• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.27 no.3
• /
• pp.36-42
• /
• 2013

This paper deals with the frequency-dependent ground impedance of ground grids combined with the carbon ground electrodes. Ground grids are generally valid for multipurpose grounding systems as well as lightning protection systems. The carbon ground electrodes may be supplementarily used to reduce the high frequency ground impedance and to improve the transient response to surge currents. The frequency-dependent ground impedances of ground grids combined with or without the carbon ground electrodes were measured and their simulations with due regard to frequency-dependent soil resistivity were implemented by using EMTP program and Matlab modeling. As a consequence, the ground impedance of ground grids combined with the carbon ground electrodes is significantly reduced when the test current is injected at the terminal of the carbon ground electrode. The measured and simulated data for the test ground grids fairly agree with each other. It was found that the proposed method of simulating the frequency-dependent ground impedance is distinguished. The simulation techniques of predicting accurately the ground impedances without actual measurements can be used in the design of grounding systems based on ground grids and the carbon ground electrodes.

• Journal of Microbiology and Biotechnology
• /
• v.25 no.7
• /
• pp.1036-1046
• /
• 2015

Extracts from Asian medicinal herbs are known to be successful therapeutic agents against cancer. In this study, the effects of three types of herbal extracts on anti-tumor growth were examined. Among the three types of herbal extracts, H9 showed stronger anti-tumor growth effects than H5 and H11 in vivo. To find the molecular mechanism by which H9 inhibited the proliferation of breast cancer cell lines, the levels of apoptotic markers were examined. Proapoptotic markers, including cleaved PARP and cleaved caspases 3 and 9, were increased, whereas the anti-apoptotic marker Bcl-2 was decreased by H9 treatment. Next, the combined effect of H9 with the chemotherapeutic drugs doxorubicin/cyclophosphamide (AC) on tumor growth was examined using 4T1-tumor-bearing mice. The combined treatment of H9 with AC did not show additive or synergetic anti-tumor growth effects. However, when tumor-bearing mice were co-treated with H9 and the targeted anti-tumor drug trastuzumab, a delay in tumor growth was observed. The combined treatment of H9 and trastuzumab caused an increase of natural killer (NK) cells and a decrease of myeloid-derived suppressor cells (MDSC). Taken together, H9 induces the apoptotic death of tumor cells while increasing anti-tumor immune activity through the enhancement of NK activity and diminishment of MDSC.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.3
• /
• pp.365-371
• /
• 2014

It is essential for the combined military weapon system to be equipped with interoperability for the efficient combat operation in the modern warfare environment. Since most of modern military systems utilize the electromagnetic wave for the radio communication in the network-centric warfare system, they can be vulnerable to the mutual interference among the adjacent combined military systems. In this paper, the typical radio communication systems are modeled with the modulation types of both spread and non-spread spectrum system. The various interference signals were generated for the simulation of the mutual interference influence from the adjacent radar and communication systems. The simulation results show that the detection performance of the victim communication receiver is seriously affected by the various interferences such as the types of modulation and the ratio of the overlapping bandwidth of the adjacent interferers. This result will be useful for defining the criteria of the interference protection in the combined military system for the interoperability in the future.

• The KSFM Journal of Fluid Machinery
• /
• v.6 no.3 s.20
• /
• pp.28-35
• /
• 2003

This paper presents analysis results for the effect of power control strategies on the part load performance of gas turbine based power generation systems utilizing exhaust heat of the gas turbine such as combined cycle power plants and regenerative gas turbines. For the combined cycle, part load efficiency variations were compared among different single shaft gas turbines representing various technology levels. Power control strategies considered were fuel only control and IGV control. It has been observed that gas turbines with higher design performances exhibit superior part load performances. Improvement of part load efficiency of the combined cycle by adopting air flow modulation was analyzed and it was concluded that since the average combined cycle performance is affected by the range of IGV control as well as its temperature control principle, a control strategy appropriate for the load characteristics of the individual plant should be adopted. For the regenerative gas turbine, it is likewise concluded that maintaining exhaust temperature as high as possible by air flow rate modulation is required to increase part load efficiency.

• Journal of Institute of Control, Robotics and Systems
• /
• v.22 no.6
• /
• pp.483-489
• /
• 2016

This paper proposes a repeat-back jamming signal detection scheme that utilizes a combined pseudo random noise signal that is effective for processing a global positioning system (GPS) repeat-back jamming signal with the early minus late phase scheme to alleviate any existing multipath signal detection. The proposed scheme uses the combined pseudo random noise signal to treat repeat-back jamming signals like similar multipath signals and can effectively detect a repeat-back jamming signal by applying the early minus late phase scheme to a combined pseudo random noise signal. Through a Monte-Carlo simulation, the detection probability of the proposed scheme is better than the one of the conventional scheme under low jamming to signal power ratio.

