• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2019년도 추계 학술논문 발표대회
• /
• pp.241-242
• /
• 2019

This technology is a water leak repair technology using composite materials of concrete structures that block leakage of structures by injecting rapid microcement into the face of underground concrete to block water and injecting flexible glycidylacrylate. Rapid micro cement system repair materials are mixed with fine fibers to improve the flexural sensitivity of the material and to form a layer that blocks stabilized water at the back of the structure by allowing rapid and tight spatial filling during injection with high cohesion The glycidylacrylate repair material can control the expansion rate, and the external stress also has the characteristic that the form of the material is not destroyed or separated, which can also be applied to vibrating induced structures that produce repetitive fatigue loads, and has an effective durability in saline, alkali, acid (chloric acid, sulfuric acid, nitric acid).

• 대한전자공학회논문지SD
• /
• 제45권8호
• /
• pp.37-43
• /
• 2008

본 논문에서는 고속 동작에서 동적 전력 소비와 정적 전력 소비를 동시에 줄일 수 있는 self-timed current-mode Logic(STCML)을 제안한다. 제안된 로직 스타일은 펄스 신호로 가상 접지를 방전하여 로직 게이트의 누설 전류(subthreshold leakage current)를 획기적으로 감소시켰다. 또한, 본 로직은 개선된 self-timing buffer를 사용하여 동적모드 동작 시 발생되는 단락 회로 전류(short-circuit current)를 최소화하였다. 80-nm CMOS 공정을 이용하여 실시한 비교 실험 결과, 제안된 로직 스타일은 기존의 대표적인 current-mode logic인 DyCML에 비하여 동일한 시간 지연에서 26 배의 누설 전력 소비를 줄이고 27%의 동적 전력 소비를 줄일 수 있었다. 또한, 대표적인 디지털 로직 스타일인 DCVS와의 비교 결과, 59%의 누설 전력 소비감소 효과가 있었다.

• Restorative Dentistry and Endodontics
• /
• 제28권1호
• /
• pp.50-56
• /
• 2003

The purpose of this study was to evaluate the effects of EDTA and pulsed Nd :YAG laser on apical leak-age of canal obturation. Forty-eight single-rooted teeth were used in this study. The teeth were instrumented up to a size 40 K-file and irrigated with 2.5% NaOCl between each fie size. And the teeth were divided into 4 groups. In group A, the root canals were irrigated with a final flush of 5ml 2.5% NaOCl as a control group. The teeth in group B were irrigated with a final flush of 5ml 17% EDTA. The teeth in group C and D were irradiated by pulsed Nd：YAG laser(laser parameters were set at 1W, 100mJ, 10Hz, and 2W, 100mJ, 20Hz respectively). The results were as follows : 1. Apical leakage was observed in 50% of samples in group A, 30% of samples in group B, 20% of samples in group C, and 10% of samples in group D. 2. The teeth in group B had less leakage than group A, but there was no statistically significant differences(p＞0.05). 3. The teeth in group C, D had less leakage than group A, and there was statistically significant differences(p＜0.05). 4. The teeth in group C, D had less leakage than group B, but there was no statistically significant differences(p＞0.05). 5. There was no significant differences in apical leakage between group C and group D(p＞0.05).

