• Journal of Korean Society of Rural Planning
• /
• v.19 no.4
• /
• pp.125-135
• /
• 2013

Analysis and evaluation of uncertainty is adopting the advanced methodology among the methods for greenhouse gas emission assessment that was defined in GPS2000 (Good practice guideline 2000) and GPG-LULUCF (GPG Land Use, Land-Use Change and Forestry). In 2006 IPCC guideline, two approaches are suggested to explain the uncertainty for each section with a national net emission and a prediction value on uncertainty as follows; 1) Spread sheet calculation based on the error propagation algorithm that was simplified with some assumptions, and 2) Monte carlo simulation that can be utilized in general purposes. There are few researches on the agricultural field including greenhouse gas emission that is generated from livestock and cultivation lands due to lack of information for statistic data, emission coefficient, and complicated emission formula. The main objective of this study is to suggest an evaluation method for the uncertainty of greenhouse gas emission in agricultural field by means of intercomparison of the prediction value on uncertainties which were estimated by spread sheet calculation and monte carlo simulation. A statistic analysis for probability density function for uncertainty of emission rate was carried out by targeting livestock intestinal fermentation, excrements treatment, and direct/indirect emission from agricultural lands and rice cultivation. It was suggested to minimize uncertainty by means of extraction of emission coefficient according to each targeting section.

• International Journal of Highway Engineering
• /
• v.12 no.2
• /
• pp.91-97
• /
• 2010

This study started from the problem recognition of climbing lane installed in Korea roads. Because design standards of climbing lane installed don't match traffic pattern of korean drivers, coefficient of utilization of climbing lane is low and merging section between climbing lane and main lane has traffic accident possibilities. For this, brand-new design standards developed from the present lane design criterion, taper lenghs, and traffic signs, then field adoption test was carried out to prove the effectiveness. As a result, coefficient of utilization of climbing lane and average traffic velocity in climbing section are improved and the economic analysis also shows that brand-new standards has high feasibility for low cost. In case of broad application to not only expressway but national and local road based on the study, it could be a significant contribution to traffic flow improvement.

• Journal of Korean Society on Water Environment
• /
• v.22 no.5
• /
• pp.856-864
• /
• 2006

For estimating the minimum discharge to maintain a river, low flow analysis is required and long term runoff records are needed for the analysis. However, runoff data should be estimated to run a hydrologic model for ungaged river basin. For the reason, parameter estimation is crucial to simulate rainfall-runoff events for those basins using Tank model. In this study, only runoff data recorded for dry season are used for parameter estimation, which is different to other methods based on runoff data recorded for wet and dry seasons. The Harmony Search algorithm is used to determine the optimum parameters for Tank model. The coefficient of determination ($R^2$) is served as the objective function in the Harmony Search. In cases that recorded data are insufficient, the recording interval is changed and Empirical CDF is adopted to analyze the estimated parameters. The suggested method is applied to Yongdam dam, Soyanggang dam, Chungju dam and Seomjingang dam basins. As results, the higher $R^2s$ are obtained when the shorter recording interval, the better recorded data quality, and the more rainfall events recorded along with certain rainfall amount is. Moreover, when the total rainfall is higher than the certain amount, $R^2$ is high. Considering the facts found from this study for the low flow analysis, it is possible to estimate the parameters for Tank model properly with the desired confidence level.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.8
• /
• pp.740-747
• /
• 2015

Recently, mobile communication systems using the millimeter-wave frequency band have been proposed, and the importance of efficient compensation of the nonlinearity caused by 60 GHz high-power amplifiers(HPAs) is increasing. In this paper, we propose a predistorter structure based on multiple coefficient sets which are separately used to different ranges of input power values. These ranges correspond to varying levels of nonlinearity characteristics. The structure is applied to the 60 GHz HPA FMM5715X and the performance of correcting the nonlinearity of LTE signals is evaluated. Evaluation results using a hardware testbed demonstrate that the proposed predistorter structure achieves the maximum of 6 dB gain over the conventional method in terms of the adjacent channel leakage ratio(ACLR).

• Structural Engineering and Mechanics
• /
• v.66 no.2
• /
• pp.273-283
• /
• 2018

Currently, the dynamic amplification effect of suction is described using the wind vibration coefficient (WVC) of external loads. In other words, it is proposed that the fluctuating characteristics of suction are equivalent to external loads. This is, however, not generally valid. Meanwhile, the effects of the ventilation rate of louver on suction and its WV are considered. To systematically analyze the effects of the ventilation rate of louver on the multi-dimensional WVC of ultra-large cooling towers under suctions, the 210 m ultra-large cooling tower under construction was studied. First, simultaneous rigid pressure measurement wind tunnel tests were executed to obtain the time history of fluctuating wind loads on the external surface and the internal surface of the cooling tower at different ventilation rates (0%, 15%, 30%, and 100%). Based on that, the average values and distributions of fluctuating wind pressures on external and internal surfaces were obtained and compared with each other; a tower/pillar/circular foundation integrated simulation model was developed using the finite element method and complete transient time domain dynamics of external loads and four different suctions of this cooling tower were calculated. Moreover, 1D, 2D, and 3D distributions of WVCs under external loads and suctions at different ventilation rates were obtained and compared with each other. The WVCs of the cooling tower corresponding to four typical response targets (i.e., radial displacement, meridional force, Von Mises stress, and circumferential bending moment) were discussed. Value determination and 2D evaluation of the WVCs of external loads and suctions of this large cooling tower at different ventilation rates were proposed. This study provides references to precise prediction and value determination of WVC of ultra-large cooling towers.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.6
• /
• pp.77-83
• /
• 1999

