• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.6C
• /
• pp.483-491
• /
• 2012

In vehicle-to-vehicle (V2V) communications, each vehicle should periodically disseminate a beacon message including the kinematics information, such as position, speed, steering, etc., so that a neighbor vehicle can better perceive and predict the movement of the vehicle. However, a simple broadcasting of such messages may lead to a low reception probability as well as an excessive delay. In this paper, we attempt to analyze the impact of the following key parameters of the beacon dissemination on the performance of vehicular networks: beacon period, carrier-sensing range, and contention window (CW) size. We first derive a beacon period which is inversely proportional to the vehicle speed. Next, we mathematically formulate the maximum beacon load to demonstrate the necessity of the transmit power control. We finally present an approximate closed-form solution of the optimal CW size that leads to the maximum throughput of beacon messages in vehicular networks.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6C
• /
• pp.423-433
• /
• 2005

We present power(in frequency domain) and rate adaptation(in time domain) schemes in multicarrier (MC) direct-sequence code-division multiple-access(DS/CDMA) communications. Utilizing channel state information from the receiver, the adaptation schemes allocate power the user's sub-band with the largest channel gain. In the time domain, the transmission data rate is adapted for a desired transmission quality. In the case of single-user channels, a closed-form expression is derived for an optimal time domain power adaptation that minimizes the average bit error rate(BER). Channel inversion power adaptation is found to provide nearly optimal performance in this case, as the number of sub-bands or available average transmission power increase. Analysis and simulation results show the BER performance of the proposed power and rate adaptations with fixed average transmission power significantly improves the performance over the power allocation in the frequency domain only. Also, we compare the performance of the proposed power and rate adaptation schemes in MC-DS/CDMA systems with that of power and rate adapted single carrier DS/CDMA systems with RAKE receiver.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.11
• /
• pp.1675-1680
• /
• 2010

Flow Accelerated Corrosion (FAC) occurring during in-service conditions results in localized wall-thinning in the feeder pipes of CANDU. The wall-thinning of the feeder pipes is the main degradation mechanisms affecting the integrity of piping systems. In this paper, we assess the integrity of wall-thinned feeder pipes by limit load analysis. The limit loads for wall-thinning feeder pipes subjected to in-plane bending and internal pressure were determined on the basis of finte element limit analyses. The limit loads are determined from the results of limit analyses of elasticperfectly-plastic materials using the large geometry change. Closed-form approximations of limit load solutions for wall-thinning feeder pipes subjected to in-plane bending and pressure are proposed.

• Journal of Construction Engineering and Project Management
• /
• v.2 no.2
• /
• pp.18-27
• /
• 2012

Despite the rapid development in the construction industry due to the changing new technologies, many projects still fail to meet target deadlines. Shortage in manpower and skilled laborers is one of the main reasons for such delays. Markets with high economic growth and economic expansion (such as Gulf Countries in the Middle East) may have pronounced labor the shortages. Labor subcontracting practices are used sometimes to increase production rates and meet project deadlines. This paper explains and analyses labor subcontracting practices currently being used in many places around the world (and especially in the Gulf Countries) and in particular defines a maximum overtime rate for laborers in the laborer-subcontracting method ensuring that the contractor gains both the time saved during overtime and also reduces the cost per unit produced. The mathematical model used formalizes a closed-form equation for overtime pay in similar situations and as such can be applicable worldwide. Data was collected from representative projects that employed such practices from various trades. Validation of the model and formula has been tested successfully by analyzing historic data. The results prove that contractors often do not reach the optimum use of their practices resulting in a higher cost per unit. The presented model and the analysis should be of interest to many contractors currently involved in the practice or considering its use and to those who wish to find new methods that would help in eliminating as much wastes as possible by allocating their resources in the most efficient way.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1A
• /
• pp.36-43
• /
• 2008

In this paper, we propose an optimal relay selection scheme for decode-and-forward relaying systems. The optimal relay selection minimizes the number of time slots used to relay source's signal and maximizes an end-to-end signal-to-noise ratio. However, decode-and-forward relaying systems require additional overhead for the optimal relay selection. Assuming independent and identically distributed Rayleigh fading channels, we provide exact and closed-form expressions for the outage probability of capacity and the bit error rate for decode-and-forward relaying systems with the optimal relay selection. It is shown that the analytic results are perfectly matched with the simulated ones. When the numbers of relay nodes are 2, 4, and 8, and the numbers of time slots for overhead are 1, 2, and 4, respectively, the proposed system achieves 1 dB, 2 dB, and 3 dB gains at 1% bit error rate, respectively, and 0.5 dB, 4 dB, and 12 dB gains at 1% outage probability for 1 bps/Hz, respectively, over the conventional decode-and-forward relaying system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.10 s.89
• /
• pp.944-951
• /
• 2004

