• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.11
• /
• pp.2196-2202
• /
• 1992

The optimum size combination of heat exchangers in a Joule-Thomson(J-T) circuit for small cryogenic systems has been sought analytically, when the circuit is combined with a two-stage Gifford-McMahon(GM) cooler. Full thermodynamic cycle analysis was carried out to predict the performance of the combined refrigeration system. Relevant convective heat transfer coefficients, the computerized properties of helium, and the refrigeration capacity curve of a typical GM cooler have been used in the analysis. The result showed that, by changing the configuration(heat exchanger area ratio) of the system, the performance of the commonly-used GM/J-T refrigerators could be optimized. For the maximum refrigeration performance, the optimum mass flow rate of the refrigerant and the relative size between the heat exchangers have been obtained, when the cooling load was 0.1W at 3.995K with the total heat exchanger area being given.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.6
• /
• pp.870-879
• /
• 2000

An experimental investigation is conducted to improve a slot film cooling system which can be used for the cooling of gas turbine combustor liner. The tangential slots are constructed of discrete holes with different injection types which are the parallel, vertical, and combined to the slot lip. The investigation is focused on the coolant supply systems of normal-, parallel-, and counter-flow paths to the mainstream direction. A naphthalene sublimation technique has been employed to measure the local heat/mass transfer coefficients in a slot with various injection types and coolant feeding directions. The velocity distributions at the exit of slot lip for the parallel and vertical injection types are fairly uniform with mild periodical patterns with respect to the hole positions. However, the combined injection type increases the nonuniformity of flow distribution with the period equaling twice that of hole-to-hole pitch due to splitting and merging of the ejected flows. The secondary flow at the lip exit has uniform velocity distributions for the parallel and vertical injection types, which are similar to the results of a two-dimensional slot injection. In the results of local heat/mass transfer coefficient, the best cooling performance inside the slot is obtained with the vertical injection type among the three different injection types due to the effect of jet impingement. The lateral distributions of Sh with the parallel- and counter-flow paths are more uniform than the normal flow path. The averaged Sh with the injection holes are $2{\sim}5$ times higher than that of a smooth two-dimensional slot path.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.1
• /
• pp.58-68
• /
• 2005

In this paper, we propose a scheme to improve discriminative property in the feature compensation method for robust speech recognition under noisy environments. The estimation of noisy speech model used in existing feature compensation methods do not guarantee the computation of posterior probabilities which discriminate reliably among the Gaussian components. Estimation of Posterior probabilities is a crucial step in determining the discriminative factor of the Gaussian models, which in turn determines the intelligibility of the restored speech signals. The proposed scheme employs minimum classification error (MCE) training for estimating the parameters of the noisy speech model. For applying the MCE training, we propose to identify and determine the 'competing components' that are expected to affect the discriminative ability. The proposed method is applied to feature compensation based on parallel combined mixture model (PCMM). The performance is examined over Aurora 2.0 database and over the speech recorded inside a car during real driving conditions. The experimental results show improved recognition performance in both simulated environments and real-life conditions. The result verifies the effectiveness of the proposed scheme for increasing the performance of robust speech recognition systems.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.10a
• /
• pp.740-743
• /
• 2012

The initial role of the operating system acts as an intermediary between the computer and the user, and, hardware and process management, and the convenience of your computer system is to use. Of these operating systems as well as servers and personal computers, smartphones and tablet mounted on mobile devices such as mobile operating system was born. Mobile Operating System has been expanded a TV or Car Area that built into a simple embedded operating system, is emergence of a variety of devices, cloud services, combined with the desire of users due to the high built-in simple embedded operating system that was working on a TV or a car is expanding to the area. The reason for the emergence of a variety of devices, cloud services, combined with the desire of users is high. In this paper, the mobile operating system, N-Screen, Smart TV to find out about and through the analysis of the major smart TV, the future Find out about trends in the mobile operating system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.5
• /
• pp.504-511
• /
• 2016

In this paper, MIMO system based on turbo equalization techniques which LDPC codes were outer code and space time trellis codes (STTC) were employed as an inner code are studied. LDPC decoder and STTC decoder are connected through the interleaving and de-interleaving that updates each other's information repeatedly. In conventional turbo equalization of MIMO system, BCJR decoder which decodes STTC coded bits required two-bit wise decoding processing. Therefore duo-binary turbo codes are optimal for MIMO system combined with STTC codes. However a LDPC decoder requires bit unit processing, because LDPC codes can't be applied to these system. Therefore this paper proposed turbo equalization for MIMO system based on LDPC codes combined with STTC codes. By the simulation results, we confirmed performance of proposed turbo equalization model was improved about 0.6dB than that of conventional LDPC codes.

• The Journal of the Korea Contents Association
• /
• v.6 no.1
• /
• pp.1-7
• /
• 2006

This paper proposes a new method that reduces the complexity of the combined system, which consists of the selective mapping(SLM) and the partial transmit sequence(PTS) in the Orthogonal Frequency Division Multiplexing(OFDM). In order to reduce the Peak-to-Average Power Ratio(PAPR), many techniques have been developed such as SLM and PTS. and their combined systems. However the method that simply combines PTS and SLM to improve the effectiveness of a system increases the complexity of calculation. The scheme employed in this research suggests a system that combines PTS and SLM reducing the complexity via the N($N=2^n$)-point inverse fast Fourier transforms(IFFT), which uses the decimation in time domain not only to improve PAPR but also to reduce the amount of calculation. The proposed method reduces the complexity by multiplying a phase sequence and a subblock index to the data sequences in the middle of IFFT, which yields an optimal sequence with minimal PAPR. The superiority of the proposed method is demonstrated by simulation results and analysis.