• 한국재료학회지
• /
• 제34권6호
• /
• pp.283-290
• /
• 2024

The aggressive scaling of dynamic random-access memory capacitors has increased the need to maintain high capacitance despite the limited physical thickness of electrodes and dielectrics. This makes it essential to use high-k dielectric materials. TiO₂ has a large dielectric constant, ranging from 30~75 in the anatase phase to 90~170 in rutile phase. However, it has significant leakage current due to low energy barriers for electron conduction, which is a critical drawback. Suppressing the leakage current while scaling to achieve an equivalent oxide thickness (EOT) below 0.5 nm is necessary to control the influence of interlayers on capacitor performance. For this, Pt and Ru, with their high work function, can be used instead of a conventional TiN substrate to increase the Schottky barrier height. Additionally, forming rutile-TiO₂ on RuO₂ with excellent lattice compatibility by epitaxial growth can minimize leakage current. Furthermore, plasma-enhanced atomic layer deposition (PEALD) can be used to deposit a uniform thin film with high density and low defects at low temperatures, to reduce the impact of interfacial reactions on electrical properties at high temperatures. In this study, TiO₂ was deposited using PEALD, using substrates of Pt and Ru treated with rapid thermal annealing at 500 and 600 ℃, to compare structural, chemical, and electrical characteristics with reference to a TiN substrate. As a result, leakage current was suppressed to around 10^-6 A/cm² at 1 V, and an EOT at the 0.5 nm level was achieved.

• Restorative Dentistry and Endodontics
• /
• 제20권1호
• /
• pp.250-260
• /
• 1995

Bases have been used in order to prevent the leakage of bleachingagents through dentinal tubules in bleached teeth. But the proximal surfaces where the actual resorption takes place havenot been protected. The purpose of this study was to compare the conventional basing method with the basing of the labial and two proximal surfaces to the cementoenamel junction. The bases were placed after conventional root canal treatment. Group I: 2mm thickness bases were placed to the level of labial cementoenamel junction line. Group II : 2mm thickness bases were placed to the level of all c-e J lines including cervical area. Control : No bases were placed. After placement of sodium perborate and 30% hydrogen peroxide mixtureinto the teeth, the changes of pH were measured. The results were as follows. 1. Group II showed smaller leakage of bleaching agents and was statistically significant difference compared to Group I.(p<0.05) 2. Group I showed no statistically significant difference compared to the control group. (p>0.05) 3. There were no significant among the upper and lower teeth groups in each group and between the groups.(p>0.05). According to the above results, it was considered that basing of the labial and proximal surfaces to the cementoenamel junction can reduce the leakage of bleaching agents during bleaching procedure of pulplessteeth.

• 미생물학회지
• /
• 제6권2호
• /
• pp.54-62
• /
• 1968

The effect of gamma-ray on yeast cells Sacch. cerevisiae, and the leakage of cellular constituents such as carbohydrates, ribose, amino acids, inorganic phosphates and organic phosphates have been studied. The samples of yeast cells washed throughly and starved intensively, radiation effects were compared with those of control (un-starved), the irradiation dose rates are in the range from 24 Kr. up. to 480, Kr. The loss of 260m$\mu$. absorbing material, are also observed. Mechanisms of membrane damage by gamma-irradiation are discussed corelating to permeability changes and loss of substances, then active and passive transport process are also under considerations in discussion. The experimental results are as follows, 1. Carbohydrates of yeast cell leak out by gamma-irradiation, and amounts of loss increase proportionally as the increasing of radiation dose, curve of carbohydrates loss in starved cells is parallel with those of non-starved cells. 2. Ribose leak out less than that of carbohydrate from irradiated cell, the dose response curve of loss is straight and proportional to the increasing of radiation doses, slope of the curve is much lower than of carbohydrates. 3. Amino acids also leak out and the curve of losses to radiation is not proportional, it is revealed that there are little losses from yeast at lower doses of irradiation. 4. The losses of inorganic phosphates increase unproportionally to the increasing of irradiation doses, there are little leakage at the lower doses of irradiation. The losses of organic phosphates increase proportionally to the increasing of irradiation doses, and the amount of losses are much more than that of inorganic phosphate at lower doses of irradiation. 5. Leakage from irradiated yeast cells was shown to be due to passive transport process not an energy requiring process of ion transport. 6. Loss of 260 m$\mu$. absorbing material is little more than that of control yeast by the gamma-irradiation dose of 120K.r. and 240K.r.

