• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.12 no.5
• /
• pp.527-534
• /
• 1987

Two phase voltage controlled oscillation was realized by using the Electronic analog simulation of nonlinear simultaneous 2st order equation in terms of vibration and it's usefullness was sustined. Sinde it is complex and expensive to implement the circuits actually which composits and multiplicate the two phase signal squared respectively, this paper is obtained the simplificotion and switching circuit. The circuit introducced in this paper had propotionality of frequency to control input voltage, rapid response time, and little phase error, also this circuit operated with very low THD(Total Harmonic Distortion) and constant amplitude at higher than 10 :1 of frequency ratio.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.3
• /
• pp.544-551
• /
• 2011

This paper presents the circuit arrangement and effective control method of regenerative energy storage system for an electric vehicle using super-capacitors as the braking energy storage element. A bi-directional controlled current flow of the DC-DC converters with the capacitor bank is connected in parallel with battery, and is controlled so that the whole of the braking energy is effectively absorbed into the capacitors and released back to the electric motor upon acceleration. The converter needs the series-parallel switching circuit for making the best use of the series capacitors and for limiting the step-up ratio of the boost converter. The proposed methods are verified by computer simulation and experimental set-up. They are usefully applied to the electric vehicles such as green cars, electric motorcycles, bike, etc which are power- supplied by the electric batteries.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.4
• /
• pp.1623-1630
• /
• 2018

Normally, various auxiliary loads are installed along with the main load in industrial applications. Usually, load transformers are used to convey such types of auxiliary loads. The transformers become energized when the loads are turned-on, consequently, high amplitude of inrush current appears at the output of the uninterrupted power supply (UPS) system. To mitigate these high current amplitudes, this manuscript suggests a three-phase line-interactive UPS system to counter the inrush current during the turning-on of the auxiliary load transformer while powering the main load by using a current controlled inverter. Experimental results of a laboratory-sized prototype are provided in the support of the proposed UPS system for validation.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2004.05a
• /
• pp.313-317
• /
• 2004

This paper shows the structure of a control System for Fluorescent fin Dimming Ballasts. The control system is composed of phase angle controller, a transducer, many dimmable ballasts. For the implementation of the control system, We made a controller and the transducer that transform the phase angle controlled signal into the DC level. we used the conventional dimmable ballast In this ballast, dimming control is achieved by varying the switching frequency that is controlled by the external DC level. This has non-linear illumination characteristics as the dimming control. Therefore we compensate characteristics using the transducer proposed in this paper. We measured the illumination of two FL-28 lamps with dimming controller.

• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.774-776
• /
• 2003

In this paper the controlled closing algorithm to locate contact touch instants within the span in which the making voltage is minimized is proposed with the characteristics of circuit breakers such as RDDS(rate of decrease of dielectric strength) and a mechanical operating tolerance taken into account. The analytic results on the voltages across circuit breaker terminals upon closing operation play an important roles as references to describe the suggested method. Even though in the case of the isolated neutral capacitor banks, it is possible to decide the optimum contact instants without any dedicated procedures.

• Proceedings of the KIPE Conference
• /
• 2014.07a
• /
• pp.341-342
• /
• 2014

VSC-HVDC system based on Modular Multilevel Converter (MMC) is an emerging technology since compared to the conventional VSC-HVDC system an MMC presents several advantages such as modularity, low dv/dt, low harmonics, and low switching losses. In this paper, a comprehensive control strategy of an MMC-based VSC-HVDC system is proposed. In contrast to the conventional system control strategy, the DC side of the MMC operates as a controlled voltage source by the proposed method, and the dynamics of the transmission line voltage and current can be actively controlled. Validity of the proposed strategy was verified by 201-level full-scale computer simulation.

• Proceedings of the KIEE Conference
• /
• 2005.10c
• /
• pp.122-125
• /
• 2005

A novel torque ripple reduction scheme of single-phase SRM with high power factor is presented. The proposed SRM drive has one additional active switches in the conventional asymmetric inverter. In order to get a higher power factor, the source current is controlled sinusoidal, And additional excitation current is added from charge capacitor due to torque ripple reduction. The switching period of source and charged voltage is controlled properly to get unity power factor and torque ripple reduction. The characteristics and validity of the proposed scheme is discussed with some simulation results.

• Proceedings of the KIPE Conference
• /
• 2003.07a
• /
• pp.69-72
• /
• 2003

In this paper new control strategy of series resonant converter system for control power supply is suggested. Frequency controlled series resonant converter system is robust to load variations because it is POSR(parallel output series resonant) type. And it provides stable output voltage by changing switching frequency to input voltage variations. Firstly, operation analysis about suggested series resonant converter system was carried. Then simulations using ACSL(Advanced Continuous Simulation Language) and experiments to actual system were carried to prove characteristics of suggested system.

• Proceedings of the KIPE Conference
• /
• 2004.07b
• /
• pp.834-838
• /
• 2004

This paper presents the structure of a dimming control system for multiple fluorescent lamps. The dimming control system is composed of a phase angle controller, a transducer, and dimmable ballasts. In these ballasts, dimming control is achieved by varying the switching frequency that is controlled by the external DC level.

• Proceedings of the KIEE Conference
• /
• 1993.11a
• /
• pp.135-138
• /
• 1993

The Modelling, design and analysis of the steady state and performance characteristic of the constant switching frequency P.W.M controlled LLC and LLCC-type P.R.C are presented continuous conduction mode of operation. A set of characteristic frequency are plotted which design parameters can be obtained.