• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.2227-2232
• /
• 2003

For a reasonable analysis of grade efficiency of cyclone separator, in-line measurements of particle size and particle concentration are needed. The purpose of this study is to define the correlation of measurement data and to measure grade efficiency and pressure drop. The authors adapted that the grade efficiency could be calculated directly from the counted particle numbers. The problem of collection efficiency calculation was different from counting rate of aerosol counters under the same conditions. It is important factor to use the rate of the particle counters to obtain reliable results. Therefore, the authors should use and calculate compensation factor considering sensitivity of aerosol counters, gas velocity and concentration affect higher 30% than originally measured grade efficiency. As the pressure drop and grade efficiency increase, as flow rate increase and then also pressure drop and grade efficiency increase.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.33 no.3
• /
• pp.207-214
• /
• 2009

Crossover of nitrogen from cathode to anode is inevitable in typical membranes used in PEM fuel cells. This crossovered nitrogen normally accumulates in the hydrogen recirculation system at anode side channels. Excessive buildup of nitrogen in the anode side lowers the relative hydrogen concentration and finally affects the performance of fuel cell stack. So it is very important to analysis the nitrogen gas crossover at various operating conditions. In this study, characterization of nitrogen gas crossover in PEM fuel cell stack was investigated. The mass spectroscopy (MS) has been applied to measure the amount of the crossovered nitrogen gas at the anode exit. Results show that nitrogen gas crossover rate was affected by current density, anode and cathode stoichiometric ratio and operating pressure. Current density, anode stoichiometric ratio and anode operating pressure do not affect nitrogen crossover rate but anode exit concentration of nitrogen. Cathode pressure and stoichiometric ratio largely affect the nitrogen crossover rate.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1997.10a
• /
• pp.263-268
• /
• 1997

One of the principal causes of the deterioation of coastal concrete structures is the corrosion of reinforcing steel induced by the attack of chloride ions. An experimental study was performed to investigate the distribution of concentration of chloride ions in a coastal concrete structure and to measure the half-cell potential of embedded steel by using the copper-copper sulfate reference electrode. Quantitative analysis showed that the concentration of chloride ion in the aqueous phase near the surface of embedded steel exceeded a threshold value for corrosion, 0.05% by weight in concrete. The absolute value of half-cell potential at some members of embedded steel was measured to be higher than 350mV, indicating that the probability of corrosion is more than 90%. The prediction on corrosion based on the experimental measurements was confirmed by the observation of corrosion on the surface of steel bars in the concrete core taken out of the concrete structure.

• Journal of Korean Society for Atmospheric Environment
• /
• v.11 no.3
• /
• pp.291-298
• /
• 1995

An intensive field study was carried out during Aug. 1993 in Seoul to study the characteristics of summertime visibility and diurnal trend of ionic composition of ambient particles. A transmissometer, nephelometer with heated and unheated inlets, PM3 fine particle sampler, and cascade impactor were used to measure optical and particle properties of ambient air. During this study period, a weak smog episode has occurred. Light scattering by particles is the most dominant factor on total light extinction. The effect of light absorption by particles in Seoul is much higher than other major cities in U.S.A. throughout the summer and fall with relatively constant values. The effect of water on $b_{sp}$ was small during the period. The particle size distribution shows a typical bimodal one. Sulfate, ammonium, chloride, and nitrate are the major chemical species in fine fraction aerosols, about 30% of toral mass concentration. Concentraion of sulfate is higher during the daytime while those of nitrate and chloride are higher during the nighttime. Ammonium concentration is constant through the daytime.

• Proceedings of the KSME Conference
• /
• 2000.11a
• /
• pp.339-344
• /
• 2000

In this study, the fracture phenomena of optical disks are discussed and then some recommendations are presented to prevent the fracture. The fracture occurs when disks have crack on the inner radius of the disks. Since the crack growth and the fracture result from the stress concentration on the tip of the crack, a measure should be taken to overcome the stress concentration. This problem can be resolved by the structural modification of a disk. This study proposes 3 types of improved optical disks, which are robust to the disk fracture due to the high spinning speed of a disk. The first type is a disk reinforced by wire rings, the second type is a disk added by texture fibers, and the third type is a rubber-coated disk.