• 마이크로전자및패키징학회지
• /
• 제13권1호통권38호
• /
• pp.17-22
• /
• 2006

2단계 스퍼터링으로 강유전 PZT 박막을 형성시켜 유전특성과 전도기구를 조사하였다. 또한 PZT 박막 내의 carrier를 보상해주기위해 도너 불순물을 도핑하였다. 2단계 스퍼터링으로 상온층 두에를 조절하여 누설전류를 $10^{-7}A/cm^2$ order까지 줄일 수 있었다. 전도기구가 bulk-limited의 하나임을 확인하였고 따라서 적정한 도너 불순물을 채택하였다. 도너 불순물을 도핑한 경우 2단계 스퍼터링한 PZT 박막의 누설전류 특성은 $10^{-8}A/cm^2$ order까지 개선되었다.

• Journal of Mechanical Science and Technology
• /
• 제20권3호
• /
• pp.426-434
• /
• 2006

The impact of leakage was incorporated into the transfer functions of the complex head and discharge. The impedance transfer functions for the various leaking pipeline systems were also derived. Hydraulic transients could be efficiently analyzed by the developed method. The simulation of normalized pressure variation using the method of characteristics and the impulse response method shows good agreement to the condition of turbulent flow. The leak calibration could be performed by incorporation of the impulse response method with Genetic Algorithm (GA) and Harmony Search (HS). The objective functions for the leakage detection can be made using the pressure-head response at the valve, or the pressure-head or the flow response at a certain point of the pipeline located upstream from the valve. The proposed method is not constrained by the Courant number to control the numerical dissipation of the method of characteristics. The limitations associated with the discreteness of the pipeline system in the inverse transient analysis can be neglected in the proposed method.

• Restorative Dentistry and Endodontics
• /
• 제19권2호
• /
• pp.611-620
• /
• 1994

The purpose of this study was to evaluate the effect of post space preparation on apical sealing according to the methods and time of gutta percha removal. Forty six extracted single rooted teeth were selected for this study. Forty teeth were used as experimental groups and six teeth as control groups. Forty teeth were routinely prepared by step-back method and obturated with gutta percha cones and zinc oxide-eugenol cement using lateral condensation. All obturated teeth were divided into 4 groups of 10 teeth each. In each group of 1, 2, 3, heated plugger, gate glidden drill and chloroform and K-file were used respectively for post space preparation by removing the gutta percha immediately after obturation. In group 4, post space were prepared with gate glidden drill one week after obturation. In all experimental groups, the post space were prepared so that 4mm of apical gutta percha remained. After post space preparation, apical leakage were measured with electrochemical method for 28 days and analyzed statistically. The following results were obtained ; 1. No statistically significant differences in apical leakage were occured among the experimental groups using heated plugger, gate glidden drill and chloroform and K-file to remove the gutta percha immediately after obturation. 2. No significant difference in apical leakage was found between the teeth prepared post space immediately after obturation and those prepared 1 week after obturation. 3. In all experimental groups, the apical leakage was increased with time passage regardless of the post space preparation time and the gutta percha removal techniques.

• 한국콘텐츠학회논문지
• /
• 제6권11호
• /
• pp.310-316
• /
• 2006

상수도관망에서 발생하는 누수현상은 수자원의 손실뿐만 아니라 압력손실로 인한 추가적 가압 설비의 필요성 및 누수 되는 관로 주변의 토질의 약화 등을 초래하여 관망의 유지관리를 어렵게 하고, 심각한 경제적 손실을 야기하고 있다. 본 연구는 구역고립으로 인한 수압과 유량 등을 상시 모니터링 하여 누수사고의 적극적인 대처와 누수발생을 미연에 방지함으로써 유수율을 향상시킬 수 있다. 실제 구역고립 후 계속되는 수압조절 및 유입유량의 모니터링에 인하여 구역 내 유수율 산정결과 평균 유수율은 88.94%로서 부산광역시 2003년도의 유수율 79.5%보다 9.44% 높게 조사되었다.