• Analytical Science and Technology
• /
• v.8 no.4
• /
• pp.799-806
• /
• 1995

In industrial field, a large volume of regenerants (acid and caustic soda) and their washing effluents are regularly disposed off from the water demineralization plant during regeneration of the ion-exchanger units. Of these waste effluents, a part of the wash water discharged from the single bed Anion and Mixed Bed units can be utilized at a certain stage of their washing cycles when its conductivity is fallen down and becomes considerably less than that of the input raw water. The main aim of this specific waste effluent utilization is to dilute the TDS concentration of the input raw water (fed into the single bed ion-exchanger units) by blending. The achievement is the increase of the longevity of the production cycles of the I.E. units along with the improvement of the production quality and decrease of the regeneration frequencies. As a result, regenerant consumption would be saved because of the reduction of ionic load in feed water which will ultimately reduce the water purification cost. At the same time, the environment pollution will also be protected to a considerable extent. This operational measure is quite effective and useful specially where high TDS water is demineralized only by single bed ion-exchangers. In such case, the water treatment plant is very often found to suffer from both production quality and quantity in addition to carrying out of random and restless regenerations. Proper reuses of the aforesaid wash water effluents of the Anion and MB units excellently minimizes the difficulties experienced in practice. This paper contains the utilities and techniques of reuses of the different kinds of waste effluents of the industrial water treatment plant in addition to the specific reuses of the post-regeneration wash waters of the Anion and MB ion-exchanger units.

• Environmental and Resource Economics Review
• /
• v.19 no.4
• /
• pp.915-961
• /
• 2010

This study is concerned with health damages from $SO_2$ under different assumptions on the relationship between air concentrations and their marginal health impacts. $SO_2$ concentration profiles resulting under emission caps, and a system of tradable emission allowances are compared. Using slopes and curvatures of the health response function consistent with evidence in medical literature, emission caps are shown to lead to lower aggregate damages under all considered parameters, an advantage of $26~452 million. The benefit of emission caps over tradable allowances increases with the curvature of the response function, but falls with its slope. The advantage of emission caps in terms of environmental damages is never overturned completely for the considered functional forms. The marginal damage function would have to be steeper than what the current medical evidence suggests for price instruments to outperform emission caps in terms of aggregate damages. With other welfare consequences included-emission abatement costs, consumer and producer surpluses, and government revenue-emission caps always lead to a $3.7~4.1 billion greater measure of social welfare.

• Journal of Food Hygiene and Safety
• /
• v.10 no.4
• /
• pp.225.2-262
• /
• 1995

Ochratoxin A was produced from Aspergillus ochraceus ATCC 18472 which was then orally administered into the experimental mice to study the toxic levels of ochratoxin A. AELISA (enzyme-linked immunosorbent assay) method which is more rapid and safe than conventional analytical method, was developed by using ochratoxin A antibody. This method was successfully used to measure the levels of ochratoxin Ain blood, liver and kidney of mice. In order to produce a large amount of ochratoxin A to study toxicity in the mice, Aspergillus ochraceus ATCC 18412 was incubated in the rice medium and as a result 0.5 g of ochratoxin A form rice medium (kg) was produced after extraction and purification Feed consumption and gain in body weight of mice with ochratoxin A at a level of $10 \mu\textrm{g}/g$ body weight was significantly (p<0.05) reduced as compared with control during period of 3 weeks. Ochratoxin A-BSA conjugate was made by putting 13 mole of ochratoxin A on I mole of BSA. This conjugate was used to develop ELISA method. The minmum detection level of ochratoxin A by established ELISA method was 0.5 ppb. After oral adminstraton of ochratoxin A dose of $10\;\mu\textrm{g}/g$ every two day for 3 weeks, concentration of ochratoxin A was measured in the blood, liver and kidney by ELISA method. The level of ochratoxin A was $11\;\mu\textrm{g}/dl,\;0.9 \mu\textrm{g}/g\;and\;3.7\;\mu\textrm{g}/g$ in the blood, liver and kidney, respectively.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.21 no.2
• /
• pp.157-166
• /
• 1985

The Purpose of this study are to investigate the characteristics of the flame behavior of gasoline-methanol blended fuels in spark ignition engine. Ionization probe were installed at the cylinder head and piston in order to measure flame speed. Other parameter such as engine performance, fuel consumption rate and exhaust gas were measured. The results were as follows. 1. In the case of increase methanol contents in blend fuel, flame propagation speed were increased, and thermal efficiency of the engine were increased due to decrease of energy consumption rate. 2. In the case of fixed equivalance ratio, NO sub(X) in exhaust gas were increased in accordance with increase of spark advance, and mean effective pressure were decreased in accordance with increase of methanol contents. 3. CO and HC concentration were decreased in accordance with increase of methanol contents.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.13 no.2
• /
• pp.1-9
• /
• 2005

An end beam is one of the most important structural members supporting uncovered freight under in-service loading. In general, it needs to endure over 25 years. However fatigue fracture has occurred at dynamic stress concentration location of the end beam because user's specifications demanded high speed and vehicle manufacturer made the uncovered freight car with comparatively low strength and stiffness. For durability analysis, finite element analysis is performed to evaluate the problem of uncovered freight structure and local strain. The uncovered freight car was operated on actual problematic railroad line to measure dynamic stress versus time history on the critical part from which a crack is initiated often. Rainflow cycle counting method was used to estimate fatigue damage at dangerous area under operating condition. Therefore, this study shows that analytical fatigue life at the end beam can be predicted on the basis of S-N curve and structure analysis and has a fairly good correlation with experimental fatigue life.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.19 no.5
• /
• pp.92-99
• /
• 2011

