• Transactions on Control, Automation and Systems Engineering
• /
• v.4 no.4
• /
• pp.296-304
• /
• 2002

A position tracking control schemes on the precise mechanical system in presence of nonlinear dynamic friction is proposed. A nonlinear dynamic friction is regarded as the bristle friction model to compensate effects of friction. The conventional sliding mode controller often has been used as a non-model-based friction controller, but it has a poor tracking performance in high-precision position tracking application since it completely cannot compensate the friction effect below a certain precision level. Thus to improve the precise position tracking performance, we propose the sliding mode control method combined with the friction-model-based observer having tunable structure of the transient response. Then this control scheme has a good transient response as well as the high precise tracking performance compared with the conventional sliding mode control without observer and the control system with similar type of observer. The experiments on the bali-screw drive table with the nonlinear dynamic friction show the feasibility of the proposed control scheme.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.1
• /
• pp.27-35
• /
• 2008

A navigation system is one of the important components of an unmanned ground vehicle (UGV). A GPS receiver collects data signals transmitted by (Earth orbiting) satellites. However, these data signals may contain many errors resulting misinformation and depending on one's position (environment), reception may be impossible. The proposed self-driven algorithm uses three low-cost GPS in order to minimize errors of existing inexpensive single GPS's driving algorithm. By using reliable final data, which is analyzed and combined from each of three GPS's received data signals, gathering a vehicle's steering performance information and its current pin-point position is improved even with error containing signals or from a place where signal gathering is impossible. The purpose of this thesis is to explain navigation system algorithm using multiple GPS and compass sensor and prove the algorithm through experiments.

• Journal of Institute of Control, Robotics and Systems
• /
• v.13 no.1
• /
• pp.52-57
• /
• 2007

In this paper we proposed multi-directional matching windows combined by multi-dimensional feature vector matching, which uses not only intensity values but also multiple feature values, such as variance, first and second derivative of pixels. Multi-dimensional feature vector matching has the advantage of compensating the drawbacks of area-based stereo matching using one feature value, such as intensity. We define matching cost of a pixel by the minimum value among eight multi-dimensional feature vector distances of the pixels expanded in eight directions having the interval of 45 degrees. As best stereo matches, we determine the two points with the minimum matching cost within the disparity range. In the experiment we used aerial imagery and IKONOS satellite imagery and obtained more accurate matching results than that of conventional matching method.

• Journal of Institute of Control, Robotics and Systems
• /
• v.18 no.1
• /
• pp.7-12
• /
• 2012

In this paper, we present an effective viewpoint estimation algorithm for the Moving parallax barrier method of 3D display mobile device. Moving parallax barrier is designed to overcome the biggest problem, the limited view angle. To accomplish it, the position of the viewer's eyes or face should be estimated with strong stability and no latency. We focus on these requirements in the poor performance of mobile processors. We used a pre-processing algorithm in order to overcome the various illumination changes. And, we combined the conventional Viola-Jones face detection method and Optical-flow algorithm for robust and stable viewpoint estimation. Various computer simulations prove the effectiveness of the proposed method.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.9
• /
• pp.904-908
• /
• 2008

Every autonomous system like a robot needs a power source known as a battery. And proper management of the battery is very important for proper operation. To know State of Charge(SOC) of a battery is the very core of proper battery management. In this paper, the SOC estimation problem is tackled based on the well known Extended Kalman Filter(EKF). Combined the existing battery model is used and then EKF is employed to estimate the SOC. SOC table is constructed by extensive experiment under various conditions and used as a true SOC. To verify the estimation result, extensive experiment is performed with various loads. The comparison result shows the battery estimation problem can be well solved with the technique proposed in this paper. The result of this paper can be used to develop related autonomous system.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.9
• /
• pp.886-892
• /
• 2008

In this paper, a closed-loop observer to extract the center of mass (CoM) of a bipedal robot is suggested. Comparing with the simple conversion method of just using joint angle measurements, it enables to get more reliable estimates by fusing both joint angle measurements and F/T sensor outputs at ankle joints. First, a nonlinear-type observer is constructed to estimate the flexible rotational motion of the biped in the extended Kalman filter framework. It adopts the flexible inverted pendulum model which is appropriate to address the flexible motion of bipeds, specifically in the single support phase. The predicted estimates of CoM in terms of the flexible motion observer are combined with measurements (that is, output of the CoM conversion equation with joint angles). Then, we have final CoM estimates depending on the weighting values which penalize the flexible motion model and the CoM conversion equation. Simulation results show the effectiveness of the proposed algorithm.

• Journal of electromagnetic engineering and science
• /
• v.1 no.2
• /
• pp.131-138
• /
• 2001

The DTV (Digital TV) tuner for an 8-VSB (Vestigial Side-Band) modulation was developed to meet the requirements of the ATSC (Advanced Television Systems Committee). The double frequency conversion and the active tracking filter in the front-end were used to cancel interferences between adjacent channels and multi-channels by suppressing the IF beat and the Image frequency. However, It was impossible to get frequency mapping between the tracking filter and the first VCO (Voltage Controlled Oscillator) in the existing DTV tuner structure which differs from the NTSC (National Television Systems Committee) tuner. This paper, therefore, suggests an assailable structure and a new method for the automatic frequency selection by mapping the frequency characteristics over the tracking voltage and the combined HW which is composed of a Micro-controller, an EEPROM (Electrically Erasable Programmable Read Only Memory), a DAC (Digital-to-Analog Converter), an OP amplifier, and a switch driver.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.111-112
• /
• 2008

Although two types of uncertainty such as randomness and fuzziness simultaneously exist in power systems, yet they have been treated as distinct fields to evaluate the power system reliability. Thus, this paper presents a reliability assessment method based on a combined concept of fuzzy and probability. To reflect the two-fold uncertainty, a modified load duration curve(MLDC) is proposed using the probability distribution of historical load data in which a fuzzy model for the peak load forecast is embedded. IEEE RTS system was used to demonstrate the usefulness and applicability of the proposed method, and the reliability indices were obtained using the proposed MLDC. The results show a wider insight into impact of load fuzziness on uncertainties of reliability indices for power systems.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.608-609
• /
• 2008

Photovoltaics and wind energy sources are being increased recognised as cost effective generation sources in small isolated power systems(SIPS) primarily supplied by costly diesel fuel. Deterministic and probabilistic techniques are combined using a system well-being approach to provide useful reliability indices for SIPS containing renewable energy. An evaluation of the contribution from photovoltaics and wind energy sources to SIPS reliability is presented. The practicality and effectiveness of the methodology is illustrated by a case study.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1759-1760
• /
• 2008

This paper proposes a neural network(NN)-based adaptive sliding mode controller for discrete-time nonlinear systems. By using disturbance estimation technique, a sliding mode controller is designed, which forces the sliding variable to be zero. Then, NN compensator with hidden-layer-to-output-layer weight update rule is combined with sliding mode controller in order to reduce the error of the estimates of both disturbances and nonlinear functions. The whole closed loop system rejects disturbances excellently and is proved to be ultimately uniformly bounded(UUB) provided that certain conditions for design parameters are satisfied.