• 전기의세계
• /
• v.17 no.3
• /
• pp.39-42
• /
• 1968

We have been studying on the discharged phenomena if compound dielectrics for insulator which is very important in electric machinery and et al. In this paper we come to the couclusion that as a result of studying on the electric design of Ozonizer, the higher frequency becomes the better output could be got, and then discharge power could be the greatest by selecting the distance of the discharge gap and atomospheric pressure properly under the same applied voltage, and that power factor of the Ozonizer reached the maximum power at a particular frequency when the discharge power is maintained at constant.

• 전기의세계
• /
• v.15 no.4
• /
• pp.18-21
• /
• 1966

A transistorized counting-rate meter was designed by substituting one of diodes in the ordinary diode pumping circuit by the Darling's constant current source. Its circuit is so simple and stable that it is proper to use as a part of portable radiation detectors. Maximum readable counting rate is well above 100 kc/s and the linearity is very good. Output deviations due to the variations of embient temperatures are less than 5% in the temperatures from 20.deg. C to 40.deg. C.

• 전기의세계
• /
• v.26 no.3
• /
• pp.63-68
• /
• 1977

In this paper, the theory of pulse frequency modulated DC/DC power converter to obtain constant output voltage for all input voltage changes is discussed. The switch controller consisting of integrator and comparator determines the ON time of power switch-Thyristor-by the error between the load voltage and a load reference voltage. Resulting voltage and current waveforms have been studied theoretically in detail and verified experimentally for a resistive and inductive load condition. State equations for voltages and currents using binary logic variables are computed by digital computer. Comparison of these withe oscillograms obtained from an experimental model shows very close agreement.

• ETRI Journal
• /
• v.29 no.6
• /
• pp.811-813
• /
• 2007

We report on a ridge waveguide laser diode with laterally tapered waveguides fabricated in a single growing step using a double patterning method. In this structure, nearly constant output power is obtained with the change of the lower tapered waveguide width, and the facet power ratio of 1.4 to 1.5 is observed over the current range. The asymmetric facet power property is also investigated.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.22-25
• /
• 2005

In the paper, algorithms for disturbance observers are newly presented in the time-domain. Attention is paid to observing a ramp disturbance by introducing an integral term to the output equation of a constant disturbance observer. In order to reduce the sensitivity to the measurement noise, the disturbance observer is combined with the state observer. It will be shown that the estimation dynamics can be arbitrarily chosen by assigning the eigenvalues of a characteristic equation. Also, we provide the analysis of observer behaviors subject to non-ramp-style disturbances. Finally, we propose the generalized disturbance observer that accurately estimates disturbances of higher order in time series expansion.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.8
• /
• pp.867-873
• /
• 1988

The degradation due to channel distortion in a quadrature modulation system from the ideal constant values over the bandwidth of a direct sequence spread spectrum signal are considered. Through using series expansion for the channel gain and phase response, the degradation in the correlator output at the receiver is found as a function of the parameters involved , including phase error, delay error, linear gin variation, quadratic gain variation, and quadratic phase variation.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.5 no.4
• /
• pp.320-328
• /
• 1981

Experimental study of a round. free air jet is accomplished using a crossed hot wire probe with a constant temperature hot wire anemometer. Mean velocity Profiles, Reynolds stresses, tubulent intensities, velocity probability densities and correlation functions are measured in the down tream region. These values are calculated and averaged inthe correlation and probability analyzer. The reults are interpreted by the output of te dual beam oscilloscope.

• 전기의세계
• /
• v.22 no.4
• /
• pp.11-16
• /
• 1973

This paper presents an optimum control of the field resistance for the self-excited DC shunt generator to keep a constant terminal voltage in case of the load change or the torque variation in the system. The non-linearity of the system is linearized by applying the small signal technique and the linearized equation is solved by the maximum principle with the digital computer. The optimal control value of the field resistance for the step error of the generator output voltage is obtained and the transient voltage characteristics in the system are investigated.

• Proceedings of the KIEE Conference
• /
• 2001.11c
• /
• pp.307-310
• /
• 2001

Mobile AGV is one of the nonholon-omic systems. The integration of the kinematic adaptive controller for the dynamic in this pa-per introduction a motion control problem's dynamic state feedback as well as output feedback tracking laws will be constructed with the adaptive extension of the controller is proposed. Feedback control strategies for mobile AGV are important to compensate for disturabances and errors in the initial condition. The problems of path following or tracking and of stabilization about a constant configuration have been treated as separate problems for nonholonomic mobile AGV.

• 제어로봇시스템학회:학술대회논문집
• /
• 1992.10a
• /
• pp.548-553
• /
• 1992

In this paper and recursive version of orthogonal ARMA identification algorithm is proposed. The basic algorithm is based on Gram-Schmidt orthogonalization of automatically selected basis functions from specified function space, but does not require explicit creation of orthogonal functions. By using two dimensional autocorrelations and crosscorrelations of input and output with constant data length, identification algorithm is extended to cope slowly time-varying or order-varying delayed system.