant (k= 20~25), wide band gap (5~7 eV) as well as a close thermal expansion coefficient with Si that results in good thermal stability of the $ZrO_2/Si$ structure. In order to get fine-line patterns, plasma etching has been studied more in the fabrication of ultra large-scale integrated circuits. The relation between the etch characteristics of high-k dielectric materials and plasma properties is required to be studied more to match standard processing procedure with low damaged removal process. Due to the easy control of ion energy and flux, low ownership and simple structure of the inductively coupled plasma (ICP), we chose it for high-density plasma in our study. And the $BCl_3$ included in the gas due to the effective extraction of oxygen in the form of $BCl_xO_y$ compound In this study, the surface kinetic properties of $ZrO_2$ thin film was investigated in function of Ch addition to $BCl_3/Ar$ gas mixture ratio, RF power and DC-bias power based on substrate temperature. The figure 1 showed the etch rate of $ZrO_2$ thin film as function of gas mixing ratio of $Cl_2/BCl_3/Ar$ dependent on temperature. The chemical state of film was investigated using x-ray photoelectron spectroscopy (XPS). The characteristics of the plasma were estimated using optical emission spectroscopy (OES). Auger electron spectroscopy (AES) was used for elemental analysis of etched surface.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.5
• /
• pp.533-541
• /
• 2007

The Zienkiewicz-Zhu(Z/Z) error estimate is slightly modified for the hierarchical p-refinement, and is then applied to L-shaped plates subjected to bending to demonstrate its effectiveness. An adaptive procedure in finite element analysis is presented by p-refinement of meshes in conjunction with a posteriori error estimator that is based on the superconvergent patch recovery(SPR) technique. The modified Z/Z error estimate p-refinement is different from the conventional approach because the high order shape functions based on integrals of Legendre polynomials are used to interpolate displacements within an element, on the other hand, the same order of basis function based on Pascal's triangle tree is also used to interpolate recovered stresses. The least-square method is used to fit a polynomial to the stresses computed at the sampling points. The strategy of finding a nearly optimal distribution of polynomial degrees on a fixed finite element mesh is discussed such that a particular element has to be refined automatically to obtain an acceptable level of accuracy by increasing p-levels non-uniformly or selectively. It is noted that the error decreases rapidly with an increase in the number of degrees of freedom and the sequences of p-distributions obtained by the proposed error indicator closely follow the optimal trajectory.

• Journal of Periodontal and Implant Science
• /
• v.26 no.3
• /
• pp.771-778
• /
• 1996

The assessment of alveolar bone changes on dental radiographs to indicate progression of periodontal diseases or healing response to therapy is routine procedure. However, the diagnostic accuracy in detecting small alveolar bone changes is very limited. Recently, guided bone regeneration therapy is popular, but the quantification of new bone is somewhat difficult with conventional evaluation method. To quantificate the amount of new bone, various evaluating methods have been introduced including histomorphometry, radiomorphometry, biochemical analysis, X-ray probe microanalysis, scanning electron microscope backscatter method. In this study, guided bone regeneration using resorbable membrane with & without PDGF-BB is quatificated through histomorphmetry to evaluate the efficacy of histomorphometric analysis. 4 beagle dogs and 8 Sprague-Dawley rats were selected as experimental animals. In beagle dog experiment, $4{\times}4mm$ Class II defects were created in maxillary both second premolars, and biodegradable membrane containing PDGF-BB(experimental group) were covered over one defect, and same membrane without PDGF-BB(control group) were covered over the other defect. At 2 weeks, 5 weeks after surgery, each beagle dogs were sacrificed, and the tissues were treated by undecalcified fixation. In Sprague-Dawley rat experiment, 5mm round defect were created in temporal bone, the same membranes were covered on the defects. At 1 week, 2 weeks after surgery, each rats were sacrificed, and undecalcified fixation were taken. After grinding tissue specimen, we analyse them histomorphometrically using image analysis system. In beagle dog 2 weeks specimens, new bone formation area were $0.03123mm^2$ in experimental group,and $0.03012mm^2$ in control group. At 5 weeks specimens, $0.15324mm^2$ in experimental group, and $0.09123mm^2$ in control group. In Sprague-Dawley rat specimens, new bone fomation area were $0.20448mm^2$ in 1 week experimental group, $0.03604mm^2$ in 1 week control group. At 2 weeks specimens, $0.46349mm^2$ in experimental group, $0.17741mm^2$ in control group. The results indicated that histomorphometric analysis of new bone formation using image analysis system is very effective quantification method to evaluate the efficacy of treatment modalities.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.648-658
• /
• 2006

We propose a thin frequency selective surface(FSS) superstrate etched on a substrate for dual-band directivity enhancement, and present a design method of the superstrate. In the proposed new design, two FSS arrays with the same periodicity, but with different alignments are placed above and below a thin dielectric layer to overcome the problem of conventional superstrates for dual band directivity enhancements. Based on the unit-cell simulation, several important parameters that characterize the thin FSS superstrate are investigated, and the procedure for designing such a superstrate is described. We compare the resonant frequencies and the qualify factors of the unit cell with those of three FSS antenna composites with different quality factors, and identify the quality factors which support similar directivity enhancement at the dual-band directivity enhancement. It was found that there is an optimum FSS array size of a superstrate to enhance the directivity most efficiently. Measured results for a fabricated superstrate show a good agreement with the simulated ones.

• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.30 no.2
• /
• pp.101-106
• /
• 2019

Background and Objectives Reinke's edema is a benign vocal fold disease caused by an edematous laryngeal superficial layer of lamina propria. The first line treatment is cessation of smoking and laryngeal microsurgery. The aim of the study is to evaluate the feasibility and efficacy of percutaneous steroid injection via cricothyroid membrane in patients with Reinke's edema. Materials and Method From Jan 2010 to July 2018, 33 Patients with Reinke's edema managed by vocal fold steroid injection via the cricothyroid membrane were included in this study. We compared medical records of laryngoscopy, stroboscopy and Multi-Dimensional Voice Program analysis at pre-treatment and post-treatment. Subjective voice improvement was evaluated using Voice Handicap Index-30 (VHI-30). Results 75.7% of the patients showed partial response and 6.06% showed complete response. 93.94% were present smokers and only 4 patients ceased smoking after the treatment. In acoustic analysis, the pre-treatment mean value of jitter, shimmer, and noise to harmonic ratio was 2.30±3.21, 9.34±10.37, 1.11±2.90 each. The post-treatment value was 2.20±1.89, 6.96±5.30, 0.20±0.09 respectively and none of the parameters were statistically significant. For subjective symptom improvement, 25 (75.8%) patients showed a better score on post-treatment VHI-30 compared to pre-treatment. Conclusion According to our study, steroid injection is a relatively safe and effective procedure for patients with Reinke's edema. A vocal fold steroid injection via the cricothyroid membrane can be an alternative treatment option for those who are not able to undergo conventional laryngeal microscopic surgery, however cessation of smoking is necessary for effective treatment.

• Journal of Korea Multimedia Society
• /
• v.8 no.3
• /
• pp.313-321
• /
• 2005

Digital halftoning is a process to produce a binary image so that the original image and its binary counterpart appear similar when observed from a distance. Among digital halftoning methods, error diffusion is a procedure for generating high quality bilevel images from continuous-tone images but blurs the edge information in the bilevel images. To solve this problem, we propose the improved error diffusion using local spatial information of the original images. Based on the fact that the human vision perceives not a pixel but local mean of input image, we compute edge enhancement information(EEI) by appling the ratio of a pixel and its adjacent pixels to local mean. The weights applied to local means is computed using the ratio of local activity measure(LAM) to the difference between input pixels of 3$\times$3 blocks and theirs mean. LAM is the measure of luminance changes in local regions and is obtained by adding the square of the difference between input pixels of 3$\times$3 blocks and theirs mean. We add the value to a input pixel of quantizer to enhance edge. The performance of the proposed method is compared with conventional methods by measuring the edge correlation. The halftone images by using the proposed method show better quality due to the enhanced edge. And the detailed edge is preserved in the halftone images by using the proposed method. Also the proposed method improves the quality of halftone images because unpleasant patterns for human visual system are reduced.

• Korean Journal of Environmental Agriculture
• /
• v.8 no.1
• /
• pp.7-16
• /
• 1989

Application of steam distillation on the analysis of pesticide residue in soil, water and crops was studied using the nitrogen distillation apparatus. Most pesticides which were extracted by organic solvents could be analyzed by the steam distillation method. For instance, distillations of PCNB, ${\gamma}-BHC$, ${\alpha}-or$ ${\beta}-endosulfan$, IBP, diazinon, fenthion, fenitrothion, alachlor, butachlor, pretilachlor, metolachlor, pendimethalin, benthiocarb and molinate were possible, but not simazine, atrazine and nitrofen. The optimum volume of distillate for a sufficient extraction of pesticide varied according to kind of pesticide. In general, the volume needed was little for carbamate, but much more for organochlorine. When the definite amount of distillate was obtained and then the condenser was washed by acetone, the optimum volume of distillate was less. Using the steam distillation method, the amount of organic solvent needed for one extraction of pesticide from soil, water and vegetable was less than the conventional solvent extraction method, and the analytical procedure became simpler. The process of concentration and clean up was mostly unnecessary, although a ghost peak was apparent in the gas chromatogram according to the kind of materials distilled.

• Archives of Plastic Surgery
• /
• v.37 no.5
• /
• pp.589-594
• /
• 2010

Purpose: Full thickness skin grafts are useful in the reconstruction of facial skin defects when primary closure is not feasible. Although the supraclavicular area has been considered as the choice of donor site for large facial skin defect, many patients are reluctant to get a neck scar and some patients do not have enough skin to cover the defect owing to the same insult occurred to the neck such as burn accident. We present several cases of reconstruction of facial skin defects by freehand full-thickness skin graft from anterolateral chest wall resulting aesthetically acceptable outcome with lesser donor site morbidity. Methods: Retrospective review was performed from March, 2007 to September, 2009. 15 patients were treated by this method. Mean age was 31.5 years. The ethiology was congenital melanocytic nevus in 7 cases, capillary malformation in 5 cases and burn scar contracture in 3 cases. Mean area of lesion was measured to 67.3 cm2 preoperatively. The lesion was removed beneath the subcutaneous fatty tissue layer. The graft was not trimmed to be thin except defatting procedure. For the larger size of defect, two pieces of grafts were harvested from both anterolateral chest wall in separation and combined by suture. Results: The mean follow up period was 9.7 months. All the grafts survived without any problem except small necrotic areas in 4 cases, which healed spontaneously under conventional dressings in 6 weeks postoperatively. Color match was relatively excellent. There were 2 cases of hyperpigmentation immediately, but all of them disappeared in a few months. Conclusion: In cases of large facial skin defects, the anterolateral chest wall may be a good alternative choice of full-thickness skin graft.