To measure the traffic pollutants with high temporal and spatial resolution under real conditions, a mobile emission laboratory (MEL) was designed. The equipment of the mini-van provides gas phase measurements of CO, NOx, $CO_2$, THC (Total hydrocarbon) and number density & size distribution measurements of fine and ultra-fine particles by a fast mobility particle sizer (FMPS) and a condensation particle counter (CPC). The inlet sampling port above the bumper enables the chasing of different type of vehicles. This paper introduces the technical details of the MEL and presents data from the car chasing experiment of diesel bus equipped with aftertreatment system. The dilution ratio was calculated by the ratio of ambient NOx and tail-pipe NOx. Most particles from the diesel bus were counted under 300 nm and the peak concentration of the particles was located between 30 and 60 nm. The total PM number emission from diesel bus equipped with DPF was 10 orders of magnitude lower compared to those emitted from base diesel bus. And the total PM number emission from diesel bus equipped with SCR was comparable to the particle emission from base diesel bus.

• Analytical Science and Technology
• /
• v.18 no.3
• /
• pp.241-249
• /
• 2005

In this study, instrumental neutron activation analysis was used to measure the concentrations of about 30 trace elements in airborne particulate (PM2.5) samples at urban area of Daejeon city located in the southwestern region of Korea. An inspection of the measurement data indicates that the distribution patterns of trace elements could clearly distinguish the elements with their concentrations ranging over five orders of magnitude. The mean values for Lu and Dy were found to be the lowest at values of 0.01 and $0.04ng/m^3$, while those for K and Fe showed the highest value of 671 and $653ng/m^3$, respectively. The results of correlation analysis showed that PM2.5 concentrations can exhibit much more enhanced correlations with the elements of earth crustal components. The results of factor analysis further indicated that there are no more than six factors with statistical significance, which may exert dominant roles in regulating the elemental concentration levels in the study area. Enrichment factor analysis supports explicit interpretation of results found by this factor analysis.

• Analytical Science and Technology
• /
• v.13 no.6
• /
• pp.775-780
• /
• 2000

The electrical conductivity of glass melter at high temperature has been measured. The conductivity is an important physical property for the research and the manufacturing process of glass. Because high temperature is an inconvenient situation to measure the conductivity of glass melter, we have made a platinum crucible and electrode and have measured the conductivity at high temperature. KCl solution, of which concentration is adjusted to the conductivity of glass melter, is used to get parameters of the conductivity cell. A measuring circuit is composed with an AC 1 kHz sine wave generator and an operational amplifier. The cell constants are determined from the measured voltages and the equivalent conductances of KCl solution. Various cells are tested to find a suitable shape for high temperature experiment. The results are compared by cell size, electrode depth, and cell configuration. The conductivity of the borosilicate melter is $0.053{\Omega}^{-1}cm^{-1}$ at $1,450^{\circ}C$.

• Applied Chemistry for Engineering
• /
• v.9 no.4
• /
• pp.469-474
• /
• 1998

Poly (vinyl alcohol) (PVA) membranes crosslinked with poly (styrene-co-maleic anhydride) (PSMAn) have been prepared by the solution method. To investigate the separation behavior of the crosslinked PVA/PSMAn membranes in the pervaporation process, the selective sorption experiment and swelling measurements of the membranes in ethanol-water mixtures of 30~90 wt % ethanol contents were conducted with equipment that was able to measure the concentration and amount of the liquid absorbed in the membranes. The membranes prepared in this study exhibited good selectivity toward water component in sorption and permeation. Also, in the feed containing ethanol more than 50 wt %, the permeation selectivity of the membrane showed better correlation with the sorption selectivity than that with the swelling ratio changing toward the crosslinking content. This behavior was consistence with a solution-diffusion model correlating permeation and sorption selectivity, and led to the conclusion that the permeation selectivity was determined by sorption step rather than by diffusion step in the membrane.

• Food Science of Animal Resources
• /
• v.23 no.2
• /
• pp.155-160
• /
• 2003

The purpose of this study was to purify epidermal growth factor(EGF) as growth factor from human colostrum. The effects of purified EGF fraction were directly related to the growth of cells. Results were as follows; After eliminated fat from colostrum, skim milk was obtained. We obtained the EGF fraction by performing ultrafiltration and gel filtration, and then were convicted by SDS-PAGE. The result of analysis of purified EGF fraction by high performance liquid chromatography(HPLC) was shown a peak at 31.185 min period. And it was similar with standard EGF that was shown a peak at 31.545 min. 10 ng of EGF was contained in 10 mg/mL through immunoassay to measure EGF content from isolated fraction. After SDS-PAGE, isolation degree of purified fraction was convicted through western blotting. BALB/3T3 cell was the most effectively stimulated and proliferated at 1 mg/mL concentration of the purified EGF fraction and percentage of cell proliferation was about 95%. In the case of IEC-6 cell, that was about 71%.