• Journal of Photoscience
• /
• v.1 no.2
• /
• pp.83-88
• /
• 1994

The synergic effect of iron plus blue light on the peroxidation of membrane lipid was investigated, using liposomes made of phospholipid. While strong irradiation did not affect Fe$^{+2}$-promoted lipid peroxidation that turned out to be O$_2$-dependent, ferric iron in bright light exerted a pronounced effect on the initiation of lipid peroxidation: this combined action of light and Fe$^{+3}$ on liposomal membranes was apparently independent of O$_2$. When liposomal samples containing Fe$^{+3}$ were subjected to irradiation, some portions of Fe$^{+3}$ were converted into Fe$^{+2}$. The extent of the Fe$^{+3}$-Fe$^{+2}$ conversion increased with increasing time of irradiation, which resembled the dependence of Fe$^{+3}$-promoted lipid peroxidation on irradiation. Further, it was observed that the effect of irradiation in liposomal samples containing Fe$^{+2}$ was strikingly mimicked by that of Fe$^{+2}$ addition to the same samples. The obligatory requirement of a suitable Fe$^{+3}$/Fe$^{+2}$ ratio for the genesis of iron-dependent lipid peroxidation, a controversial proposition, was also confirmed by the observation that lipid peroxidation was substantially enhanced by the addition of a mixture of Fe$^{+3}$ and Fe$^{+2}$, as compared to the addition of Fe$^{+3}$ or Fe$^{+2}$ alone. The results obtained in this study not only suggest that light acts as an effector for initiating lipid peroxidation, when Fe$^{+3}$ is present in membrane systems, but also imply that any chemical or physical factor that influences the redox states of iron in membranes can play a role in lipid peroxidation reactions.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.12 no.5
• /
• pp.171-179
• /
• 2004

Today, the number of vehicle increased rapidly with the development of modem science technology, and it caused serious problems; traffic jam, accident and pollution etc. One of the solve methods these problems it is necessary to develope the vehicle navigation systems and it is already widely used to in field of military etc. Vehicle navigation system can increase the efficiency of traffic flow and offer at a drivers at a best driving conditions. In the vehicle navigation, most important thing is to measure of correct position. There are classifiable as three types. The first is G.P.S., method at artificial satellites which measures the present position and velocity any time, any where in the world at the same time. Secondly, a vehicle can determine its position and path information with a gyroscope and odometer signal, which is called Dead-Reckoning method. Thirdly, hybrid navigation system is the combined of two methods to make utilize the advantage of each navigation system. In the paper, we are analyzed to characteristics at a gyro sensor and introduce at a composition of hybrid navigation system which is combined with the G.P.S., D.R., and map-matching technique. We analyze deeply for the Map-Matching method and explain the coordinate transformation for G.P.S., and the Hybrid navigation algorithm is developed and experimented. Finally, we conclude and comment about our road test results.

• Journal of Korea Game Society
• /
• v.10 no.1
• /
• pp.135-146
• /
• 2010

The development of image technologies in such area as broadcasting and movies has recently increased our attention to 3D stereoscopic images. In addition, the development of stereoscopic image representation technologies in 3D contents becomes more active over time due to the representational limitations of 2D images. Without limitation to the above-mentioned area, stereoscopic image technologies have been developed and studied so that they can be widely accessed in diverse areas including medical services and education. Due to the refined production, however, required to represent a three dimensional effects and the fatigue caused by the perception of a three dimensional effects, the stereoscopic image technologies are not combined into real time systems such as games where environments change unforeseeably. In this study we design a technique to adjust the depth scaling that will enable efficient management of a three dimensional effects and to relieve fatigue through automatic view point interval adjustment in accordance with situations based on the geometrical structure of the DirectX SDK graphic pipeline. Through this, we would like to suggest a new alternative idea to activate the production of games combined with stereoscopic image technologies.

• Progress in Medical Physics
• /
• v.13 no.4
• /
• pp.229-233
• /
• 2002

We have tested a combined CT/SPECT system with a single CZT detector for x-ray and gamma-ray medical imaging. The size of detector is 10$\times$10$\times$5 ㎣, and the anodes are pixellated as a 4$\times$4 array with a pixel dimension of $1.5\times$1.5 $\textrm{mm}^2$. The cathode was coated with a continuous Au-plated. We have characterized the system performance by scanning a radiographic resolution phantom and the Hoffman Brain phantom. Pulse counting electronics with very short shaping time (50 ㎱) are used to satisfy high photon rates in x-ray imaging, and response linearity up to 3$\times$10$^{5}$ counts per second per detector element is achieved. Energy resolution of 10.4% and 5.3% FWHM at Tc-99m 140 keV peak are obtained for the 50 ㎱ and 2 $mutextrm{s}$ shaping times, respectively. The spatial resolutions of CT and SPECT are about 1mm and 9mm, respectively. Photopeak efficiency of detector systems are 41.0% for 50㎱ and 72.5% for 2 $mutextrm{s}$ shaping time.