• Proceedings of the KSME Conference
• /
• 2001.06d
• /
• pp.726-731
• /
• 2001

A thermal design software is developed for the heat recovery steam generator(HRSG) of combined cogeneration systems. The heat transfer is calculated by using the element method to account for the varying thermal properties across the heat transfer elements. The circulation balance is computed for the evaporator to accurately estimate the steam generation rate and to check the proper circulation of the boiler water through the tubes. The software developed can be used to simulate HRSG systems with various combinations of auxiliary burner, wall superheater, superheater, reheater, evaporator, and economizer. Systems with several different combinations of the system components are successfully tested. And it is concluded that the developed software can be used for the design of heat recovery steam generators with various combinations of heat transfer components.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.31 no.2 s.257
• /
• pp.221-230
• /
• 2007

An iterated improved reduced system (IIRS) procedure combined with sub-structuring scheme for nonclassically damped structural systems is presented. For dynamic analysis of such systems, complex eigenproperties are required to incorporate properly the nonclassical damping effect. In complex structural systems, the equations of motion are written in the state space from. Thus, the number of degrees of freedom of the new equations of motion and the size of the associated eigenvalue problem required to obtain the complex eigenvalues and eigenvectors are doubled. Iterated IRS method is an efficient reduction technique because the eigenproperties obtained in each iteration step improve the condensation matrix in the next iteration step. However, although this reduction technique reduces the size of problem drastically, it is not efficient to apply this technique to a single domain finite element model with degrees of freedom over several thousands. Therefore, for a practical application of the reduction method, accompanying sub-structuring scheme is necessary. In the present study, iterated IRS method combined with sub-structuring scheme for nonclssically damped structures is developed. Numerical examples demonstrate the convergence and the efficiency of a newly developed scheme.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2008.04a
• /
• pp.223-226
• /
• 2008

This paper presents an effectiveness of a four-link mechanism with a tip which has four joints, but only one is an active joint. Even though the degree-of-freedom of the mechanism is one, it can be applied to implement a combined joint motion adequately. So, this paper analyzes its motion for effective robotic applications.

• Journal of Korean Society on Water Environment
• /
• v.23 no.4
• /
• pp.458-466
• /
• 2007

This study is to evaluate control effects of separation wall by surveying water quality and sewer overflows during dry and wet periods in combined sewer and separated sewer systems. Ravine water from the combined Seokgyo outfall with the separation wall was separated about four times larger than sewage flow during dry periods. The water quality of the combined Seokgyo outfall with separation wall during dry periods is flow weighed average BOD 61 mg/L, the combined Cheonseokgyo outfall without the separation wall is average BOD 71 mg/L, and the separated Pyeongsong center outfall is average BOD 41 mg/L. The BOD concentration in separated outfall form about 57% of the combined outfall, and this means the separated outfall (i.e. storm sewer) is polluted by inflow of sewage. The overflow load of the separated outfall is ten times higher than the combined outfall and its overflow load per rainfall is three times than combined outfall during the wet periods. Therefore, the control plan of overflow load is required in storm sewer. The control effects of the overflow load increased 79% by setting the separation wall in the combined sewer, and showed 27% increase without the separation wall in separated sewer, but forecasted over 80% increase of effects if the separation wall was set.

• The Journal of Information Systems
• /
• v.19 no.4
• /
• pp.183-206
• /
• 2010

The technology acceptance model (TAM) is a lot of cited in information technology adoption and usage researches. But TAM has been conducted primarily in volitional environments of the adoption of new technology. This paper discusses technology acceptance in accounting information systems to examine TAM with Characteristics of Organizations and Individuals in mandated using Combined Guard System. Combined Guard System is a scientific guard system that is composed of automated surveillance system, automated sensing system and control system. GOP Scientific Guard System is operated by GOP unit in Korean Army O Division from 2006. In this study, using the extended technology acceptance model, we have analyzed factors which affect the usage intention of GOP Scientific Guard System in mandated using environment. Based upon previous researches, we have selected Support of management unit, Training, Perceived Risk, Subjective Knowledge and Computer Self-efficacy, perceived usefulness, perceived ease of use, and usage intention as variables and proposed a research model. We collected 253 survey questionnaires from Korean army officer and soldier who are serviced at GOP unit in O Division, and analyzed the data using SPSS 12.0 and SmartPLS 2.0M3. According to the results by PLS analysis, According to the results by PLS analysis, Training and Subjective Knowledge did not affect Perceived usefulness, but the other hypotheses were accepted. And Perceived usefulness, and Ease of use influenced the Usage intention. The results of this study will increase Characteristics of Organizations and Individuals on GOP Scientific Guard System and eventually contribute to establishing the activation of Combined Guard System.