H.263 is an international standard of ITU-T that can makes the service such as video phone, video conference in the transmission line less than 64Kbps. This recommendation draft has used motion estimation/compensation, transform coding and quantizing methods. TMN5 used for the performance estimation of H.263 has fundamentally used DCT in transform coding method and presented quantizer for quantizing the DCT transform coefficient. This paper is presenting adaptive quantizer effectively able to quantize DCT coefficient considering the human visual sensitivity while the structure of TMN5 is maintaining. As quantizer that proposed DCT-based H.263 could make transmit more frame than TMN5 in a same transfer speed, it could lower the frame drop effect. And the luminance signal appeared the difference of -0.3 ～ +0.7dB in the average PSNR for the estimation of objective image quality and the chrominance signal appeared the improvement in about 1.5dB in comparision with TMN5. As a result it can attain the better image quality compared to TMN5 in the estimation of subjective image quality.

• Journal of Korean Academy of Nursing
• /
• v.32 no.4
• /
• pp.560-569
• /
• 2002

The purpose of this study was to develop an instrument to measure family resilience for Korean families with a chronically ill child, and to test the validity and reliability of the instrument. Method: The items of instruments used based on the researchers' previous study of concept analysis of Korean family resilience. Nineteen item scales were developed with five domains. In order to test reliability and validity of the scale, data were collected from 231 families, who had a child with a chronic illness. Data was collected between August and September of 2001 in a 3rd level University Hospital in Seoul, Korea. Result: The results were as follows: As a result of the item analysis, 19 items were selected from the total of 37 items, excluding items with low correlation with the total scale. Five factors were evolved by factor analysis, which explained 56.4% of the total variance. The first factor 'Family strength' explained 28.5%, 2nd factor 'Family maturity' 8.7%, 3rd factor 'The ability to use of external resources' 7.0%, 4th factor 'Control' 6.6%, 5th factor 'The driving force for finance' 5.7%. The attributes in these factors were different with those identified by concept analysis of the family resilience in Korean families from the previous study. Cronbach's $\alpha$ coefficient of this scale was .8039 and Guttman spilt- half coefficient was .8184. Conclusion: The study support the reliability and validity of the scale. Because the main concept of family resilience was family strength, there were distinct differences in dimensions of family functioning scales.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.5C
• /
• pp.478-486
• /
• 2007

Double-talk detection errors can result in either large residual echo or distorting the near-end talker's input speech. Thus accurate double-talk detection is an important problem in the acoustic echo canceller to improve the speech quality. In the double-talk detection algorithm using a cross-correlation coefficient, double-talk detection errors can occur in the initial convergence period of an adaptive filter or in noisy environment since the cross-correlation coefficient becomes large in such situations. In this paper, we propose a new double-talk detection algorithm based on the cross-correlation method using a normalized error signal power to reduce the double-talk detection errors. The experimental results have shown the performance improvement of an acoustic echo canceller as well as the noise-robustness of the proposed double-talk detector.

• Journal of the Korea Institute of Building Construction
• /
• v.20 no.1
• /
• pp.35-41
• /
• 2020

The thin coating material used in the outer insulation finishing method is a finishing material mainly based on acrylic emulsion. In this study, the properties of silane modified acrylic emulsion and silica dispersed acrylic emulsion were evaluated. Experimental results showed that the silane modified acrylic emulsion had no significant effect on improving tensile strength, but was effective in improving the performance of adhesion strength, water absorption coefficient, and hot and cold repeat resistance. Silica-dispersed acrylic emulsions were effective in improving tensile strength, and at 10% substitution rate, they were effective in improving the performance of adhesion strength, water absorption coefficient and hot / cold resistance. Through this, it was judged that a composite emulsion capable of improving the performance of the acrylic emulsion could be prepared.

• Composites Research
• /
• v.33 no.4
• /
• pp.198-204
• /
• 2020

In this study, we employ the full atomistic molecular dynamics simulation and finite element homogenization method to predict the thermo-mechanical properties of nanocomposites including carbon nanotube bundle. As the number of carbon nanotubes within the single bundle increases, the effective in-plane Young's modulus and in-plane shear modulus decrease, and in-plane thermal expansion coefficient increases, despite the same volume fraction of carbon nanotubes. To investigate the thickness of interphase zone, we employ the radial density distribution. It is investigated that the interphase thickness is almost independent on the number of carbon nanotubes within the single bundle. It is assumed that the matrix and interphase are isotropic materials. According to the predicted thermo-mechanical properties of interphase zone, the Young's modulus and shear modulus of interphase zone clearly decrease, and the thermal expansion coefficient increases. Based on the thermo-mechanical interphase behavior, we developed the multiscale homogenization model to predict the thermo-mechanical properties of PLA nanocomposites that include the carbon nanotube bundle.