• 한국지반공학회논문집
• /
• 제20권4호
• /
• pp.57-63
• /
• 2004

공용상태 포장에서 노상토 및 보조기층 재료가 경험하는 구속응력 범위는 150㎪ 이내이다. 따라서 포장 시스템 설계 및 해석에서 낮은 구속응력 단계의 변형특성은 매우 중요한 물성치이다. 실제 포장시공 현장에서 노상토 및 보조기층 재료를 채취하였으며, 낮은 구속응력 단계에서 탄성계수에 대한 구속응력 영향 평가를 위하여 공진주시험(RC) 및 자유단공진주시험(FFRC)을 수행하였다. 흥미롭게, 낮은 구속응력 단계에서는 구속응력과 탄성계수의 관계가 대수공간보다는 선형공간에서 더욱 적합한 관계를 나타내었다. 이러한 결과를 근거로 낮은 구속응력단계에서 구속응력의 탄성계수에 대한 영향을 평가하는 새로운 모델을 제안하였다.

• Geomechanics and Engineering
• /
• 제31권6호
• /
• pp.557-571
• /
• 2022

Landslides are often triggered by weak interlayers initiated in tailings dam foundations, and hazards gradually occur. This is serious for landslides in high tailings dams due to their high potential energy. Tailing samples with a fine-grained interlayer at a set dip angle were prepared. Consolidated undrained (CU) triaxial shear tests were carried out by using a high-pressure triaxial apparatus. The results were compared with the results under a low confining pressure. Four reasons were summarized for high tailings dams more prone to instability than low dams. The shear strength of the samples with dipping interlayers decreases with increasing dip angle. An obvious straight drop in the stress path after the peak occurs in samples with dipping interlayers at an angle of 60°. The effect of the interlayer on the mechanical behaviour of tailings is very sensitive, especially for the sample with a dipping interlayer at an angle of 60°. Shear slipping along the interlayer should be given more attention in tailings dams. Compared with the results under low confining pressure, the stress decreases continuously for the samples with dipping interlayers at large angles under high confining pressure. The positive pore pressure, which reduces the effective stress, occurred in tailings samples under high confining pressure. The residual strength of tailings under high confining pressure is smaller than that under low confining pressure. These factors increase the dam break risk and the disaster impact for high tailings dams.

• Geomechanics and Engineering
• /
• 제30권5호
• /
• pp.401-411
• /
• 2022

To obtain the dynamic mechanical properties, fracture modes, energy and brittleness characteristics of Furong Baijiao coal rock, the dynamic impact compression tests under 0, 4, 8 and 12 MPa confining pressure were carried out using the split Hopkinson pressure bar. The results show that failure mode of coal rock in uniaxial state is axial splitting failure, while it is mainly compression-shear failure with tensile failure in triaxial state. With strain rate and confining pressure increasing, compressive strength and peak strain increase, average fragmentation increases and fractal dimension decreases. Based on energy dissipation theory, the dissipated energy density of coal rock increases gradually with growing confining pressure, but it has little correlation with strain rate. Considering progressive destruction process of coal rock, damage variable was defined as the ratio of dissipated energy density to total absorbed energy density. The maximum damage rate was obtained by deriving damage variable to reflect its maximum failure severity, then a brittleness index BD was established based on the maximum damage rate. BD value declined gradually as confining pressure and strain rate increase, indicating the decrease of brittleness and destruction degree. When confining pressure rises to 12 MPa, brittleness index and average fragmentation gradually stabilize, which shows confining pressure growing cannot cause continuous damage. Finally, integrating dynamic deformation and destruction process of coal rock and according to its final failure characteristics under different confining pressures, BD value is used to classify the brittleness into four grades.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2001년도 추계 학술발표회 논문집 Proceedings of EESK Conference-Fall 2001
• /
• pp.98-106
• /
• 2001

The deformation characteristics of cohesionless soils in Korea were investigated using resonant column tests. Total 60 samples, which were sampled from sedimentary and residual soils and reconstituted using controlled particle-size distributions, were prepared. The confining pressure applied in the tests ranges from 20 kPa to 500 kPa. The test results ware categorized into 3 groups including clean sands, silt and silty sand, and residual soils. Based on test results, the small-strain shear modulus(G$_{max}$) and damping ratio(D$_{min}$) were determined and the effects of confinement on G$_{max}$ and D$_{max}$ were characterized. The empirical correlations predicting G$_{max}$ were suggested for 3 group soils. Nonlinear deformational characteristics of clean sands are significantly affected by confining pressure and the ranges and mean curves for G and D are suggested considering the range of confining Pressure. The silt and silty sand and residual soils were weakly affected by confining pressure, so the representative ranges and curves, independent of confining pressure, were proposed.d.posed.d.

• Computers and Concrete
• /
• 제21권2호
• /
• pp.189-197
• /
• 2018

A discrete element approach is used to investigate the effects of confining stress on the shear behaviour of joint's bridge area. A punch-through shear test is used to model the concrete cracks under different shear and confining stresses. Assuming a plane strain condition, special rectangular models are prepared with dimension of $75mm{\times}100mm$. Within the specimen model and near its four corners, four equally spaced vertical notches of the same depths are provided so that the central portion of the model remains intact. The lengths of notches are 35 mm. and these models are sequentially subjected to different confining pressures ranging from 2.5 to 15 MPa. The axial load is applied to the punch through the central portion of the model. This testing and models show that the failure process is mostly governed by the confining pressure. The shear strengths of the specimens are related to the fracture pattern and failure mechanism of the discontinuities. The shear behaviour of discontinuities is related to the number of induced shear bands which are increased by increasing the confining pressure while the cracks propagation lengths are decreased. The failure stress and the crack initiation stress both are increased due to confining pressure increase. As a whole, the mechanisms of brittle shear failure changes to that of the progressive failure by increasing the confining pressure.