• Journal of Pharmaceutical Investigation
• /
• v.22 no.1
• /
• pp.55-62
• /
• 1992

In order to measure the bioavailability of Coptidis Rhizoma preparations, berberine was extracted by the mixture (1:1 v/v) of methanol and water from Coptidis Rhizoma and formulated into pills with some excipients. Disintegration time, dissolution rate, intestinal absorption rate, antibacterial effect, and serum concentration were measured. All pills were disintegrated about 60 minutes in gastric and intestinal juices and disintegration time did not change upon storage at $40^{\circ}C$ for 30 days. The pills manufactured using the extract which was extracted with the solvent containing dilute sulfuric acid showed faster dissolution and absorption from the small intestine than the other samples. It also showed not only the largest area under the serum concentration time curve and relative bioavailability, but also more potent antibacterial effect against gram-positive and gram-negative bacterias than the other samples. The correlation of the dissolution rate with absorption rate constant or $t_{max}$ showed a significant linear relationship.

• Economic and Environmental Geology
• /
• v.29 no.1
• /
• pp.21-24
• /
• 1996

Inductively coupled plasma atomic emission spectrophotometer (ICP/AES) is a versatile modern instruments for the multi-element analysis, but quantitative analysis using ICP/AES with normal pneumatic nebulizer is not applicable for the measurement of elemental concentrations in water down to the drinkining water standard level except a few elements because of poor detection limits. However, the detection limit can be lowered enough to measure drinking water standard, if ultrasonic nebulizer and/or hydride vapor generator is attached. This method is tested with groundwater samples from Tajeon area. It is confirmed that the elemental concentrations in these samples are within the limit of drinking water standard for the most elements. However, uranium concentration is very high in some samples compared with the concentrations suggested by Environmental Protection Agency of U.S.A. There is no standard concentration level to this element in Korea and it should be prepared immediately.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.04a
• /
• pp.111-114
• /
• 2003

A new monitoring system has been developed for in-situ and realtime measurement of ozone transport in unsaturated porous media using a fiber optic sensor. The calibration of the fiber optic transflection dip probe (FOTDP) system was successfully carried out at various ozone concentrations using a column with length of 30 cm and diameter of 5 cm packed with glass beads, which don't react with gaseous ozone. The breakthrough curves (BTCs) of ozone was obtained by converting the normalized intensity into ozone concentration. The FOTDP system reflected the ideal transport phenomena of gas phase ozone at various flow rates. The FOTDP system worked well for in-situ monitoring of gas phase ozone at various water saturations and in presence of SOM. However, the FOTDP system did not measure the ozone concentration at more than 70% water saturation.

• Journal of Korean Society on Water Environment
• /
• v.23 no.1
• /
• pp.81-86
• /
• 2007

This paper describes a study on the role of limestone which might affect the dissolution of phosphates when phosphate containing sediments are put under anaerobic conditions. A small quantity of calcium hydroxy-apatite, alone or mixed with limestone powder, was put in contact with aqueous solution of acetic acid or carbonic acid, and variations of phosphate concentration were determined time dependantly. The results showed that the concentration was remarkably low in the presence of limestone, signifying that the coexistence of limestone suppresses the dissolution of phosphate by organic acid and/or carbonic acid. Separate experiments conducted by developing an anaerobic condition, after mixing lake sediments with dried leaves and limestone, showed that the existence of limestone suppressed the dissolution of phosphate. These results show that the application of limestone might be a useful measure to prevent deterioration of water quality originated from eutrophication by inhibiting the internal loading of P in eutrophic water-bodies.

• Textile Coloration and Finishing
• /
• v.16 no.2
• /
• pp.47-51
• /
• 2004

A differential refractive index detector was used for monitoring glucose contents in textile processing solutions. The sensitivity of the device was high enough to measure 0.05％ aqueous glucose solution that could not be measured by normal refractive index measurement. The device was set to monitor glucose concentration continuously in real time by measuring differential refractive index and calibrated by standard glucose solutions in a range of 0.1 to 1.0%. The possibility of industrial application of the device was demonstrated by real-time monitoring of glucose concentration in textile processing solutions such as desizing bath and cellulase treatment bath. Both of solutions contained glucose as a major degraded product. The device would be able to control the weight loss of cellulosic fiber during cellulase treatment since the amount of degraded products in a processing bath is proportional to its weight loss.