In this paper, we proposed the method of the characteristic impedance and effective dielectric constant calculations of the shielded microstrip line with ground aperture using conformal mapping method. This method has advantages that can calculate the transmission parameters without using any other numerical method because present the closed form equations. First of all, we supposed the signal propagate with the microstrip mode(Quasi-TEM) and calculated the capacitance divide by three sections and calculated the characteristic impedance and effective dielectric constant using calculated capacitances. From the HFSS simulation result, calculated result was very similar to the simulation result within the five percent error range.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.8
• /
• pp.1804-1810
• /
• 2013

In this paper, we study the opportunistic cooperation scheme that improves the outage performance through the efficient selection between a cooperative mode and a non-cooperative mode. Especially, in decode-and-forward relaying systems, we analyze the outage performance for the opportunistic cooperation using partial relay selection, where closed-form expressions of exact and asymptotic outage probabilities are derived assuming independent and identically distributed Rayleigh fading channels. In the numerical results, we verify the derived expressions, and investigate the outage performances for various target data rates and different numbers of relays. Also, we compare the outage performances of the conventional cooperation scheme and the opportunistic cooperation scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.9
• /
• pp.1081-1094
• /
• 2016

KREONET is a principal national R&E network running by KISTI in Korea. It uniquely provides production research network services for around 200 non-profit research and educational organizations, based on hybrid (IP and non-IP) network infrastructure. However, KREONET is limited to meet various needs of new network services for advanced Science & Technology (S&T) users because its infrastructure is inherently derived form classical hardware-based, fixed and closed environments. So, KREONET-S is designed to provide advanced S&T services to catch up with time-to-research and time-to-collaboration. In this paper, we present a system architecture of KREONET-S based on network infrastructure that consists of data and control planes separately. Furthermore, we propose and describe VDN service which is capable of building a virtual dedicate & bandwidth-guaranteed network for S&T group dynamically. we implement VDN application on KREONET-S and then perform performance analysis for proving that KREONET-S system and VDN application can be a good solutions to cope with new network paradigms for various advanced S&T applications and users.

• Journal of Korean Society of Steel Construction
• /
• v.18 no.2
• /
• pp.203-211
• /
• 2006

This paper presents a new, effective torsional constant for thin-waled open beams under concentrated and uniformly distributed torques. The proposed constant can be used directly, instead of the St. Venant torsional constant, for any generic comemrcial finite-element program, without modifying the algorithm. The derived torsional constant accounts for both the pure torsion and the warping torsion, and is equal to the St. Venant torsion constant times a correction factor. It is also shown, in the case of the St. Venant torsion, that the derived constant is identical to the torsional constant. The derived effective torsional constant is different from the one given by Elhelbawey et al. The pure torsional shear stress, the warping shear stress, and the warping normal stress were also determine d, using the maximum twisting angle. The accuracy of the proposed torsional constant was validated by comparing the numerical results with the closed-form solutions or other numerical results available in the literature.

• Mycobiology
• /
• v.47 no.2
• /
• pp.230-241
• /
• 2019

The Great Sebkha of Oran is a closed depression located in northwestern of Algeria. Despite the ranking of this sebkha among the wetlands of global importance by Ramsar Convention in 2002, no studies on the fungal community in this area have been carried out. In our study, samples were collected from two different regions. The first region is characterized by halophilic vegetation and cereal crops and the second by a total absence of vegetation. The isolated strains were identified morphologically then by molecular analysis. The biotechnological interest of the strains was evaluated by testing their ability to grow at different concentration of NaCl and to produce extracellular enzymes (i.e., lipase, amylase, protease, and cellulase) on solid medium. The results showed that the soil of sebkha is alkaline, with the exception of the soil of cereal crops that is neutral, and extremely saline. In this work, the species Gymnoascus halophilus, Trichoderma gamsii, the two phytopathogenic fungi, Fusarium brachygibbosum and Penicillium allii, and the teleomorphic form of P. longicatenatum observed for the first time in this species, were isolated for the first time in Algeria. The halotolerance test revealed that the majority of the isolated are halotolerant. Wallemia sp. and two strains of G. halophilus are the only obligate halophilic strains. All strains are capable to secrete at least one of the four tested enzymes. The most interesting species presenting the highest enzymatic index were Aspergillus sp. strain A4, Chaetomium sp. strain H1, P. vinaceum, G. halophilus, Wallemia sp. and Ustilago cynodontis.