• 한국지반환경공학회 논문집
• /
• 제23권12호
• /
• pp.25-31
• /
• 2022

해양지반에 설치된 구조물은 육상지반에 설치된 구조물과는 달리 해상에서의 파하중, 풍하중, 그리고 조류하중 등과 같은 장기 반복하중을 고려해야 된다. 이에 해양지반에 설치된 구조물을 설계하기 위해서는 장기 반복하중을 받는 지반의 거동을 분석하는 것이 중요하다. 본 논문에서는 반복단순전단시험을 수행하여 구속압에 따른 장기반복하중에 대한 지반거동을 분석하고, 구속압에 따른 파괴특성을 쉽게 확인할 수 있는 3차원 설계파괴곡선을 작성하였다. 분석결과, 동일한 반복전단응력비와 평균전단응력비 조건이어도 구속압에 따라 설계파괴곡선의 위치가 차이가 있었으며, 파괴에 도달하는 반복하중횟수가 구속압에 영향을 받는 것을 확인하였다. 작성한 구속압에 따른 3차원 설계파괴곡선은 구속압에 따른 설계파괴곡선의 경향성과 대략적인 값을 추정할 수 있다.

• 한국산업융합학회 논문집
• /
• 제6권3호
• /
• pp.185-192
• /
• 2003

This study consolidation undrain Triaxial Compression Tests using constant confining pressure in clay that receive preconsolidation stress that is different and, void ratio, pore water pressure coefficient, shear strength compare with another thing theory and studied analyzing change relation of elastic modules. The summary of analysis is follows: If preconsolidation stress increases in same confining stress in relation of preconsolidation stress and deviator stress, deviator stress is proportional and increased. Can know that excess void pressure is proportional and decreases in size of preconsolidation stress in same confining stress state if preconsolidation stress increases preconsolidation stress and relation of excess void pressure. Also, over consolidated state can assume that this is thing by Dilatancy's effect though excess void pressure decreased remarkably. Preconsolidation stress and relation of stress path can know that shear strength degree increases preconsolidation stress increases, and specially, preconsolidation stress was appear in stress path form of overconsolidated state case of clay that receive at 300, 400, 500kPa in 100, 150kPa's deviator stress.

• 한국구조물진단유지관리공학회 논문집
• /
• 제6권1호
• /
• pp.193-203
• /
• 2002

The results of an experimental study on Saemangeum dredged sands are presented. Undrained triaxial compression tests were performed with there different initial relative densities, namely 18, 34, and 50%, intend to evaluate undrained Behavior. All undrained triaxial compression tests were performed under static loading conditions. Undrained triaxial compression tests were exhibited complete static liquefaction, zero effective confining pressure and zero stress difference at lower confining pressures. As confining pressures were increased, the effective stress paths indicated increasing resistance to static liquefaction by showing increasing dilatant tendencies. The fines and larger particles create a particle structure with high compressibility at lower confining pressure. The effect of increasing relative density was to increase the resistance of the sand against static liquefaction by making the sand more dilatant.

• Geomechanics and Engineering
• /
• 제16권5호
• /
• pp.547-558
• /
• 2018

Studies of soil dynamic properties in Malaysia are still very limited. This study aims to investigate the dynamic properties of two selected tropical residual soils (i.e., Sandy Clay and Sandy Silt) and a sand mining trail (Silty Sand) in Peninsular Malaysia using 1g shaking table test. The use of 1g shaking table test for soil dynamic testing is often constrained to large strain level and small confining pressure only. Three new experimental setups, namely large laminar shear box test (LLSBT), small chamber test with positive air pressure (SCT), and small sample test with suction (SSTS) are attempted with the aims of these experimental setups are capable of evaluating the dynamic properties of soils covering a wider range of shear strain and confining pressure. The details of each experimental setup are described explicitly in this paper. Experimental results show that the combined use of the LLSBT and SCT is capable of rendering soil dynamic properties covering a strain range of 0.017%-1.48% under confining pressures of 5-100 kPa. The studied tropical residual soils in Malaysia behaved neither as pure sand nor clay, but show a relatively good agreement with the dynamic properties of residual soils in Singapore. Effects of confining pressure and plasticity index on the studied tropical residual soils are found to be insignificant in this particular study.

• Geomechanics and Engineering
• /
• 제7권5호
• /
• pp.569-587
• /
• 2014

Triaxial compression creep tests were performed on salt rock samples using cyclic confining pressure with a static axial pressure. The test results show that, up to a certain time, changes in the confining pressure have little influence on creep properties of salt rock, and the axial creep curve is smooth. After this point, the axial creep curve clearly fluctuates with the confining pressure, and is approximately a straight line both when the confining pressure decreases and when it increases within one cycle period. The slope of these lines differs: it is greater when the confining pressure decreases than when it increases. In accordance with rheology model theory, axial creep equations were deduced for Maxwell and Kelvin models under cyclic loading. These were combined to establish an axial creep equation for the Burgers model. We supposed that damage evolution follows an exponential law during creep process and replaced the apparent stress in creep equation for the Burgers model with the effective stress, the axial creep damage equation for the Burgers model was obtained. The model suitability was verified using creep test results for salt rock. The fitting curves are in excellent agreement with the test curves, so the proposed model can well reflect the creep behavior of salt rock under low-frequency cyclic loading. In particular, it reflects the fluctuations in creep deformation and creep rate as the confining pressure increasing and decreasing under different cycle periods.